Stephan Kubowicz
Research Subjects
Stephan Kubowicz has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
Helmuth Möhwald
Max Planck Institute of Colloids and Interfaces, Research Campus Golm, D-14424 Potsdam, Germany
2 shared publicationsJean Daillant
CEA, IRAMIS, LIONS
2 shared publications- Andrew M. Booth
SINTEF Ocean
1 shared publication Christian Blot
CEA, IRAMIS, LIONS, CEA-Saclay, 91191 Gif-sur-Yvette Cedex, France, Surface Physics Division, Saha Institute of Nuclear Physics, 1/AF, Bidhannagar, Kolkata-7000064, India, Chemistry and Physics of Materials Unit, Jawaharlal Nehru Center for Advanced Scientific Research, Jakkur P.O., Bangalore-560064, India, European Synchrotron Radiation Facility, Beamline ID10b, 38043 Grenoble Cedex, France, and Max Planck Institute of Colloids and Interfaces, Research Campus Golm, 14424 Potsdam, Germany
1 shared publication- Jean-Marc Verbavatz
Institut Jacques Monod, Université Paris Cité, CNRS, Paris, France
1 shared publication - Markus Alexander Hartmann
Ludwig Boltzmann Institute of Osteology at the Hanusch Hospital of OEGK and AUVA Trauma Centre Meidling, 1st Medical Department Hanusch Hospital, Vienna, Austria
1 shared publication
Latest Publications
- Open Access
- 1 December 2021
- Published by Elsevier in Marine Pollution Bulletin
- Vol. 173 (Pt B) , 113062
Co-production of future scenarios of policy action plans in a science-policy-industry interface – The case of microfibre pollution from waste water treatment plants in Norway
- 1 December 2021
- Published by Elsevier in Marine Pollution Bulletin
- Vol. 173 (Pt B) , 113062
Open AccessCo-production of future scenarios of policy action plans in a science-policy-industry interface – The case of microfibre pollution from waste water treatment plants in Norway
- 19 November 2009
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 26 (3) , 1642-1648
Mixed-Monolayer-Protected Gold Nanoparticles for Emulsion Stabilization
Nanometer-sized gold nanoparticles have been prepared and surface-modified in order to stabilize alkane-in-water emulsions. A mixed hexane−undecanol ligand layer at the surface of the nanoparticles allowed us to tune their wettability and thus the adsorption at the oil−water interface. Oil droplets of the stable emulsions have been evidenced by confocal fluorescence microscopy, freeze-fracture transmission electron microscopy, and dynamic light scattering. Prepared emulsions were stable during performed cooling−heating cycles, in which the temperature stability of the emulsions has been studied by means of dynamic light scattering. The interfacial structure of the oil droplets was investigated by small-angle X-ray scattering. The obtained area per nanoparticle at the oil droplet interface was 30 nm2. The investigation of the nanoparticle adsorption at the curved interface of the emulsion droplets is in agreement with our previous study at a planar oil−water interface, in which the nanoparticles started to interact with each other at about the same area per particle.
- 19 November 2009
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 26 (3) , 1642-1648
Mixed-Monolayer-Protected Gold Nanoparticles for Emulsion Stabilization
Nanometer-sized gold nanoparticles have been prepared and surface-modified in order to stabilize alkane-in-water emulsions. A mixed hexane−undecanol ligand layer at the surface of the nanoparticles allowed us to tune their wettability and thus the adsorption at the oil−water interface. Oil droplets of the stable emulsions have been evidenced by confocal fluorescence microscopy, freeze-fracture transmission electron microscopy, and dynamic light scattering. Prepared emulsions were stable during performed cooling−heating cycles, in which the temperature stability of the emulsions has been studied by means of dynamic light scattering. The interfacial structure of the oil droplets was investigated by small-angle X-ray scattering. The obtained area per nanoparticle at the oil droplet interface was 30 nm2. The investigation of the nanoparticle adsorption at the curved interface of the emulsion droplets is in agreement with our previous study at a planar oil−water interface, in which the nanoparticles started to interact with each other at about the same area per particle.
- 29 December 2008
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 25 (2) , 952-958
Gold Nanoparticles at the Liquid−Liquid Interface: X-ray Study and Monte Carlo Simulation
The behavior of mixed-ligand-coated gold nanoparticles at a liquid−liquid interface during compression has been investigated. The system was characterized by measuring pressure−area isotherms and by simultaneously performing in situ X-ray studies. Additionally, Monte Carlo (MC) simulations were carried out in order to interpret the experimental findings. With this dual approach it was possible to characterize and identify the different stages of compression and understand what happens microscopically: first, a compression purely in-plane, and, second, the formation of a second layer when the in-plane pressure pushes the particles out of the plane. The first stage is accompanied by the emergence of an in-plane correlation peak in the scattering signal and a strong increase of the pressure in the isotherm. The second stage is characterized by the weakening of the correlation peak and a slower increase in pressure.
- 29 December 2008
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 25 (2) , 952-958
Gold Nanoparticles at the Liquid−Liquid Interface: X-ray Study and Monte Carlo Simulation
The behavior of mixed-ligand-coated gold nanoparticles at a liquid−liquid interface during compression has been investigated. The system was characterized by measuring pressure−area isotherms and by simultaneously performing in situ X-ray studies. Additionally, Monte Carlo (MC) simulations were carried out in order to interpret the experimental findings. With this dual approach it was possible to characterize and identify the different stages of compression and understand what happens microscopically: first, a compression purely in-plane, and, second, the formation of a second layer when the in-plane pressure pushes the particles out of the plane. The first stage is accompanied by the emergence of an in-plane correlation peak in the scattering signal and a strong increase of the pressure in the isotherm. The second stage is characterized by the weakening of the correlation peak and a slower increase in pressure.