T. Schwarzl
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
T. Schwarzl has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Gunther Springholz
Institut für Halbleiter‐Und Festkörperphysik Johannes Kepler Universität Linz Austria
3 shared publications E. Kaufmann
Institut für Halbleiter- und Festkörperphysik, Johannes Kepler Universität Linz, Altenbergerstrasse 69, A-4040 Linz, Austria
2 shared publications- Wolfgang Heiss
Institute of Materials for Electronics and Energy Technology (i‐MEET) Friedrich‐Alexander‐Universität Erlangen‐Nürnberg Erlangen Germany
2 shared publications A. Raab
Institut für Halbleiter- und Festkörperphysik, Johannes Kepler Universität Linz, Altenbergerstrasse 69, A-4040 Linz, Austria
1 shared publicationG. Bauer
OundExperimentalphysik I, Universität Bayreuth, Universitätsstrasse 30, D‐95447 Bayreuth, Germany
1 shared publicationH. Krenn
Institut für Experimentalphysik, Karl-Franzens-Universität Graz, Universitätsplatz 5, A-8010 Graz, Austria
1 shared publication
Latest Publications
- 23 October 2008
- Published by American Physical Society (APS) in Physical Review B
- Vol. 78 (16) , 165320
Temperature-dependent midinfrared photoluminescence of epitaxial PbTe/CdTe quantum dots and calculation of the corresponding transition energy
We present the temperature dependence of continuous-wave midinfrared photoluminescence of PbTe quantum dots in a CdTe matrix. The quantum dots are formed by epitaxial precipitation of a two-dimensional PbTe layer upon thermal annealing. A strong shift of the emission to longer wavelengths with decreasing temperature is found. This shift is not only caused by the strong temperature dependence of the band gap of PbTe but also by the strain in the dot as well as by the change in quantization energies, both being temperature dependent due to the thermal-expansion mismatch between PbTe and CdTe, and via the effective masses of PbTe. At low temperatures we observed an increase in the emission intensity with rising temperature, depending on dot size. This is attributed to the presence of a dark ground state, as was also observed for lead salt nanocrystals. The influence of the excitation power on the emission spectra at various temperatures indicates carrier redistribution between the dots. Furthermore, an analytical calculation of the ground-state transition energy in the dots is performed using a spherical dot shape, and including the temperature-dependent strain in the dots and the matrix as well as the temperature dependence of the effective masses of PbTe. From these model calculations, a good agreement to the experimental data is obtained over the whole temperature range from 20 to 300 K.
- 23 October 2008
- Published by American Physical Society (APS) in Physical Review B
- Vol. 78 (16) , 165320
Temperature-dependent midinfrared photoluminescence of epitaxial PbTe/CdTe quantum dots and calculation of the corresponding transition energy
We present the temperature dependence of continuous-wave midinfrared photoluminescence of PbTe quantum dots in a CdTe matrix. The quantum dots are formed by epitaxial precipitation of a two-dimensional PbTe layer upon thermal annealing. A strong shift of the emission to longer wavelengths with decreasing temperature is found. This shift is not only caused by the strong temperature dependence of the band gap of PbTe but also by the strain in the dot as well as by the change in quantization energies, both being temperature dependent due to the thermal-expansion mismatch between PbTe and CdTe, and via the effective masses of PbTe. At low temperatures we observed an increase in the emission intensity with rising temperature, depending on dot size. This is attributed to the presence of a dark ground state, as was also observed for lead salt nanocrystals. The influence of the excitation power on the emission spectra at various temperatures indicates carrier redistribution between the dots. Furthermore, an analytical calculation of the ground-state transition energy in the dots is performed using a spherical dot shape, and including the temperature-dependent strain in the dots and the matrix as well as the temperature dependence of the effective masses of PbTe. From these model calculations, a good agreement to the experimental data is obtained over the whole temperature range from 20 to 300 K.
- 4 May 2007
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 893 (1) , 1135
Emission Properties of 6.7 Micron Vertical-Emitting Microcavity Lasers Operating in Continuous-Wave Mode
The emission properties of lead salt continuous‐wave (cw) vertical‐cavity surface‐emitting lasers for the mid‐infrared are presented. The structures, based on high‐finesse microcavities containing PbSe as active medium, show optically pumped cw laser emission up to temperatures of 100 K at a long wavelength of 6.7 μm. Stimulated emission with a very narrow beam divergence below 1° and a large temperature tuning range of 70 nm is found. The measured line width of the laser emission is only 0.6 nm limited by the spectrometer resolution with a strong narrowing with respect to the line width of the sub‐threshold signal. The sharp laser threshold is at a low pump power of 67 W/cm2 and the observed cw output power amounts up to 1.2 mW at 85 K with a conversion efficiency of 0.5 %.
- 4 May 2007
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 893 (1) , 1135
Emission Properties of 6.7 Micron Vertical-Emitting Microcavity Lasers Operating in Continuous-Wave Mode
The emission properties of lead salt continuous‐wave (cw) vertical‐cavity surface‐emitting lasers for the mid‐infrared are presented. The structures, based on high‐finesse microcavities containing PbSe as active medium, show optically pumped cw laser emission up to temperatures of 100 K at a long wavelength of 6.7 μm. Stimulated emission with a very narrow beam divergence below 1° and a large temperature tuning range of 70 nm is found. The measured line width of the laser emission is only 0.6 nm limited by the spectrometer resolution with a strong narrowing with respect to the line width of the sub‐threshold signal. The sharp laser threshold is at a low pump power of 67 W/cm2 and the observed cw output power amounts up to 1.2 mW at 85 K with a conversion efficiency of 0.5 %.
- 21 June 2002
- Published by American Physical Society (APS) in Physical Review B
- Vol. 65 (24) , 245321
Midinfrared absorption ofquantum dot superlattices in IV-VI microcavitiesThe midinfrared absorption of highly ordered self-assembled quantum dot superlattices is investigated. A different approach is used for quantitative determination of the absorption spectrum of the dot superlattice by inserting it into a high-finesse microcavity structure with a small mode spacing and Bragg mirrors. For such microcavities, we show a linear relation between the width of each cavity resonance and the extinction coefficient at the resonance energy. Thus, the absorption spectrum is experimentally determined from the resonance widths. It reveals a narrow peak arising from the quantum dots and a step from the two-dimensional wetting layers. The peak absorption coefficient of the dot ensemble amounts to and is similar to that of the wetting layers. We also present calculations of the dispersion of the absorption coefficient based on model dielectric functions of quantum dots and wetting layers. From a fit to the experimental absorption spectrum, we deduce interband transition energies as well as corresponding oscillator strengths and level broadenings. The broadening of the dot transition due to dot size fluctuations of the large quantum dot ensemble is only 8.7 meV, confirming the exceptionally high dot size uniformity in the PbSe quantum dot superlattice.- 21 June 2002
- Published by American Physical Society (APS) in Physical Review B
- Vol. 65 (24) , 245321
Midinfrared absorption ofquantum dot superlattices in IV-VI microcavitiesThe midinfrared absorption of highly ordered self-assembled quantum dot superlattices is investigated. A different approach is used for quantitative determination of the absorption spectrum of the dot superlattice by inserting it into a high-finesse microcavity structure with a small mode spacing and Bragg mirrors. For such microcavities, we show a linear relation between the width of each cavity resonance and the extinction coefficient at the resonance energy. Thus, the absorption spectrum is experimentally determined from the resonance widths. It reveals a narrow peak arising from the quantum dots and a step from the two-dimensional wetting layers. The peak absorption coefficient of the dot ensemble amounts to and is similar to that of the wetting layers. We also present calculations of the dispersion of the absorption coefficient based on model dielectric functions of quantum dots and wetting layers. From a fit to the experimental absorption spectrum, we deduce interband transition energies as well as corresponding oscillator strengths and level broadenings. The broadening of the dot transition due to dot size fluctuations of the large quantum dot ensemble is only 8.7 meV, confirming the exceptionally high dot size uniformity in the PbSe quantum dot superlattice.