Marc J.P. Gouw
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Marc J.P. Gouw has a total of 1 co-authors. Here are the top co-authors by number of shared publications:
G. Erkens
Department of Physical Geography, Faculty of Geosciences, Utrecht University, P.O. Box 80.115, 3508 TC Utrecht, The Netherlands
1 shared publication
Latest Publications
- 15 September 2008
- Published by Wiley in Sedimentology
- Vol. 55 (5) , 1487-1516
Alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands)
Ancient fluvial successions often act as hydrocarbon reservoirs. Sub‐surface data on the alluvial architecture of fluvial successions are often incomplete and modelling is performed to reconstruct the stratigraphy. However, all alluvial architecture models suffer from the scarcity of field data to test and calibrate them. The purposes of this study were to quantify the alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands) and to determine spatio‐temporal trends in the architecture. Five north–south orientated cross‐sections, perpendicular to the general flow direction, were compiled for the fluvial‐dominated part of the delta. These sections were used to calculate the width/thickness ratios of fluvial sandbodies (SBW/SBT) and the proportions of channel‐belt deposits (CDP), clastic overbank deposits (ODP) and organic material (OP) in the succession. Furthermore, the connectedness ratio (CR) between channel belts was calculated for each cross‐section. Distinct spatial and temporal trends in the alluvial architecture were found. SBW/SBT ratios decrease by a factor of ca 4 in a downstream direction. CDP decreases from ca 0·7 (upstream) to ca 0·3 (downstream). OP increases from less than 0·05 in the upstream part of the delta to more than 0·25 in the downstream delta. ODP is approximately constant (0·4). CR is ca 0·25 upstream, which is approximately two times larger than in the downstream part of the delta. Furthermore, CDP in the downstream Rhine–Meuse delta increases after 3000 cal yr BP. These trends are attributed to variations in available accommodation space, floodplain geometry and channel‐belt size. For instance, channel belts tend to narrow in a downstream direction, which reduces SBW/SBT, CDP and CR. Tectonics cause local deviations in the general architectural trends. In addition, the positive correlation between avulsion frequency and the ratio of local to regional aggradation rate probably influenced alluvial architecture in the Rhine–Meuse delta. The Rhine–Meuse data set can be a great resource when developing more sophisticated models for alluvial architecture simulation, which eventually could lead to better characterizations of hydrocarbon reservoirs. To aid such usage of the Rhine–Meuse data set, constraints for relevant parameters are provided at the end of the paper.
- 15 September 2008
- Published by Wiley in Sedimentology
- Vol. 55 (5) , 1487-1516
Alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands)
Ancient fluvial successions often act as hydrocarbon reservoirs. Sub‐surface data on the alluvial architecture of fluvial successions are often incomplete and modelling is performed to reconstruct the stratigraphy. However, all alluvial architecture models suffer from the scarcity of field data to test and calibrate them. The purposes of this study were to quantify the alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands) and to determine spatio‐temporal trends in the architecture. Five north–south orientated cross‐sections, perpendicular to the general flow direction, were compiled for the fluvial‐dominated part of the delta. These sections were used to calculate the width/thickness ratios of fluvial sandbodies (SBW/SBT) and the proportions of channel‐belt deposits (CDP), clastic overbank deposits (ODP) and organic material (OP) in the succession. Furthermore, the connectedness ratio (CR) between channel belts was calculated for each cross‐section. Distinct spatial and temporal trends in the alluvial architecture were found. SBW/SBT ratios decrease by a factor of ca 4 in a downstream direction. CDP decreases from ca 0·7 (upstream) to ca 0·3 (downstream). OP increases from less than 0·05 in the upstream part of the delta to more than 0·25 in the downstream delta. ODP is approximately constant (0·4). CR is ca 0·25 upstream, which is approximately two times larger than in the downstream part of the delta. Furthermore, CDP in the downstream Rhine–Meuse delta increases after 3000 cal yr BP. These trends are attributed to variations in available accommodation space, floodplain geometry and channel‐belt size. For instance, channel belts tend to narrow in a downstream direction, which reduces SBW/SBT, CDP and CR. Tectonics cause local deviations in the general architectural trends. In addition, the positive correlation between avulsion frequency and the ratio of local to regional aggradation rate probably influenced alluvial architecture in the Rhine–Meuse delta. The Rhine–Meuse data set can be a great resource when developing more sophisticated models for alluvial architecture simulation, which eventually could lead to better characterizations of hydrocarbon reservoirs. To aid such usage of the Rhine–Meuse data set, constraints for relevant parameters are provided at the end of the paper.
- 1 April 2007
- Published by Netherlands Journal of Geosciences Foundation in Netherlands Journal of Geosciences
- Vol. 86 (1) , 23-54
Architecture of the Holocene Rhine-Meuse delta (the Netherlands) - A result of changing external controls
The Holocene Rhine-Meuse delta is formed under the influence of sea-level rise, tectonics, and variations in discharge and sediment supply. This paper aims to determine the relative importance of these external controls to improve our understanding of the evolution of the Rhine-Meuse fluvio-deltaic system. To do this, the geological and lithological composition of the fluvio-deltaic wedge has to be known in detail, both in space and time. This study presents five cross-valley sections in the Holocene Rhine-Meuse delta, based on almost 2000 shallow borings. Over 130 14C dates provide detailed time control and are used to draw time lines in the sections. Distinct spatio-temporal trends in the composition of the Holocene fluvio-deltaic wedge were found. In the upstream delta, the Holocene succession is characterised by stacked channel belts encased in clastic flood basin deposits through which several palaeo-A-horizon levels are traceable. In a downstream direction, the fluvio-deltaic wedge thickens from 3 to 7 m. The Holocene succession in the downstream cross sections formed from onwards and is characterised by single channel belts encased in organic flood basin deposits. The main part of the organic beds accumulated between 6000 and 3000 cal yr BP. After 3000 cal yr BP, clastic deposition dominated throughout the delta, indicating an increase in the area of clastic sedimentation. The Holocene fluvio-deltaic wedge is subdivided into three segments based on the relative importance of eustatic sea-level rise, subsidence, and upstream controls (discharge and sediment supply). Before 5000 cal yr BP, eustatic sea-level rise controlled the build-up of the wedge. After eustatic sea-level rise ceased, subsidence was dominant from 5000 to 3000 cal yr BP. From 3000 cal yr BP onwards, increased sediment supply and discharge from the hinterland controlled the formation of the fluvio-deltaic wedge. A significant part of the present-day Rhine-Meuse fluvio-deltaic wedge aggraded after eustatic sea-level rise ceased. We therefore conclude that external controls other than eustatic sea-level rise were also of major importance for the formation of the fluvio-deltaic wedge. Because this is probably true for other aggrading fluvial systems at continental margins as well, all external controls should be addressed to when interpreting (ancient) fluvio-deltaic successions.
- 1 April 2007
- Published by Netherlands Journal of Geosciences Foundation in Netherlands Journal of Geosciences
- Vol. 86 (1) , 23-54
Architecture of the Holocene Rhine-Meuse delta (the Netherlands) - A result of changing external controls
The Holocene Rhine-Meuse delta is formed under the influence of sea-level rise, tectonics, and variations in discharge and sediment supply. This paper aims to determine the relative importance of these external controls to improve our understanding of the evolution of the Rhine-Meuse fluvio-deltaic system. To do this, the geological and lithological composition of the fluvio-deltaic wedge has to be known in detail, both in space and time. This study presents five cross-valley sections in the Holocene Rhine-Meuse delta, based on almost 2000 shallow borings. Over 130 14C dates provide detailed time control and are used to draw time lines in the sections. Distinct spatio-temporal trends in the composition of the Holocene fluvio-deltaic wedge were found. In the upstream delta, the Holocene succession is characterised by stacked channel belts encased in clastic flood basin deposits through which several palaeo-A-horizon levels are traceable. In a downstream direction, the fluvio-deltaic wedge thickens from 3 to 7 m. The Holocene succession in the downstream cross sections formed from onwards and is characterised by single channel belts encased in organic flood basin deposits. The main part of the organic beds accumulated between 6000 and 3000 cal yr BP. After 3000 cal yr BP, clastic deposition dominated throughout the delta, indicating an increase in the area of clastic sedimentation. The Holocene fluvio-deltaic wedge is subdivided into three segments based on the relative importance of eustatic sea-level rise, subsidence, and upstream controls (discharge and sediment supply). Before 5000 cal yr BP, eustatic sea-level rise controlled the build-up of the wedge. After eustatic sea-level rise ceased, subsidence was dominant from 5000 to 3000 cal yr BP. From 3000 cal yr BP onwards, increased sediment supply and discharge from the hinterland controlled the formation of the fluvio-deltaic wedge. A significant part of the present-day Rhine-Meuse fluvio-deltaic wedge aggraded after eustatic sea-level rise ceased. We therefore conclude that external controls other than eustatic sea-level rise were also of major importance for the formation of the fluvio-deltaic wedge. Because this is probably true for other aggrading fluvial systems at continental margins as well, all external controls should be addressed to when interpreting (ancient) fluvio-deltaic successions.