Uwe Brauch
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Uwe Brauch has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Adolf Giesen
Univ. Stuttgart (Germany)
3 shared publications - A. Giesen
Universität Stuttgart, Institut für Strahlwerkzeuge, Pfaffenwaldring 43, D-70569 Stuttgart, Germany
1 shared publication A. Voss
Forschungsgesellschaft für Strahlwerkzeuge mbH, Nobelstraße 15, D-70569 Stuttgart, Germany
1 shared publicationAndreas Voss
Univ. Stuttgart (Germany)
1 shared publicationC. Stewen
Universität Stuttgart, Institut für Strahlwerkzeuge, Pfaffenwaldring 43, D-70569 Stuttgart, Germany
1 shared publication- Christian Manz
Fraunhofer-Institut für Angewandte Festkörperphysik (Germany)
1 shared publication
Latest Publications
- 21 April 2006
- Published by SPIE-Intl Soc Optical Eng
- Vol. 6184
GaSb-based VECSELs emitting at around 2.35 ?m employing different optical pumping concepts
We report on the characteristics of (AlGaIn)(AsSb)-based optically pumped vertical-external-cavity surface-emitting lasers (VECSELs) emitting at wavelengths around 2.35 μm. For barrier-pumped VECSELs mounted substrate-side down without substrate thinning, typical room temperature cw output powers of 2 mW were achieved, limited by premature thermal rollover due to strong device overheating. The thermal impedance of the VECSEL semiconductor chip could be considerably reduced by bonding an intra-cavity polycrystalline CVD diamond heat spreader to the top surface of the chip. This way, at -18°C a maximum cw output power of 0.6 W and a slope efficiency of 10% were obtained for a multiple transverse mode output beam limited by the available pump power rather than by thermal rollover. Optimising the resonator for TEM00 mode operation (M2≈1.1), an output power exceeding 0.4 W was achieved. To reduce the large quantum deficit of more than 50% inherent to barrier-pumped (1.06 μm pump wavelength) GaSb-based VECSELs which emit at wavelengths above 2 μm, we realized a first in-well pumped (AlGaIn)(AsSb) VECSEL where the pump light is absorbed directly in the quantum wells, with the amount of absorbed light enhanced by a higher order microcavity resonance. Using a pump wavelength of 1.94 μm, the quantum deficit is reduced to only 18% and an output power of 5mW, limited by the available pump power, and a slope efficiency of 10% were achieved. Further optimisation of the pump optics is expected to result in a significant increase in device performance.
- 21 April 2006
- Published by SPIE-Intl Soc Optical Eng
- Vol. 6184
GaSb-based VECSELs emitting at around 2.35 ?m employing different optical pumping concepts
We report on the characteristics of (AlGaIn)(AsSb)-based optically pumped vertical-external-cavity surface-emitting lasers (VECSELs) emitting at wavelengths around 2.35 μm. For barrier-pumped VECSELs mounted substrate-side down without substrate thinning, typical room temperature cw output powers of 2 mW were achieved, limited by premature thermal rollover due to strong device overheating. The thermal impedance of the VECSEL semiconductor chip could be considerably reduced by bonding an intra-cavity polycrystalline CVD diamond heat spreader to the top surface of the chip. This way, at -18°C a maximum cw output power of 0.6 W and a slope efficiency of 10% were obtained for a multiple transverse mode output beam limited by the available pump power rather than by thermal rollover. Optimising the resonator for TEM00 mode operation (M2≈1.1), an output power exceeding 0.4 W was achieved. To reduce the large quantum deficit of more than 50% inherent to barrier-pumped (1.06 μm pump wavelength) GaSb-based VECSELs which emit at wavelengths above 2 μm, we realized a first in-well pumped (AlGaIn)(AsSb) VECSEL where the pump light is absorbed directly in the quantum wells, with the amount of absorbed light enhanced by a higher order microcavity resonance. Using a pump wavelength of 1.94 μm, the quantum deficit is reduced to only 18% and an output power of 5mW, limited by the available pump power, and a slope efficiency of 10% were achieved. Further optimisation of the pump optics is expected to result in a significant increase in device performance.
- 4 September 2000
- Published by Springer Nature
- p. 303-368
High-Power Diode Lasers for Direct Applications
- 4 September 2000
- Published by Springer Nature
- p. 303-368
High-Power Diode Lasers for Direct Applications
- 20 September 1999
- Published by Optica Publishing Group in Applied Optics
- Vol. 38 (27) , 5752-5760
Power-scalable system of phase-locked single-mode diode lasers
The direct use of diode lasers for high-power applications in material processing is limited to applications with relatively low beam quality and power density requirements. To achieve high beam quality one must use single-mode diode lasers, however with the drawback of relatively low optical output powers from these components. To realize a high-power system while conserving the high beam quality of the individual emitters requires coherent coupling of the emitters. Such a power-scalable system consisting of 19 slave lasers that are injection locked by one master laser has been built and investigated, with low-power diode lasers used for system demonstration. The optical power of the 19 injection-locked lasers is coupled into polarization-maintaining single-mode fibers and geometrically superimposed by a lens array and a focusing lens. The phase of each emitter is controlled by a simple electronic phase-control loop. The coherence of each slave laser is stabilized by computer control of the laser current and guarantees a stable degree of coherence of the whole system of 0.7. An enhancement factor of 13.2 in peak power density compared with that which was achievable with the incoherent superposition of the diode lasers was observed.
- 20 September 1999
- Published by Optica Publishing Group in Applied Optics
- Vol. 38 (27) , 5752-5760
Power-scalable system of phase-locked single-mode diode lasers
The direct use of diode lasers for high-power applications in material processing is limited to applications with relatively low beam quality and power density requirements. To achieve high beam quality one must use single-mode diode lasers, however with the drawback of relatively low optical output powers from these components. To realize a high-power system while conserving the high beam quality of the individual emitters requires coherent coupling of the emitters. Such a power-scalable system consisting of 19 slave lasers that are injection locked by one master laser has been built and investigated, with low-power diode lasers used for system demonstration. The optical power of the 19 injection-locked lasers is coupled into polarization-maintaining single-mode fibers and geometrically superimposed by a lens array and a focusing lens. The phase of each emitter is controlled by a simple electronic phase-control loop. The coherence of each slave laser is stabilized by computer control of the laser current and guarantees a stable degree of coherence of the whole system of 0.7. An enhancement factor of 13.2 in peak power density compared with that which was achievable with the incoherent superposition of the diode lasers was observed.
- 1 January 1998
- Published by Optica Publishing Group
- p. HP1
100 W TEM00 Operation of Yb:YAG Thin Disc Laser with High Efficiency
We report on the power scalability of the thin disc laser design with high efficiency and good beam quality. Nearly 100 W of TEM00 power (M2 = 1.2) with an electrical to optical efficiency of more than of 13% is obtained. A maximum laser power of 346 W was extracted from one single disc with an electrical to optical efficiency of 16.8%.
- 1 January 1998
- Published by Optica Publishing Group
- p. HP1
100 W TEM00 Operation of Yb:YAG Thin Disc Laser with High Efficiency
We report on the power scalability of the thin disc laser design with high efficiency and good beam quality. Nearly 100 W of TEM00 power (M2 = 1.2) with an electrical to optical efficiency of more than of 13% is obtained. A maximum laser power of 346 W was extracted from one single disc with an electrical to optical efficiency of 16.8%.
- 1 November 1997
- Published by SPIE-Intl Soc Optical Eng
- Vol. 3176, 341-345
Multiwatt diode-pumped thin-disc Yb:YAG laser tunable between 1016 and 1062 nm
The tunability of a diode pumped Yb:YAG laser is presented. With the thin disc laser concept good efficiencies with scalable output power are obtained. Up to 147 W output power, optical efficiencies of 64 percent and diffraction limited beam quality have been achieved.
- 1 November 1997
- Published by SPIE-Intl Soc Optical Eng
- Vol. 3176, 341-345
Multiwatt diode-pumped thin-disc Yb:YAG laser tunable between 1016 and 1062 nm
The tunability of a diode pumped Yb:YAG laser is presented. With the thin disc laser concept good efficiencies with scalable output power are obtained. Up to 147 W output power, optical efficiencies of 64 percent and diffraction limited beam quality have been achieved.