Saswati Chakraborty
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Saswati Chakraborty has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
Biju Prava Sahariah
Centre for the Environment, Indian Institute of Technology Guwahati, Assam, India
2 shared publicationsH. Veeramani
1 shared publicationPraisy Terangpi
Centre for the Environment, Indian Institute of Technology, Guwahati, India
1 shared publicationSachin Chauhan
Department of Civil Engineering Indian Institute of Technology Guwahati Assam-781039 India
1 shared publicationSachin Kumar Tomar
Department of Civil Engineering, Indian Institute of Technology Guwahati, Guwahati 781039, India
1 shared publicationSagar Patil
A Department of Civil Engineering , Indian Institute of Technology Guwahati , Assam , India
1 shared publication
Latest Publications
- 14 January 2018
- Published by Springer Nature
- p. 171-184
Treatment of Synthetic Petroleum Refinery Wastewater in Anoxic Reactors at Varied Feed Phenol
- 14 January 2018
- Published by Springer Nature
- p. 171-184
Treatment of Synthetic Petroleum Refinery Wastewater in Anoxic Reactors at Varied Feed Phenol
- Open Access
- 21 December 2016
- Published by Springer Nature in Applied Water Science
- Vol. 7 (7) , 3661-3671
Adsorption kinetics and equilibrium studies for removal of acid azo dyes by aniline formaldehyde condensate
- 21 December 2016
- Published by Springer Nature in Applied Water Science
- Vol. 7 (7) , 3661-3671
Open AccessAdsorption kinetics and equilibrium studies for removal of acid azo dyes by aniline formaldehyde condensate
- 7 December 2016
- Published by Taylor & Francis in Journal of Environmental Science and Health, Part A
- Vol. 52 (4) , 403-412
Effects of step-feeding and intermittent aeration on organics and nitrogen removal in a horizontal subsurface flow constructed wetland
The effect of step feed strategy and intermittent aeration on removal of chemical oxygen demand (COD) and nitrogen was investigated in a laboratory scale horizontal subsurface flow constructed wetland (HSSFCW). Wetland was divided into four zones along the length (zone I to IV), and influent was introduced into first and third zones by step feeding. Continuous study was carried out in four phases. In phases I to III, 30% of influent was bypassed to zone III for denitrification along with organics removal. Intermittent aeration was provided only in zone II at 2.5 L/min for 4 h/day, during phases II, III and IV. In phase I, 87% COD and 43% NH4+-N (ammonia-nitrogen) removal were obtained from influents of 331 and 30 mg/L, respectively. In phase II study, external aeration resulted in 97% COD and 71% NH4+-N removal in the wetland. In phase IV, 40% of feed was delivered to zone III. Higher supply of organic in zone III resulted in higher denitrification, and total nitrogen removal rate increased to 70% from 56%. In the final effluent, concentration of NO3−-N was 9–11 mg/L in phase I to III and decreased to 4 mg/L in phase IV. Batch study showed that COD and NH4+-N removal followed first order kinetics in different zones of wetland.
- 7 December 2016
- Published by Taylor & Francis in Journal of Environmental Science and Health, Part A
- Vol. 52 (4) , 403-412
Effects of step-feeding and intermittent aeration on organics and nitrogen removal in a horizontal subsurface flow constructed wetland
The effect of step feed strategy and intermittent aeration on removal of chemical oxygen demand (COD) and nitrogen was investigated in a laboratory scale horizontal subsurface flow constructed wetland (HSSFCW). Wetland was divided into four zones along the length (zone I to IV), and influent was introduced into first and third zones by step feeding. Continuous study was carried out in four phases. In phases I to III, 30% of influent was bypassed to zone III for denitrification along with organics removal. Intermittent aeration was provided only in zone II at 2.5 L/min for 4 h/day, during phases II, III and IV. In phase I, 87% COD and 43% NH4+-N (ammonia-nitrogen) removal were obtained from influents of 331 and 30 mg/L, respectively. In phase II study, external aeration resulted in 97% COD and 71% NH4+-N removal in the wetland. In phase IV, 40% of feed was delivered to zone III. Higher supply of organic in zone III resulted in higher denitrification, and total nitrogen removal rate increased to 70% from 56%. In the final effluent, concentration of NO3−-N was 9–11 mg/L in phase I to III and decreased to 4 mg/L in phase IV. Batch study showed that COD and NH4+-N removal followed first order kinetics in different zones of wetland.
- Open Access
- 1 November 2016
- Published by Korean Society of Environmental Engineering in Environmental Engineering Research
- Vol. 22 (1) , 95-107
Adsorption isotherm and kinetics analysis of hexavalent chromium and mercury on mustard oil cake
Adsorption equilibrium and kinetic behavior of two toxic heavy metals hexavalent chromium [Cr(VI)] and mercury [Hg(II)] on mustard oil cake (MOC) was studied. Isotherm of total chromium was of concave type (S1 type) suggesting cooperative adsorption. Total chromium adsorption followed BET isotherm model. Isotherm of Hg(II) was of L3 type with monolayer followed by multilayer formation due to blockage of pores of MOC at lower concentration of Hg(II). Combined BET-Langmuir and BET-Freundlich models were appropriate to predict Hg(II) adsorption data on MOC. Boyd's model confirmed that external mass transfer was rate limiting step for both total chromium and Hg(II) adsorptions with average diffusivity of 1.09 × 10-16 and 0.97 m 2 /sec, respectively. Desorption was more than 60% with Hg(II), but poor with chromium. The optimum pH for adsorptions of total chromium and Hg(II) were 2-3 and 5, respectively. At strong acidic pH, Cr(VI) was adsorbed by ion exchange mechanism and after adsorption reduced to Cr(III) and remained on MOC surface. Hg(II) removal was achieved by complexation of HgCl2 with deprotonated amine (-NH2) and carboxyl (COO-) groups of MOC.
- 1 November 2016
- Published by Korean Society of Environmental Engineering in Environmental Engineering Research
- Vol. 22 (1) , 95-107
Open AccessAdsorption isotherm and kinetics analysis of hexavalent chromium and mercury on mustard oil cake
Adsorption equilibrium and kinetic behavior of two toxic heavy metals hexavalent chromium [Cr(VI)] and mercury [Hg(II)] on mustard oil cake (MOC) was studied. Isotherm of total chromium was of concave type (S1 type) suggesting cooperative adsorption. Total chromium adsorption followed BET isotherm model. Isotherm of Hg(II) was of L3 type with monolayer followed by multilayer formation due to blockage of pores of MOC at lower concentration of Hg(II). Combined BET-Langmuir and BET-Freundlich models were appropriate to predict Hg(II) adsorption data on MOC. Boyd's model confirmed that external mass transfer was rate limiting step for both total chromium and Hg(II) adsorptions with average diffusivity of 1.09 × 10-16 and 0.97 m 2 /sec, respectively. Desorption was more than 60% with Hg(II), but poor with chromium. The optimum pH for adsorptions of total chromium and Hg(II) were 2-3 and 5, respectively. At strong acidic pH, Cr(VI) was adsorbed by ion exchange mechanism and after adsorption reduced to Cr(III) and remained on MOC surface. Hg(II) removal was achieved by complexation of HgCl2 with deprotonated amine (-NH2) and carboxyl (COO-) groups of MOC.
- 1 January 2013
- Published by Taylor & Francis in Environmental Technology
- Vol. 34 (2) , 245-256
Effects of cycle time and fill time on the performance of an anaerobic–anoxic–aerobic-fed batch moving-bed reactor
Performance of a fed batch moving-bed reactor system arranged in anaerobic (B1)–anoxic (B2)–aerobic (B3) mode was investigated using cycle time (18–36 h), gradual fill time (total 5–18.5 h; B1: 1–3.7 h; B2 and B3: 2–7.4 h each) and instantaneous fill time as variable parameters. During cycle time variation, total hydraulic retention time changed from 4.5 to 9 days (B1: 2.25–4.5 days; B2 and B3: 1.13–2.25 days each). Synthetic wastewater contained phenol (1500 mg/l), thiocyanate (SCN− 800 mg/l at gradual fill and 100 mg/l at instantaneous fill) and ammonia ( 500 mg/l). Phenol and chemical oxygen demand (COD) removals in B1 increased with increase in cycle time and gradual shorter filling showed higher performance than gradual long filling and instantaneous filling. In B2, simultaneous removals of phenol, SCN, COD and -N were achieved and effects of cycle time and fill times were not profound. In B3, removal efficiency increased with increase in both cycle time and gradual fill time. The minimum cycle time of 30 h and total hydraulic retention time of 7.5 days and total fill time of 12.5 h were recommended. A modified Stover–Kincannon model showed the highest correlation for removal of substrates in B1, B2 and B3.
- 1 January 2013
- Published by Taylor & Francis in Environmental Technology
- Vol. 34 (2) , 245-256
Effects of cycle time and fill time on the performance of an anaerobic–anoxic–aerobic-fed batch moving-bed reactor
Performance of a fed batch moving-bed reactor system arranged in anaerobic (B1)–anoxic (B2)–aerobic (B3) mode was investigated using cycle time (18–36 h), gradual fill time (total 5–18.5 h; B1: 1–3.7 h; B2 and B3: 2–7.4 h each) and instantaneous fill time as variable parameters. During cycle time variation, total hydraulic retention time changed from 4.5 to 9 days (B1: 2.25–4.5 days; B2 and B3: 1.13–2.25 days each). Synthetic wastewater contained phenol (1500 mg/l), thiocyanate (SCN− 800 mg/l at gradual fill and 100 mg/l at instantaneous fill) and ammonia ( 500 mg/l). Phenol and chemical oxygen demand (COD) removals in B1 increased with increase in cycle time and gradual shorter filling showed higher performance than gradual long filling and instantaneous filling. In B2, simultaneous removals of phenol, SCN, COD and -N were achieved and effects of cycle time and fill times were not profound. In B3, removal efficiency increased with increase in both cycle time and gradual fill time. The minimum cycle time of 30 h and total hydraulic retention time of 7.5 days and total fill time of 12.5 h were recommended. A modified Stover–Kincannon model showed the highest correlation for removal of substrates in B1, B2 and B3.
- 19 June 2012
- Published by Springer Nature in Clean Technologies and Environmental Policy
- Vol. 15 (2) , 225-233
Performance of anaerobic–anoxic–aerobic batch fed moving-bed reactor at varying phenol feed concentrations and hydraulic retention time
- 19 June 2012
- Published by Springer Nature in Clean Technologies and Environmental Policy
- Vol. 15 (2) , 225-233
Performance of anaerobic–anoxic–aerobic batch fed moving-bed reactor at varying phenol feed concentrations and hydraulic retention time
- 1 December 2006
- Published by Elsevier in Bioresource Technology
- Vol. 97 (18) , 2407-2413
Role of various parameters in synthesis of insoluble agrobased xanthates for removal of copper from wastewater
- 1 December 2006
- Published by Elsevier in Bioresource Technology
- Vol. 97 (18) , 2407-2413
Role of various parameters in synthesis of insoluble agrobased xanthates for removal of copper from wastewater
- 1 May 2005
- Published by Elsevier in Bioresource Technology
- Vol. 96 (7) , 761-767
Response of pulse phenol injection on an anaerobic–anoxic–aerobic system
- 1 May 2005
- Published by Elsevier in Bioresource Technology
- Vol. 96 (7) , 761-767
Response of pulse phenol injection on an anaerobic–anoxic–aerobic system