M. Cynthia Goh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
M. Cynthia Goh has a total of 43 co-authors. Here are the top co-authors by number of shared publications:
- Amr Helmy
University of Toronto
3 shared publications Bernie D. Sattin
Department of Chemistry, University of Toronto, Toronto, ON M5S 3H6, Canada
3 shared publicationsCalvin C.H. Cheng
University of Toronto, 80 St. George Street, Toronto, ON M5S 3H6, Canada
2 shared publications- Cheng Lu
Department of Chemistry, University of Toronto, Toronto, Canada
2 shared publications Emanuel Istrate
Univ. of Toronto (Canada)
2 shared publicationsJohn E. Sipe
Univ. of Toronto (Canada)
2 shared publications
Latest Publications
- Open Access
- 1 September 2019
- Published by Elsevier in Journal of Photochemistry and Photobiology A: Chemistry
- Vol. 382
1H NMR as a quick screen for photocatalytic reaction efficiency
- 1 September 2019
- Published by Elsevier in Journal of Photochemistry and Photobiology A: Chemistry
- Vol. 382
Open Access1H NMR as a quick screen for photocatalytic reaction efficiency
- Open Access
- 8 January 2019
- Published by Springer Nature in Discover Nano
- Vol. 14 (1) , 11
Ultra-stable Electrochemical Sensor for Detection of Caffeic Acid Based on Platinum and Nickel Jagged-Like Nanowires
Electrochemical sensors have the high sensitivity, fast response, and simple operation for applications in biological, medical, and chemical detection, but limited by the poor stability and high cost of the electrode materials. In this work, we used PtNi lagged-like nanowire for caffeic acid (CA) electrochemical detection. The removal of outer layer Ni during reaction process contributed to the rehabilitation of active Pt sites at the surface, leading to the excellent electrocatalytic behavior of CA sensing. Carbon-supported PtNi-modified glassy carbon electrode (PtNi/C electrode) showed a broad CA detecting range (from 0.75 to 591.783 μM), a low detection limit (0.5 μM), and excellent stability. The electrode preserved high electrocatalytic performance with 86.98% of the initial oxidation peak current retained after 4000 potential cycles in 0.5 mM caffeic acid solution. It also demonstrates excellent anti-interference capability and is ready for use in the real sample analysis.
- 8 January 2019
- Published by Springer Nature in Discover Nano
- Vol. 14 (1) , 11
Open AccessUltra-stable Electrochemical Sensor for Detection of Caffeic Acid Based on Platinum and Nickel Jagged-Like Nanowires
Electrochemical sensors have the high sensitivity, fast response, and simple operation for applications in biological, medical, and chemical detection, but limited by the poor stability and high cost of the electrode materials. In this work, we used PtNi lagged-like nanowire for caffeic acid (CA) electrochemical detection. The removal of outer layer Ni during reaction process contributed to the rehabilitation of active Pt sites at the surface, leading to the excellent electrocatalytic behavior of CA sensing. Carbon-supported PtNi-modified glassy carbon electrode (PtNi/C electrode) showed a broad CA detecting range (from 0.75 to 591.783 μM), a low detection limit (0.5 μM), and excellent stability. The electrode preserved high electrocatalytic performance with 86.98% of the initial oxidation peak current retained after 4000 potential cycles in 0.5 mM caffeic acid solution. It also demonstrates excellent anti-interference capability and is ready for use in the real sample analysis.
- 1 January 2018
- Published by Canadian Science Publishing in Canadian Journal of Chemistry
- Vol. 96 (1) , 44-50
Universal aqueous synthesis of ultra-small polymer-templated nanoparticles: synthesis optimization methodology for counterion-collapsed poly(acrylic acid)
A long polyelectrolyte chain collapses into a nano-sized particle upon the addition of counterions under appropriate solution conditions. This phenomenon forms the basis for a simple universal method for aqueous synthesis of ultra-small (<10 nm) metal, metal oxide, and other types of nanoparticles in the following manner: the counterion-collapsed polyelectrolyte chains are made stable by crosslinking, effectively trapping the counterions, which are subsequently chemically modified, to form metal nanoparticles via reduction or metal oxides nanoparticles via oxidation, within the collapsed polymer nanoparticle. This highly versatile platform methodology can be applied to almost any polyelectrolyte–counterion pair, making possible the rapid development of syntheses of different nanoparticles within the same chemical environment. Using poly(acrylic acid) as a model system, a methodology for the optimization of conditions for the polyelectrolyte collapse by various mono- and multi-valent metal cations is developed. The optimal counterion concentration did not correlate with ionic strength and metal ion valency and was highly variable from system to system. By monitoring the polyelectrolyte conformation using viscosity and turbidity measurements, the appropriate metal ion concentration for each nanoparticle system was determined.
- 1 January 2018
- Published by Canadian Science Publishing in Canadian Journal of Chemistry
- Vol. 96 (1) , 44-50
Universal aqueous synthesis of ultra-small polymer-templated nanoparticles: synthesis optimization methodology for counterion-collapsed poly(acrylic acid)
A long polyelectrolyte chain collapses into a nano-sized particle upon the addition of counterions under appropriate solution conditions. This phenomenon forms the basis for a simple universal method for aqueous synthesis of ultra-small (<10 nm) metal, metal oxide, and other types of nanoparticles in the following manner: the counterion-collapsed polyelectrolyte chains are made stable by crosslinking, effectively trapping the counterions, which are subsequently chemically modified, to form metal nanoparticles via reduction or metal oxides nanoparticles via oxidation, within the collapsed polymer nanoparticle. This highly versatile platform methodology can be applied to almost any polyelectrolyte–counterion pair, making possible the rapid development of syntheses of different nanoparticles within the same chemical environment. Using poly(acrylic acid) as a model system, a methodology for the optimization of conditions for the polyelectrolyte collapse by various mono- and multi-valent metal cations is developed. The optimal counterion concentration did not correlate with ionic strength and metal ion valency and was highly variable from system to system. By monitoring the polyelectrolyte conformation using viscosity and turbidity measurements, the appropriate metal ion concentration for each nanoparticle system was determined.
- 1 August 2016
- Published by Elsevier in Dental Materials
- Vol. 32 (8) , 968-977
Characterizing the collagen stabilizing effect of crosslinked chitosan nanoparticles against collagenase degradation
- 1 August 2016
- Published by Elsevier in Dental Materials
- Vol. 32 (8) , 968-977
Characterizing the collagen stabilizing effect of crosslinked chitosan nanoparticles against collagenase degradation
- 17 November 2015
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 3 (12) , 3123-3129
New Method to Synthesize S-Doped TiO2 with Stable and Highly Efficient Photocatalytic Performance under Indoor Sunlight Irradiation
- 17 November 2015
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 3 (12) , 3123-3129
New Method to Synthesize S-Doped TiO2 with Stable and Highly Efficient Photocatalytic Performance under Indoor Sunlight Irradiation
- 3 August 2015
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9665, 96651
University of Toronto Institute for Optical Sciences collaborative program in optics
We describe the activities of the Institute for Optical Sciences (IOS) at the University of Toronto towards the establishment of a Master’s Program in Optics. The IOS was formed as a collaboration between faculty members interested in optics from the four departments of Physics, Chemistry, Electrical and Computer Engineering and Materials Science and Engineering. One of its goals is to serve as unifying entity for graduate and undergraduate programs in optical sciences. The details of the proposed graduate program will be discussed. It will be set up in the form of a collaborative university program, where students must satisfy the requirements of one of the four home departments, as well as a set of IOS-specific requirements of the program. IOS-specific activities include attending the Distinguished Visiting Scientist Series, participation in a best-research-practice mini-course, where essential research skills are discussed, as well as participation in an annual internal conference. The benefits of this interdisciplinary program, for students, faculty and relevant industries are discussed. The students will benefit from a wider exposure and a more coherent curriculum. The IOS will also serve as local community within the campus to which students could belong and network. Faculty, on the other hand, will benefit from a reduced teaching load, as redundancies among the departments will be removed. © (2015) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
- 3 August 2015
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9665, 96651
University of Toronto Institute for Optical Sciences collaborative program in optics
We describe the activities of the Institute for Optical Sciences (IOS) at the University of Toronto towards the establishment of a Master’s Program in Optics. The IOS was formed as a collaboration between faculty members interested in optics from the four departments of Physics, Chemistry, Electrical and Computer Engineering and Materials Science and Engineering. One of its goals is to serve as unifying entity for graduate and undergraduate programs in optical sciences. The details of the proposed graduate program will be discussed. It will be set up in the form of a collaborative university program, where students must satisfy the requirements of one of the four home departments, as well as a set of IOS-specific requirements of the program. IOS-specific activities include attending the Distinguished Visiting Scientist Series, participation in a best-research-practice mini-course, where essential research skills are discussed, as well as participation in an annual internal conference. The benefits of this interdisciplinary program, for students, faculty and relevant industries are discussed. The students will benefit from a wider exposure and a more coherent curriculum. The IOS will also serve as local community within the campus to which students could belong and network. Faculty, on the other hand, will benefit from a reduced teaching load, as redundancies among the departments will be removed. © (2015) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
- Open Access
- 20 September 2012
- Published by MyJove Corporation in Journal of Visualized Experiments
- No. 67,p. e4417
In vitro Synthesis of Native, Fibrous Long Spacing and Segmental Long Spacing Collagen
Collagen fibrils are present in the extracellular matrix of animal tissue to provide structural scaffolding and mechanical strength. These native collagen fibrils have a characteristic banding periodicity of ~67 nm and are formed in vivo through the hierarchical assembly of Type I collagen monomers, which are 300 nm in length and 1.4 nm in diameter. In vitro, by varying the conditions to which the monomer building blocks are exposed, unique structures ranging in length scales up to 50 microns can be constructed, including not only native type fibrils, but also fibrous long spacing and segmental long spacing collagen. Herein, we present procedures for forming the three different collagen structures from a common commercially available collagen monomer. Using the protocols that we and others have published in the past to make these three types typically lead to mixtures of structures. In particular, unbanded fibrils were commonly found when making native collagen, and native fibrils were often present when making fibrous long spacing collagen. These new procedures have the advantage of producing the desired collagen fibril type almost exclusively. The formation of the desired structures is verified by imaging using an atomic force microscope.
- 20 September 2012
- Published by MyJove Corporation in Journal of Visualized Experiments
- No. 67,p. e4417
Open AccessIn vitro Synthesis of Native, Fibrous Long Spacing and Segmental Long Spacing Collagen
Collagen fibrils are present in the extracellular matrix of animal tissue to provide structural scaffolding and mechanical strength. These native collagen fibrils have a characteristic banding periodicity of ~67 nm and are formed in vivo through the hierarchical assembly of Type I collagen monomers, which are 300 nm in length and 1.4 nm in diameter. In vitro, by varying the conditions to which the monomer building blocks are exposed, unique structures ranging in length scales up to 50 microns can be constructed, including not only native type fibrils, but also fibrous long spacing and segmental long spacing collagen. Herein, we present procedures for forming the three different collagen structures from a common commercially available collagen monomer. Using the protocols that we and others have published in the past to make these three types typically lead to mixtures of structures. In particular, unbanded fibrils were commonly found when making native collagen, and native fibrils were often present when making fibrous long spacing collagen. These new procedures have the advantage of producing the desired collagen fibril type almost exclusively. The formation of the desired structures is verified by imaging using an atomic force microscope.
- 18 September 2009
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 113 (42) , 18020-18026
Polyelectrolyte Multilayer Films as Templates for the In Situ Photochemical Synthesis of Silver Nanoparticles
- 18 September 2009
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 113 (42) , 18020-18026
Polyelectrolyte Multilayer Films as Templates for the In Situ Photochemical Synthesis of Silver Nanoparticles
- 1 January 2009
- Published by Springer Nature in MRS Proceedings
- Vol. 1207
Post-Synthesis Crystallinity Tailoring of Water-Soluble Polymer Encapsulated CdTe Nanoparticles using Rapid Thermal Annealing
- 1 January 2009
- Published by Springer Nature in MRS Proceedings
- Vol. 1207
Post-Synthesis Crystallinity Tailoring of Water-Soluble Polymer Encapsulated CdTe Nanoparticles using Rapid Thermal Annealing