Caspar Leendertz
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Caspar Leendertz has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Lars Korte
Helmholtz-Zentrum Berlin für Materialien und Energie GmbH, Division Solar Energy, Kekuléstraße 5, 12489 Berlin, Germany
4 shared publications - Bernd Rech
Helmholtz‐Zentrum Berlin für Materialien und Energie GmbH Scientific Management Hahn‐Meitner‐Platz 1 14109 Berlin Germany
3 shared publications T. F. Schulze
Helmholtz-Zentrum Berlin für Materialien und Energie GmbH 1 , Lise-Meitner-Campus, Hahn-Meitner-Platz 1, 14109 Berlin, Germany
2 shared publicationsA.-M. Teodoreanu
Department Silicon Photovoltaics 1 , Helmholtz-Zentrum Berlin für Materialien und Energie, Kekuléstraße 5, Berlin D-12489, Germany
1 shared publication- Anja Dobrich
Helmholtz-Zentrum Berlin, Materials for Photovoltaics, Berlin, Germany
1 shared publication - Hannes Ner Beushausen
Helmholtz-Zentrum Berlin, Institute for Silicon Photovoltaics, Berlin, Berlin, Germany
1 shared publication
Latest Publications
- 24 January 2013
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 113 (4) , 044510
The influence of space charge regions on effective charge carrier lifetime in thin films and resulting opportunities for materials characterization
The analysis of injection-dependent charge carrier lifetimes is a well-established method to determine material and interface quality in crystalline silicon wafer-based device structures such as solar cells. However, for thin films, this method has rarely been used. One reason is that the physical interpretation of experimental data must rely on advanced theoretical models. In this study, we show by numerical simulations and analytical approximations that the effective charge carrier lifetime in thin films is heavily affected by space charge regions (SCR) over a wide range of injection levels. By analysis of the characteristic features in the injection-dependent effective charge carrier lifetime curves, qualitative information about SCRs that occur at grain boundaries or interfaces can be obtained. In contrast, information about the defect density can only be extracted in a very limited range of injection levels and the relationship between effective charge carrier lifetime and the quasi-Fermi level splitting, which is limiting the open circuit voltage of wafer-based solar cells, is not valid in thin films. On the basis of this theoretical study, we analyze measurements of effective charge carrier lifetime in thin and fine-grained polycrystalline silicon films with lifetimes of up to and find experimental evidence for grain boundary potential barriers. Finally, we present guidelines for optimized photoconductance measurements and the evaluation of charge carrier lifetimes in thin films, in general.- 24 January 2013
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 113 (4) , 044510
The influence of space charge regions on effective charge carrier lifetime in thin films and resulting opportunities for materials characterization
The analysis of injection-dependent charge carrier lifetimes is a well-established method to determine material and interface quality in crystalline silicon wafer-based device structures such as solar cells. However, for thin films, this method has rarely been used. One reason is that the physical interpretation of experimental data must rely on advanced theoretical models. In this study, we show by numerical simulations and analytical approximations that the effective charge carrier lifetime in thin films is heavily affected by space charge regions (SCR) over a wide range of injection levels. By analysis of the characteristic features in the injection-dependent effective charge carrier lifetime curves, qualitative information about SCRs that occur at grain boundaries or interfaces can be obtained. In contrast, information about the defect density can only be extracted in a very limited range of injection levels and the relationship between effective charge carrier lifetime and the quasi-Fermi level splitting, which is limiting the open circuit voltage of wafer-based solar cells, is not valid in thin films. On the basis of this theoretical study, we analyze measurements of effective charge carrier lifetime in thin and fine-grained polycrystalline silicon films with lifetimes of up to and find experimental evidence for grain boundary potential barriers. Finally, we present guidelines for optimized photoconductance measurements and the evaluation of charge carrier lifetimes in thin films, in general.- 16 May 2011
- Published by AIP Publishing in Applied Physics Letters
- Vol. 98 (20) , 202108
Discerning passivation mechanisms at a-Si:H/c-Si interfaces by means of photoconductance measurements
The photoconductance decay (PCD) measurement is a fast and simple method to characterize amorphous/crystalline silicon interfaces for high-efficiency solar cells. However, PCD only yields information concerning the overall recombination rate in the structure. To overcome this limitation, we have developed and validated a computer-aided PCD (CA-PCD) analysis method to determine the defect density of recombination-active dangling bonds at the interface and the potential drop in the crystalline absorber adjacent to the interface. As a practical example, we investigate layer stacks and show that the CA-PCD method is capable of discerning the influence of field-effect and defect passivation.- 16 May 2011
- Published by AIP Publishing in Applied Physics Letters
- Vol. 98 (20) , 202108
Discerning passivation mechanisms at a-Si:H/c-Si interfaces by means of photoconductance measurements
The photoconductance decay (PCD) measurement is a fast and simple method to characterize amorphous/crystalline silicon interfaces for high-efficiency solar cells. However, PCD only yields information concerning the overall recombination rate in the structure. To overcome this limitation, we have developed and validated a computer-aided PCD (CA-PCD) analysis method to determine the defect density of recombination-active dangling bonds at the interface and the potential drop in the crystalline absorber adjacent to the interface. As a practical example, we investigate layer stacks and show that the CA-PCD method is capable of discerning the influence of field-effect and defect passivation.- 23 March 2010
- Published by Wiley in physica status solidi (c)
- Vol. 7 (3-4) , 1005-1010
A recombination model for a‐Si:H/c‐Si heterostructures
A semi‐analytical model to describe the excess carrier concentration‐dependent recombination processes and the charge carrier lifetime in a‐Si:H/c‐Si heterostructures has been developed. In contrast to previously proposed models it accounts for most relevant physical processes: In addition to bulk recombination processes the recombination via distributed dangling bond defects at the interface is integrated. Furthermore interface band bending depending on the a‐Si:H doping and the Fermi‐level dependent defect charge is taken into consideration as well as charge carrier diffusion to the interface. Despite its complexity the model allows for rapid computation and is thus well suited for fitting lifetime measurements in order to extract interface parameters. The model is crosschecked for various experimentally relevant situations against the numerical simulation tool AFORS‐HET
- 23 March 2010
- Published by Wiley in physica status solidi (c)
- Vol. 7 (3-4) , 1005-1010
A recombination model for a‐Si:H/c‐Si heterostructures
A semi‐analytical model to describe the excess carrier concentration‐dependent recombination processes and the charge carrier lifetime in a‐Si:H/c‐Si heterostructures has been developed. In contrast to previously proposed models it accounts for most relevant physical processes: In addition to bulk recombination processes the recombination via distributed dangling bond defects at the interface is integrated. Furthermore interface band bending depending on the a‐Si:H doping and the Fermi‐level dependent defect charge is taken into consideration as well as charge carrier diffusion to the interface. Despite its complexity the model allows for rapid computation and is thus well suited for fitting lifetime measurements in order to extract interface parameters. The model is crosschecked for various experimentally relevant situations against the numerical simulation tool AFORS‐HET