Kris Broos
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Kris Broos has a total of 90 co-authors. Here are the top co-authors by number of shared publications:
- Jeroen Spooren
Material and Chemistry Unit (MatCh), Flemish Institute for Technological Research (VITO), Boeretang 200, 2400 Mol, Belgium
11 shared publications - Liesbeth Horckmans
VITO
11 shared publications - Mieke Quaghebeur
Sustainable Materials Management, VITO, Boeretang 200, 2400 Mol, Belgium
10 shared publications - Michael St. John Warne
Water Quality and Investigations, Environmental Monitoring and Assessment Science, Science Delivery, Department of Science, Information Technology, Innovation and the Arts, Brisbane, Australia
9 shared publications Mike J. McLaughlin
Centre for Environmental Contaminants Research, CSIRO Land and Water
7 shared publications- Erik Smolders
Division of Soil and Water Management, KU Leuven, Kasteelpark Arenberg 20, 3001 Heverlee, Belgium
6 shared publications
Latest Publications
- 1 February 2021
- Published by Elsevier in Journal of Environmental Management
- Vol. 279, 111525
Granulation and calcination of alum sludge for the development of a phosphorus adsorbent: From lab scale to pilot scale
- 1 February 2021
- Published by Elsevier in Journal of Environmental Management
- Vol. 279, 111525
Granulation and calcination of alum sludge for the development of a phosphorus adsorbent: From lab scale to pilot scale
- Open Access
Microwave Radiation as a Pre-Treatment for Standard and Innovative Fragmentation Techniques in Concrete Recycling
Recent advances in concrete recycling technology focus on novel fragmentation techniques to obtain aggregate fractions with low cement matrix content. This study assesses the aggregate liberation effectiveness of four different treatment processes including standard and innovative concrete fragmentation techniques. Lab-made concrete samples were subjected to either standard mechanical crushing technique (SMT) or electrodynamic fragmentation (EDF). For both fragmentation processes, the influence of a microwave weakening pre-treatment technique (MWT) was investigated. A detailed analysis of the particle size distribution was carried out on samples after fragmentation. The >5.6 mm fraction was more deeply characterized for aggregate selective liberation (manual classification to separate liberated aggregates) and for cement matrix content (thermogravimetric measurements). Results highlight that EDF treatment is more effective than SMT treatment to selectively liberate aggregates and to decrease the cement matrix content of the >5.6 mm fraction. EDF fully liberates up to 37 wt.% of the >5.6 mm natural aggregates, while SMT only liberates 14–16 wt.%. MWT pre-treatment positively affects aggregate liberation and cement matrix removal only if used in combination with SMT; no significant effect in combination with EDF was recorded. These results of this study can provide insights to successfully implement innovative technology in concrete recycling plants.
Open AccessMicrowave Radiation as a Pre-Treatment for Standard and Innovative Fragmentation Techniques in Concrete Recycling
Recent advances in concrete recycling technology focus on novel fragmentation techniques to obtain aggregate fractions with low cement matrix content. This study assesses the aggregate liberation effectiveness of four different treatment processes including standard and innovative concrete fragmentation techniques. Lab-made concrete samples were subjected to either standard mechanical crushing technique (SMT) or electrodynamic fragmentation (EDF). For both fragmentation processes, the influence of a microwave weakening pre-treatment technique (MWT) was investigated. A detailed analysis of the particle size distribution was carried out on samples after fragmentation. The >5.6 mm fraction was more deeply characterized for aggregate selective liberation (manual classification to separate liberated aggregates) and for cement matrix content (thermogravimetric measurements). Results highlight that EDF treatment is more effective than SMT treatment to selectively liberate aggregates and to decrease the cement matrix content of the >5.6 mm fraction. EDF fully liberates up to 37 wt.% of the >5.6 mm natural aggregates, while SMT only liberates 14–16 wt.%. MWT pre-treatment positively affects aggregate liberation and cement matrix removal only if used in combination with SMT; no significant effect in combination with EDF was recorded. These results of this study can provide insights to successfully implement innovative technology in concrete recycling plants.
- 1 June 2018
- Published by Elsevier in Minerals Engineering
- Vol. 122, 17-25
Recovery of iron and lead from a secondary lead smelter matte by magnetic separation
- 1 June 2018
- Published by Elsevier in Minerals Engineering
- Vol. 122, 17-25
Recovery of iron and lead from a secondary lead smelter matte by magnetic separation
- Open Access
- 26 October 2017
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 7 (79) , 49999-50005
Closed-loop solvometallurgical process for recovery of lead from iron-rich secondary lead smelter residues
A solvometallurgical process based on acetic acid was developed for the recovery of lead from iron-rich residues (matte and slag).
- 26 October 2017
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 7 (79) , 49999-50005
Open AccessClosed-loop solvometallurgical process for recovery of lead from iron-rich secondary lead smelter residues
A solvometallurgical process based on acetic acid was developed for the recovery of lead from iron-rich residues (matte and slag).
- 1 August 2017
- Published by Elsevier in Hydrometallurgy
- Vol. 171, 245-253
Effect of milling on metal leaching: Induction of galvanic effect in a secondary lead smelter matte by prolonged milling
- 1 August 2017
- Published by Elsevier in Hydrometallurgy
- Vol. 171, 245-253
Effect of milling on metal leaching: Induction of galvanic effect in a secondary lead smelter matte by prolonged milling
- 1 May 2017
- Published by Elsevier in Hydrometallurgy
- Vol. 169, 589-598
Process development for hydrometallurgical recovery of valuable metals from sulfide-rich residue generated in a secondary lead smelter
- 1 May 2017
- Published by Elsevier in Hydrometallurgy
- Vol. 169, 589-598
Process development for hydrometallurgical recovery of valuable metals from sulfide-rich residue generated in a secondary lead smelter
- 1 May 2017
- Published by Elsevier in Hydrometallurgy
- Vol. 169, 372-381
Selective leaching of Pb, Cu, Ni and Zn from secondary lead smelting residues
- 1 May 2017
- Published by Elsevier in Hydrometallurgy
- Vol. 169, 372-381
Selective leaching of Pb, Cu, Ni and Zn from secondary lead smelting residues
- 1 May 2017
- Published by Elsevier in Hydrometallurgy
- Vol. 169, 290-296
Recycling of a secondary lead smelting matte by selective citrate leaching of valuable metals and simultaneous recovery of hematite as a secondary resource
- 1 May 2017
- Published by Elsevier in Hydrometallurgy
- Vol. 169, 290-296
Recycling of a secondary lead smelting matte by selective citrate leaching of valuable metals and simultaneous recovery of hematite as a secondary resource
- 1 November 2016
- Published by Elsevier in Chemical Engineering Journal
- Vol. 303, 359-368
In-situ chromium and vanadium recovery of landfilled ferrochromium and stainless steel slags
- 1 November 2016
- Published by Elsevier in Chemical Engineering Journal
- Vol. 303, 359-368
In-situ chromium and vanadium recovery of landfilled ferrochromium and stainless steel slags
- 1 September 2016
- Published by Elsevier in Waste Management
- Vol. 55, 31-37
Round robin testing of a percolation column leaching procedure
- 1 September 2016
- Published by Elsevier in Waste Management
- Vol. 55, 31-37
Round robin testing of a percolation column leaching procedure