Chang-Sui Zhao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Chang-Sui Zhao has a total of 75 co-authors. Here are the top co-authors by number of shared publications:
- Huichao Chen
School of Energy and Environment, Southeast University, Nanjing 210096, China
7 shared publications C. Liang
Southeast University, School of Energy and Environment, Key Laboratory of Energy Thermal Conversion and Control of Ministry of Education, Nanjing, China
6 shared publications- Lunbo Duan
School of Energy and Environment, Southeast University, Nanjing, China
5 shared publications Cai Liang
Southeast University
4 shared publicationsX. P. Chen
Southeast University
4 shared publicationsXiaoping Chen
School of Energy and Environment, Southeast University, Nanjing 210096, People's Republic of China
4 shared publications
Latest Publications
- Open Access
- 28 November 2013
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2013, 1-11
DSMC Prediction of Particle Behavior in Gas-Particle Two-Phase Impinging Streams
Devices with impinging streams have been employed in various fields of chemical engineering, as a means of intensifying heat and mass transfer processes. The particle behavior in gas-particle two-phase impinging streams (GPISs), which is of essential importance for the research of transfer processes, was simulated by an Eulerian-Lagrangian approach in this paper. Collisional interaction of particles was taken into account by means of a modified direct simulation Monte Carlo (DSMC) method based on a Lagrangian approach and the modified Nanbu method. A quantitative agreement was obtained between the predicted results and the experimental data in the literature. The particle motion behavior and the distributions of particle concentration and particle collision positions were presented reasonably. The results indicate that the particle distribution in GPIS can be divided into three zones: particle-collision zone, particle-jetting zone, and particle-scattering zone. Particle collisions occur mainly in the particle-collision zone, which obviously results in a few particles penetrating into the opposite stream. The interparticle collision rate and the particle concentration reach their maximum values in the particle-collision zone, respectively. The maximum value of the particle concentration increases with the increasing inlet particle concentration according to a logarithmic function. The interparticle collision rate is directly proportional to the square of local particle concentration.
- 28 November 2013
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2013, 1-11
Open AccessDSMC Prediction of Particle Behavior in Gas-Particle Two-Phase Impinging Streams
Devices with impinging streams have been employed in various fields of chemical engineering, as a means of intensifying heat and mass transfer processes. The particle behavior in gas-particle two-phase impinging streams (GPISs), which is of essential importance for the research of transfer processes, was simulated by an Eulerian-Lagrangian approach in this paper. Collisional interaction of particles was taken into account by means of a modified direct simulation Monte Carlo (DSMC) method based on a Lagrangian approach and the modified Nanbu method. A quantitative agreement was obtained between the predicted results and the experimental data in the literature. The particle motion behavior and the distributions of particle concentration and particle collision positions were presented reasonably. The results indicate that the particle distribution in GPIS can be divided into three zones: particle-collision zone, particle-jetting zone, and particle-scattering zone. Particle collisions occur mainly in the particle-collision zone, which obviously results in a few particles penetrating into the opposite stream. The interparticle collision rate and the particle concentration reach their maximum values in the particle-collision zone, respectively. The maximum value of the particle concentration increases with the increasing inlet particle concentration according to a logarithmic function. The interparticle collision rate is directly proportional to the square of local particle concentration.
- Open Access
Investigation on Dynamic Calibration for an Optical-Fiber Solids Concentration Probe in Gas-Solid Two-Phase Flows
This paper presents a review and analysis of the research that has been carried out on dynamic calibration for optical-fiber solids concentration probes. An introduction to the optical-fiber solids concentration probe was given. Different calibration methods of optical-fiber solids concentration probes reported in the literature were reviewed. In addition, a reflection-type optical-fiber solids concentration probe was uniquely calibrated at nearly full range of the solids concentration from 0 to packed bed concentration. The effects of particle properties (particle size, sphericity and color) on the calibration results were comprehensively investigated. The results show that the output voltage has a tendency to increase with the decreasing particle size, and the effect of particle color on calibration result is more predominant than that of sphericity.
Open AccessInvestigation on Dynamic Calibration for an Optical-Fiber Solids Concentration Probe in Gas-Solid Two-Phase Flows
This paper presents a review and analysis of the research that has been carried out on dynamic calibration for optical-fiber solids concentration probes. An introduction to the optical-fiber solids concentration probe was given. Different calibration methods of optical-fiber solids concentration probes reported in the literature were reviewed. In addition, a reflection-type optical-fiber solids concentration probe was uniquely calibrated at nearly full range of the solids concentration from 0 to packed bed concentration. The effects of particle properties (particle size, sphericity and color) on the calibration results were comprehensively investigated. The results show that the output voltage has a tendency to increase with the decreasing particle size, and the effect of particle color on calibration result is more predominant than that of sphericity.
- 4 April 2013
- Published by Wiley in Chemical Engineering & Technology
- Vol. 36 (5) , 773-780
Conveying Characteristics of Pulverized Coal in a Top‐Discharge Blow Tank System
- 4 April 2013
- Published by Wiley in Chemical Engineering & Technology
- Vol. 36 (5) , 773-780
Conveying Characteristics of Pulverized Coal in a Top‐Discharge Blow Tank System
- 18 August 2012
- Published by Springer Nature
- p. 355-362
Trace Elements Partitioning During Coal Combustion in Fluidized Bed Under O2/CO2 Atmosphere
- 18 August 2012
- Published by Springer Nature
- p. 355-362
Trace Elements Partitioning During Coal Combustion in Fluidized Bed Under O2/CO2 Atmosphere
- 18 August 2012
- Published by Springer Nature
- p. 1377-1383
Attrition and Cyclic CO2 Capture of CaO Pellets with Aluminates Under Pressurized Carbonation
- 18 August 2012
- Published by Springer Nature
- p. 1377-1383
Attrition and Cyclic CO2 Capture of CaO Pellets with Aluminates Under Pressurized Carbonation
- 5 July 2011
- Published by Elsevier in Chemical Engineering Science
- Vol. 66 (20) , 4922-4931
A modified DSMC method for simulating gas–particle two-phase impinging streams
- 5 July 2011
- Published by Elsevier in Chemical Engineering Science
- Vol. 66 (20) , 4922-4931
A modified DSMC method for simulating gas–particle two-phase impinging streams
- 13 September 2010
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 24 (10) , 5751-5756
CO2 Capture Performance of Calcium-Based Sorbents in a Pressurized Carbonation/Calcination Loop
- 13 September 2010
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 24 (10) , 5751-5756
CO2 Capture Performance of Calcium-Based Sorbents in a Pressurized Carbonation/Calcination Loop
- 10 August 2009
- Published by Wiley in Chemical Engineering & Technology
- Vol. 32 (8) , 1176-1182
CO2 Capture Behavior of Shell during Calcination/Carbonation Cycles
The cyclic carbonation performances of shells as CO2 sorbents were investigated during multiple calcination/carbonation cycles. The carbonation kinetics of the shell and limestone are similar since they both exhibit a fast kinetically controlled reaction regime and a diffusion controlled reaction regime, but their carbonation rates differ between these two regions. Shell achieves the maximum carbonation conversion for carbonation at 680–700 °C. The mactra veneriformis shell and mussel shell exhibit higher carbonation conversions than limestone after several cycles at the same reaction conditions. The carbonation conversion of scallop shell is slightly higher than that of limestone after a series of cycles. The calcined shell appears more porous than calcined limestone, and possesses more pores > 230 nm, which allow large CO2 diffusion‐carbonation reaction rates and higher conversion due to the increased surface area of the shell. The pores of the shell that are greater than 230 nm do not sinter significantly. The shell has more sodium ions than limestone, which probably leads to an improvement in the cyclic carbonation performance during the multiple calcination/carbonation cycles.
- 10 August 2009
- Published by Wiley in Chemical Engineering & Technology
- Vol. 32 (8) , 1176-1182
CO2 Capture Behavior of Shell during Calcination/Carbonation Cycles
The cyclic carbonation performances of shells as CO2 sorbents were investigated during multiple calcination/carbonation cycles. The carbonation kinetics of the shell and limestone are similar since they both exhibit a fast kinetically controlled reaction regime and a diffusion controlled reaction regime, but their carbonation rates differ between these two regions. Shell achieves the maximum carbonation conversion for carbonation at 680–700 °C. The mactra veneriformis shell and mussel shell exhibit higher carbonation conversions than limestone after several cycles at the same reaction conditions. The carbonation conversion of scallop shell is slightly higher than that of limestone after a series of cycles. The calcined shell appears more porous than calcined limestone, and possesses more pores > 230 nm, which allow large CO2 diffusion‐carbonation reaction rates and higher conversion due to the increased surface area of the shell. The pores of the shell that are greater than 230 nm do not sinter significantly. The shell has more sodium ions than limestone, which probably leads to an improvement in the cyclic carbonation performance during the multiple calcination/carbonation cycles.
- 16 July 2009
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 23 (7) , 3826-3830
Investigation on Coal Pyrolysis in CO2Atmosphere
- 16 July 2009
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 23 (7) , 3826-3830
Investigation on Coal Pyrolysis in CO2Atmosphere
- 19 June 2009
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 99 (1) , 301-306
Catalytic effects of Fe, Al and Si on the formation of NOX precursors and HCl during straw pyrolysis
- 19 June 2009
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 99 (1) , 301-306
Catalytic effects of Fe, Al and Si on the formation of NOX precursors and HCl during straw pyrolysis