O. Schmidt
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
O. Schmidt has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
A. Kliner
Friedrich-Schiller-University of Jena, Institute of Applied Physics, Albert-Einstein-Str. 15, 07745 Jena, Germany
3 shared publicationsA. Tünnermann
Fraunhofer Institute for Applied Optics and Precision Engineering, Albert-Einstein-Str. 7, 07745 Jena, Germany
3 shared publicationsC. Wirth
Fraunhofer Institute for Applied Optics and Precision Engineering, Albert-Einstein-Str. 7, 07745 Jena, Germany
3 shared publicationsM. Rekas
Fraunhofer Institute for Applied Optics and Precision Engineering, Albert-Einstein-Str. 7, 07745 Jena, Germany
3 shared publicationsR. Eberhardt
Fraunhofer Institute for Applied Optics and Precision Engineering, Albert-Einstein-Str. 7, 07745 Jena, Germany
3 shared publicationsS. Rhein
Friedrich-Schiller-University of Jena, Institute of Applied Physics, Albert-Einstein-Str. 15, 07745 Jena, Germany
3 shared publications
Latest Publications
- 22 February 2011
- Published by Optica Publishing Group in Optics Express
- Vol. 19 (5) , 4421-4427
High power narrow-band fiber-based ASE source
In this paper we describe a high power narrow-band amplified spontaneous emission (ASE) light source at 1030 nm center wavelength generated in an Yb-doped fiber-based experimental setup. By cutting a small region out of a broadband ASE spectrum using two fiber Bragg gratings a strongly constrained bandwidth of 12 ± 2 pm (3.5 ± 0.6 GHz) is formed. A two-stage high power fiber amplifier system is used to boost the output power up to 697 W with a measured beam quality of M2≤1.34. In an additional experiment we demonstrate a stimulated Brillouin scattering (SBS) suppression of at least 17 dB (theoretically predicted ~20 dB), which is only limited by the dynamic range of the measurement and not by the onset of SBS when using the described light source. The presented narrow-band ASE source could be of great interest for brightness scaling applications by beam combination, where SBS is known as a limiting factor.
- 22 February 2011
- Published by Optica Publishing Group in Optics Express
- Vol. 19 (5) , 4421-4427
High power narrow-band fiber-based ASE source
In this paper we describe a high power narrow-band amplified spontaneous emission (ASE) light source at 1030 nm center wavelength generated in an Yb-doped fiber-based experimental setup. By cutting a small region out of a broadband ASE spectrum using two fiber Bragg gratings a strongly constrained bandwidth of 12 ± 2 pm (3.5 ± 0.6 GHz) is formed. A two-stage high power fiber amplifier system is used to boost the output power up to 697 W with a measured beam quality of M2≤1.34. In an additional experiment we demonstrate a stimulated Brillouin scattering (SBS) suppression of at least 17 dB (theoretically predicted ~20 dB), which is only limited by the dynamic range of the measurement and not by the onset of SBS when using the described light source. The presented narrow-band ASE source could be of great interest for brightness scaling applications by beam combination, where SBS is known as a limiting factor.
- 1 January 2011
- Published by Optica Publishing Group
- p. AMF3
High power narrow-band ASE as source for beam combining applications
We report on a 12 pm narrow-band ASE source with 697 W of continuous-wave output power and a beam quality of M2=1.3. Such an emission is ideal for spectral beam combining setups where SBS is known as one of the primary limiting nonlinear effects.
- 1 January 2011
- Published by Optica Publishing Group
- p. AMF3
High power narrow-band ASE as source for beam combining applications
We report on a 12 pm narrow-band ASE source with 697 W of continuous-wave output power and a beam quality of M2=1.3. Such an emission is ideal for spectral beam combining setups where SBS is known as one of the primary limiting nonlinear effects.
- 1 January 2011
- Published by Optica Publishing Group
- p. FTuW3
Relative intensity noise characterization of a linear polarized 1.1 kW fiber-amplified narrow-band ASE source
We present the characterization of narrow-linewidth ASE source, which has been amplified to 1.1 kW using a RMO-fiber design. SBS is known as the main limiting effect for fiber amplified single-frequency and narrow-band signals, respectively.
- 1 January 2011
- Published by Optica Publishing Group
- p. FTuW3
Relative intensity noise characterization of a linear polarized 1.1 kW fiber-amplified narrow-band ASE source
We present the characterization of narrow-linewidth ASE source, which has been amplified to 1.1 kW using a RMO-fiber design. SBS is known as the main limiting effect for fiber amplified single-frequency and narrow-band signals, respectively.