Ce´dric Lenaerts
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ce´dric Lenaerts has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
K. Fleury-Frenette
Université de Liège
3 shared publicationsS. Habraken
Université de Liège
3 shared publicationsC. Desfours
Université de Liège
2 shared publications- J. Hastanin
Centre Spatial de Liège, University of Liege, Angleur, Belgium
2 shared publications B. Pinchemel
Laboratoire de Physique des Lasers, Atomes et Molécules
1 shared publicationBernard Tilkens
The authors are with the Hololab, Department of Physics, University of Liège, Allée du 6 août, Bâtiment B5a, 4000 Liège, Belgium
1 shared publication
Latest Publications
- 9 March 2013
- Published by Springer Nature in Plasmonics
- Vol. 8 (2) , 1203-1208
Substrate Mode-Integrated SPR Sensor
- 9 March 2013
- Published by Springer Nature in Plasmonics
- Vol. 8 (2) , 1203-1208
Substrate Mode-Integrated SPR Sensor
- 9 February 2012
- Published by SPIE-Intl Soc Optical Eng
- Vol. 8234
Experimental investigation of droplet biosensing by multi-wavelength plasmonic
Surface Plasmons Resonance (SPR) architectures involving multi-wavelength interrogation is an attractive alternative for droplet biosensing. In this work, we address two detection formats experimentally investigated by our research group. The first one involves an angular scanning combining one near-IR and one visible light probes. It enables to increase the number of parameters for numerical fitting, which improves the precision of measurement. The second concept involves the SPR Coupler and Disperser sensor principle, where the spectrum analysis is performed on each detector pixel using the same diffraction grating that is employed for the optical coupling of the incident light with the surface plasmons.
- 9 February 2012
- Published by SPIE-Intl Soc Optical Eng
- Vol. 8234
Experimental investigation of droplet biosensing by multi-wavelength plasmonic
Surface Plasmons Resonance (SPR) architectures involving multi-wavelength interrogation is an attractive alternative for droplet biosensing. In this work, we address two detection formats experimentally investigated by our research group. The first one involves an angular scanning combining one near-IR and one visible light probes. It enables to increase the number of parameters for numerical fitting, which improves the precision of measurement. The second concept involves the SPR Coupler and Disperser sensor principle, where the spectrum analysis is performed on each detector pixel using the same diffraction grating that is employed for the optical coupling of the incident light with the surface plasmons.
- 19 August 2010
- Published by SPIE-Intl Soc Optical Eng
- Vol. 7757
A spectral surface plasmon resonance sensor based on transmission grating: architecture analysis dedicated to spectral sensors
Surface Plasmons Resonance (SPR) architectures based on grating coupler/disperser combination is an attractive alternative for spectral-based sensing. We present a new concept where the plasmon coupling occurs through thin film grating and sensing occurs via the first diffraction order in reflective or transmitive mode. The developed geometry is dedicated to droplet sensing. The extension of the architecture to bi-dimensional array of sensors is also facilitated. This paper describes several designs of sensors. The analysis of their theoretical performances is demonstrated and compared, including a sensitivity evaluation.
- 19 August 2010
- Published by SPIE-Intl Soc Optical Eng
- Vol. 7757
A spectral surface plasmon resonance sensor based on transmission grating: architecture analysis dedicated to spectral sensors
Surface Plasmons Resonance (SPR) architectures based on grating coupler/disperser combination is an attractive alternative for spectral-based sensing. We present a new concept where the plasmon coupling occurs through thin film grating and sensing occurs via the first diffraction order in reflective or transmitive mode. The developed geometry is dedicated to droplet sensing. The extension of the architecture to bi-dimensional array of sensors is also facilitated. This paper describes several designs of sensors. The analysis of their theoretical performances is demonstrated and compared, including a sensitivity evaluation.
- 1 October 2005
- Published by Optica Publishing Group in Applied Optics
- Vol. 44 (28) , 6017-6022
High transmission efficiency for surface plasmon resonance by use of a dielectric grating
The efficiency of the transmission of surface plasmon waves by use of a dielectric diffraction grating is discussed. The Kretschmann device allows us to obtain a surface plasmon resonance that consists of an absorption peak in the reflection spectrum. When surface plasmon resonance occurs, the TM-polarization mode of the incident electromagnetic wave is neither transmitted nor reflected. The procedure to transform an absorption peak into a transmission peak is described. Transmittivity of 68% is obtained for a simple structure that consists of a thin-film layer of Ag coated on a volume diffraction grating and embedded between two dielectric media. The results presented herein were obtained by numerical simulations that were carried out by use of an algorithm based on the rigorous coupled-wave theory.
- 1 October 2005
- Published by Optica Publishing Group in Applied Optics
- Vol. 44 (28) , 6017-6022
High transmission efficiency for surface plasmon resonance by use of a dielectric grating
The efficiency of the transmission of surface plasmon waves by use of a dielectric diffraction grating is discussed. The Kretschmann device allows us to obtain a surface plasmon resonance that consists of an absorption peak in the reflection spectrum. When surface plasmon resonance occurs, the TM-polarization mode of the incident electromagnetic wave is neither transmitted nor reflected. The procedure to transform an absorption peak into a transmission peak is described. Transmittivity of 68% is obtained for a simple structure that consists of a thin-film layer of Ag coated on a volume diffraction grating and embedded between two dielectric media. The results presented herein were obtained by numerical simulations that were carried out by use of an algorithm based on the rigorous coupled-wave theory.
- 1 November 2004
- Published by SPIE-Intl Soc Optical Eng in Optical Engineering
- Vol. 43 (11) , 2631-2639
Narrow bandwidth wavelength filter by guided mode resonance
Simple resonant structures that permit holographic reflection filtering are studied. The filters under study work under a 45-deg incidence for a wavelength of λ=632.8 nm, a condition useful for future inclusion in substrate mode systems. First, the influence of the structural parameters of the grating and the waveguide on the position and the shape of the resonance peaks are studied by numerical computation. The numerical results, obtained within the rigorous coupled wave theory, are compared with the measured response of some filters. These filters contain a grating recorded by holography deposited on the substrate. In the case of the bilayer filter, a waveguide is introduced between the grating and the substrate. Second, the numerical results are used for the conception of an active substrate mode spectral filter built from electro-optic zinc oxide. © 2004 Society of Photo-Optical Instrumentation Engineers.
- 1 November 2004
- Published by SPIE-Intl Soc Optical Eng in Optical Engineering
- Vol. 43 (11) , 2631-2639
Narrow bandwidth wavelength filter by guided mode resonance
Simple resonant structures that permit holographic reflection filtering are studied. The filters under study work under a 45-deg incidence for a wavelength of λ=632.8 nm, a condition useful for future inclusion in substrate mode systems. First, the influence of the structural parameters of the grating and the waveguide on the position and the shape of the resonance peaks are studied by numerical computation. The numerical results, obtained within the rigorous coupled wave theory, are compared with the measured response of some filters. These filters contain a grating recorded by holography deposited on the substrate. In the case of the bilayer filter, a waveguide is introduced between the grating and the substrate. Second, the numerical results are used for the conception of an active substrate mode spectral filter built from electro-optic zinc oxide. © 2004 Society of Photo-Optical Instrumentation Engineers.
- 28 May 2003
- Published by EDP Sciences in EAS Publications Series
- Vol. 8, 117-128
Achromatic Four Quadrant Phase Mask Coronagraph using the Dispersion of Form Birefringence
We describe an alternative design for the 4-quadrant phase mask coronagraph described recently by Rouan et al. (2000). Based on the same principle, i.e. producing a very efficient nulling by mutually destructive interferences of the coherent light from the main source, our mask realises the π phase shift using some properties of ZOGs (Zeroth Order Gratings) and according to an original scheme respecting the 4-quadrant symmetry. When the period of the one-dimension grating structure is smaller than the wavelength of the incident light, the structure becomes birefringent. The effective refractive indices depend on the wavelength. Using this feature, we can design a mask whose nulling efficiency is maintained within a wide wavelength range. Numerical simulations were made according to the RCWA (Rigorous Coupled Wave Analyses).
- 28 May 2003
- Published by EDP Sciences in EAS Publications Series
- Vol. 8, 117-128
Achromatic Four Quadrant Phase Mask Coronagraph using the Dispersion of Form Birefringence
We describe an alternative design for the 4-quadrant phase mask coronagraph described recently by Rouan et al. (2000). Based on the same principle, i.e. producing a very efficient nulling by mutually destructive interferences of the coherent light from the main source, our mask realises the π phase shift using some properties of ZOGs (Zeroth Order Gratings) and according to an original scheme respecting the 4-quadrant symmetry. When the period of the one-dimension grating structure is smaller than the wavelength of the incident light, the structure becomes birefringent. The effective refractive indices depend on the wavelength. Using this feature, we can design a mask whose nulling efficiency is maintained within a wide wavelength range. Numerical simulations were made according to the RCWA (Rigorous Coupled Wave Analyses).