Sei-Hyung Ryu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Sei-Hyung Ryu has a total of 60 co-authors. Here are the top co-authors by number of shared publications:
- Anant Agarwal
Cree Inc
7 shared publications - John Palmour
Cree, Inc., 4600 Silicon Dr., Durham, NC, 27703, United States
5 shared publications - Sumi Krishnaswami
Cree Inc., Durham, NC, 27703, United States
3 shared publications - Bradley Heath
Cree, Inc, Durham, NC, 27703, United States
2 shared publications - Charles J. Scozzie
Army Research Laboratory, Adelphi, MD, 20783, United States
2 shared publications - Charlotte Jonas
Cree Inc
2 shared publications
Latest Publications
- 28 July 2015
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 30 (8) , 084001
Ultra high voltage MOS controlled 4H-SiC power switching devices
Ultra high voltage (UHV, >15 kV) 4H-silicon carbide (SiC) power devices have the potential to significantly improve the system performance, reliability, and cost of energy conversion systems by providing reduced part count, simplified circuit topology, and reduced switching losses. In this paper, we compare the two MOS based UHV 4H-SiC power switching devices; 15 kV 4H-SiC MOSFETs and 15 kV 4H-SiC n-IGBTs. The 15 kV 4H-SiC MOSFET shows a specific on-resistance of 204 mΩ cm2 at 25 °C, which increased to 570 mΩ cm2 at 150 °C. The 15 kV 4H-SiC MOSFET provides low, temperature-independent, switching losses which makes the device more attractive for applications that require higher switching frequencies. The 15 kV 4H-SiC n-IGBT shows a significantly lower forward voltage drop (VF), along with reasonable switching performance, which make it a very attractive device for high voltage applications with lower switching frequency requirements. An electrothermal analysis showed that the 15 kV 4H-SiC n-IGBT outperforms the 15 kV 4H-SiC MOSFET for applications with switching frequencies of less than 5 kHz. It was also shown that the use of a carrier storage layer (CSL) can significantly improve the conduction performance of the 15 kV 4H-SiC n-IGBTs.
- 28 July 2015
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 30 (8) , 084001
Ultra high voltage MOS controlled 4H-SiC power switching devices
Ultra high voltage (UHV, >15 kV) 4H-silicon carbide (SiC) power devices have the potential to significantly improve the system performance, reliability, and cost of energy conversion systems by providing reduced part count, simplified circuit topology, and reduced switching losses. In this paper, we compare the two MOS based UHV 4H-SiC power switching devices; 15 kV 4H-SiC MOSFETs and 15 kV 4H-SiC n-IGBTs. The 15 kV 4H-SiC MOSFET shows a specific on-resistance of 204 mΩ cm2 at 25 °C, which increased to 570 mΩ cm2 at 150 °C. The 15 kV 4H-SiC MOSFET provides low, temperature-independent, switching losses which makes the device more attractive for applications that require higher switching frequencies. The 15 kV 4H-SiC n-IGBT shows a significantly lower forward voltage drop (VF), along with reasonable switching performance, which make it a very attractive device for high voltage applications with lower switching frequency requirements. An electrothermal analysis showed that the 15 kV 4H-SiC n-IGBT outperforms the 15 kV 4H-SiC MOSFET for applications with switching frequencies of less than 5 kHz. It was also shown that the use of a carrier storage layer (CSL) can significantly improve the conduction performance of the 15 kV 4H-SiC n-IGBTs.
- 11 June 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 60 (7) , 2361-2367
Temperature Dependence and Postirradiation Annealing Response of the $1/f$ Noise of 4H-SiC MOSFETsThe temperature dependence of the low-frequency noise of 4H-silicon carbide (SiC) MOSFETs with nitrided oxides is reported over the temperature range 85-510 K. The 1/f noise decreases significantly with increasing measurement temperature. This decrease in noise results primarily from a decrease in the density of interface traps at increasing temperatures. The 1/f noise is also characterized after total ionizing dose irradiation and postirradiation annealing. No significant change in the 1/f noise is observed after the devices are irradiated to 1 Mrad (SiO2) and then annealed under bias at elevated temperature. These results show that the 1/f noise in 4H-SiC MOSFETs is dominated by the interaction of channel carriers with slow interface traps at temperatures <; 360 K and with border traps >360 K. This result contrasts with most experience with Si/SiO2-based MOSFETs, and results from the wider bandgap and greater density of slow interface traps in SiC/SiO2-based MOSFETs than in Si/SiO2-based MOSFETs.
- 11 June 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 60 (7) , 2361-2367
Temperature Dependence and Postirradiation Annealing Response of the $1/f$ Noise of 4H-SiC MOSFETsThe temperature dependence of the low-frequency noise of 4H-silicon carbide (SiC) MOSFETs with nitrided oxides is reported over the temperature range 85-510 K. The 1/f noise decreases significantly with increasing measurement temperature. This decrease in noise results primarily from a decrease in the density of interface traps at increasing temperatures. The 1/f noise is also characterized after total ionizing dose irradiation and postirradiation annealing. No significant change in the 1/f noise is observed after the devices are irradiated to 1 Mrad (SiO2) and then annealed under bias at elevated temperature. These results show that the 1/f noise in 4H-SiC MOSFETs is dominated by the interaction of channel carriers with slow interface traps at temperatures <; 360 K and with border traps >360 K. This result contrasts with most experience with Si/SiO2-based MOSFETs, and results from the wider bandgap and greater density of slow interface traps in SiC/SiO2-based MOSFETs than in Si/SiO2-based MOSFETs.
- 1 January 2009
- Published by Springer Nature in MRS Proceedings
- Vol. 1195
Gate Stack Reliability of High-Mobility 4H SiC Lateral MOSFETs with Deposited Al2O3 Gate Dielectric
- 1 January 2009
- Published by Springer Nature in MRS Proceedings
- Vol. 1195
Gate Stack Reliability of High-Mobility 4H SiC Lateral MOSFETs with Deposited Al2O3 Gate Dielectric
- 1 January 2008
- Published by Springer Nature in MRS Proceedings
- Vol. 1069
Effective Channel Mobility in Epitaxial and Implanted 4H-SiC Lateral MOSFETs
- 1 January 2008
- Published by Springer Nature in MRS Proceedings
- Vol. 1069
Effective Channel Mobility in Epitaxial and Implanted 4H-SiC Lateral MOSFETs
- 1 January 2008
- Published by Springer Nature in MRS Proceedings
- Vol. 1069
Degradation of Majority Carrier Conductions and Blocking Capabilities in 4H-SiC High Voltage Devices due to Basal Plane Dislocations
- 1 January 2008
- Published by Springer Nature in MRS Proceedings
- Vol. 1069
Degradation of Majority Carrier Conductions and Blocking Capabilities in 4H-SiC High Voltage Devices due to Basal Plane Dislocations
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 911
Development of A 4H-SiC CMOS Inverter
In this paper we report the first 4H-SiC CMOS inverter, which was designed to be integrated in the process flow of a 4H-SiC power DMOSFET. The channels of both of the n channel and p-channel MOSFETs of the inverter were 50 um wide by 3 um long. NMOSFET threshold voltage (VTH) ranged from 4.4 V at 25°C to 2.2 V at 250°C and PMOSFET VTH ranged from -4.75 V at 25°C to just under -4 V at 300°C. The transfer threshold voltage (Vm) of the 4H-SiC CMOS inverter was in a very tight range of 2.8 V to 2.9 V over the entire temperature range of 25°C to 300°C when using a drive voltage (VDD) of 10 V.
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 911
Development of A 4H-SiC CMOS Inverter
In this paper we report the first 4H-SiC CMOS inverter, which was designed to be integrated in the process flow of a 4H-SiC power DMOSFET. The channels of both of the n channel and p-channel MOSFETs of the inverter were 50 um wide by 3 um long. NMOSFET threshold voltage (VTH) ranged from 4.4 V at 25°C to 2.2 V at 250°C and PMOSFET VTH ranged from -4.75 V at 25°C to just under -4 V at 300°C. The transfer threshold voltage (Vm) of the 4H-SiC CMOS inverter was in a very tight range of 2.8 V to 2.9 V over the entire temperature range of 25°C to 300°C when using a drive voltage (VDD) of 10 V.
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 911
950V, 8.7mohm-cm2 High Speed 4H-SiC Power DMOSFETs
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 911
950V, 8.7mohm-cm2 High Speed 4H-SiC Power DMOSFETs
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 911
Reliability of High Voltage 4H-SiC MOSFET Devices
The commercialization of 4H-SiC MOSFETs will greatly depend on the reliability of gate oxide. Long-term gate oxide reliability and device stability of 1200 V 4H-SiC MOSFETs are being studied, both under the on- and off-states. Device reliability is studied by stressing the device under three conditions: (a) Gate stress - a constant gate voltage of +15 V is applied to the gate at a temperature of 175°C. The forward I-V characteristics and threshold voltage are monitored for device stability, (b) Forward current stress – devices are stressed under a constant drain current of Id = 4 A and Vg = 20 V. The devices were allowed to self-heat to a temperature of Tsink = 125°C and the I-V curves are monitored with time, and (c) High temperature reverse bias testing at 1200 V and 175°C to study the reliability of the devices in the off-state. Our very first measurements on (a) and (b) show very little variation between the pre-stress and post-stress I-V characteristics and threshold voltage up to 1000 hrs of operation at 175°C indicating excellent stability of the MOSFETs in the on-state. In addition, high temperature reverse bias stress test looks very promising with the devices showing very little variation in the reverse leakage current with time.
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 911
Reliability of High Voltage 4H-SiC MOSFET Devices
The commercialization of 4H-SiC MOSFETs will greatly depend on the reliability of gate oxide. Long-term gate oxide reliability and device stability of 1200 V 4H-SiC MOSFETs are being studied, both under the on- and off-states. Device reliability is studied by stressing the device under three conditions: (a) Gate stress - a constant gate voltage of +15 V is applied to the gate at a temperature of 175°C. The forward I-V characteristics and threshold voltage are monitored for device stability, (b) Forward current stress – devices are stressed under a constant drain current of Id = 4 A and Vg = 20 V. The devices were allowed to self-heat to a temperature of Tsink = 125°C and the I-V curves are monitored with time, and (c) High temperature reverse bias testing at 1200 V and 175°C to study the reliability of the devices in the off-state. Our very first measurements on (a) and (b) show very little variation between the pre-stress and post-stress I-V characteristics and threshold voltage up to 1000 hrs of operation at 175°C indicating excellent stability of the MOSFETs in the on-state. In addition, high temperature reverse bias stress test looks very promising with the devices showing very little variation in the reverse leakage current with time.
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 911
Degradation of Current Gain in SiC BJTs
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 911
Degradation of Current Gain in SiC BJTs
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 911
Fabrication and Characterization of 5 kV IGBTs on 4H-SiC
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 911
Fabrication and Characterization of 5 kV IGBTs on 4H-SiC