Sungmin Yoon
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Sungmin Yoon has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
Umashankar Balunaini
3 shared publicationsBumjoo Kim
2 shared publications- Monica Prezzi
Purdue Univ
2 shared publications - Murad Y. Abu-Farsakh
Louisiana Transportation Research Center, Louisiana State University, Baton Rouge, LA
2 shared publications - Irem Zeynep Yildirim
Boğaziçi University
1 shared publication - Nayyar Z. Siddiki
Research Associate, Louisiana Transportation Research Center, Baton Rouge, LA 70808
1 shared publication
Latest Publications
- 31 December 2009
- Published by Elsevier in Geotextiles and Geomembranes
- Vol. 27 (6) , 516-518
Reply to the discussions by Huang, C.C. on “Analytical modeling of geogrid reinforced soil foundation” [Geotextiles and Geomembranes 27(2), 2009, pp. 63–72]
- 31 December 2009
- Published by Elsevier in Geotextiles and Geomembranes
- Vol. 27 (6) , 516-518
Reply to the discussions by Huang, C.C. on “Analytical modeling of geogrid reinforced soil foundation” [Geotextiles and Geomembranes 27(2), 2009, pp. 63–72]
- 1 June 2009
- Published by American Society of Civil Engineers (ASCE) in Journal of Materials in Civil Engineering
- Vol. 21 (6) , 271-278
Construction of an Embankment with a Fly and Bottom Ash Mixture: Field Performance Study
Fly ash and bottom ash are coal combustion by-products (CCBPs) that are generated in large quantities throughout the world. It is often economical to dispose ash as mixtures rather than separately; that notwithstanding, only a few studies have been performed to investigate the behavior of fly and bottom ash mixtures, particularly those with high contents of fly ash. Also, there is very limited data available in the literature on the field performance of structures constructed using ash mixtures. This paper describes the construction and the instrumentation of a demonstration embankment built with an ash mixture (60:40 by weight of fly ash:bottom ash) on State Road 641, Terre Haute, Ind. Monitoring of the demonstration embankment was conducted for a period of 1 year from the start of construction of the embankment. The settlement of the embankment stabilized approximately 5 months after the end of its construction. According to horizontal inclinometer readings, the differential settlement at the top of the...
- 1 June 2009
- Published by American Society of Civil Engineers (ASCE) in Journal of Materials in Civil Engineering
- Vol. 21 (6) , 271-278
Construction of an Embankment with a Fly and Bottom Ash Mixture: Field Performance Study
Fly ash and bottom ash are coal combustion by-products (CCBPs) that are generated in large quantities throughout the world. It is often economical to dispose ash as mixtures rather than separately; that notwithstanding, only a few studies have been performed to investigate the behavior of fly and bottom ash mixtures, particularly those with high contents of fly ash. Also, there is very limited data available in the literature on the field performance of structures constructed using ash mixtures. This paper describes the construction and the instrumentation of a demonstration embankment built with an ash mixture (60:40 by weight of fly ash:bottom ash) on State Road 641, Terre Haute, Ind. Monitoring of the demonstration embankment was conducted for a period of 1 year from the start of construction of the embankment. The settlement of the embankment stabilized approximately 5 months after the end of its construction. According to horizontal inclinometer readings, the differential settlement at the top of the...
- Open Access
- 1 January 2009
- Published by Elsevier in KSCE Journal of Civil Engineering
- Vol. 13 (1) , 15-22
Laboratory investigation on the strength characteristics of cement-sand as base material
- 1 January 2009
- Published by Elsevier in KSCE Journal of Civil Engineering
- Vol. 13 (1) , 15-22
Open AccessLaboratory investigation on the strength characteristics of cement-sand as base material
- 1 January 2006
- Published by Purdue University Press
Determination of Ash Mixture Properties and Construction of Test Embankment, Part B
- 1 January 2006
- Published by Purdue University Press
Determination of Ash Mixture Properties and Construction of Test Embankment, Part B
- 1 January 2006
- Published by Purdue University Press
Determination of Ash Mixture Properties and Construction of Test Embankment , Part A
Class F fly ash and bottom ash are solid residue byproducts produced by coal-burning plants. They are usually disposed off with a typical disposal rate of 80 % fly ash and 20 % bottom ash. To maximize the use of the coal ash, and thus significantly reduce the disposal problem that electric utility companies and our society in general face, the direct use of ponded or landfilled ash that is composed of high proportions of fly ash would be desirable. However, a general understanding of the behavior of high volume fly ash mixtures is needed. Although there have been investigations into the properties of separated single types of ash, the studies of the fly/bottom ash mixtures, especially with high fly ash contents, are very limited. Representative samples of class F fly ash and bottom ash were collected from two utility plants in Indiana and a series of extensive laboratory tests were conducted to obtain the mechanical properties of the mixture. Since the mechanical properties of ash mixtures are dependent on the mixture proportions, the investigations evaluate fly/bottom ash mixtures with different mixture ratios (with Fly ash contents of 50%, 75%, and 100%). The results obtained are merged with other considerations relevant to embankment design and construction and used to develop guidelines on coal ash utilization in highway embankments. In order to examine suitable fly/bottom ash mixture compositions and embankment geometries, slope stability analyses were performed on ash embankments with different geometries using the different properties of the ash mixtures with different mixture ratios. The limit equilibrium method was used for the stability analyses. Additionally, the corrosion potential to metal structures, which are commonly included in highway construction, is examined by performing corrosivity tests on the ash mixtures.
- 1 January 2006
- Published by Purdue University Press
Determination of Ash Mixture Properties and Construction of Test Embankment , Part A
Class F fly ash and bottom ash are solid residue byproducts produced by coal-burning plants. They are usually disposed off with a typical disposal rate of 80 % fly ash and 20 % bottom ash. To maximize the use of the coal ash, and thus significantly reduce the disposal problem that electric utility companies and our society in general face, the direct use of ponded or landfilled ash that is composed of high proportions of fly ash would be desirable. However, a general understanding of the behavior of high volume fly ash mixtures is needed. Although there have been investigations into the properties of separated single types of ash, the studies of the fly/bottom ash mixtures, especially with high fly ash contents, are very limited. Representative samples of class F fly ash and bottom ash were collected from two utility plants in Indiana and a series of extensive laboratory tests were conducted to obtain the mechanical properties of the mixture. Since the mechanical properties of ash mixtures are dependent on the mixture proportions, the investigations evaluate fly/bottom ash mixtures with different mixture ratios (with Fly ash contents of 50%, 75%, and 100%). The results obtained are merged with other considerations relevant to embankment design and construction and used to develop guidelines on coal ash utilization in highway embankments. In order to examine suitable fly/bottom ash mixture compositions and embankment geometries, slope stability analyses were performed on ash embankments with different geometries using the different properties of the ash mixtures with different mixture ratios. The limit equilibrium method was used for the stability analyses. Additionally, the corrosion potential to metal structures, which are commonly included in highway construction, is examined by performing corrosivity tests on the ash mixtures.
- 1 January 2006
- Published by Purdue University Press
Determination of Ash Mixture Properties and Construction of Test Embankment - Part A
- 1 January 2006
- Published by Purdue University Press
Determination of Ash Mixture Properties and Construction of Test Embankment - Part A