Yujie J. Ding
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yujie J. Ding has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
Xiaodong Mu
Lehigh Univ. (United States)
8 shared publicationsGregory J. Salamo
Univ. of Arkansas (United States)
5 shared publicationsHaeyeon Yang
Department of Physics, University of Arkansas, Fayetteville, Arkansas 72701
3 shared publicationsJohn Little
Army Research Lab. (United States)
2 shared publicationsZhiming Wang
Univ. of Arkansas (United States)
2 shared publicationsIoulia B. Zotova
Department of Physics, University of Arkansas, Fayetteville, AR 72701, USA
1 shared publication
Latest Publications
- 4 April 2005
- Published by SPIE-Intl Soc Optical Eng
- Vol. 5734, 19-27
InAs quantum dots coupled with strained InGaAs/GaAs coupled quantum-wells
We have studied the coupling between the InAs quantum dots and coupled quantum wells strained by the InAs quantum dots (i.e. coupled-quantum-well dots) by measuring photoluminescence spectra. By comparing the photoluminescence spectra of the coupled-quantum-well dots in which either the narrow well or wide well is grown next to the InAs quantum dots, we have evidenced the spatially inhomogeneous strains applied by the InAs quantum dots on the coupled quantum wells. Moreover, we have also investigated the three coupling regimes, i.e. when the dot level is higher than, lower than, and aligned to the lowest quantum-well transition. Based on our measurements, we conclude that the optical properties for the coupled-quantum-well dots have been significantly improved over the quantum dots.
- 4 April 2005
- Published by SPIE-Intl Soc Optical Eng
- Vol. 5734, 19-27
InAs quantum dots coupled with strained InGaAs/GaAs coupled quantum-wells
We have studied the coupling between the InAs quantum dots and coupled quantum wells strained by the InAs quantum dots (i.e. coupled-quantum-well dots) by measuring photoluminescence spectra. By comparing the photoluminescence spectra of the coupled-quantum-well dots in which either the narrow well or wide well is grown next to the InAs quantum dots, we have evidenced the spatially inhomogeneous strains applied by the InAs quantum dots on the coupled quantum wells. Moreover, we have also investigated the three coupling regimes, i.e. when the dot level is higher than, lower than, and aligned to the lowest quantum-well transition. Based on our measurements, we conclude that the optical properties for the coupled-quantum-well dots have been significantly improved over the quantum dots.
- 1 January 2004
- Published by Optica Publishing Group
- p. IWA35
Coupling between InAs quantum dots and strained InGaAs/GaAs coupled quantum-wells: A novel type of quantum dots
We have studied coupling between InGaAs/GaAs coupled quantum wells and self-assembled InAs quantum dots by measuring the linewidths, peak energies and peak intensities of photoluminescence peaks for different pump powers and lateral locations.
- 1 January 2004
- Published by Optica Publishing Group
- p. IWA35
Coupling between InAs quantum dots and strained InGaAs/GaAs coupled quantum-wells: A novel type of quantum dots
We have studied coupling between InGaAs/GaAs coupled quantum wells and self-assembled InAs quantum dots by measuring the linewidths, peak energies and peak intensities of photoluminescence peaks for different pump powers and lateral locations.
- 5 August 2002
- Published by AIP Publishing in Applied Physics Letters
- Vol. 81 (6) , 1107-1109
Vertically stacking self-assembled quantum wires
Self-assembled InP/InAs/InP quantum wires (QWRs) have been stacked for ten vertical periods and characterized based on photoluminescence (PL) studies. Compared with single-period QWRs, behaviors in the PL spectra and some fundamental effects have been observed. Through the detailed analyses of the PL shapes, linewidths, and polarizations at different pump wavelengths, pump intensities, and sample temperatures, it is evidenced that the wire width and subband energy gradually decrease while the average wire thickness increases from the bottom period to the top one, period by period. Meanwhile, the average wire width gradually decreases. Following these results, growth conditions have been suggested, which can be essential to improving the optical quality of these self-assembled QWRs.
- 5 August 2002
- Published by AIP Publishing in Applied Physics Letters
- Vol. 81 (6) , 1107-1109
Vertically stacking self-assembled quantum wires
Self-assembled InP/InAs/InP quantum wires (QWRs) have been stacked for ten vertical periods and characterized based on photoluminescence (PL) studies. Compared with single-period QWRs, behaviors in the PL spectra and some fundamental effects have been observed. Through the detailed analyses of the PL shapes, linewidths, and polarizations at different pump wavelengths, pump intensities, and sample temperatures, it is evidenced that the wire width and subband energy gradually decrease while the average wire thickness increases from the bottom period to the top one, period by period. Meanwhile, the average wire width gradually decreases. Following these results, growth conditions have been suggested, which can be essential to improving the optical quality of these self-assembled QWRs.
- 30 July 2001
- Published by AIP Publishing in Applied Physics Letters
- Vol. 79 (5) , 569-571
Cavity-enhanced and quasiphase-matched multi-order reflection-second-harmonic generation from GaAs/AlAs and GaAs/AlGaAs multilayers
We have observed quasiphase-matched second-harmonic generation in the reflection geometry from GaAs/AlAs multilayers. By using GaAs/AlGaAs multilayers and Fresnel reflection as a cavity, we have also achieved cavity-enhanced nonphase-matched second-harmonic generation from GaAs/AlAs multilayers. The linewidth for the first order reflection-second-harmonic generation is limited only by wave-vector mismatch. In addition, we have demonstrated two-order-of-magnitude enhancement on the conversion efficiency by using the cavity.
- 30 July 2001
- Published by AIP Publishing in Applied Physics Letters
- Vol. 79 (5) , 569-571
Cavity-enhanced and quasiphase-matched multi-order reflection-second-harmonic generation from GaAs/AlAs and GaAs/AlGaAs multilayers
We have observed quasiphase-matched second-harmonic generation in the reflection geometry from GaAs/AlAs multilayers. By using GaAs/AlGaAs multilayers and Fresnel reflection as a cavity, we have also achieved cavity-enhanced nonphase-matched second-harmonic generation from GaAs/AlAs multilayers. The linewidth for the first order reflection-second-harmonic generation is limited only by wave-vector mismatch. In addition, we have demonstrated two-order-of-magnitude enhancement on the conversion efficiency by using the cavity.
- 23 April 2001
- Published by SPIE-Intl Soc Optical Eng
- Vol. 4280, 211-218
Reflection second-harmonic generation from GaAs/AlAs and GaAs/AlGaAs multilayers
We have observed first-, second- and third-order quasi- phase-matched second-harmonic generation in the reflection geometry from GaAs/AlAs multilayers. We have measured phase- matching curves and identified all the peaks. The linewidth for the first order is limited only by wave-vector mismatch. We have demonstrated two-order-of-magnitude enhancement solely using quasi-phase-matched multilayers. We have also achieved cavity-enhanced quasi-phase-matched second-order and non-phase-matched second-harmonic generation from GaAs/Al0.8Ga0.2As multilayers. We have determined the element of the second-order susceptibility tensor used for quasi-phase matching. We have measured the conversion efficiencies and discussed possibilities for further enhancements.
- 23 April 2001
- Published by SPIE-Intl Soc Optical Eng
- Vol. 4280, 211-218
Reflection second-harmonic generation from GaAs/AlAs and GaAs/AlGaAs multilayers
We have observed first-, second- and third-order quasi- phase-matched second-harmonic generation in the reflection geometry from GaAs/AlAs multilayers. We have measured phase- matching curves and identified all the peaks. The linewidth for the first order is limited only by wave-vector mismatch. We have demonstrated two-order-of-magnitude enhancement solely using quasi-phase-matched multilayers. We have also achieved cavity-enhanced quasi-phase-matched second-order and non-phase-matched second-harmonic generation from GaAs/Al0.8Ga0.2As multilayers. We have determined the element of the second-order susceptibility tensor used for quasi-phase matching. We have measured the conversion efficiencies and discussed possibilities for further enhancements.
- 26 June 2000
- Published by Elsevier in Optics Communications
- Vol. 181 (1-3) , 153-159
Backward second-harmonic generation in submicron-period ion-exchanged KTiOPO4 waveguide
- 26 June 2000
- Published by Elsevier in Optics Communications
- Vol. 181 (1-3) , 153-159
Backward second-harmonic generation in submicron-period ion-exchanged KTiOPO4 waveguide
- 20 June 2000
- Published by Optica Publishing Group in Applied Optics
- Vol. 39 (18) , 3099-3103
Investigation of damage mechanisms of KTiOPO_4 crystals by use of a continuous-wave argon laser
We have developed a simple method that uses cw irradiation from an argon laser to measure the damage threshold of KTP crystals. Our experimental results show that there are two types of damage in KTP crystal, depending on the polarization of the incident laser beam. One type of optical damage is the appearance of gray tracks, including both dark tracks and orange dots, when the pump polarization is perpendicular to the z axis. The other type is invisible damage when the polarization is parallel to the z axis. In addition, we have also observed weak photorefractive two-wave mixing in KTP crystals in each of these polarization states. After a systematic analysis we have concluded that the first type of damage is due to the formation and absorption of Ti3+ and Fe3+ centers and the second is due to the drift of K+ ions. The weak photorefractive effect is the result of screening of the electric field by the drifted K+ ions.
- 20 June 2000
- Published by Optica Publishing Group in Applied Optics
- Vol. 39 (18) , 3099-3103
Investigation of damage mechanisms of KTiOPO_4 crystals by use of a continuous-wave argon laser
We have developed a simple method that uses cw irradiation from an argon laser to measure the damage threshold of KTP crystals. Our experimental results show that there are two types of damage in KTP crystal, depending on the polarization of the incident laser beam. One type of optical damage is the appearance of gray tracks, including both dark tracks and orange dots, when the pump polarization is perpendicular to the z axis. The other type is invisible damage when the polarization is parallel to the z axis. In addition, we have also observed weak photorefractive two-wave mixing in KTP crystals in each of these polarization states. After a systematic analysis we have concluded that the first type of damage is due to the formation and absorption of Ti3+ and Fe3+ centers and the second is due to the drift of K+ ions. The weak photorefractive effect is the result of screening of the electric field by the drifted K+ ions.
- 15 January 2000
- Published by Optica Publishing Group in Optics Letters
- Vol. 25 (2) , 117-119
Third-harmonic generation by cascading second-order nonlinear processes in a cerium-doped KTiOPO_4 crystal
We have achieved effective third-harmonic generation (THG) by cascading second-harmonic and sum-frequency generation in a single cerium-doped crystal by using femtosecond laser pulses at . A conversion efficiency of 0.17% was achieved with an average pump power of 35 mW. Furthermore, a unique quadratic power dependence for this type of THG was confirmed. We developed a theory and obtained an analytical solution for the THG. The solution exactly describes the measured characteristics of the THG.- 15 January 2000
- Published by Optica Publishing Group in Optics Letters
- Vol. 25 (2) , 117-119
Third-harmonic generation by cascading second-order nonlinear processes in a cerium-doped KTiOPO_4 crystal
We have achieved effective third-harmonic generation (THG) by cascading second-harmonic and sum-frequency generation in a single cerium-doped crystal by using femtosecond laser pulses at . A conversion efficiency of 0.17% was achieved with an average pump power of 35 mW. Furthermore, a unique quadratic power dependence for this type of THG was confirmed. We developed a theory and obtained an analytical solution for the THG. The solution exactly describes the measured characteristics of the THG.