SFShawn Fullmer

Shawn Fullmer

*This is an algorithmically generated author record based on publicly available information.

Shawn Fullmer has a total of 19 co-authors. Here are the top co-authors by number of shared publications:

  • Charles Kerans

    Department of Earth and Planetary Sciences, Jackson School of Geosciences The University of Texas at Austin 2305 Speedway, Stop C1160 Austin Texas 78712‐1692 USA

    2 shared publications
  • Antonio Buono

    ExxonMobil Upstream Research Company, 22777 Springwoods Village Parkway, Spring, Texas 77389, USA

    1 shared publication
  • Antonio Buono

    ExxonMobil Upstream Research Company, 22777 Springwoods Village Parkway, Spring, Texas 77389, USA

    1 shared publication
  • B. Rendall

    ExxonMobil Upstream Research Company , 22777 Springwood Village Parkway, Houston, Texas 77389

    1 shared publication
  • Bo Gao

    ExxonMobil Upstream Research Company, 22777 Springwoods Village Parkway, Spring, Texas 77389, USA

    1 shared publication
  • Brian Kelley

    ExxonMobil Upstream Research Company, 22777 Springwoods Village Parkway, Spring, Texas 77389, USA

    1 shared publication

Latest Publications

  • Carbonate Pore‐System Influence on Hydrocarbon Displacement and Potential Recovery

    by Shawn Fullmer, Hisham Al Qassab, Antonio Buono, Bo Gao, Brian Kelley, P.J. Moore

    Understanding reservoir performance and predicting hydrocarbon recovery in carbonate reservoirs are challenging due to the complexity of the pore system and the dynamic interplay of multiphase fluids that move through the pore network. A multiyear study of carbonate reservoirs across a broad spectrum of geologic conditions, fluid types, and field maturities has resulted in key insights on the links between pore-system characteristics and dynamic fluid-flow behavior with material relevance to carbonate resource assessment, field development optimization, and maximizing ultimate recovery. Pore-system heterogeneity is a primary control on hydrocarbon displacement efficiency. Multiphase flow through heterogeneous pore systems with a mix of pore types results in lower recovery than flow through more homogeneous pore systems. Due to the homogeneous nature of the micropore system, rocks dominated by micropores can have favorable hydrocarbon displacement with residual oil saturation to water displacement (Sorw) less than 5%. Rocks with a heterogeneous mix of interparticle and micropores have less favorable displacement, with Sorw as high as 20%, despite having higher permeability. A threshold of approximately 80% microporosity appears to distinguish: (1) more favorable displacement in micropore-dominated rocks vs. less favorable displacement in rocks with a mixed pore system, (2) the magnitude of permeability for a given porosity in mixed vs. micropore systems, and (3) the proportion of microporosity above which pore space of any type is connected exclusively through the micropore network and flow properties reflect the homogeneous nature of that pore system. Within the homogeneous micropore system, Sorw increases from about 5% to 20% as porosity and permeability decrease and micropore type transitions from type 1 (higher quality) to type 2 (lower quality). A major control on multiphase fluid movement in reservoirs with interlayered mixed and micropore-dominated flow units is the contrast in capillary pressure (Pc) and water relative permeability (Krw) between these distinct pore systems. When compared on a consistent basis, 60% water saturation, for instance, rocks with a mixed pore system have approximately neutral (0 psi, 0 kPa) Pc values and higher Krw values, whereas rocks dominated by microporosity have more strongly negative (−6 psi, (−41 kPa) Pc values and lower Krw values. In the case of a water flood operation, this contrast in Pc and Krw can lead to more heterogeneous sweep patterns and lower recovery. A new method for tagging in-place oil with xenon was coupled with flow-through micro-computed tomography imaging to directly investigate oil displacement under water flood conditions. The results provide a qualitative demonstration of how brine flooding displaces xenon-saturated oil. Displacement patterns in micropore-dominated rocks are homogeneous and compact with limited bypass of oil, consistent with relatively low Sorw. Conversely, the displacement pattern in rocks with a mixed pore system is more heterogeneous and exhibits significant regions of bypassed oil, consistent with higher Sorw and Krw.


  • Resurrection of a reservoir sandstone from tomographic data using three-dimensional printing

    by Sergey Ishutov, Franciszek J. Hasiuk, Shawn M. Fullmer, Antonio S. Buono, Joseph N. Gray, Chris Harding

    Three-dimensional (3-D) printing provides an opportunity to build lab-testable models of reservoir rocks from tomographic data. This study combines tomography and 3-D printing to reproduce a sample of the Fontainebleau sandstone at different magnifications to test how this workflow can help characterization of transport properties at multiple scales. For this sandstone, literature analysis has given a porosity of 11%, permeability of 455 md, mean pore throat radius of 15 μm, and a mean grain size of 250 μm. Digital rock analysis of tomographic data from the same sample yielded a porosity of 13%, a permeability of 251 md, and a mean pore throat radius of 15.2 μm. The 3-D printer available for this study was not able to reproduce the sample’s pore system at its original scale. Instead, models were 3-D printed at 5-fold, 10-fold, and 15-fold magnifications. Mercury porosimetry performed on these 3-D models revealed differences in porosity (28%–37%) compared to the literature (11%) and to digital calculations (12.7%). Mercury may have intruded the smallest matrix pores of the printing powder and led to a greater than 50% increase in measured porosity. However, the 3-D printed models’ pore throat size distribution (15 μm) and permeability (350–443 md) match both literature data and digital rock analysis. The powder-based 3-D printing method was only able to replicate parts of the pore system (permeability and pore throats) but not the pore bodies. Other 3-D printing methods, such as resin-based stereolithography and photopolymerization, may have the potential to reproduce reservoir rock porosity more accurately.


  • Facies-independent reservoir characterization of the micropore-dominated Word field (Edwards Formation), Lavaca County, Texas

    by S. Van Simaeys, B. Rendall, F. J. Lucia, C. Kerans, S. Fullmer

    Micropore-dominated carbonate reservoirs remain challenging for accurate hydrocarbon evaluation and production because conventional reservoir models using depositional textures and petrophysical properties to distribute porosity and permeability cannot be applied. Nevertheless, understanding the distribution of pore systems and predicting the fluid flow behavior of microporous reservoirs is fundamental because micropores constitute a significant percentage of the total porosity and storage capacity. We present the results from an integrated study on the producing micropore-dominated Word field characterized by a facies-independent, diagenetically controlled pore system that approaches 100% microporosity. Four cored wells through the Albian Edwards Formation were described and correlated using stacking patterns and vertical facies trends; pore type characterization was done through thin section petrography, routine core analyses, scanning electron microscopy, and mercury injection capillary pressure data. This study is an example of a permeable reservoir in which intergrain pores are cemented during burial diagenesis and micropores, being more resistant to cementation, remain open to depths greater than 4000 m (13,000 ft). A unique relationship exists between porosity, permeability, median pore throat size, and microcrystalline textures, independent of facies and fabrics. Cumulative gas production data show there is a correlation between the total porosity and the structural position of the wells: wells high on the structure have the highest production. We demonstrate that an equally well–connected micropore network exists in mud-dominated rocks via the matrix and via grain-to-grain contacts in grain-dominated rocks. The here described intragrain micropore network through grain-to-grain contacts in cemented grainstones is a new carbonate flow path that will likely become more important as more unconventional carbonate reservoirs are explored.


  • Mapping facies distributions on modern carbonate platforms through integration of multispectral Landsat data, statistics-based unsupervised classifications, and surface sediment data

    by Stephen E. Kaczmarek, Melissa K. Hicks, Shawn M. Fullmer, Kelley L. Steffen, Steven L. Bachtel

    Benthic sediment facies maps were constructed for a series of large, isolated carbonate platforms, including (1) Great and Little Bahamas Banks; (2) Caicos Platform, British West Indies; (3) Chinchorro Bank, Mexico; (4) Glovers Reef, Belize; (5) south Cocos (Keeling) atoll, Indian Ocean; and (6) Bu Tini shoal, Persian Gulf. Facies maps were generated by applying statistics-based image analysis algorithms, called unsupervised classifications, to Landsat 7 multispectral satellite data. Classification results were subsequently validated with sediment data to create geologic facies maps. Landsat-derived facies maps demonstrate 82–85% agreement when compared to sediment data. At the platform scale, Landsat-derived facies maps accurately capture the principal depositional facies observed on each platform and are in general agreement with published maps generated through conventional mapping techniques. Examination at more detailed scales reveals that Landsat-derived maps differ from conventional maps with respect to the spatial dimensions and shapes of facies bodies. Landsat-derived maps show a level of complexity and heterogeneity that is more realistic than shown in previously published maps, which are characterized by broad, homogeneous facies belts. These results suggest that application of statistical algorithms to Landsat data, coupled with sediment data, provides a cost- and time-efficient method for quantitatively mapping spatial variability of depositional facies in modern carbonate environments. Landsat-derived facies maps, like the ones presented here, provide depositional analogs for subsurface carbonate reservoirs as well as a global data set for extracting predictive relationships between the occurrence and distribution of carbonate sediments that can aid in global hydrocarbon exploration and production.