A. E. Gildemeister
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
A. E. Gildemeister has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
A. C. Gossard
University of California Materials Department Santa Barbara, California 93106, USA
7 shared publicationsD. C. Driscoll
University of California Materials Department Santa Barbara, California 93106, USA
7 shared publicationsK. Ensslin
Solid State Physics Laboratory, ETH Zurich, 8093 Zurich, Switzerland
7 shared publications- Thomas Ihn
ETH Zurich
6 shared publications M. Sigrist
Solid State Physics Laboratory, ETH Zurich, 8093 Zurich, Switzerland
5 shared publicationsT. Ihn
3 shared publications
Latest Publications
- 17 October 2007
- Published by Elsevier in Physica E: Low-dimensional Systems and Nanostructures
- Vol. 40 (5) , 1640-1641
Lever arm of a metallic tip in scanning gate experiments
- 17 October 2007
- Published by Elsevier in Physica E: Low-dimensional Systems and Nanostructures
- Vol. 40 (5) , 1640-1641
Lever arm of a metallic tip in scanning gate experiments
- Open Access
- 15 October 2007
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 102 (8) , 083703
Imaging a coupled quantum dot-quantum point contact system
We have quantitatively studied the effect of charge traps on the electrical conductance of a quantum dot and a capacitively coupled quantum point contact. Using the sharp metallic tip of a low-temperature scanning force microscope as a scanned gate, we could localize the traps. The quantum point contact served as a charge detector and allowed us to distinguish single electron charging events in several traps from charging events on the dot. We used the quantum dot to analyze the tip-induced potential quantitatively and found its shape to be independent of the voltage applied to the tip within a certain range of parameters. We estimate that the trap density is below of the doping density, that the charging energy of a trap is three times higher than that of the quantum dot, and that the interaction energy between the quantum dot and a trap is a significant portion of the dot’s charging energy. Possibly, such charge traps are the reason for frequently observed parametric charge rearrangements.- 15 October 2007
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 102 (8) , 083703
Open AccessImaging a coupled quantum dot-quantum point contact system
We have quantitatively studied the effect of charge traps on the electrical conductance of a quantum dot and a capacitively coupled quantum point contact. Using the sharp metallic tip of a low-temperature scanning force microscope as a scanned gate, we could localize the traps. The quantum point contact served as a charge detector and allowed us to distinguish single electron charging events in several traps from charging events on the dot. We used the quantum dot to analyze the tip-induced potential quantitatively and found its shape to be independent of the voltage applied to the tip within a certain range of parameters. We estimate that the trap density is below of the doping density, that the charging energy of a trap is three times higher than that of the quantum dot, and that the interaction energy between the quantum dot and a trap is a significant portion of the dot’s charging energy. Possibly, such charge traps are the reason for frequently observed parametric charge rearrangements. - Open Access
Measurement of the Tip-Induced Potential in Scanning Gate Experiments
We present a detailed experimental study on the electrostatic interaction between a quantum dot and the metallic tip of a scanning force microscope. Our method allowed us to quantitatively map the tip-induced potential and to determine the spatial dependence of the tip's lever arm with high resolution. We find that two parts of the tip-induced potential can be distinguished, one that depends on the voltage applied to the tip and one that is independent of this voltage. The first part is due to the metallic tip while we interpret the second part as the effect of a charged dielectric particle on the tip. In the measurements of the lever arm we find fine structure that depends on which quantum state we study. The results are discussed in view of scanning gate experiments where the tip is used as a movable gate to study nanostructures.
Open AccessMeasurement of the Tip-Induced Potential in Scanning Gate Experiments
We present a detailed experimental study on the electrostatic interaction between a quantum dot and the metallic tip of a scanning force microscope. Our method allowed us to quantitatively map the tip-induced potential and to determine the spatial dependence of the tip's lever arm with high resolution. We find that two parts of the tip-induced potential can be distinguished, one that depends on the voltage applied to the tip and one that is independent of this voltage. The first part is due to the metallic tip while we interpret the second part as the effect of a charged dielectric particle on the tip. In the measurements of the lever arm we find fine structure that depends on which quantum state we study. The results are discussed in view of scanning gate experiments where the tip is used as a movable gate to study nanostructures.
- Open Access
In Situ Treatment of a Scanning Gate Microscopy Tip
In scanning gate microscopy, where the tip of a scanning force microscope is used as a movable gate to study electronic transport in nanostructures, the shape and magnitude of the tip-induced potential are important for the resolution and interpretation of the measurements. Contaminations picked up during topography scans may significantly alter this potential. We present an in situ high-field treatment of the tip that improves the tip-induced potential. A quantum dot was used to measure the tip-induced potential.
Open AccessIn Situ Treatment of a Scanning Gate Microscopy Tip
In scanning gate microscopy, where the tip of a scanning force microscope is used as a movable gate to study electronic transport in nanostructures, the shape and magnitude of the tip-induced potential are important for the resolution and interpretation of the measurements. Contaminations picked up during topography scans may significantly alter this potential. We present an in situ high-field treatment of the tip that improves the tip-induced potential. A quantum dot was used to measure the tip-induced potential.
- 24 May 2007
- Published by American Physical Society (APS) in Physical Review B
- Vol. 75 (19) , 195338
Measurement of the tip-induced potential in scanning gate experiments
We present a detailed experimental study on the electrostatic interaction between a quantum dot and the metallic tip of a scanning force microscope. Our method allowed us to quantitatively map the tip-induced potential and to determine the spatial dependence of the tip’s lever arm with high resolution. We find that two parts of the tip-induced potential can be distinguished, one that depends on the voltage applied to the tip and one that is independent of this voltage. The first part is due to the metallic tip while we interpret the second part as the effect of a charged dielectric particle on the tip. In the measurements of the lever arm we find fine structure that depends on which quantum state we study. The results are discussed in view of scanning gate experiments where the tip is used as a movable gate to study nanostructures.
- 24 May 2007
- Published by American Physical Society (APS) in Physical Review B
- Vol. 75 (19) , 195338
Measurement of the tip-induced potential in scanning gate experiments
We present a detailed experimental study on the electrostatic interaction between a quantum dot and the metallic tip of a scanning force microscope. Our method allowed us to quantitatively map the tip-induced potential and to determine the spatial dependence of the tip’s lever arm with high resolution. We find that two parts of the tip-induced potential can be distinguished, one that depends on the voltage applied to the tip and one that is independent of this voltage. The first part is due to the metallic tip while we interpret the second part as the effect of a charged dielectric particle on the tip. In the measurements of the lever arm we find fine structure that depends on which quantum state we study. The results are discussed in view of scanning gate experiments where the tip is used as a movable gate to study nanostructures.
- 21 May 2007
- Published by AIP Publishing in Applied Physics Letters
- Vol. 90 (21) , 213113
In situ treatment of a scanning gate microscopy tip
In scanning gate microscopy, where the tip of a scanning force microscope is used as a movable gate to study electronic transport in nanostructures, the shape and magnitude of the tip-induced potential are important for the resolution and interpretation of the measurements. Contaminations picked up during topography scans may significantly alter this potential. The authors present an in situ high-field treatment of the tip that improves the tip-induced potential. A quantum dot was used to measure the tip-induced potential.
- 21 May 2007
- Published by AIP Publishing in Applied Physics Letters
- Vol. 90 (21) , 213113
In situ treatment of a scanning gate microscopy tip
In scanning gate microscopy, where the tip of a scanning force microscope is used as a movable gate to study electronic transport in nanostructures, the shape and magnitude of the tip-induced potential are important for the resolution and interpretation of the measurements. Contaminations picked up during topography scans may significantly alter this potential. The authors present an in situ high-field treatment of the tip that improves the tip-induced potential. A quantum dot was used to measure the tip-induced potential.
- 4 May 2007
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 893 (1) , 819
Scanning Gate Measurements on a Coupled Quantum Dot — Quantum Point Contact System
We use the metallic tip of a low‐temperature scanning force microscope as a movable gate to study a quantum dot and an adjacent quantum point contact. By scanning the tip we can add single electrons to the dot and detect them with the quantum point contact. Additionally, we detect other charging events which we attribute to charge traps.
- 4 May 2007
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 893 (1) , 819
Scanning Gate Measurements on a Coupled Quantum Dot — Quantum Point Contact System
We use the metallic tip of a low‐temperature scanning force microscope as a movable gate to study a quantum dot and an adjacent quantum point contact. By scanning the tip we can add single electrons to the dot and detect them with the quantum point contact. Additionally, we detect other charging events which we attribute to charge traps.
- Open Access
Imaging a Coupled Quantum Dot - Quantum Point Contact System
We performed measurements on a quantum dot and a capacitively coupled quantum point contact by using the sharp metallic tip of a low-temperature scanning force microscope as a scanned gate. The quantum point contact served as a detector for charges on the dot or nearby. It allowed us to distinguish single electron charging events in several charge traps from charging events on the dot. We analyzed the tip-induced potential quantitatively and found its shape to be independent of the voltage applied to the tip within a certain range of parameters. We estimate that the trap density is below 0.1% of the doping density and that the interaction energy between the quantum dot and a trap is a significant portion of the dot's charging energy. Possibly, such charge traps are the reason for frequently observed parametric charge rearrangements.
Open AccessImaging a Coupled Quantum Dot - Quantum Point Contact System
We performed measurements on a quantum dot and a capacitively coupled quantum point contact by using the sharp metallic tip of a low-temperature scanning force microscope as a scanned gate. The quantum point contact served as a detector for charges on the dot or nearby. It allowed us to distinguish single electron charging events in several charge traps from charging events on the dot. We analyzed the tip-induced potential quantitatively and found its shape to be independent of the voltage applied to the tip within a certain range of parameters. We estimate that the trap density is below 0.1% of the doping density and that the interaction energy between the quantum dot and a trap is a significant portion of the dot's charging energy. Possibly, such charge traps are the reason for frequently observed parametric charge rearrangements.
- 1 January 2007
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 78 (1) , 013704
Construction of a dilution refrigerator cooled scanning force microscope
We present a scanning force microscope that operates in a dilution refrigerator at temperatures of about 100 mK. We use tuning fork sensors for scanning gate experiments on mesoscopic semiconductor nanostructures. Slip-stick motors allow sample coarse-positioning at base temperature. The construction, thermal anchoring, and a procedure to optimize the settings of the phase-locked loop that we use for sensor control are discussed in detail. We present low-temperature topographic and scanning gate images as examples of successful operation.
- 1 January 2007
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 78 (1) , 013704
Construction of a dilution refrigerator cooled scanning force microscope
We present a scanning force microscope that operates in a dilution refrigerator at temperatures of about 100 mK. We use tuning fork sensors for scanning gate experiments on mesoscopic semiconductor nanostructures. Slip-stick motors allow sample coarse-positioning at base temperature. The construction, thermal anchoring, and a procedure to optimize the settings of the phase-locked loop that we use for sensor control are discussed in detail. We present low-temperature topographic and scanning gate images as examples of successful operation.