M. Nagase
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
M. Nagase has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
H. Namatsu
NTT Basic Research Laboratories, 3-1 Morinosato-Wakamiya, Atsugi, Kanagawa 243-0198, Japan
2 shared publicationsA. Fujiwara
NTT Basic Research Laboratories, 3-1 Morinosato-Wakamiya, Atsugi, Kanagawa 243-0198, Japan
1 shared publicationH Kageshima
NTT Corp, NTT, Basic Res Labs, Kanagawa 2430198, Japan
1 shared publicationH. Tamagawa
1 shared publication- Hiroki Hibino
School of Science and Technology, Kwansei Gakuin University, 2-1 Gakuen, Sanda, Hyogo, 669-1337, Japan
1 shared publication - Hiroshi Yamaguchi
NTT Basic Research Laboratories, NTT Corporation, Atsugi, Kanagawa 243-0198, Japan
1 shared publication
Latest Publications
- 1 September 2015
- Published by Elsevier in European Journal of Cancer
- Vol. 51, S389-S390
2168 Predictive biomarker analysis of early tumor shrinkage induced by FOLFIRI+Bev for patients with metastatic colorectal cancer in WJOG4407G study
- 1 September 2015
- Published by Elsevier in European Journal of Cancer
- Vol. 51, S389-S390
2168 Predictive biomarker analysis of early tumor shrinkage induced by FOLFIRI+Bev for patients with metastatic colorectal cancer in WJOG4407G study
- 7 October 2009
- Published by IOP Publishing in Nanotechnology
- Vol. 20 (44) , 445704
Local conductance measurements of double-layer graphene on SiC substrate
The microscopic structural and electrical properties of few-layer graphene grown on an SiC substrate were characterized by low-energy electron microscopy, transmission electron microscopy and scanning probe microscopy measurements of local conductance. The double-layer graphene sheet was confirmed to be continuous across the atomic steps on the buried SiC substrate surface, and the measured local conductance was clearly modified in the vicinity of the steps. The conductance decreased ( slightly increased) at the lower ( upper) side of the steps, suggesting deformation-induced strain is the origin of the conductance modification. From the contact force dependence of the conductance images, the effective contact areas for both nanogap-probe and point-probe measurements were estimated.
- 7 October 2009
- Published by IOP Publishing in Nanotechnology
- Vol. 20 (44) , 445704
Local conductance measurements of double-layer graphene on SiC substrate
The microscopic structural and electrical properties of few-layer graphene grown on an SiC substrate were characterized by low-energy electron microscopy, transmission electron microscopy and scanning probe microscopy measurements of local conductance. The double-layer graphene sheet was confirmed to be continuous across the atomic steps on the buried SiC substrate surface, and the measured local conductance was clearly modified in the vicinity of the steps. The conductance decreased ( slightly increased) at the lower ( upper) side of the steps, suggesting deformation-induced strain is the origin of the conductance modification. From the contact force dependence of the conductance images, the effective contact areas for both nanogap-probe and point-probe measurements were estimated.
- 6 December 2001
- Published by Elsevier in Applied Surface Science
- Vol. 190 (1-4) , 144-150
Single-electron devices formed by pattern-dependent oxidation: microscopic structural evaluation
- 6 December 2001
- Published by Elsevier in Applied Surface Science
- Vol. 190 (1-4) , 144-150
Single-electron devices formed by pattern-dependent oxidation: microscopic structural evaluation
- 1 January 1998
- Published by AIP Publishing
Nanometrology using scanning probe microscopy and its application to resist patterns
A new metrological method for critical dimension measurement of nano-structures had been developed. Two critical dimensions of a fabricated pattern—the width and the radius of an edge—were calculated from the height dependence of the apparent width measured by scanning probe microscopy. The feasibility of this method was confirmed by measuring sub-100 nm resist patterns. The modeled shape of ZEP resist patterns, fabricated by electron beam lithography, was presented along with the measured dimensions (width and radius). The distance accuracy and repeatability of the method were investigated for Si and resist patterns and were found to be good enough for nanometrology.
- 1 January 1998
- Published by AIP Publishing
Nanometrology using scanning probe microscopy and its application to resist patterns
A new metrological method for critical dimension measurement of nano-structures had been developed. Two critical dimensions of a fabricated pattern—the width and the radius of an edge—were calculated from the height dependence of the apparent width measured by scanning probe microscopy. The feasibility of this method was confirmed by measuring sub-100 nm resist patterns. The modeled shape of ZEP resist patterns, fabricated by electron beam lithography, was presented along with the measured dimensions (width and radius). The distance accuracy and repeatability of the method were investigated for Si and resist patterns and were found to be good enough for nanometrology.