Tracey C. van Stijn

While conducting a landscape genomics study of invasive tammar wallabies (Notamacropus eugenii) in Aotearoa New Zealand we discovered that parma wallabies (N. parma) are also present in the North Island. This population has gone undetected for at least 30 years (and potentially for over a century), hidden amongst the morphologically similar tammar wallabies. The fact that an invasive wallaby species could remain undetected for so long, highlights the need for greater monitoring efforts for invasive species including genomic species identification.

Modified, agricultural landscapes are susceptible to damage by insect pests. Biological control of pests is typically successful once a control agent has established, but this depends on the agent’s capacity to co-evolve with the host. Theoretical studies have shown that different levels of genetic variation between the host and the control agent will lead to rapid evolution of resistance in the host. Although this has been reported in one instance, the underlying genetics have not been studied. To address this, we measured the genetic variation in New Zealand populations of the pasture pest, Argentine stem weevil (Listronotus bonariensis), which is controlled with declining effectiveness by a parasitoid wasp, Microctonus hyperodae. We constructed a draft reference genome of the weevil, collected samples from a geographical survey of 10 sites around New Zealand, and genotyped them using a modified genotyping-by-sequencing approach. New Zealand populations of Argentine stem weevil have high levels of heterozygosity and low population structure, consistent with a large effective population size and frequent gene flow. This implies that Argentine stem weevils were able to evolve more rapidly than their biocontrol agent, which reproduces asexually. These findings show that monitoring genetic diversity in biocontrol agents and their targets is critical for long-term success of biological control.

The Tunisian Noire de Thibar sheep breed is a composite breed, recently selected to create animals that are uniformly black in order to avoid skin photosensitization after the ingestion of toxic “hypericum perforatum” weeds, which causes a major economic loss to sheep farmers. We assessed genetic differentiation and estimated marker F_ST using genotyping-by-sequencing (GBS) data in black (Noire de Thibar) and related white-coated (Queue fine de l’ouest) sheep breeds to identify signals of artificial selection. The results revealed the selection signatures within candidate genes related to coat color, which are assumed to be indirectly involved in the mechanism of photosensitization in sheep. The identified genes could provide important information for molecular breeding.

Microbial community profiles have been associated with a variety of traits, including methane emissions in livestock, however, these profiles can be difficult and expensive to obtain for thousands of samples. The objective of this work was to develop a low-cost, high-throughput approach to capture the diversity of the rumen microbiome. Restriction enzyme reduced representation sequencing (RE-RRS) using ApeK I or Pst I, and two bioinformatic pipelines (reference-based and reference-free) were compared to 16S rRNA gene sequencing using repeated samples collected two weeks apart from 118 sheep that were phenotypically extreme (60 high and 58 low) for methane emitted per kg dry matter intake (n=236). DNA was extracted from freeze-dried rumen samples using a phenol chloroform and bead-beating protocol prior to sequencing. The resulting sequences were used to investigate the repeatability of the rumen microbial community profiles, the effect of host genetics, laboratory and analytical method, and the genetic and phenotypic correlations with methane production. The results suggested that the best method was Pst I RE-RRS analyzed with the reference-free approach via a correspondence analysis, with estimates for repeatability of 0.62±0.06, heritability 0.31±0.29, and genetic and phenotypic correlation with methane emissions of 0.88±0.25 and 0.64±0.05 respectively for the first component of correspondence analysis. The reference-free approach assigned 62.0±5.7% of reads to common 65 bp tags, much higher than the reference-based approach of 6.8±1.8% of reads assigned. Sensitivity studies suggested approximately 2000 samples could be sequenced in a single lane on an Illumina HiSeq 2500, therefore the current work of 118 samples/lane and future proposed 384 samples/lane are well within that threshold. Our approach is now being used to investigate host factors affecting the rumen and its association with a variety of production and environmental traits. With minor adaptations, our approach could be used to obtain microbial profiles from other metagenomic samples.

Summary: Genotypes are often used to assign parentage in agricultural and ecological settings. Sequencing can be used to obtain genotypes but does not provide unambiguous genotype calls, especially when sequencing depth is low in order to reduce costs. In that case, standard parentage analysis methods no longer apply. A strategy for using low-depth sequencing data for parentage assignment is developed here. It entails the use of relatedness estimates along with a metric termed excess mismatch rate which, for parent-offspring pairs or trios, is the difference between the observed mismatch rate and the rate expected under a model of inheritance and allele reads without error. When more than one putative parent has similar statistics, bootstrapping can provide a measure of the relatedness similarity. Putative parent-offspring trios can be further checked for consistency by comparing the offspring’s estimated inbreeding to half the parent relatedness. Suitable thresholds are required for each metric. These methods were applied to a deer breeding operation consisting of two herds of different breeds. Relatedness estimates were more in line with expectation when the herds were analysed separately than when combined, although this did not alter which parents were the best matches with each offspring. Parentage results were largely consistent with those based on a microsatellite parentage panel with three discordant parent assignments out of 1561. Two models are investigated to allow the parentage metrics to be calculated with non-random selection of alleles. The tools and strategies given here allow parentage to be assigned from low-depth sequencing data.

Black-billed gulls (Larus bulleri) are endemic to New Zealand and are suspected to be undergoing substantial population declines. They primarily breed on open gravel beds in braided rivers of the South Island—a habitat that is diminishing and becoming increasingly modified. Although management of this species is increasing, little has been published on their movements and demographics. In this study, both mitochondrial DNA (mtDNA) control region domain I and nuclear single nucleotide polymorphisms (SNPs) were examined to help understand the connectivity and population structure of black-billed gulls across the country and to help inform management decisions. Mitochondrial DNA showed no population structure, with high haplotype and low nucleotide diversity, and analyses highlighted mitochondrial introgression with the closely related red-billed gulls (Larus novaehollandiae scopulinus). Nuclear DNA analyses, however, identified two groups, with Rotorua birds in the North Island being distinct from the rest of New Zealand, and isolation-by-distance evident across the South Island populations. Gene flow primarily occurs between nearby colonies with a stepwise movement across the landscape. The importance from a genetic perspective of the more isolated North Island birds (1.6% of total population) needs to be further evaluated. From our results, we infer that the South Island black-billed gull management should focus on maintaining several populations within each region rather than focusing on single specific colonies or river catchments. Future study is needed to investigate the genetic structure of populations at the northern limit of the species’ range, and identify the mechanisms behind, and extent of, the hybridisation between red-billed and black-billed gulls.

The recent development of next-generation sequencing DNA marker technologies, such as genotyping-by-sequencing (GBS), generates thousands of informative single nucleotide polymorphism markers in almost any species, regardless of genomic resources. This enables poorly resourced or “orphan” crops/species access to high-density, high-throughput marker platforms which have revolutionised population genetics studies and plant breeding. DNA quality underpins success of GBS methods as the DNA must be amenable to restriction enzyme digestion and sequencing. A barrier to implementing GBS technologies is access to inexpensive, high-throughput extraction methods that yield sequencing-quality genomic DNA (gDNA) from plants. Several high-throughput DNA extraction methods are available, but typically provide low yield or poor quality gDNA, or are costly (US$6–$9/sample) for consumables. We modified a non-organic solvent protocol to extract microgram quantities (1–13 μg) of sequencing-quality high molecular weight gDNA inexpensively in 96-well plates from either fresh, freeze-dried or silica gel-dried plant tissue. The protocol was effective for several easy and difficult-to-extract forage, crop, horticultural and common model species including Trifolium, Medicago, Lolium, Secale, Festuca, Malus, Oryza, and Arabidopsis. The extracted DNA was of high molecular weight and digested readily with restriction enzymes. Contrasting with other extraction protocols we assessed, Illumina-based sequencing of GBS libraries developed from this gDNA had very uniform high quality base-calls to the end of sequence reads. Furthermore, DNA extracted using this method has been sequenced successfully with the PacBio long-read platform. The protocol is scalable, readily automated without requirement for fume hoods, requires approximately three hours to process 192 samples (384–576 samples/day), and is inexpensive at US$0.62/sample for consumables. This versatile, scalable and simple protocol yields high molecular weight genomic DNA suitable for restriction enzyme digestion and next-generation sequencing applications including GBS and long-read sequencing platforms such as PacBio. The low cost, high-throughput, and extraction of high quality gDNA from a range of fresh and dried source plant material makes this method suitable for many sequencing and genotyping applications including large-scale sample screening underpinning breeding programmes.

High-throughput sequencing methods that multiplex a large number of individuals have provided a cost-effective approach for discovering genome-wide genetic variation in large populations. These sequencing methods are increasingly being utilized in population genetic studies across a diverse range of species. One side-effect of these methods, however, is that one or more alleles at a particular locus may not be sequenced, particularly when the sequencing depth is low, resulting in some heterozygous genotypes being called as homozygous. Under-called heterozygous genotypes have a profound effect on the estimation of linkage disequilibrium and, if not taken into account, leads to inaccurate estimates. We developed a new likelihood method, GUS-LD, to estimate pairwise linkage disequilibrium using low coverage sequencing data that accounts for under-called heterozygous genotypes. Our findings show that accurate estimates were obtained using GUS-LD on low coverage sequencing data, whereas underestimation of linkage disequilibrium results if no adjustment is made for under-called heterozygotes.

Genotyping-by-sequencing (GBS) is becoming an attractive alternative to array-based methods for genotyping individuals for a large number of single nucleotide polymorphisms (SNPs). Costs can be lowered by reducing the mean sequencing depth, but this results in genotype calls of lower quality. A common analysis strategy is to filter SNPs to just those with sufficient depth, thereby greatly reducing the number of SNPs available. We investigate methods for estimating relatedness using GBS data, including results of low depth, using theoretical calculation, simulation and application to a real data set. We show that unbiased estimates of relatedness can be obtained by using only those SNPs with genotype calls in both individuals. The expected value of this estimator is independent of the SNP depth in each individual, under a model of genotype calling that includes the special case of the two alleles being read at random. In contrast, the estimator of self-relatedness does depend on the SNP depth, and we provide a modification to provide unbiased estimates of self-relatedness. We refer to these methods of estimation as kinship using GBS with depth adjustment (KGD). The estimators can be calculated using matrix methods, which allow efficient computation. Simulation results were consistent with the methods being unbiased, and suggest that the optimal sequencing depth is around 2–4 for relatedness between individuals and 5–10 for self-relatedness. Application to a real data set revealed that some SNP filtering may still be necessary, for the exclusion of SNPs which did not behave in a Mendelian fashion. A simple graphical method (a ‘fin plot’) is given to illustrate this issue and to guide filtering parameters. We provide a method which gives unbiased estimates of relatedness, based on SNPs assayed by GBS, which accounts for the depth (including zero depth) of the genotype calls. This allows GBS to be applied at read depths which can be chosen to optimise the information obtained. SNPs with excess heterozygosity, often due to (partial) polyploidy or other duplications can be filtered based on a simple graphical method.

Background: Genotyping-by-sequencing (GBS) is becoming an attractive alternative to array-based methods for genotyping individuals for a large number of single nucleotide polymorphisms (SNPs). Costs can be lowered by reducing the mean sequencing depth, but this results in genotype calls of lower quality. A common analysis strategy is to filter SNPs to just those with sufficient depth, thereby greatly reducing the number of SNPs available. We investigate methods for estimating relatedness using GBS data, including results of low depth, using theoretical calculation, simulation and application to a real data set. Results: We show that unbiased estimates of relatedness can be obtained by using only those SNPs with genotype calls in both individuals. The expected value of this estimator is independent of the SNP depth in each individual, under a model of genotype calling that includes the special case of the two alleles being read at random. In contrast, the estimator of self-relatedness does depend on the SNP depth, and we provide a modification to provide unbiased estimates of self-relatedness. We refer to these methods of estimation as kinship using GBS with depth adjustment (KGD). The estimators can be calculated using matrix methods, which allow efficient computation. Simulation results were consistent with the methods being unbiased, and suggest that the optimal sequencing depth is around 2-4 for relatedness between individuals and 5-10 for self-relatedness. Application to a real data set revealed that some SNP filtering may still be necessary, for the exclusion of SNPs which did not behave in a Mendelian fashion. A simple graphical method (a ‘fin plot’) is given to illustrate this issue and to guide filtering parameters. Conclusion: We provide a method which gives unbiased estimates of relatedness, based on SNPs assayed by GBS, which accounts for the depth (including zero depth) of the genotype calls. This allows GBS to be applied at read depths which can be chosen to optimise the information obtained. SNPs with excess heterozygosity, often due to (partial) polyploidy or other duplications can be filtered based on a simple graphical method.