Toru Shinmei
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Toru Shinmei has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
T. Irifune
Geodynamics Research Center, Ehime University, 2-5 Bunkyo-cho, Matsuyama 790-8577, Japan
2 shared publications- A. Bianconi
Rome International Center for Materials Science Superstripes (RICMASS), Via dei Sabelli 119A, 00185 Roma, Italy
1 shared publication A. Nozawa
Japan Synchrotron Radiation Research Institute, Hyogo, Japan
1 shared publicationA. S. Caporale
Dipartimento di Fisica, Universitá di Roma “La Sapienza,” P.le Aldo Moro 2, 00185 Roma, Italy
1 shared publication- Anna Krzton-Maziopa
Faculty of Chemistry, Warsaw University of Technology, Noakowskiego 3, 00-664 Warsaw, Poland
1 shared publication - Atsuki Yokota
Department of Mechanical Engineering, Ehime University, 3-Bunkyocho, Matsuyama 790-0826, Japan
1 shared publication
Latest Publications
- Open Access
Formation Process of Long-Period Stacking-Ordered Structures in Mg97Zn1Y2 Alloy Comprising HCP and Cubic Phases Fabricated by High-Pressure High-Temperature Annealing
As-cast Mg97Zn1Y2 alloy consists of α-Mg matrix and 18R-type long-period stacking-ordered (LPSO) structures. We observed that the alloy undergoes a phase transformation to D03 superlattices and α-Mg matrix due to high-pressure high-temperature (HPHT) annealing at 3 GPa and above 773 K. Further, the alloy recovered after HPHT annealing, consisting of the α-Mg matrix and D03 superlattices, transformed into 18R-type LPSO structures during further annealing at ambient pressure. An fcc structure with a lattice parameter of 1.42 nm, which was twice that of D03, emerged in both the collapse process of the 18R-type LPSO structure under high-pressure, and the formation process of the 18R-type LPSO structure at ambient pressure. This fcc phase was an intermediate structure between 18R-type LPSO and D03. From the electron diffraction results, it is considered that 18R-type LPSO is continuously present with 2H including stacking faults, which almost corresponded with previous studies.
Open AccessFormation Process of Long-Period Stacking-Ordered Structures in Mg97Zn1Y2 Alloy Comprising HCP and Cubic Phases Fabricated by High-Pressure High-Temperature Annealing
As-cast Mg97Zn1Y2 alloy consists of α-Mg matrix and 18R-type long-period stacking-ordered (LPSO) structures. We observed that the alloy undergoes a phase transformation to D03 superlattices and α-Mg matrix due to high-pressure high-temperature (HPHT) annealing at 3 GPa and above 773 K. Further, the alloy recovered after HPHT annealing, consisting of the α-Mg matrix and D03 superlattices, transformed into 18R-type LPSO structures during further annealing at ambient pressure. An fcc structure with a lattice parameter of 1.42 nm, which was twice that of D03, emerged in both the collapse process of the 18R-type LPSO structure under high-pressure, and the formation process of the 18R-type LPSO structure at ambient pressure. This fcc phase was an intermediate structure between 18R-type LPSO and D03. From the electron diffraction results, it is considered that 18R-type LPSO is continuously present with 2H including stacking faults, which almost corresponded with previous studies.
- 12 April 2021
- Published by Wiley in ChemistrySelect
- Vol. 6 (14) , 3399-3402
Crystallization of Diamond from Graphene Oxide Nanosheets by a High Temperature and High Pressure Method
Herein we report a high temperature and high pressure driven crystallization of two‐dimensional graphene oxide (GO) nanosheets to three‐dimensional diamond. The successful phase transformation was confirmed using X‐ray diffraction (XRD), Raman spectroscopy, and X‐ray photoelectron spectroscopy (XPS). The phase transition platform will available to utilize for a wide variety of diamond doping employing, for example, nitrogen or other light elements, in which the correspondingly doped GO is used as the starting material.
- 12 April 2021
- Published by Wiley in ChemistrySelect
- Vol. 6 (14) , 3399-3402
Crystallization of Diamond from Graphene Oxide Nanosheets by a High Temperature and High Pressure Method
Herein we report a high temperature and high pressure driven crystallization of two‐dimensional graphene oxide (GO) nanosheets to three‐dimensional diamond. The successful phase transformation was confirmed using X‐ray diffraction (XRD), Raman spectroscopy, and X‐ray photoelectron spectroscopy (XPS). The phase transition platform will available to utilize for a wide variety of diamond doping employing, for example, nitrogen or other light elements, in which the correspondingly doped GO is used as the starting material.
- 12 November 2013
- Published by American Physical Society (APS) in Physical Review B
- Vol. 88 (18) , 180506
Interplay of electronic and lattice degrees of freedom inFeSesuperconductors under pressureThe local structure and electronic properties of RbFeSe are investigated by means of site selective polarized x-ray absorption spectroscopy at the iron and selenium edges as a function of pressure. A combination of dispersive geometry and a nanodiamond anvil pressure cell has permitted us to reveal a steplike decrease in the Fe-Se bond distance at GPa and, at the same pressure, the local atomic structure of RbFeSe becomes more ordered. Thus, at this pressure the phase separation might be suppressed, which has a large influence on the electronic structure, as evidenced by changes in the Fe -edge prepeak. The present results provide compelling evidence that the reemerging superconductivity in FeSe is closely related to the transition to a locally more ordered state, which has a different electronic structure.- 12 November 2013
- Published by American Physical Society (APS) in Physical Review B
- Vol. 88 (18) , 180506
Interplay of electronic and lattice degrees of freedom inFeSesuperconductors under pressureThe local structure and electronic properties of RbFeSe are investigated by means of site selective polarized x-ray absorption spectroscopy at the iron and selenium edges as a function of pressure. A combination of dispersive geometry and a nanodiamond anvil pressure cell has permitted us to reveal a steplike decrease in the Fe-Se bond distance at GPa and, at the same pressure, the local atomic structure of RbFeSe becomes more ordered. Thus, at this pressure the phase separation might be suppressed, which has a large influence on the electronic structure, as evidenced by changes in the Fe -edge prepeak. The present results provide compelling evidence that the reemerging superconductivity in FeSe is closely related to the transition to a locally more ordered state, which has a different electronic structure.- 1 September 2008
- Published by Taylor & Francis in High Pressure Research
- Vol. 28 (3) , 363-373
Phase transition and compression behavior of phase D up to 46 GPa using multi-anvil apparatus with sintered diamond anvils
A thermal equation of state of phase D with a Mg1.02Si1.73H3.03O6 composition has been derived from in situ X-ray diffraction experiments using synchrotron radiation and multianvil apparatus with sintered diamond anvils at pressures up to 46 GPa and temperatures up to 1300 K. The refined unit-cell parameters at ambient conditions are: a=4.7643(7) Å, c=4.346(2) Å, and V 0=85.43(4)Å3 and the zero-pressure density of ρ0=3.357(2) g/cm3 (Z=1; formula weight=172.70 g/mol). At room temperature, the unit-cell parameters show anisotropic compression behavior up to ∼35 GPa, where the c-axis is more compressible than the a-axis. Above 35 GPa, however, the c-axis becomes less compressible than the a-axis. This change of the axial compression behavior tends to start at higher pressure with increasing temperature. The change of the linear compressibilities may be related to the hydrogen-bond symmetrization in phase D, as suggested by recent first-principles calculations.
- 1 September 2008
- Published by Taylor & Francis in High Pressure Research
- Vol. 28 (3) , 363-373
Phase transition and compression behavior of phase D up to 46 GPa using multi-anvil apparatus with sintered diamond anvils
A thermal equation of state of phase D with a Mg1.02Si1.73H3.03O6 composition has been derived from in situ X-ray diffraction experiments using synchrotron radiation and multianvil apparatus with sintered diamond anvils at pressures up to 46 GPa and temperatures up to 1300 K. The refined unit-cell parameters at ambient conditions are: a=4.7643(7) Å, c=4.346(2) Å, and V 0=85.43(4)Å3 and the zero-pressure density of ρ0=3.357(2) g/cm3 (Z=1; formula weight=172.70 g/mol). At room temperature, the unit-cell parameters show anisotropic compression behavior up to ∼35 GPa, where the c-axis is more compressible than the a-axis. Above 35 GPa, however, the c-axis becomes less compressible than the a-axis. This change of the axial compression behavior tends to start at higher pressure with increasing temperature. The change of the linear compressibilities may be related to the hydrogen-bond symmetrization in phase D, as suggested by recent first-principles calculations.
- 15 November 2005
- Published by Springer Nature in Physics and Chemistry of Minerals
- Vol. 32 (8-9) , 594-602
High-temperature and high-pressure equation of state for the hexagonal phase in the system NaAlSiO4 – MgAl2O4
- 15 November 2005
- Published by Springer Nature in Physics and Chemistry of Minerals
- Vol. 32 (8-9) , 594-602
High-temperature and high-pressure equation of state for the hexagonal phase in the system NaAlSiO4 – MgAl2O4