Thomas J. Ahrens
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Thomas J. Ahrens has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
C. Liu
Seismological Laboratory 252-21, California Institute of Technology, Pasadena, California 91125
2 shared publicationsWenbo Yang
Lindhurst Laboratory of Experimental Geophysics, Seismological Laboratory, California Institute of Technology, Pasadena, CA 91125, USA
2 shared publicationsChi Ma
Division of Geological and Planetary Sciences, and
1 shared publicationGeorge Q. Chen
Present address: The Santa Cruz Operations, Inc., 400 Encinal Street, POB 1900, Santa Cruz, CA 95061–1900
1 shared publicationN. S. Brar
University of Dayton Research Institute, Dayton, Ohio 45469-0182
1 shared publicationNatalya Kostandova
Division of Geological and Planetary Sciences, and
1 shared publication
Latest Publications
- 18 August 2009
- Published by National Academy of Sciences in Proceedings of the National Academy of Sciences
- Vol. 106 (33) , 13691-13695
Ultrafast growth of wadsleyite in shock-produced melts and its implications for early solar system impact processes
We observed micrometer-sized grains of wadsleyite, a high-pressure phase of (Mg,Fe) 2 SiO 4, in the recovery products of a shock experiment. We infer these grains crystallized from shock-generated melt over a time interval of <1 μs, the maximum time over which our experiment reached and sustained pressure sufficient to stabilize this phase. This rapid crystal growth rate (≈1 m/s) suggests that, contrary to the conclusions of previous studies of the occurrence of high-pressure phases in shock-melt veins in strongly shocked meteorites, the growth of high-pressure phases from the melt during shock events is not diffusion-controlled. Another process, such as microturbulent transport, must be active in the crystal growth process. This result implies that the times necessary to crystallize the high-pressure phases in shocked meteorites may correspond to shock pressure durations achieved on impacts between objects 1–5 m in diameter and not, as previously inferred, ≈1–5 km in diameter. These results may also provide another pathway for syntheses, via shock recovery, of some high-value, high-pressure phases.
- 18 August 2009
- Published by National Academy of Sciences in Proceedings of the National Academy of Sciences
- Vol. 106 (33) , 13691-13695
Ultrafast growth of wadsleyite in shock-produced melts and its implications for early solar system impact processes
We observed micrometer-sized grains of wadsleyite, a high-pressure phase of (Mg,Fe) 2 SiO 4, in the recovery products of a shock experiment. We infer these grains crystallized from shock-generated melt over a time interval of <1 μs, the maximum time over which our experiment reached and sustained pressure sufficient to stabilize this phase. This rapid crystal growth rate (≈1 m/s) suggests that, contrary to the conclusions of previous studies of the occurrence of high-pressure phases in shock-melt veins in strongly shocked meteorites, the growth of high-pressure phases from the melt during shock events is not diffusion-controlled. Another process, such as microturbulent transport, must be active in the crystal growth process. This result implies that the times necessary to crystallize the high-pressure phases in shocked meteorites may correspond to shock pressure durations achieved on impacts between objects 1–5 m in diameter and not, as previously inferred, ≈1–5 km in diameter. These results may also provide another pathway for syntheses, via shock recovery, of some high-value, high-pressure phases.
- Open Access
- 1 October 2006
- Published by Oxford University Press (OUP) in Geophysical Journal International
- Vol. 167 (1) , 445-452
Surface motion of a fluid planet induced by impacts
- 1 October 2006
- Published by Oxford University Press (OUP) in Geophysical Journal International
- Vol. 167 (1) , 445-452
Open AccessSurface motion of a fluid planet induced by impacts
- Open Access
- 20 May 2002
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 91 (11) , 9136-9146
Effect of phase change on shock wave attenuation in GeO2
Stress-wave profiles in vitreous induced by planar and spherical projectile impact were measured using piezoresistance gauges in the 4 to 18 GPa shock pressure range. The planar experiments demonstrate the response of vitreous This response can be divided into three regimes: (1) An elastic shock regime with ramp 4 GPa Hugoniot elastic limit (HEL) precursor. Shock propagation velocity decreases from an initial longitudinal elastic wave speed of 3.5 to 2.8 km/s at 4 GPa. (2) A transition wave regime where the ramp wave is superimposed on the precursor with an additional amplitude of 0 to 2 GPa followed by a sharp increase in shock pressure achieving peak loading pressures of 8 to 14 GPa. Above 4 GPa the ramp wave velocity decreases to a value below 2.5 km/s (the speed of the bulk wave, at the HEL). (3) A shock wave achieving the final shock state forms when peak pressure is >6 GPa specified by linear shock-particle velocity relation u (km/s) over the 6–40 GPa range for an initial density of 3.655 g/cm3. The Hugoniots of and both initially vitreous, are found to be virtually coincident if pressure in is calculated by multiplying the pressure by the ratio of the initial densities of vitreous to fused The volume axes are translated by aligning the specific volumes for onset and completion of the four- to six-fold coordination phase change. Although only limited spherical impactor spherically diverging shock experiments were conducted, our present results demonstrate (1) The supported elastic shock in fused decays less rapidly than a linear elastic wave when elastic wave stress amplitude is higher than 4 GPa. A supported elastic precursor in vitreous decays faster with radius than a linear elastic wave; (2) in (vitreous) unsupported shock waves decay with peak pressure in a phase transition range (4–15 GPa) with propagation radius (r) as- 20 May 2002
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 91 (11) , 9136-9146
Open AccessEffect of phase change on shock wave attenuation in GeO2
Stress-wave profiles in vitreous induced by planar and spherical projectile impact were measured using piezoresistance gauges in the 4 to 18 GPa shock pressure range. The planar experiments demonstrate the response of vitreous This response can be divided into three regimes: (1) An elastic shock regime with ramp 4 GPa Hugoniot elastic limit (HEL) precursor. Shock propagation velocity decreases from an initial longitudinal elastic wave speed of 3.5 to 2.8 km/s at 4 GPa. (2) A transition wave regime where the ramp wave is superimposed on the precursor with an additional amplitude of 0 to 2 GPa followed by a sharp increase in shock pressure achieving peak loading pressures of 8 to 14 GPa. Above 4 GPa the ramp wave velocity decreases to a value below 2.5 km/s (the speed of the bulk wave, at the HEL). (3) A shock wave achieving the final shock state forms when peak pressure is >6 GPa specified by linear shock-particle velocity relation u (km/s) over the 6–40 GPa range for an initial density of 3.655 g/cm3. The Hugoniots of and both initially vitreous, are found to be virtually coincident if pressure in is calculated by multiplying the pressure by the ratio of the initial densities of vitreous to fused The volume axes are translated by aligning the specific volumes for onset and completion of the four- to six-fold coordination phase change. Although only limited spherical impactor spherically diverging shock experiments were conducted, our present results demonstrate (1) The supported elastic shock in fused decays less rapidly than a linear elastic wave when elastic wave stress amplitude is higher than 4 GPa. A supported elastic precursor in vitreous decays faster with radius than a linear elastic wave; (2) in (vitreous) unsupported shock waves decay with peak pressure in a phase transition range (4–15 GPa) with propagation radius (r) as - 1 October 2001
- Published by Springer Nature in Pure and Applied Geophysics
- Vol. 158 (11) , 1909-1949
Wave Generation from Explosions in Rock Cavities
- 1 October 2001
- Published by Springer Nature in Pure and Applied Geophysics
- Vol. 158 (11) , 1909-1949
Wave Generation from Explosions in Rock Cavities
- 30 May 2001
- Published by Elsevier in Earth and Planetary Science Letters
- Vol. 188 (3-4) , 399-412
Shock-induced vaporization of anhydrite and global cooling from the K/T impact
- 30 May 2001
- Published by Elsevier in Earth and Planetary Science Letters
- Vol. 188 (3-4) , 399-412
Shock-induced vaporization of anhydrite and global cooling from the K/T impact
- 30 March 1998
- Published by Elsevier in Earth and Planetary Science Letters
- Vol. 156 (3-4) , 125-140
Shock vaporization of anhydrite and global effects of the K/T bolide
- 30 March 1998
- Published by Elsevier in Earth and Planetary Science Letters
- Vol. 156 (3-4) , 125-140
Shock vaporization of anhydrite and global effects of the K/T bolide
- 1 January 1997
- Published by Springer Nature in MRS Proceedings
- Vol. 499
High Pressure and High Temperature Equation-of-State of Gamma and Liquid Iron
Shock-wave experiments on pure iron preheated to 1573 K were conducted in the 17–73 GPa range. The shock-wave equation of state of γ-iron at an initial temperature of 1573 K can be fit with us = 4.102 (0.015) km/s + 1.610(0.014) up with ρo = 7.413±0.012 Mg/m3 We obtain for γ-iron's bulk modulus and pressure derivative the values: 124.7±1.1 GPa and 5.44±0.06, respectively.We present new data for sound velocities in the γ- and liquid-phases. In the γ-phase, to a first approximation, the longitudinal sound velocity is linear with respect to density: Vp = −3.13 (0.72) + 1.119(0.084) p(units for Vp and p are km/s and Mg/m3, respectively). Melting was observed in the highest pressure (about 70–73 GPa) experiments at a calculated shock temperature of 2775±160 K. This result is consistent with a previously calculated melting curve (for ε-iron) which is close to those measured by Boehler [1] and Saxena et al. [2]. The liquid iron sound velocity data yields a Grüneisen parameter value of 1.63±0.28 at 9.37±0.02 Mg/m3 at 71.6 GPa. The quantity γρ is 15.2±2.6 Mg/m3, which agrees with the uncertainty bounds of Brown and McQueen [3] (13.3–19.6 Mg/m3). Based on upward pressure and temperature extrapolation of the melting curve of γ-iron, the estimated inner core-outer core boundary temperature is 5500±400 K, the temperature at the core-mantle boundary on the outer core side is 3930±630 K.
- 1 January 1997
- Published by Springer Nature in MRS Proceedings
- Vol. 499
High Pressure and High Temperature Equation-of-State of Gamma and Liquid Iron
Shock-wave experiments on pure iron preheated to 1573 K were conducted in the 17–73 GPa range. The shock-wave equation of state of γ-iron at an initial temperature of 1573 K can be fit with us = 4.102 (0.015) km/s + 1.610(0.014) up with ρo = 7.413±0.012 Mg/m3 We obtain for γ-iron's bulk modulus and pressure derivative the values: 124.7±1.1 GPa and 5.44±0.06, respectively.We present new data for sound velocities in the γ- and liquid-phases. In the γ-phase, to a first approximation, the longitudinal sound velocity is linear with respect to density: Vp = −3.13 (0.72) + 1.119(0.084) p(units for Vp and p are km/s and Mg/m3, respectively). Melting was observed in the highest pressure (about 70–73 GPa) experiments at a calculated shock temperature of 2775±160 K. This result is consistent with a previously calculated melting curve (for ε-iron) which is close to those measured by Boehler [1] and Saxena et al. [2]. The liquid iron sound velocity data yields a Grüneisen parameter value of 1.63±0.28 at 9.37±0.02 Mg/m3 at 71.6 GPa. The quantity γρ is 15.2±2.6 Mg/m3, which agrees with the uncertainty bounds of Brown and McQueen [3] (13.3–19.6 Mg/m3). Based on upward pressure and temperature extrapolation of the melting curve of γ-iron, the estimated inner core-outer core boundary temperature is 5500±400 K, the temperature at the core-mantle boundary on the outer core side is 3930±630 K.