Yong-Duan Song
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yong-Duan Song has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
Qi Song
2 shared publicationsFang Cao
State Key Laboratory of Rail Traffic Control and Safety, Beijing JiaoTong University, Beijing 100044, China
1 shared publication- Fengqin Xia
College of Automation, Chongqing University, 47913 Chongqing, Chongqing China
1 shared publication - Hamid Reza Karimi
Politecnico di Milano
1 shared publication - Ling Zhao
School of Information Science and Engineering, Chongqing Jiaotong University, Chongqing 400074, China
1 shared publication Ling-Ling Fan
1 shared publication
Latest Publications
- 18 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Fuzzy Systems
- Vol. 26 (6) , 3755-3769
$\mathcal {L}_{2}$ – $\mathcal {L}_{\infty }$ Output Feedback Controller Design for Fuzzy Systems Over Switching ParametersThis paper focuses on the problem of $\mathcal{L}_{2}$-$\mathcal{L}_{\infty}$ dynamic output feedback controller design for nonlinear switched systems with nonlinear perturbations in the Takagi-Sugeno fuzzy framework. First, the average dwell time approach is used to stabilize a nonlinear switched system exponentially under an arbitrary switching law. Then, based on the technique of piecewise Lyapunov functions, a fuzzy-rule-dependent dynamic output feedback controller is designed to ensure that the overall closed-loop system is exponentially stable with a weighted $\mathcal{L}_{2}$-$\mathcal{L}_{\infty}$ performance level $\left(\gamma,\alpha \right)$. The solvability condition for the desired dynamic output feedback controller is derived using a linearization technique. It is shown that the controller parameters can be obtained as solutions to a set of strict linear matrix inequalities that are numerically solvable with available standard software. Finally, two simulation examples illustrate effectiveness of the developed technique, including cognitive-radio systems.- 18 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Fuzzy Systems
- Vol. 26 (6) , 3755-3769
$\mathcal {L}_{2}$ – $\mathcal {L}_{\infty }$ Output Feedback Controller Design for Fuzzy Systems Over Switching ParametersThis paper focuses on the problem of $\mathcal{L}_{2}$-$\mathcal{L}_{\infty}$ dynamic output feedback controller design for nonlinear switched systems with nonlinear perturbations in the Takagi-Sugeno fuzzy framework. First, the average dwell time approach is used to stabilize a nonlinear switched system exponentially under an arbitrary switching law. Then, based on the technique of piecewise Lyapunov functions, a fuzzy-rule-dependent dynamic output feedback controller is designed to ensure that the overall closed-loop system is exponentially stable with a weighted $\mathcal{L}_{2}$-$\mathcal{L}_{\infty}$ performance level $\left(\gamma,\alpha \right)$. The solvability condition for the desired dynamic output feedback controller is derived using a linearization technique. It is shown that the controller parameters can be obtained as solutions to a set of strict linear matrix inequalities that are numerically solvable with available standard software. Finally, two simulation examples illustrate effectiveness of the developed technique, including cognitive-radio systems.- Open Access
- 18 November 2013
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2013, 1-11
Peak Power Demand and Energy Consumption Reduction Strategies for Trains under Moving Block Signalling System
In the moving block signalling (MBS) system where the tracking target point of the following train is moving forward with its leading train, overload of the substations occurs when a dense queue of trains starts (or restarts) in very close distance interval. This is the peak power demand problem. Several methods have been attempted in the literature to deal with this problem through changing train’s operation strategies. However, most existing approaches reduce the service quality. In this paper, two novel approaches—“Service Headway Braking” (SHB) and “Extending Stopping Distance Interval” (ESDI)—are proposed according to available and unavailable extra station dwell times, respectively. In these two methods, the restarting times of the trains are staggered and traction periods are reduced, which lead to the reduction of peak power demand and energy consumption. Energy efficient control switching points are seen as the decision parameters. Nonlinear programming method is used to model the process. Simulation results indicate that, compared with ARL, peak power demands are reduced by 40% and 20% by applying SHB and ESDI without any arrival time delay, respectively. At the same time, energy consumptions are also reduced by 77% and 50% by applying SHB and ESDI, respectively.
- 18 November 2013
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2013, 1-11
Open AccessPeak Power Demand and Energy Consumption Reduction Strategies for Trains under Moving Block Signalling System
In the moving block signalling (MBS) system where the tracking target point of the following train is moving forward with its leading train, overload of the substations occurs when a dense queue of trains starts (or restarts) in very close distance interval. This is the peak power demand problem. Several methods have been attempted in the literature to deal with this problem through changing train’s operation strategies. However, most existing approaches reduce the service quality. In this paper, two novel approaches—“Service Headway Braking” (SHB) and “Extending Stopping Distance Interval” (ESDI)—are proposed according to available and unavailable extra station dwell times, respectively. In these two methods, the restarting times of the trains are staggered and traction periods are reduced, which lead to the reduction of peak power demand and energy consumption. Energy efficient control switching points are seen as the decision parameters. Nonlinear programming method is used to model the process. Simulation results indicate that, compared with ARL, peak power demands are reduced by 40% and 20% by applying SHB and ESDI without any arrival time delay, respectively. At the same time, energy consumptions are also reduced by 77% and 50% by applying SHB and ESDI, respectively.
- 1 June 2012
- Published by Elsevier in Acta Automatica Sinica
- Vol. 38 (6) , 1033-1040
PI-like Fault-tolerant Control of Nonaffine Systems with Actuator Failures
- 1 June 2012
- Published by Elsevier in Acta Automatica Sinica
- Vol. 38 (6) , 1033-1040
PI-like Fault-tolerant Control of Nonaffine Systems with Actuator Failures
- 1 January 2012
- Published by China Science Publishing & Media Ltd. in Acta Automatica Sinica
- Vol. 38 (6)
PI-like Fault-tolerant Control of Nonaffine Systems with Actuator Failures
- 1 January 2012
- Published by China Science Publishing & Media Ltd. in Acta Automatica Sinica
- Vol. 38 (6)
PI-like Fault-tolerant Control of Nonaffine Systems with Actuator Failures
- 27 June 2011
- Published by Taylor & Francis in Vehicle System Dynamics
- Vol. 49 (9) , 1441-1454
Adaptive backstepping control of train systems with traction/braking dynamics and uncertain resistive forces
Although backstepping control design approach has been widely utilised in many practical systems, little effort has been made in applying this useful method to train systems. The main purpose of this paper is to apply this popular control design technique to speed and position tracking control of high-speed trains. By integrating adaptive control with backstepping control, we develop a control scheme that is able to address not only the traction and braking dynamics ignored in most existing methods, but also the uncertain friction and aerodynamic drag forces arisen from uncertain resistance coefficients. As such, the resultant control algorithms are able to achieve high precision train position and speed tracking under varying operation railway conditions, as validated by theoretical analysis and numerical simulations.
- 27 June 2011
- Published by Taylor & Francis in Vehicle System Dynamics
- Vol. 49 (9) , 1441-1454
Adaptive backstepping control of train systems with traction/braking dynamics and uncertain resistive forces
Although backstepping control design approach has been widely utilised in many practical systems, little effort has been made in applying this useful method to train systems. The main purpose of this paper is to apply this popular control design technique to speed and position tracking control of high-speed trains. By integrating adaptive control with backstepping control, we develop a control scheme that is able to address not only the traction and braking dynamics ignored in most existing methods, but also the uncertain friction and aerodynamic drag forces arisen from uncertain resistance coefficients. As such, the resultant control algorithms are able to achieve high precision train position and speed tracking under varying operation railway conditions, as validated by theoretical analysis and numerical simulations.
- 26 November 2010
- Published by Elsevier in Acta Automatica Sinica
- Vol. 36 (11) , 1620-1625
On Fault-tolerant Control of Dynamic Systems with Actuator Failures and External Disturbances
- 26 November 2010
- Published by Elsevier in Acta Automatica Sinica
- Vol. 36 (11) , 1620-1625
On Fault-tolerant Control of Dynamic Systems with Actuator Failures and External Disturbances
- 20 November 2010
- Published by China Science Publishing & Media Ltd. in Acta Automatica Sinica
- Vol. 36 (11) , 1620-1625
On Fault-tolerant Control of Dynamic Systems with Actuator Failures and External Disturbances
- 20 November 2010
- Published by China Science Publishing & Media Ltd. in Acta Automatica Sinica
- Vol. 36 (11) , 1620-1625
On Fault-tolerant Control of Dynamic Systems with Actuator Failures and External Disturbances