Z. L. Liau
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Z. L. Liau has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
G. W. Turner
Massachusetts Institute of Technology 1 Lincoln Laboratory Lexington, Massachusetts 02420-9108, USA
2 shared publicationsC.C. Cook
1 shared publicationG.W. Turner
1 shared publication- Gang Chen
Department of Mechanical Engineering, Massachusetts Institute of Technology, Cambridge, MA, USA
1 shared publication H. K. Choi
Lincoln Laboratory, Massachusetts Institute of Technology, 244 Wood St., Lexington, Massachusetts 02173-9108
1 shared publicationH.K. Choi
1 shared publication
Latest Publications
- 14 July 2008
- Published by AIP Publishing in Applied Physics Letters
- Vol. 93 (2) , 021917
Reduction of thermal conductivity in wafer-bonded silicon
Blocks of silicon up to thick have been formed by directly bonding stacks of thin wafer chips. These stacks showed significant reductions in the thermal conductivity in the bonding direction. In each sample, the wafer chips were obtained by polishing a commercial wafer to as thin as , followed by dicing. Stacks whose starting wafers were patterned with shallow dots showed greater reductions in thermal conductivity. Diluted-HF treatment of wafer chips prior to bonding led to the largest reduction of the effective thermal conductivity, by approximately a factor of 50. Theoretical modeling based on restricted conduction through the contacting dots and some conduction across the planar nanometer air gaps yielded good agreement for samples fabricated without the HF treatment.- 14 July 2008
- Published by AIP Publishing in Applied Physics Letters
- Vol. 93 (2) , 021917
Reduction of thermal conductivity in wafer-bonded silicon
Blocks of silicon up to thick have been formed by directly bonding stacks of thin wafer chips. These stacks showed significant reductions in the thermal conductivity in the bonding direction. In each sample, the wafer chips were obtained by polishing a commercial wafer to as thin as , followed by dicing. Stacks whose starting wafers were patterned with shallow dots showed greater reductions in thermal conductivity. Diluted-HF treatment of wafer chips prior to bonding led to the largest reduction of the effective thermal conductivity, by approximately a factor of 50. Theoretical modeling based on restricted conduction through the contacting dots and some conduction across the planar nanometer air gaps yielded good agreement for samples fabricated without the HF treatment.- 15 October 2003
- Published by Elsevier in Materials Science and Engineering: R: Reports
- Vol. 42 (2) , 41-63
Mass transport: semiconductor microstructure fabrication by surface energy
- 15 October 2003
- Published by Elsevier in Materials Science and Engineering: R: Reports
- Vol. 42 (2) , 41-63
Mass transport: semiconductor microstructure fabrication by surface energy
- 1 October 1999
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 11 (10) , 1223-1225
High-power high-brightness GaInAsSb-AlGaAsSb tapered laser arrays with anamorphic collimating lenses emitting at 2.05 /spl mu/m
Linear arrays of GaInAsSb-AlGaAsSb tapered MQW lasers emitting at 2.05 μm have been fabricated and operated with 1-ms current pulses. Peak power over 3 W was obtained for nine-element arrays at 18.5 A. Up to 1.7-W peak power, within a 65-mrad full-angle cone, was measured in the far field using anamorphic collimating lens arrays, fabricated by mass transport in GaP.
- 1 October 1999
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 11 (10) , 1223-1225
High-power high-brightness GaInAsSb-AlGaAsSb tapered laser arrays with anamorphic collimating lenses emitting at 2.05 /spl mu/m
Linear arrays of GaInAsSb-AlGaAsSb tapered MQW lasers emitting at 2.05 μm have been fabricated and operated with 1-ms current pulses. Peak power over 3 W was obtained for nine-element arrays at 18.5 A. Up to 1.7-W peak power, within a 65-mrad full-angle cone, was measured in the far field using anamorphic collimating lens arrays, fabricated by mass transport in GaP.
- 31 October 1994
- Published by AIP Publishing in Applied Physics Letters
- Vol. 65 (18) , 2251-2253
3.9-μm InAsSb/AlAsSb double-heterostructure diode lasers with high output power and improved temperature characteristics
Double‐heterostructure diode lasers emitting at ∼3.9 μm have exhibited pulsed operation at temperatures up to 170 K and cw operation up to 105 K, with single‐ended cw output power of 30 mW at 70 K. The laser structure, grown on GaSb substrates by molecular‐beam epitaxy, has an InAsSb active layer and AlAsSb cladding layers. The lowest pulsed threshold current density is 36 A/cm2 obtained at 60 K. The characteristic temperature is 20 K over the entire temperature range.
- 31 October 1994
- Published by AIP Publishing in Applied Physics Letters
- Vol. 65 (18) , 2251-2253
3.9-μm InAsSb/AlAsSb double-heterostructure diode lasers with high output power and improved temperature characteristics
Double‐heterostructure diode lasers emitting at ∼3.9 μm have exhibited pulsed operation at temperatures up to 170 K and cw operation up to 105 K, with single‐ended cw output power of 30 mW at 70 K. The laser structure, grown on GaSb substrates by molecular‐beam epitaxy, has an InAsSb active layer and AlAsSb cladding layers. The lowest pulsed threshold current density is 36 A/cm2 obtained at 60 K. The characteristic temperature is 20 K over the entire temperature range.