Mohd Harun Abdullah
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Mohd Harun Abdullah has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Baba Musta
Faculty of Science and Technology (FST) Universiti Malaysia Sabah Kota Kinabalu 88400 Sabah Malaysia
3 shared publications - Sazmal Effendi Arshad
Faculty of Science and Natural Resources, Universiti Malaysia Sabah
2 shared publications - A. Ahmed
School of Science and Technology, University of Malaysia Sabah, Kota Kinabalu, Malaysia
1 shared publication - Ahmad Zaharin Aris
International Institute of Aquaculture and Aquatic Sciences, Universiti Putra Malaysia, Port Dickson, Malaysia
1 shared publication - Chin Yik Lin
Department of Geology, Faculty of Science, University of Malaya, 50603 Kuala Lumpur, Malaysia
1 shared publication - Collin Glenn Joseph
Sonophotochemistry Research Group, Faculty of Science and Technology, Universiti Malaysia Sabah, Kota Kinabalu 88400, Sabah, Malaysia
1 shared publication
Latest Publications
- Open Access
- 31 December 2024
- Published by Univ. of Malaya in Malaysian Journal of Science
- Vol. 43 (4) , 31-37
A Spatial Tropical Island Database of Northern Borneo, Malaysia using Google Earth
The state of Sabah in Northern Borneo, Malaysia is surrounded by numerous small tropical islands. However, the recent surge in tourist activities has significantly impacted the biological diversity and natural resources of these islands. This study aims to develop a systematic database for the region prioritize and preserved the conservation and integrity of these tropical islands. The database was compiled using topographic maps and Google Earth data. Variables such as island size, distance, distribution, and isolation from the Sabah coastline were analysed through maps and scatter plots generated in a GIS environment. The significance of the islands was evaluated across various aspects based on the compiled data. The database identifies a total of 510 islands along Sabah’s coastline with 82 located on the west coast and the remaining 428 on the east coast. Approximately 80% of these islands are small with an area of less than 1 km2. Only five islands exceed 100 km2, while smaller islands are predominantly located closer to the coast. The finding indicate that the significance of the islands varies based on factors such as tourist attractions, flora and fauna, marine ecosystems, and national security. The methodology adopted in this study is robust and offers potential for examining island distribution in other regions.
- 31 December 2024
- Published by Univ. of Malaya in Malaysian Journal of Science
- Vol. 43 (4) , 31-37
Open AccessA Spatial Tropical Island Database of Northern Borneo, Malaysia using Google Earth
The state of Sabah in Northern Borneo, Malaysia is surrounded by numerous small tropical islands. However, the recent surge in tourist activities has significantly impacted the biological diversity and natural resources of these islands. This study aims to develop a systematic database for the region prioritize and preserved the conservation and integrity of these tropical islands. The database was compiled using topographic maps and Google Earth data. Variables such as island size, distance, distribution, and isolation from the Sabah coastline were analysed through maps and scatter plots generated in a GIS environment. The significance of the islands was evaluated across various aspects based on the compiled data. The database identifies a total of 510 islands along Sabah’s coastline with 82 located on the west coast and the remaining 428 on the east coast. Approximately 80% of these islands are small with an area of less than 1 km2. Only five islands exceed 100 km2, while smaller islands are predominantly located closer to the coast. The finding indicate that the significance of the islands varies based on factors such as tourist attractions, flora and fauna, marine ecosystems, and national security. The methodology adopted in this study is robust and offers potential for examining island distribution in other regions.
- 1 January 2023
- Published by China Geology in China Geology
- Vol. 6 (4) , 580-593
ASSESSMENT OF SEDIMENT QUALITY DUE TO HEAVY METAL CONTAMINATION IN MARINE SEDIMENTS ALONG THE NORTHWEST COAST OF SABAH, MALAYSIA
Heavy metal contents along the Northwest coast of Sabah were determined to interpret the contamination level in the marine sediment. The metal abundance is regulated by the physico-chemical properties such as the average sediment pH (7.82, 9.00 and 8.99), organic matter (0.62%, 1.60%, and 2.27%), moisture content (25.00%, 29.70%, and 15.00%) and sandy texture in Kota Belud, Kudat and Mantanani Island, respectively. The major elements show Ca>Fe>Mg>Al>Mn for all study sites, while the heavy metals show Ni>Cr>Zn>Cu>Co>Pb, Cr>Ni>Zn>Cu>Pb>Co and Zn>Pb>Cr>Ni, for Kota Belud, Kudat and Mantanani Island, respectively. The contamination degree of heavy metals was evaluated using the Sediment Quality Assessment (SQA). The SQA parameters indicated none to moderate contamination in Kota Belud that shows Class 0, Class 1 and Class 2 contamination. The parameters also indicated none to low contamination in Kudat and Mantanani Island that show only Class 0 contamination. The enrichment factor (EF) suggested minor to moderately severe metal enrichment by anthropogenic sources in Kota Belud, whereas only minor enrichment in Kudat and Mantanani Island. The modified contamination degree (mCd<1.5) and pollution load index (0≤PLI<1) indicating only low pollution level in the marine sediments for all study sites. The objectives of this study are to determine the physico-chemical parameters of sediments, estimate the heavy metal contents and evaluate the sediment quality.
- 1 January 2023
- Published by China Geology in China Geology
- Vol. 6 (4) , 580-593
ASSESSMENT OF SEDIMENT QUALITY DUE TO HEAVY METAL CONTAMINATION IN MARINE SEDIMENTS ALONG THE NORTHWEST COAST OF SABAH, MALAYSIA
Heavy metal contents along the Northwest coast of Sabah were determined to interpret the contamination level in the marine sediment. The metal abundance is regulated by the physico-chemical properties such as the average sediment pH (7.82, 9.00 and 8.99), organic matter (0.62%, 1.60%, and 2.27%), moisture content (25.00%, 29.70%, and 15.00%) and sandy texture in Kota Belud, Kudat and Mantanani Island, respectively. The major elements show Ca>Fe>Mg>Al>Mn for all study sites, while the heavy metals show Ni>Cr>Zn>Cu>Co>Pb, Cr>Ni>Zn>Cu>Pb>Co and Zn>Pb>Cr>Ni, for Kota Belud, Kudat and Mantanani Island, respectively. The contamination degree of heavy metals was evaluated using the Sediment Quality Assessment (SQA). The SQA parameters indicated none to moderate contamination in Kota Belud that shows Class 0, Class 1 and Class 2 contamination. The parameters also indicated none to low contamination in Kudat and Mantanani Island that show only Class 0 contamination. The enrichment factor (EF) suggested minor to moderately severe metal enrichment by anthropogenic sources in Kota Belud, whereas only minor enrichment in Kudat and Mantanani Island. The modified contamination degree (mCd<1.5) and pollution load index (0≤PLI<1) indicating only low pollution level in the marine sediments for all study sites. The objectives of this study are to determine the physico-chemical parameters of sediments, estimate the heavy metal contents and evaluate the sediment quality.
- Open Access
Waste Fiber-Based Poly(hydroxamic acid) Ligand for Toxic Metals Removal from Industrial Wastewater
Toxic metals in the industrial wastewaters have been liable for drastic pollution hence a powerful and economical treatment technology is needed for water purification. For this reason, some pure cellulosic materials were derived from waste fiber to obtain an economical adsorbent for wastewater treatment. Conversion of cellulose into grafting materials such as poly(methyl acrylate)-grafted cellulose was performed by free radical grafting process. Consequently, poly(hydroxamic acid) ligand was produced from the grafted cellulose. The intermediate products and poly(hydroxamic acid) ligand were analyzed by FT-IR, FE-SEM, TEM, EDX, and XPS spectroscopy. The adsorption capacity (qe) of some toxic metals ions by the polymer ligand was found to be excellent, e.g., copper capacity (qe) was 346.7 mg·g−1 at pH 6. On the other hand, several metal ions such as cobalt chromium and nickel also demonstrated noteworthy sorption capacity at pH 6. The adsorption mechanism obeyed the pseudo second-order rate kinetic model due to the satisfactory correlated experimental sorption values (qe). Langmuir model isotherm study showed the significant correlation coefficient with all metal ions (R2 > 0.99), indicating that the single or monolayer adsorption was the dominant mode on the surface of the adsorbent. This polymer ligand showed good properties on reusability. The result shows that the adsorbent may be recycled for 6 cycles without any dropping of starting sorption capabilities. This polymeric ligand showed outstanding toxic metals removal magnitude, up to 90–99% of toxic metal ions can be removed from industrial wastewater.
Open AccessWaste Fiber-Based Poly(hydroxamic acid) Ligand for Toxic Metals Removal from Industrial Wastewater
Toxic metals in the industrial wastewaters have been liable for drastic pollution hence a powerful and economical treatment technology is needed for water purification. For this reason, some pure cellulosic materials were derived from waste fiber to obtain an economical adsorbent for wastewater treatment. Conversion of cellulose into grafting materials such as poly(methyl acrylate)-grafted cellulose was performed by free radical grafting process. Consequently, poly(hydroxamic acid) ligand was produced from the grafted cellulose. The intermediate products and poly(hydroxamic acid) ligand were analyzed by FT-IR, FE-SEM, TEM, EDX, and XPS spectroscopy. The adsorption capacity (qe) of some toxic metals ions by the polymer ligand was found to be excellent, e.g., copper capacity (qe) was 346.7 mg·g−1 at pH 6. On the other hand, several metal ions such as cobalt chromium and nickel also demonstrated noteworthy sorption capacity at pH 6. The adsorption mechanism obeyed the pseudo second-order rate kinetic model due to the satisfactory correlated experimental sorption values (qe). Langmuir model isotherm study showed the significant correlation coefficient with all metal ions (R2 > 0.99), indicating that the single or monolayer adsorption was the dominant mode on the surface of the adsorbent. This polymer ligand showed good properties on reusability. The result shows that the adsorbent may be recycled for 6 cycles without any dropping of starting sorption capabilities. This polymeric ligand showed outstanding toxic metals removal magnitude, up to 90–99% of toxic metal ions can be removed from industrial wastewater.
- 1 January 2009
- Published by Springer Nature in MRS Proceedings
- Vol. 1219
Heavy Metal Removal from Electroplating Wastewater Using Acacia Cellulose Based Polymeric Chelating Ligand
- 1 January 2009
- Published by Springer Nature in MRS Proceedings
- Vol. 1219
Heavy Metal Removal from Electroplating Wastewater Using Acacia Cellulose Based Polymeric Chelating Ligand
- 1 September 2007
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 4 (4) , 441-450
Controlling factors of groundwater hydrochemistry in a small island’s aquifer
- 1 September 2007
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 4 (4) , 441-450
Controlling factors of groundwater hydrochemistry in a small island’s aquifer