Chris Lacor
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Chris Lacor has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
Bamdad Lessani
1 shared publicationCharles Hirsch
NUMECA Int
1 shared publication- Charles Hirsch
Numeca International
1 shared publication Cristian Dinescu
NUMECA Int
1 shared publicationD. Kumar
Fluid Mechanics and Thermodynamics Research Group, Department of Mechanical Engineering Vrije Universiteit Brussels Pleinlaan 2 1050 Brussels Belgium
1 shared publicationDinesh Kumar
Vrije Universiteit Brussel
1 shared publication
Latest Publications
- 1 May 2016
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 54 (5) , 1812-1813
Reply by the Authors to S. Lee and K. Brentner
- 1 May 2016
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 54 (5) , 1812-1813
Reply by the Authors to S. Lee and K. Brentner
- 1 January 2016
- Published by Springer Nature
- p. 59-72
Multi-Objective Surrogate Based Optimization of Gas Cyclones Using Support Vector Machines and CFD Simulations
- 1 January 2016
- Published by Springer Nature
- p. 59-72
Multi-Objective Surrogate Based Optimization of Gas Cyclones Using Support Vector Machines and CFD Simulations
- 26 March 2015
- Published by Wiley in International Journal for Numerical Methods in Engineering
- Vol. 103 (4) , 293-312
A non‐intrusive model reduction approach for polynomial chaos expansion using proper orthogonal decomposition
Summary: In this paper, a non‐intrusive stochastic model reduction scheme is developed for polynomial chaos representation using proper orthogonal decomposition. The main idea is to extract the optimal orthogonal basis via inexpensive calculations on a coarse mesh and then use them for the fine‐scale analysis. To validate the developed reduced‐order model, the method is implemented to: (1) the stochastic steady‐state heat diffusion in a square slab; (2) the incompressible, two‐dimensional laminar boundary‐layer over a flat plate with uncertainties in free‐stream velocity and physical properties; and (3) the highly nonlinear Ackley function with uncertain coefficients. For the heat diffusion problem, the thermal conductivity of the slab is assumed to be a stochastic field with known exponential covariance function and approximated via the Karhunen–Loève expansion. In all three test cases, the input random parameters are assumed to be uniformly distributed, and a polynomial chaos expansion is found using the regression method. The Sobol's quasi‐random sequence is used to generate the sample points. The numerical results of the three test cases show that the non‐intrusive model reduction scheme is able to produce satisfactory results for the statistical quantities of interest. It is found that the developed non‐intrusive model reduction scheme is computationally more efficient than the classical polynomial chaos expansion for uncertainty quantification of stochastic problems. The performance of the developed scheme becomes more apparent for the problems with larger stochastic dimensions and those requiring higher polynomial order for the stochastic discretization. Copyright © 2015 John Wiley & Sons, Ltd.
- 26 March 2015
- Published by Wiley in International Journal for Numerical Methods in Engineering
- Vol. 103 (4) , 293-312
A non‐intrusive model reduction approach for polynomial chaos expansion using proper orthogonal decomposition
Summary: In this paper, a non‐intrusive stochastic model reduction scheme is developed for polynomial chaos representation using proper orthogonal decomposition. The main idea is to extract the optimal orthogonal basis via inexpensive calculations on a coarse mesh and then use them for the fine‐scale analysis. To validate the developed reduced‐order model, the method is implemented to: (1) the stochastic steady‐state heat diffusion in a square slab; (2) the incompressible, two‐dimensional laminar boundary‐layer over a flat plate with uncertainties in free‐stream velocity and physical properties; and (3) the highly nonlinear Ackley function with uncertain coefficients. For the heat diffusion problem, the thermal conductivity of the slab is assumed to be a stochastic field with known exponential covariance function and approximated via the Karhunen–Loève expansion. In all three test cases, the input random parameters are assumed to be uniformly distributed, and a polynomial chaos expansion is found using the regression method. The Sobol's quasi‐random sequence is used to generate the sample points. The numerical results of the three test cases show that the non‐intrusive model reduction scheme is able to produce satisfactory results for the statistical quantities of interest. It is found that the developed non‐intrusive model reduction scheme is computationally more efficient than the classical polynomial chaos expansion for uncertainty quantification of stochastic problems. The performance of the developed scheme becomes more apparent for the problems with larger stochastic dimensions and those requiring higher polynomial order for the stochastic discretization. Copyright © 2015 John Wiley & Sons, Ltd.
- 1 February 2015
- Published by SAGE Publications in International Journal of Aeroacoustics
- Vol. 14 (1-2) , 105-132
Acoustic Velocity Formulation for Kirchhoff Data Surfaces
This paper deals with the derivation of an analytical time-domain formulation for the prediction of the acoustic velocity field generated by moving bodies in a medium at rest, according to the Kirchhoff method. The present formulation can be implemented in acoustic pressure codes based on the Farassat's Kirchhoff formula for arbitrary moving bodies, thus allowing direct and fast calculation of the acoustic velocity field in scattering problems. For validation purposes, four test cases are considered, namely a three-dimensional monopole, dipole and quadrupole source, as well as a monopole in uniform flow. Comparison of the results with the analytical solutions proves the remarkable accuracy of the present formulation.
- 1 February 2015
- Published by SAGE Publications in International Journal of Aeroacoustics
- Vol. 14 (1-2) , 105-132
Acoustic Velocity Formulation for Kirchhoff Data Surfaces
This paper deals with the derivation of an analytical time-domain formulation for the prediction of the acoustic velocity field generated by moving bodies in a medium at rest, according to the Kirchhoff method. The present formulation can be implemented in acoustic pressure codes based on the Farassat's Kirchhoff formula for arbitrary moving bodies, thus allowing direct and fast calculation of the acoustic velocity field in scattering problems. For validation purposes, four test cases are considered, namely a three-dimensional monopole, dipole and quadrupole source, as well as a monopole in uniform flow. Comparison of the results with the analytical solutions proves the remarkable accuracy of the present formulation.
- 27 July 2013
- Published by Springer Nature
- p. 193-223
Implementation of Intrusive Polynomial Chaos in CFD Codes and Application to 3D Navier-Stokes
- 27 July 2013
- Published by Springer Nature
- p. 193-223
Implementation of Intrusive Polynomial Chaos in CFD Codes and Application to 3D Navier-Stokes
- Open Access
Large eddy simulation of a muffler with the high-order spectral difference method
The combination of the high-order accurate spectral difference discretization on unstructured grids with subgrid-scale modelling is investigated for large eddy simulation of a muffler at Re = 4.64 10^4 and low Mach number. The subgrid-scale stress tensor is modelled by the wall-adapting local eddy-viscosity model with a cut-off length which is a decreasing function of the order of accuracy of the scheme. Numerical results indicate that although the high-order solver without subgrid-scale modelling is already able to capture well the features of the flow, the coupling with the wall-adapting local eddy-viscosity model improves the quality of the solution.
Open AccessLarge eddy simulation of a muffler with the high-order spectral difference method
The combination of the high-order accurate spectral difference discretization on unstructured grids with subgrid-scale modelling is investigated for large eddy simulation of a muffler at Re = 4.64 10^4 and low Mach number. The subgrid-scale stress tensor is modelled by the wall-adapting local eddy-viscosity model with a cut-off length which is a decreasing function of the order of accuracy of the scheme. Numerical results indicate that although the high-order solver without subgrid-scale modelling is already able to capture well the features of the flow, the coupling with the wall-adapting local eddy-viscosity model improves the quality of the solution.
- 10 May 2009
- Published by Springer Nature
- p. 463-468
Stochastic generation of velocity fluctuation for turbulent inflow and initial condition
- 10 May 2009
- Published by Springer Nature
- p. 463-468
Stochastic generation of velocity fluctuation for turbulent inflow and initial condition
- 1 May 2009
- Published by Taylor & Francis in Journal of Hydraulic Research
- Vol. 47 (3) , 291-298
Large eddy simulation of sediment transport in open-channel flow
Large Eddy Simulation (LES) is used to investigate the 3D-transport of sediment suspension in an open channel flow at a Reynolds number based on the frictional velocity.An Eulerian model was employed to represent the fluid and the sediment phases. The subgrid-scale fluid stresses were modeled with the Smagorinsky model, whereas subgrid-scale sediment fluxes were based on a gradient approach. To avoid tuning constants, a dynamic procedure was applied. A two-way coupling between sediment and fluid improved the computational description of sediment transport. Sediment concentration profiles and the statistics of sediment fluxes are presented and compared with the Rouse profile and the RANS solution. The results obtained agree well with the theory and with measurements. The LES results also indicate that the assumption of a constant Schmidt number, as is mostly assumed in RANS simulations is erroneous.
- 1 May 2009
- Published by Taylor & Francis in Journal of Hydraulic Research
- Vol. 47 (3) , 291-298
Large eddy simulation of sediment transport in open-channel flow
Large Eddy Simulation (LES) is used to investigate the 3D-transport of sediment suspension in an open channel flow at a Reynolds number based on the frictional velocity.An Eulerian model was employed to represent the fluid and the sediment phases. The subgrid-scale fluid stresses were modeled with the Smagorinsky model, whereas subgrid-scale sediment fluxes were based on a gradient approach. To avoid tuning constants, a dynamic procedure was applied. A two-way coupling between sediment and fluid improved the computational description of sediment transport. Sediment concentration profiles and the statistics of sediment fluxes are presented and compared with the Rouse profile and the RANS solution. The results obtained agree well with the theory and with measurements. The LES results also indicate that the assumption of a constant Schmidt number, as is mostly assumed in RANS simulations is erroneous.
- 1 April 2004
- Published by Taylor & Francis in International Journal of Computational Fluid Dynamics
- Vol. 18 (3) , 221-233
Efficient Large-eddy Simulations of Low Mach Number Flows Using Preconditioning and Multigrid
In the present paper, an implicit time accurate approach combined with multigrid, preconditioning and residual smoothing is used for the large-eddy simulation (LES) of low Mach number flow. In general, due to the restriction imposed on the time step by the physics of the flow, the advantage of an implicit method over an explicit one for LES is not obvious. It is shown that for the test cases considered in this paper, the present approach allows an efficiency gain of a factor 4–7 compared to the use of a purely explicit approach. The efficiency varies according to the test case, grid clustering, physical time step and requested residual drop. Numerical difficulties are catalogued and mitigatory procedures are introduced. Several problems with available experimental and DNS data are employed to verify the efficiency of the method.
- 1 April 2004
- Published by Taylor & Francis in International Journal of Computational Fluid Dynamics
- Vol. 18 (3) , 221-233
Efficient Large-eddy Simulations of Low Mach Number Flows Using Preconditioning and Multigrid
In the present paper, an implicit time accurate approach combined with multigrid, preconditioning and residual smoothing is used for the large-eddy simulation (LES) of low Mach number flow. In general, due to the restriction imposed on the time step by the physics of the flow, the advantage of an implicit method over an explicit one for LES is not obvious. It is shown that for the test cases considered in this paper, the present approach allows an efficiency gain of a factor 4–7 compared to the use of a purely explicit approach. The efficiency varies according to the test case, grid clustering, physical time step and requested residual drop. Numerical difficulties are catalogued and mitigatory procedures are introduced. Several problems with available experimental and DNS data are employed to verify the efficiency of the method.