Sandro Solmi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Sandro Solmi has a total of 44 co-authors. Here are the top co-authors by number of shared publications:
- Aldo Armigliato
CNR-IMM Institute, Via P.Gobetti, 101 40129 Bologna, Italy
4 shared publications - Antonella Poggi
CNR-IMM
3 shared publications - Dario Narducci
University of Milano Bicocca, Department of Materials Science , via R. Cozzi 55, 20125 Milan
2 shared publications - Dario Nobili
CNR‐IMM Sezione di Bologna, Via Gobetti, 101‐40129 Bologna, Italy
2 shared publications - G. F. Cerofolini
Post-Silicon Technology, STMicroelectronics, Milan, Italy
2 shared publications R. Angelucci
2 shared publications
Latest Publications
- 5 September 2012
- Published by Springer Nature in Journal of Materials Science
- Vol. 48 (7) , 2779-2784
Phonon scattering enhancement in silicon nanolayers
- 5 September 2012
- Published by Springer Nature in Journal of Materials Science
- Vol. 48 (7) , 2779-2784
Phonon scattering enhancement in silicon nanolayers
- 16 February 2011
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 26 (4)
Crossbar architecture for tera-scale integration
- 16 February 2011
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 26 (4)
Crossbar architecture for tera-scale integration
- 1 January 2010
- Published by Springer Nature in MRS Proceedings
- Vol. 1246
Passivation by N Implantation of the SiO2/SiC Acceptor Interface States: Impact on the Oxide Hole Traps and the Gate Oxide Reliability
- 1 January 2010
- Published by Springer Nature in MRS Proceedings
- Vol. 1246
Passivation by N Implantation of the SiO2/SiC Acceptor Interface States: Impact on the Oxide Hole Traps and the Gate Oxide Reliability
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 911
Ion Implanted p+/n 4H-SiC Junctions: effect of the Heating Rate during Post Implantation Annealing
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 911
Ion Implanted p+/n 4H-SiC Junctions: effect of the Heating Rate during Post Implantation Annealing
- 15 October 2003
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 94 (8) , 4950-4955
Transient enhanced diffusion of arsenic in silicon
The transient enhanced diffusion (TED) of As in silicon samples implanted at 35 keV with dose has been investigated in the temperature range between 750 and 1030 °C by comparing experimental and simulated profiles. For temperatures higher than 900 °C the phenomenon is of modest entity and vanishes after a few seconds, whereas at lower temperatures diffusivity enhancements of some order of magnitude have been observed. The anomalous shift of the junction depth, evaluated at is about 12 nm at 900 °C and increases up to 45 nm at 750 °C. It has been verified that the two are the contributions, that generate the interstitial excess responsible for the TED: (i) the implantation damage and (ii) the aggregation in clusters of the As atoms. From an experiment that allows us to separate the two contributions, we estimate that about one third of the TED observed in the first 20 min of annealing at 800 °C is due to the defects produced by clustering. The influence of clustering on the shape of the As profiles after diffusion at different temperatures is also discussed.- 15 October 2003
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 94 (8) , 4950-4955
Transient enhanced diffusion of arsenic in silicon
The transient enhanced diffusion (TED) of As in silicon samples implanted at 35 keV with dose has been investigated in the temperature range between 750 and 1030 °C by comparing experimental and simulated profiles. For temperatures higher than 900 °C the phenomenon is of modest entity and vanishes after a few seconds, whereas at lower temperatures diffusivity enhancements of some order of magnitude have been observed. The anomalous shift of the junction depth, evaluated at is about 12 nm at 900 °C and increases up to 45 nm at 750 °C. It has been verified that the two are the contributions, that generate the interstitial excess responsible for the TED: (i) the implantation damage and (ii) the aggregation in clusters of the As atoms. From an experiment that allows us to separate the two contributions, we estimate that about one third of the TED observed in the first 20 min of annealing at 800 °C is due to the defects produced by clustering. The influence of clustering on the shape of the As profiles after diffusion at different temperatures is also discussed.- 15 January 2000
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 87 (2) , 658-662
Reverse annealing, clustering, and electron mobility in arsenic doped silicon
The reverse annealing phenomena and the nature of the As clusters were studied on silicon on insulator samples uniformly doped with As at concentrations up to 7.6×1020 cm−3. Carrier concentration and electron mobility were determined by Hall and resistivity measurements after annealing at temperatures in the range 550–800 °C. The amplitude of transient reactivation, which can involve up to 20% of the clustered As, depends on dopant concentration and on the annealing temperatures and times. The results of a detailed study of the influence of these parameters are reported. The occurrence of reverse annealing confirms the existence of different types of As clusters, whose distribution and features depend on the experimental conditions. The effect of clustered As on the electron mobility was measured and a quantitative relationship for this phenomenon is reported. The amplitude of this effect is in agreement with the view that at room temperature As clusters are electrically neutral.
- 15 January 2000
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 87 (2) , 658-662
Reverse annealing, clustering, and electron mobility in arsenic doped silicon
The reverse annealing phenomena and the nature of the As clusters were studied on silicon on insulator samples uniformly doped with As at concentrations up to 7.6×1020 cm−3. Carrier concentration and electron mobility were determined by Hall and resistivity measurements after annealing at temperatures in the range 550–800 °C. The amplitude of transient reactivation, which can involve up to 20% of the clustered As, depends on dopant concentration and on the annealing temperatures and times. The results of a detailed study of the influence of these parameters are reported. The occurrence of reverse annealing confirms the existence of different types of As clusters, whose distribution and features depend on the experimental conditions. The effect of clustered As on the electron mobility was measured and a quantitative relationship for this phenomenon is reported. The amplitude of this effect is in agreement with the view that at room temperature As clusters are electrically neutral.
- 15 June 1996
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 79 (12) , 9037-9042
High-temperature annealings of Sb and Sb/B heavily implanted silicon wafers studied by near grazing incidence fluorescence extended x-ray absorption fine structure
The local atomic environment of the Sb dopant in 2 and 5X10(16) ions/cm(2) implanted Si samples has been studied by near grazing incidence fluorescence extended x-ray absorption fine structure at different stages of the Sb deactivation process. The annealings were performed at high temperature (900-1000 degrees C) during various periods: 30 s-4 h. The Sb out-diffusion and the high percentage of Sb precipitates are put into evidence especially for Sb-only implanted samples. The comparison of the Sb and B codiffusion data with the corresponding ones obtained by the diffusion of Sb alone revealed several anomalous effects due to dopant interaction. Moreover, a simulation program including dopant precipitation and donor-acceptor pairing allows us to foresee most of the anomalous phenomena occurring in high-concentration codiffusion experiments. (C) 1996 American Institute of Physics
- 15 June 1996
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 79 (12) , 9037-9042
High-temperature annealings of Sb and Sb/B heavily implanted silicon wafers studied by near grazing incidence fluorescence extended x-ray absorption fine structure
The local atomic environment of the Sb dopant in 2 and 5X10(16) ions/cm(2) implanted Si samples has been studied by near grazing incidence fluorescence extended x-ray absorption fine structure at different stages of the Sb deactivation process. The annealings were performed at high temperature (900-1000 degrees C) during various periods: 30 s-4 h. The Sb out-diffusion and the high percentage of Sb precipitates are put into evidence especially for Sb-only implanted samples. The comparison of the Sb and B codiffusion data with the corresponding ones obtained by the diffusion of Sb alone revealed several anomalous effects due to dopant interaction. Moreover, a simulation program including dopant precipitation and donor-acceptor pairing allows us to foresee most of the anomalous phenomena occurring in high-concentration codiffusion experiments. (C) 1996 American Institute of Physics
- 1 April 1991
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 69 (7) , 3962-3967
Boron ion implantation through Mo and Mo silicide layers for shallow junction formation
Molybdenum silicide is investigated because of its possible application in a self‐aligned process for ultra large scale integration technology. p+/n shallow junctions are fabricated by boron implantation through Mo films or MoSi2 layers and rapid thermal annealing. Both procedures enable us to obtain junctions as shallow as 130 nm with very good electrical characteristics (reverse current density 1 nA/cm2 at −1 V, ideality factor 1.05 and contact resistivity 1×10−6 Ω cm2). The influence of a surface preamorphization with different thicknesses on junction depth and electrical characteristics is reported.
- 1 April 1991
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 69 (7) , 3962-3967
Boron ion implantation through Mo and Mo silicide layers for shallow junction formation
Molybdenum silicide is investigated because of its possible application in a self‐aligned process for ultra large scale integration technology. p+/n shallow junctions are fabricated by boron implantation through Mo films or MoSi2 layers and rapid thermal annealing. Both procedures enable us to obtain junctions as shallow as 130 nm with very good electrical characteristics (reverse current density 1 nA/cm2 at −1 V, ideality factor 1.05 and contact resistivity 1×10−6 Ω cm2). The influence of a surface preamorphization with different thicknesses on junction depth and electrical characteristics is reported.
- 31 October 1989
- Published by Elsevier in Materials Science and Engineering: B
- Vol. 4 (1) , 243-245
Investigation on the electrically inactive antimony at thermal equilibrium in silicon
- 31 October 1989
- Published by Elsevier in Materials Science and Engineering: B
- Vol. 4 (1) , 243-245
Investigation on the electrically inactive antimony at thermal equilibrium in silicon