Mohammed Islam
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Mohammed Islam has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
Jason Mills
4 shared publicationsRobert Gash
4 shared publications- Wayne Pearson
Ocean, Coastal and River Engineering, National Research Council, St. John’s, NL, Canada
3 shared publications Bruno Tremblay
Department of Atmospheric and Oceanic Sciences, McGill University, Montreal, Quebec, Canada
2 shared publicationsDon Spencer
Oceanic Consulting Corporation, St. John’s, NL, Canada
2 shared publications- Jean-François Lemieux
Recherche en Prévision Numérique Environnementale/Environnement et Changement Climatique Canada, 2121 route Transcanadienne, Dorval QC, Canada
2 shared publications
Latest Publications
- Open Access
- 30 July 2026
- Published by Elsevier in Ocean Engineering
- Vol. 365
Experimental assessment of vessels underwater radiated noise and source levels in deep and shallow water: A comparative analysis
- 30 July 2026
- Published by Elsevier in Ocean Engineering
- Vol. 365
Open AccessExperimental assessment of vessels underwater radiated noise and source levels in deep and shallow water: A comparative analysis
- Open Access
- 7 June 2026
- Published by Elsevier in Ocean Engineering
- Vol. 362
Free-running manoeuvring experiments of a fishing vessel model: Effects of rudder geometry and hull appendages
- 7 June 2026
- Published by Elsevier in Ocean Engineering
- Vol. 362
Open AccessFree-running manoeuvring experiments of a fishing vessel model: Effects of rudder geometry and hull appendages
- Open Access
- 16 July 2024
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 12 (7) , 1195
Smoothed Particle Hydrodynamics Modelling of Bergy Bit and Offshore Structure Interactions Due to Large Waves
This research utilised an open-sourced smoothed particle hydrodynamics (SPH) tool to model and predict the change in wave-induced forces and motions of a free-floating bergy bits approaching a fixed structure in regular waves. Simulation parameters, including particle resolution, fluid viscosity, initial wave condition and boundary treatments, are varied, and their effect on the load imparted to the bergy bit and the structure are investigated. The predicted motions are compared with previously published physical measurements for corresponding scenarios. Both predictions and measurements showed that, in regular waves, the surge motion slowed as the bergy bit approached the structure, and the heave motion increased. For wave loading on bergy bits, the agreement with the experimental data for the root mean square (RMS) force was within 2%. The pressure and velocity fields of the wave–structure–bergy bit interactions are discussed in light of the SPH predictions. This work confirms that the SPH model can accurately capture viscosity–dominated interactions, hydrodynamic damping, and eccentric impact like phenomena and predict both the impact and hydrodynamic loads due to a bergy bit drifting in waves towards a fixed offshore structure.
- 16 July 2024
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 12 (7) , 1195
Open AccessSmoothed Particle Hydrodynamics Modelling of Bergy Bit and Offshore Structure Interactions Due to Large Waves
This research utilised an open-sourced smoothed particle hydrodynamics (SPH) tool to model and predict the change in wave-induced forces and motions of a free-floating bergy bits approaching a fixed structure in regular waves. Simulation parameters, including particle resolution, fluid viscosity, initial wave condition and boundary treatments, are varied, and their effect on the load imparted to the bergy bit and the structure are investigated. The predicted motions are compared with previously published physical measurements for corresponding scenarios. Both predictions and measurements showed that, in regular waves, the surge motion slowed as the bergy bit approached the structure, and the heave motion increased. For wave loading on bergy bits, the agreement with the experimental data for the root mean square (RMS) force was within 2%. The pressure and velocity fields of the wave–structure–bergy bit interactions are discussed in light of the SPH predictions. This work confirms that the SPH model can accurately capture viscosity–dominated interactions, hydrodynamic damping, and eccentric impact like phenomena and predict both the impact and hydrodynamic loads due to a bergy bit drifting in waves towards a fixed offshore structure.
- Open Access
- 4 March 2024
- Published by Copernicus GmbH in The Cryosphere
- Vol. 18 (3) , 1013-1032
Smoothed particle hydrodynamics implementation of the standard viscous–plastic sea-ice model and validation in simple idealized experiments
The viscous–plastic (VP) rheology with an elliptical yield curve and normal flow rule is implemented in a Lagrangian modelling framework using the smoothed particle hydrodynamics (SPH) meshfree method. Results show, from a perturbation analysis of SPH sea-ice dynamic equations, that the classical SPH particle density formulation expressed as a function of sea-ice concentration and mean ice thickness leads to incorrect plastic wave speed. We propose a new formulation for particle density that gives a plastic wave speed in line with theory. In all cases, the plastic wave in the SPH framework is dispersive and depends on the smoothing length (i.e., the spatial resolution) and on the SPH kernel employed in contrast to its finite-difference method (FDM) implementation counterpart. The steady-state solution for the simple 1D ridging experiment is in agreement with the analytical solution within an error of 1 %. SPH is also able to simulate a stable upstream ice arch in an idealized domain representing the Nares Strait in a low-wind regime (5.3 m s−1) with an ellipse aspect ratio of 2, an average thickness of 1 m and free-slip boundary conditions in opposition to the FDM implementation that requires higher shear strength to simulate it. In higher-wind regimes (7.5 m s−1) no stable ice arches are simulated – unless the thickness is increased – and the ice arch formation showed no dependence on the size of particles, in contrast to what is observed in the discrete-element framework. Finally, the SPH framework is explicit, can take full advantage of parallel processing capabilities and shows potential for pan-Arctic climate simulations.
- 4 March 2024
- Published by Copernicus GmbH in The Cryosphere
- Vol. 18 (3) , 1013-1032
Open AccessSmoothed particle hydrodynamics implementation of the standard viscous–plastic sea-ice model and validation in simple idealized experiments
The viscous–plastic (VP) rheology with an elliptical yield curve and normal flow rule is implemented in a Lagrangian modelling framework using the smoothed particle hydrodynamics (SPH) meshfree method. Results show, from a perturbation analysis of SPH sea-ice dynamic equations, that the classical SPH particle density formulation expressed as a function of sea-ice concentration and mean ice thickness leads to incorrect plastic wave speed. We propose a new formulation for particle density that gives a plastic wave speed in line with theory. In all cases, the plastic wave in the SPH framework is dispersive and depends on the smoothing length (i.e., the spatial resolution) and on the SPH kernel employed in contrast to its finite-difference method (FDM) implementation counterpart. The steady-state solution for the simple 1D ridging experiment is in agreement with the analytical solution within an error of 1 %. SPH is also able to simulate a stable upstream ice arch in an idealized domain representing the Nares Strait in a low-wind regime (5.3 m s−1) with an ellipse aspect ratio of 2, an average thickness of 1 m and free-slip boundary conditions in opposition to the FDM implementation that requires higher shear strength to simulate it. In higher-wind regimes (7.5 m s−1) no stable ice arches are simulated – unless the thickness is increased – and the ice arch formation showed no dependence on the size of particles, in contrast to what is observed in the discrete-element framework. Finally, the SPH framework is explicit, can take full advantage of parallel processing capabilities and shows potential for pan-Arctic climate simulations.
- 2 November 2022
- Published by Elsevier in Ocean Engineering
- Vol. 266
Modelling of the Dynamically Positioned vessels and managed ice-field interaction dynamics using empirical-statistical techniques
- 2 November 2022
- Published by Elsevier in Ocean Engineering
- Vol. 266
Modelling of the Dynamically Positioned vessels and managed ice-field interaction dynamics using empirical-statistical techniques
- 11 October 2022
- Published by Elsevier in Applied Ocean Research
- Vol. 129
An energy-efficient dynamic positioning controller for high sea conditions
- 11 October 2022
- Published by Elsevier in Applied Ocean Research
- Vol. 129
An energy-efficient dynamic positioning controller for high sea conditions
- Open Access
- 18 August 2022
- Published by Copernicus GmbH in EGUsphere
- Vol. 2022, 1-33
Smoothed Particle Hydrodynamics Implementation of the Standard Viscous-Plastic Sea-Ice Model and Validation in Simple Idealized Experiments
The Viscous-Plastic (VP) rheology with an elliptical yield curve and normal flow rule is implemented in a Lagrangian modelling framework using the Smoothed Particle Hydrodynamics (SPH) meshfree method. Results show, from perturbation analysis of SPH sea-ice dynamic equations, that the classical SPH particle density formulation expressed as a function of sea-ice concentration and mean ice thickness, leads to incorrect plastic wave speed. We propose a new formulation for particle density that gives a plastic wave speed in line with theory. In all cases, the plastic wave in the SPH framework is dispersive and depends on the smoothing length (i.e., the spatial resolution) and on the SPH kernel employed in contrast with its finite difference method (FDM) implementation counterpart. The steady-state solution for the simple 1D ridging experiment is in agreement with the analytical solution within an error of 1 %. SPH is also able to simulate a stable upstream ice arch in an idealized domain representing the Nares Strait in low wind regime (5.3 [m · s−1]) with an ellipse aspect ratio of 2, an average thickness of 1 [m] and free-slip boundary conditions in opposition to the FDM implementation that requires higher shear strength to simulate it. In higher wind regime (7.5 [m · s−1]) no stable ice arches are simulated — unless the thickness is increased — and the ice arch formation showed no dependence on the size of particles contrary to what is observed in the discrete element framework. Finally, the SPH framework is explicit, can take full advantage of parallel processing capabilities and show potential for pan-arctic climate simulations.
- 18 August 2022
- Published by Copernicus GmbH in EGUsphere
- Vol. 2022, 1-33
Open AccessSmoothed Particle Hydrodynamics Implementation of the Standard Viscous-Plastic Sea-Ice Model and Validation in Simple Idealized Experiments
The Viscous-Plastic (VP) rheology with an elliptical yield curve and normal flow rule is implemented in a Lagrangian modelling framework using the Smoothed Particle Hydrodynamics (SPH) meshfree method. Results show, from perturbation analysis of SPH sea-ice dynamic equations, that the classical SPH particle density formulation expressed as a function of sea-ice concentration and mean ice thickness, leads to incorrect plastic wave speed. We propose a new formulation for particle density that gives a plastic wave speed in line with theory. In all cases, the plastic wave in the SPH framework is dispersive and depends on the smoothing length (i.e., the spatial resolution) and on the SPH kernel employed in contrast with its finite difference method (FDM) implementation counterpart. The steady-state solution for the simple 1D ridging experiment is in agreement with the analytical solution within an error of 1 %. SPH is also able to simulate a stable upstream ice arch in an idealized domain representing the Nares Strait in low wind regime (5.3 [m · s−1]) with an ellipse aspect ratio of 2, an average thickness of 1 [m] and free-slip boundary conditions in opposition to the FDM implementation that requires higher shear strength to simulate it. In higher wind regime (7.5 [m · s−1]) no stable ice arches are simulated — unless the thickness is increased — and the ice arch formation showed no dependence on the size of particles contrary to what is observed in the discrete element framework. Finally, the SPH framework is explicit, can take full advantage of parallel processing capabilities and show potential for pan-arctic climate simulations.
- 7 February 2022
- Published by Elsevier in Ocean Engineering
- Vol. 246
Investigation of the effects of managed ice field characteristics on a dynamic positioning AHTS vessel using physical modelling techniques
- 7 February 2022
- Published by Elsevier in Ocean Engineering
- Vol. 246
Investigation of the effects of managed ice field characteristics on a dynamic positioning AHTS vessel using physical modelling techniques
- 26 November 2021
- Published by Elsevier in Ocean Engineering
- Vol. 243, 110248
Modelling of Dynamically Positioned vessels and managed ice-field interactions using multiple regression techniques
- 26 November 2021
- Published by Elsevier in Ocean Engineering
- Vol. 243, 110248
Modelling of Dynamically Positioned vessels and managed ice-field interactions using multiple regression techniques
- 13 August 2021
- Published by Elsevier in Cold Regions Science and Technology
- Vol. 192, 103376
Physical model testing I for investigating the effects of managed ice-field characteristics on a dynamic positioning vessel
- 13 August 2021
- Published by Elsevier in Cold Regions Science and Technology
- Vol. 192, 103376
Physical model testing I for investigating the effects of managed ice-field characteristics on a dynamic positioning vessel