Krystyna Kazimierowicz-Frankowska
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Krystyna Kazimierowicz-Frankowska has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Gabriele Chiaro
University of Canterbury
1 shared publication - Jarosław Rybak
Department of Civil Engineering, Wroclaw University of Environmental and Life Sciences, 50-375 Wrocław, Poland
1 shared publication - Marek Kulczykowski
Institute of Hydro-Engineering of Polish Academy of Sciences , Gdansk , Poland
1 shared publication - Małgorzata Jastrzębska
Politechnika Slaska
1 shared publication
Latest Publications
- Open Access
- 31 December 2022
- Published by MDPI AG in Applied Sciences
- Vol. 13 (1) , 562
New Frontiers in Sustainable Geotechnics
With increasing ecological awareness, the idea of balanced development has become more popular
- 31 December 2022
- Published by MDPI AG in Applied Sciences
- Vol. 13 (1) , 562
Open AccessNew Frontiers in Sustainable Geotechnics
With increasing ecological awareness, the idea of balanced development has become more popular
- Open Access
- 7 July 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (14) , 6895
Laboratory Testing and Theoretical Modeling of Deformations of Reinforced Soil Wall
This paper presents the results of an experimental investigation of a vertical reinforced soil (RS) wall. The structure was built on a laboratory scale. Horizontal displacements on the surface of the model wall were monitored at the end of construction and during surcharge application (as post-construction displacements). The experimental results were compared with their theoretical predictions. The accuracy of the selected analytical approach was examined to predict deformations of the RS structure under external loading. It was shown that the proposed original and relatively simple analytical method for estimating structural deformation can be successfully used in practice (the average difference between the recorded and calculated values of deformation did not exceed 25%). From a scientific point of view, an important element of this work was the analysis of the effect of friction between the backfill and the side walls of the test box on the measured displacements. For the investigated case, it was shown that the impact of this element caused a reduction in the value of external loading of more than 60%. The final results may be particularly useful in the design process of structures used in transportation engineering (bridge abutments), where deformation limit values cannot be exceeded.
- 7 July 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (14) , 6895
Open AccessLaboratory Testing and Theoretical Modeling of Deformations of Reinforced Soil Wall
This paper presents the results of an experimental investigation of a vertical reinforced soil (RS) wall. The structure was built on a laboratory scale. Horizontal displacements on the surface of the model wall were monitored at the end of construction and during surcharge application (as post-construction displacements). The experimental results were compared with their theoretical predictions. The accuracy of the selected analytical approach was examined to predict deformations of the RS structure under external loading. It was shown that the proposed original and relatively simple analytical method for estimating structural deformation can be successfully used in practice (the average difference between the recorded and calculated values of deformation did not exceed 25%). From a scientific point of view, an important element of this work was the analysis of the effect of friction between the backfill and the side walls of the test box on the measured displacements. For the investigated case, it was shown that the impact of this element caused a reduction in the value of external loading of more than 60%. The final results may be particularly useful in the design process of structures used in transportation engineering (bridge abutments), where deformation limit values cannot be exceeded.
- Open Access
- 1 December 2016
- Published by Walter de Gruyter GmbH in Archives of Hydro-Engineering and Environmental Mechanics
- Vol. 63 (2-3) , 83-100
Influence of Cracks on the Lifetime of Semi-Rigid Pavements
This paper focuses on a better understanding of the process of reflective cracking propagation through the pavement structure. A series of finite element numerical simulations were conducted to investigate the initial stress and strain states in typical semi-rigid pavements with and without reflective cracks under traffic loading. It was assumed that reflective-cracks propagate from the base layer to the pavement surface. The influence of selected parameters, such as the load position, overlay thickness, and subgrade quality on stress and strain concentrations was investigated. The behaviour of the pavement structure under repeated traffic loading was analyzed in terms of ground compaction. The original theoretical model proposed by Prof. Andrzej Sawicki was used to predict the deformation of a pavement subgrade subjected to traffic loading. The damaging effect of cracks appearing in the pavement structure was investigated. It was found that even a single crack in the pavement structure may significantly reduce the pavement lifetime.
- 1 December 2016
- Published by Walter de Gruyter GmbH in Archives of Hydro-Engineering and Environmental Mechanics
- Vol. 63 (2-3) , 83-100
Open AccessInfluence of Cracks on the Lifetime of Semi-Rigid Pavements
This paper focuses on a better understanding of the process of reflective cracking propagation through the pavement structure. A series of finite element numerical simulations were conducted to investigate the initial stress and strain states in typical semi-rigid pavements with and without reflective cracks under traffic loading. It was assumed that reflective-cracks propagate from the base layer to the pavement surface. The influence of selected parameters, such as the load position, overlay thickness, and subgrade quality on stress and strain concentrations was investigated. The behaviour of the pavement structure under repeated traffic loading was analyzed in terms of ground compaction. The original theoretical model proposed by Prof. Andrzej Sawicki was used to predict the deformation of a pavement subgrade subjected to traffic loading. The damaging effect of cracks appearing in the pavement structure was investigated. It was found that even a single crack in the pavement structure may significantly reduce the pavement lifetime.
- 1 November 2008
- Published by American Society of Civil Engineers (ASCE) in Journal of Transportation Engineering
- Vol. 134 (11) , 483-492
Comparison of Stress and Strain States in Pavements with and without Reflective Cracks
Comparison of stresses and strains in pavements with and without reflective cracking is presented. The series of finite-element numerical simulations were carried out for several types of flexible pavements and overlays placed on these pavements. The influence of such parameters as: the load position, the overlay thickness, and subgrade properties on stress and strain concentrations was investigated. Numerical results confirmed the fact that stresses in cracking pavements strongly differ from corresponding values in the uncracked ones. The greatest stress concentration was observed in the zone above the crack. In the case of asymmetrical position of loading with regard to the crack a high level of shear stresses appeared near the crack. The stresses and displacements in the pavement did not differ much for overall effective modulus in the range between 1,000 and . Below this range displacements increased strongly.- 1 November 2008
- Published by American Society of Civil Engineers (ASCE) in Journal of Transportation Engineering
- Vol. 134 (11) , 483-492
Comparison of Stress and Strain States in Pavements with and without Reflective Cracks
Comparison of stresses and strains in pavements with and without reflective cracking is presented. The series of finite-element numerical simulations were carried out for several types of flexible pavements and overlays placed on these pavements. The influence of such parameters as: the load position, the overlay thickness, and subgrade properties on stress and strain concentrations was investigated. Numerical results confirmed the fact that stresses in cracking pavements strongly differ from corresponding values in the uncracked ones. The greatest stress concentration was observed in the zone above the crack. In the case of asymmetrical position of loading with regard to the crack a high level of shear stresses appeared near the crack. The stresses and displacements in the pavement did not differ much for overall effective modulus in the range between 1,000 and . Below this range displacements increased strongly.- 1 September 2005
- Published by Emerald Publishing in Geosynthetics International
- Vol. 12 (5) , 269-275
Correlation between the results of creep and relaxation tests of geotextiles
The time-dependent behaviour of geosynthetics is characterised by creep and relaxation curves. The isochronous curves derived from creep results are sometimes used to predict the relaxation behaviour of geosynthetics. The validity and precision of such an approach are investigated in this paper. Using experimental data from in-isolation creep and relaxation tests performed on selected types of geotextile, the validity and limitations of using creep isochronous curves to predict relaxation response of these materials have been investigated. The conclusions are presented in the paper.
- 1 September 2005
- Published by Emerald Publishing in Geosynthetics International
- Vol. 12 (5) , 269-275
Correlation between the results of creep and relaxation tests of geotextiles
The time-dependent behaviour of geosynthetics is characterised by creep and relaxation curves. The isochronous curves derived from creep results are sometimes used to predict the relaxation behaviour of geosynthetics. The validity and precision of such an approach are investigated in this paper. Using experimental data from in-isolation creep and relaxation tests performed on selected types of geotextile, the validity and limitations of using creep isochronous curves to predict relaxation response of these materials have been investigated. The conclusions are presented in the paper.