Myrtil L. Kahn
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Myrtil L. Kahn has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Bruno Chaudret
LCC CNRS, Toulouse, France
3 shared publications Christophe Mingotaud
Laboratoire IMRCP, CNRS UMR 5623, University of Toulouse, 118, route de Narbonne, Toulouse, France
2 shared publications- Jean-Daniel Marty
Laboratoire SOFTMAT, Université de Toulouse, Université Toulouse III-Paul Sabatier, CNRS UMR 5623, Toulouse 31062, France
2 shared publications - Philippe Menini
Laboratoire d’Analyse et d’Architecture des Systèmes (LAAS), Université de Toulouse, CNRS, UPS, 7 Avenue du Colonel Roche, 31031 Toulouse, France
2 shared publications - Pierre Fau
LCC CNRS, Toulouse, France
2 shared publications Sarmenio Saliba
Laboratoire IMRCP, CNRS UMR 5623, University of Toulouse, 118, route de Narbonne, 31062, Toulouse, France
2 shared publications
Latest Publications
- Open Access
- 1 January 2014
- Published by Elsevier in Procedia Engineering
- Vol. 87, 907-910
Shape-controlled ZnO Nanostructures for Gas Sensing Applications
- 1 January 2014
- Published by Elsevier in Procedia Engineering
- Vol. 87, 907-910
Open AccessShape-controlled ZnO Nanostructures for Gas Sensing Applications
- 21 May 2013
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 5 (15) , 6641-6661
Liquid crystalline thermotropic and lyotropic nanohybrids
This review is meant to give the reader an insight into hybrids incorporating different types of nanoparticles, e.g. metallic or metal oxides, within different types of lyotropic and thermotropic liquid crystals, from relatively small calamitic molecules to the larger discotics and polymers. In particular, this review highlights the importance of nanoparticle–liquid crystal interactions in accessing hybrid materials that exhibit synergetic properties.
- 21 May 2013
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 5 (15) , 6641-6661
Liquid crystalline thermotropic and lyotropic nanohybrids
This review is meant to give the reader an insight into hybrids incorporating different types of nanoparticles, e.g. metallic or metal oxides, within different types of lyotropic and thermotropic liquid crystals, from relatively small calamitic molecules to the larger discotics and polymers. In particular, this review highlights the importance of nanoparticle–liquid crystal interactions in accessing hybrid materials that exhibit synergetic properties.
- 23 May 2012
- Published by Wiley in Chemistry – A European Journal
- Vol. 18 (26) , 8084-8091
ZnO/Liquid Crystalline Nanohybrids: From Properties in Solution to Anisotropic Growth
Branched thermotropic liquid crystals (LCs) were successfully used as stabilizers for the synthesis of isotropic photoluminescent ZnO nanoparticles (NPs) in solution. 1H NMR spectroscopy and differential scanning calorimetry experiments demonstrate the existence of specific interactions between the LC and both the ZnO precursor and ZnO NPs. This offers the possibility for some branched molecules to act as structurally ordered hosts for the anisotropic growth of ZnO NPs.
- 23 May 2012
- Published by Wiley in Chemistry – A European Journal
- Vol. 18 (26) , 8084-8091
ZnO/Liquid Crystalline Nanohybrids: From Properties in Solution to Anisotropic Growth
Branched thermotropic liquid crystals (LCs) were successfully used as stabilizers for the synthesis of isotropic photoluminescent ZnO nanoparticles (NPs) in solution. 1H NMR spectroscopy and differential scanning calorimetry experiments demonstrate the existence of specific interactions between the LC and both the ZnO precursor and ZnO NPs. This offers the possibility for some branched molecules to act as structurally ordered hosts for the anisotropic growth of ZnO NPs.
- 1 January 2010
- Published by Springer Nature in MRS Proceedings
- Vol. 1253
When Organometallic Chemistry and Metal Oxide Nanoparticles Meet Optimized Silicon-based Gas Sensor
A robust silicon gas sensor chip (platinum heater, low deformation membrane) has been designed and successfully operated with various metal oxide nanoparticles synthesized by an organometallic route (SnO2, ZnO) and deposited by a generic ink-jet method. High quality and micron thick layers are obtained and the CO gas sensitivity is presented.
- 1 January 2010
- Published by Springer Nature in MRS Proceedings
- Vol. 1253
When Organometallic Chemistry and Metal Oxide Nanoparticles Meet Optimized Silicon-based Gas Sensor
A robust silicon gas sensor chip (platinum heater, low deformation membrane) has been designed and successfully operated with various metal oxide nanoparticles synthesized by an organometallic route (SnO2, ZnO) and deposited by a generic ink-jet method. High quality and micron thick layers are obtained and the CO gas sensitivity is presented.
- 2 June 2009
- Published by Wiley in Advanced Functional Materials
- Vol. 19 (11) , 1775-1783
Size Effect on Properties of Varistors Made From Zinc Oxide Nanoparticles Through Low Temperature Spark Plasma Sintering
Conditions for the elaboration of nanostructured varistors by spark plasma sintering (SPS) are investigated, using 8‐nm zinc oxide nanoparticles synthesized following an organometallic approach. A binary system constituted of zinc oxide and bismuth oxide nanoparticles is used for this purpose. It is synthesized at room temperature in an organic solution through the hydrolysis of dicyclohexylzinc and bismuth acetate precursors. Sintering of this material is performed by SPS at various temperatures and dwell times. The determination of the microstructure and the chemical composition of the as‐prepared ceramics are based on scanning electron microscopy and X‐ray diffraction analysis. The nonlinear electrical characteristics are evidenced by current–voltage measurements. The breakdown voltage of these nanostructured varistors strongly depends on grain sizes. The results show that nanostructured varistors are obtained by SPS at sintering temperatures ranging from 550 to 600 °C.
- 2 June 2009
- Published by Wiley in Advanced Functional Materials
- Vol. 19 (11) , 1775-1783
Size Effect on Properties of Varistors Made From Zinc Oxide Nanoparticles Through Low Temperature Spark Plasma Sintering
Conditions for the elaboration of nanostructured varistors by spark plasma sintering (SPS) are investigated, using 8‐nm zinc oxide nanoparticles synthesized following an organometallic approach. A binary system constituted of zinc oxide and bismuth oxide nanoparticles is used for this purpose. It is synthesized at room temperature in an organic solution through the hydrolysis of dicyclohexylzinc and bismuth acetate precursors. Sintering of this material is performed by SPS at various temperatures and dwell times. The determination of the microstructure and the chemical composition of the as‐prepared ceramics are based on scanning electron microscopy and X‐ray diffraction analysis. The nonlinear electrical characteristics are evidenced by current–voltage measurements. The breakdown voltage of these nanostructured varistors strongly depends on grain sizes. The results show that nanostructured varistors are obtained by SPS at sintering temperatures ranging from 550 to 600 °C.
- 10 December 2007
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 32 (4) , 662-669
Lithium ion as growth-controlling agent of ZnO nanoparticles prepared by organometallic synthesis
ZnO nanoparticles were synthesized by adding solid Zn(c-C6H11)2 to a THF solution of the lithium (sodium) precursor and octylamine (OA) as stabilizer. The proportion of Li (Na) was varied from 1 to 10 mol% compared to Zn. Two different lithium precursors namely Li[N(CH3)2] (series 1) and Li[N(Si(CH3)3)2] (series 2) and one sodium precursor namely Na[N(Si(CH3)3)2] (series 3) were used. Interestingly, Li precursors induce a modification of the growth of the particles while, no effect is observed when Na precursors is used. Indeed, isotropic nanoparticles were obtained when Li precursors were used while nanorods were formed with Na precursor as already observed in the same experimental conditions without alkali-metal precursor. Observations by TEM show that as the Li/Zn molar ratio increases, the mean diameters of the nanoparticles vary from 3.7 ± 0.7 nm to 2.5 ± 0.4 nm, and from 4.3 ± 1.0 nm to 3.1 ± 0.8 nm for series 1 and series 2, respectively, while the length and the diameter of the nanorods are ca. 11 × 4 nm, for series 3. Interestingly, the consequence of the lithium induced size variation leads to a shift of the emission band in the visible range, from yellow to blue through white as a function of increasing concentration of lithium precursor. The intensity of this emission is strong enough to be clearly seen by the human eye.
- 10 December 2007
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 32 (4) , 662-669
Lithium ion as growth-controlling agent of ZnO nanoparticles prepared by organometallic synthesis
ZnO nanoparticles were synthesized by adding solid Zn(c-C6H11)2 to a THF solution of the lithium (sodium) precursor and octylamine (OA) as stabilizer. The proportion of Li (Na) was varied from 1 to 10 mol% compared to Zn. Two different lithium precursors namely Li[N(CH3)2] (series 1) and Li[N(Si(CH3)3)2] (series 2) and one sodium precursor namely Na[N(Si(CH3)3)2] (series 3) were used. Interestingly, Li precursors induce a modification of the growth of the particles while, no effect is observed when Na precursors is used. Indeed, isotropic nanoparticles were obtained when Li precursors were used while nanorods were formed with Na precursor as already observed in the same experimental conditions without alkali-metal precursor. Observations by TEM show that as the Li/Zn molar ratio increases, the mean diameters of the nanoparticles vary from 3.7 ± 0.7 nm to 2.5 ± 0.4 nm, and from 4.3 ± 1.0 nm to 3.1 ± 0.8 nm for series 1 and series 2, respectively, while the length and the diameter of the nanorods are ca. 11 × 4 nm, for series 3. Interestingly, the consequence of the lithium induced size variation leads to a shift of the emission band in the visible range, from yellow to blue through white as a function of increasing concentration of lithium precursor. The intensity of this emission is strong enough to be clearly seen by the human eye.