Thierry Corman
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Thierry Corman has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Göran Stemme
Department of Micro and Nanosystems, KTH Royal Institute of Technology, Stockholm, Sweden
1 shared publication Kjell Norén
Department of Signals, Sensors and Systems, Royal Institute of Technology, SE-100 44 Stockholm, Sweden
1 shared publication- Peter Enoksson
Chalmers University of Technology, Gothenburg, Sweden
1 shared publication
Latest Publications
- 1 February 2000
- Published by IOP Publishing in Measurement Science and Technology
- Vol. 11 (3) , 205-211
A low-pressure encapsulated resonant fluid density sensor with feedback control electronics
In this paper we present a fully low-pressure encapsulated and closed-loop operated resonant fluid density sensor. The device consists of a tube in silicon, which is vibrating in a selected balanced torsion mode. The resonance frequency changes with the density of the fluid in the tube due to the change of the inertial mass of the vibrating system. The sensor is fabricated and encapsulated at wafer level using silicon micromachining techniques. The encapsulation is performed by anodically bonding the silicon densitometer in vacuum between two glass lids with metal electrodes for electrostatic excitation and capacitive detection. The sample volume is only 0.035 ml and the size of the encapsulated device is 14 mm × 23 mm × 1.85 mm. The measurements were performed using a novel excitation and detection technique based on discontinuous, `burst' excitation. This principle enabled us to eliminate the electrical crosstalk between excitation and detection. The electrodes could be placed on top of the glass lids without using electrical feedthroughs, and a cavity gap of 100 µm could be formed between the recessed glass lid surface and the silicon tube to reduce squeeze-film damping. The closed-loop `burst' technology enabled us to make continuous measurements of fluid densities. The sensor showed high density sensitivities of the order of -200 ppm (kg m-3 )-1 , a high mechanical Q -factor of 3400 for air in the tube and low temperature sensitivities of -29 ppm °C-1 in the range 20-100 °C.
- 1 February 2000
- Published by IOP Publishing in Measurement Science and Technology
- Vol. 11 (3) , 205-211
A low-pressure encapsulated resonant fluid density sensor with feedback control electronics
In this paper we present a fully low-pressure encapsulated and closed-loop operated resonant fluid density sensor. The device consists of a tube in silicon, which is vibrating in a selected balanced torsion mode. The resonance frequency changes with the density of the fluid in the tube due to the change of the inertial mass of the vibrating system. The sensor is fabricated and encapsulated at wafer level using silicon micromachining techniques. The encapsulation is performed by anodically bonding the silicon densitometer in vacuum between two glass lids with metal electrodes for electrostatic excitation and capacitive detection. The sample volume is only 0.035 ml and the size of the encapsulated device is 14 mm × 23 mm × 1.85 mm. The measurements were performed using a novel excitation and detection technique based on discontinuous, `burst' excitation. This principle enabled us to eliminate the electrical crosstalk between excitation and detection. The electrodes could be placed on top of the glass lids without using electrical feedthroughs, and a cavity gap of 100 µm could be formed between the recessed glass lid surface and the silicon tube to reduce squeeze-film damping. The closed-loop `burst' technology enabled us to make continuous measurements of fluid densities. The sensor showed high density sensitivities of the order of -200 ppm (kg m-3 )-1 , a high mechanical Q -factor of 3400 for air in the tube and low temperature sensitivities of -29 ppm °C-1 in the range 20-100 °C.