Edouard V. Monakhov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Edouard V. Monakhov has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
- Bengt Gunnar Svensson
Department of Physics/Center for Materials Science and Nanotechnology (SMN), University of Oslo, P.O. Box 1048, Blindern, NO-0316 Oslo, Norway
3 shared publications - Andrej Kuznetsov
Department of Physics and Centre for Materials Science and Nanotechnology, University of Oslo, Oslo, Norway
2 shared publications - Klaus Magnus Johansen
Department of Physics and Centre for Materials Science and Nanotechnology, University of Oslo 1 , Oslo, Norway
2 shared publications - Ørnulf Nordseth
Department of Solar Energy Materials and Technology, Institute for Energy Technology, 2027 Kjeller, Norway
2 shared publications A E Gunnæs
University of Oslo
1 shared publication- Augustinas Galeckas
Department of Physics , Centre for Materials Science and Nanotechnology, University of Oslo , Oslo , Norway
1 shared publication
Latest Publications
- Open Access
Metal Oxide Thin-Film Heterojunctions for Photovoltaic Applications
Silicon-based tandem solar cells incorporating low-cost, abundant, and non-toxic metal oxide materials can increase the conversion efficiency of silicon solar cells beyond their conventional limitations with obvious economic and environmental benefits. In this work, the electrical characteristics of a metal oxide thin-film heterojunction solar cell based on a cuprous oxide (Cu2O) absorber layer were investigated. Highly Al-doped n-type ZnO (AZO) and undoped p-type Cu2O thin films were prepared on quartz substrates by magnetron sputter deposition. The electrical and optical properties of these thin films were determined from Hall effect measurements and spectroscopic ellipsometry. After annealing the Cu2O film at 900 °C, the majority carrier (hole) mobility and the resistivity were measured at 50 cm2/V·s and 200 Ω·cm, respectively. Numerical modeling was carried out to investigate the effect of band alignment and interface defects on the electrical characteristics of the AZO/Cu2O heterojunction. The analysis suggests that the incorporation of a buffer layer can enhance the performance of the heterojunction solar cell as a result of reduced conduction band offset.
Open AccessMetal Oxide Thin-Film Heterojunctions for Photovoltaic Applications
Silicon-based tandem solar cells incorporating low-cost, abundant, and non-toxic metal oxide materials can increase the conversion efficiency of silicon solar cells beyond their conventional limitations with obvious economic and environmental benefits. In this work, the electrical characteristics of a metal oxide thin-film heterojunction solar cell based on a cuprous oxide (Cu2O) absorber layer were investigated. Highly Al-doped n-type ZnO (AZO) and undoped p-type Cu2O thin films were prepared on quartz substrates by magnetron sputter deposition. The electrical and optical properties of these thin films were determined from Hall effect measurements and spectroscopic ellipsometry. After annealing the Cu2O film at 900 °C, the majority carrier (hole) mobility and the resistivity were measured at 50 cm2/V·s and 200 Ω·cm, respectively. Numerical modeling was carried out to investigate the effect of band alignment and interface defects on the electrical characteristics of the AZO/Cu2O heterojunction. The analysis suggests that the incorporation of a buffer layer can enhance the performance of the heterojunction solar cell as a result of reduced conduction band offset.
- 27 June 2017
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 29 (31) , 315701
Electronic properties and morphology of copper oxide/n-type silicon heterostructures
Silicon-based tandem heterojunction solar cells utilizing cuprous oxide (Cu 2 O) as the top absorber layer show promise for high-efficiency conversion and low production cost. In the present study, single phase Cu 2 O films have been realized on n-type Si substrates by reactive magnetron sputtering at 400 °C. The obtained Cu 2 O/Si heterostructures have subsequently been heat treated at temperatures in the 400–700 °C range in Ar flow and extensively characterized by x-ray diffraction (XRD) measurements, transmission electron microscopy (TEM) imaging and electrical techniques. The Cu 2 O/Si heterojunction exhibits a current rectification of ~5 orders of magnitude between forward and reverse bias voltages. High resolution cross-sectional TEM-images show the presence of a ~2 nm thick interfacial SiO 2 layer between Cu 2 O and the Si substrate. Heat treatments below 550 °C result in gradual improvement of crystallinity, indicated by XRD. At and above 550 °C, partial phase transition to cupric oxide (CuO) occurs followed by a complete transition at 700 °C. No increase or decrease of the SiO 2 layer is observed after the heat treatment at 550 °C. Finally, a thin Cu-silicide layer (Cu 3 Si) emerges below the SiO 2 layer upon annealing at 550 °C. This silicide layer influences the lateral current and voltage distributions, as evidenced by an increasing effective area of the heterojunction diodes.
- 27 June 2017
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 29 (31) , 315701
Electronic properties and morphology of copper oxide/n-type silicon heterostructures
Silicon-based tandem heterojunction solar cells utilizing cuprous oxide (Cu 2 O) as the top absorber layer show promise for high-efficiency conversion and low production cost. In the present study, single phase Cu 2 O films have been realized on n-type Si substrates by reactive magnetron sputtering at 400 °C. The obtained Cu 2 O/Si heterostructures have subsequently been heat treated at temperatures in the 400–700 °C range in Ar flow and extensively characterized by x-ray diffraction (XRD) measurements, transmission electron microscopy (TEM) imaging and electrical techniques. The Cu 2 O/Si heterojunction exhibits a current rectification of ~5 orders of magnitude between forward and reverse bias voltages. High resolution cross-sectional TEM-images show the presence of a ~2 nm thick interfacial SiO 2 layer between Cu 2 O and the Si substrate. Heat treatments below 550 °C result in gradual improvement of crystallinity, indicated by XRD. At and above 550 °C, partial phase transition to cupric oxide (CuO) occurs followed by a complete transition at 700 °C. No increase or decrease of the SiO 2 layer is observed after the heat treatment at 550 °C. Finally, a thin Cu-silicide layer (Cu 3 Si) emerges below the SiO 2 layer upon annealing at 550 °C. This silicide layer influences the lateral current and voltage distributions, as evidenced by an increasing effective area of the heterojunction diodes.
- 23 October 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 4 (1) , 374-379
Investigation of Carrier Recombination at the SiO$_{2}$/c-Si Interface by Photoluminescence Imaging Under Applied Bias
A new technique to analyze the surface recombination for passivated silicon substrates has been employed to study the SiO2/c-Si interface under various band bending conditions. A photoluminescence imaging setup was used to measure the effective minority carrier lifetime of oxidized Si wafers while applying an external bias over the rear side passivation layer. This method was used to investigate both the effect of substrate doping polarity and postoxidation forming gas anneal (FGA) upon the surface passivation properties. The measured carrier lifetimes as a function of voltage were interpreted in the framework of the extended Shockley-Read-Hall theory. The calculated oxide charge density was found to decrease from ~7 × 1011 cm -2 to ~4 × 1011 cm-2 after the FGA treatment for both p-type and n-type substrates, causing a reduction in the field effect passivation. On the contrary, an increased chemical passivation was observed after FGA, shown by a reduction of the effective surface recombination velocity parameters by a factor of 3.8-5.5. In total, a significant increase in the effective carrier lifetime was obtained for both substrate types. Furthermore, the carrier capture efficiency at the surface defects was found to be 2-2.5 times higher for electrons than for holes, regardless of doping polarity and FGA.
- 23 October 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 4 (1) , 374-379
Investigation of Carrier Recombination at the SiO$_{2}$/c-Si Interface by Photoluminescence Imaging Under Applied Bias
A new technique to analyze the surface recombination for passivated silicon substrates has been employed to study the SiO2/c-Si interface under various band bending conditions. A photoluminescence imaging setup was used to measure the effective minority carrier lifetime of oxidized Si wafers while applying an external bias over the rear side passivation layer. This method was used to investigate both the effect of substrate doping polarity and postoxidation forming gas anneal (FGA) upon the surface passivation properties. The measured carrier lifetimes as a function of voltage were interpreted in the framework of the extended Shockley-Read-Hall theory. The calculated oxide charge density was found to decrease from ~7 × 1011 cm -2 to ~4 × 1011 cm-2 after the FGA treatment for both p-type and n-type substrates, causing a reduction in the field effect passivation. On the contrary, an increased chemical passivation was observed after FGA, shown by a reduction of the effective surface recombination velocity parameters by a factor of 3.8-5.5. In total, a significant increase in the effective carrier lifetime was obtained for both substrate types. Furthermore, the carrier capture efficiency at the surface defects was found to be 2-2.5 times higher for electrons than for holes, regardless of doping polarity and FGA.
- 14 May 2012
- Published by Wiley in physica status solidi (c)
- Vol. 9 (7) , 1590-1592
Optical and electrical properties of reactively sputtered Ag2Cu2O3 films
- 14 May 2012
- Published by Wiley in physica status solidi (c)
- Vol. 9 (7) , 1590-1592
Optical and electrical properties of reactively sputtered Ag2Cu2O3 films
- 1 January 2007
- Published by Springer Nature in MRS Proceedings
- Vol. 1035
Hydrothermally Grown Single-Crystalline Zinc Oxide; Characterization and Modification
- 1 January 2007
- Published by Springer Nature in MRS Proceedings
- Vol. 1035
Hydrothermally Grown Single-Crystalline Zinc Oxide; Characterization and Modification
- 1 January 2007
- Published by Springer Nature in MRS Proceedings
- Vol. 1035
Hydrogen Migration in Single Crystalline ZnO
- 1 January 2007
- Published by Springer Nature in MRS Proceedings
- Vol. 1035
Hydrogen Migration in Single Crystalline ZnO