Bikash Nakarmi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Bikash Nakarmi has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Yong Hyub Won
Korea Advanced Institute of Science and Technology
6 shared publications - Mohammad Rakib Uddin
The Research Foundation for State University of New York, State University of New York Polytechnic Institute, Albany, New York, USA
3 shared publications Tran Q. Hoai
KAIST (Korea, Republic of)
3 shared publications- Jian Wei Wu
$^{1}$Department of Electrical Engineering, Korea Advanced Institute of Science and Technology, Daejeon , Korea
2 shared publications Yong Hyub Won
School of Electrical Engineering, Korea Advanced Institute of Science and Technology, Daejeon 305714, South Korea
2 shared publications- Hoai Tran Quoc
Korea Advanced Institute of Science and Technology (KAIST), Daejeon, Korea
1 shared publication
Latest Publications
- 29 July 2016
- Published by IOP Publishing in Quantum Electronics
- Vol. 46 (7) , 640-643
Investigation of band-gap properties in one-dimensional ternary photonic crystals with a single defect layer
- 29 July 2016
- Published by IOP Publishing in Quantum Electronics
- Vol. 46 (7) , 640-643
Investigation of band-gap properties in one-dimensional ternary photonic crystals with a single defect layer
- Open Access
- 2 February 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (3) , 2655-2663
Optically tunable microwave, millimeter-wave and submillimeter-wave utilizing single-mode Fabry-Pérot laser diode subject to optical feedback
In this paper, we use optical feedback injection technique to generate tunable microwave, millimeter-wave and submillimeter-wave signals using single-mode Fabry-Pérot laser diode. The beat frequency of the proposed generator ranges from 30.4 GHz to 3.40 THz. The peak power ratio between two resonating modes at the output spectrum of can be less than 0.5 dB by judiciously selecting feedback wavelength. In the stabilization test, the peak fluctuation of photonic signal is as low as 0.19 dB within half hour. Aside from locking regions, where the laser is easily locked by the injection beam, the side-mode suppression ratio is well over 25 dB with the maximum value of 36.6 dB at 30.4 GHz beat frequency. In addition, the minimum beat frequency interval between two adjacent photonic signals is as low as 10 GHz.
- 2 February 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (3) , 2655-2663
Open AccessOptically tunable microwave, millimeter-wave and submillimeter-wave utilizing single-mode Fabry-Pérot laser diode subject to optical feedback
In this paper, we use optical feedback injection technique to generate tunable microwave, millimeter-wave and submillimeter-wave signals using single-mode Fabry-Pérot laser diode. The beat frequency of the proposed generator ranges from 30.4 GHz to 3.40 THz. The peak power ratio between two resonating modes at the output spectrum of can be less than 0.5 dB by judiciously selecting feedback wavelength. In the stabilization test, the peak fluctuation of photonic signal is as low as 0.19 dB within half hour. Aside from locking regions, where the laser is easily locked by the injection beam, the side-mode suppression ratio is well over 25 dB with the maximum value of 36.6 dB at 30.4 GHz beat frequency. In addition, the minimum beat frequency interval between two adjacent photonic signals is as low as 10 GHz.
- 25 June 2015
- Published by Korean Journal of Optics and Photonics in Journal of the Optical Society of Korea
- Vol. 19 (3) , 255-259
An Optical Pulse-Width Modulation Generator Using a Single-Mode Fabry-Pérot Laser Diode
- 25 June 2015
- Published by Korean Journal of Optics and Photonics in Journal of the Optical Society of Korea
- Vol. 19 (3) , 255-259
An Optical Pulse-Width Modulation Generator Using a Single-Mode Fabry-Pérot Laser Diode
- Open Access
- 17 June 2014
- Published by Optica Publishing Group in Optics Express
- Vol. 22 (13) , 15424-15436
Short-pulse controlled optical switch using external cavity based single mode Fabry-Pérot laser diode.
We propose and demonstrate a novel scheme for short pulse controlled all-optical switch using external cavity based single mode Fabry- Pérot laser diode (SMFP-LD). The proposed scheme consists of control unit and switching unit as two essential blocks. The basic principle of the proposed scheme is the optical bistability property of SMFP-LD for the control unit and the suppression of the dominant beam of SMFP-LD with injection locking for the switching unit. We also present the analysis of hysteresis width and rising/falling time with change in wavelength detuning which helps to find the optimum wavelength detuning value and power of light beams at different stages of the proposed scheme that gives wide input dynamic power range, high ON/OFF contrast ratio, and low rising/falling time. Input data of 10 Gb/s Non Return to Zero (NRZ) signal is switched at output ports depending upon the control signal generated by the control unit, which comprises of optical SR latch. Output waveforms, clear eye diagrams with extinction ratio of about 11 dB, rising/falling time of about 30 ps and 40 ps, and bit error rate (BER) are measured to validate proposed scheme. No noise floor is observed at output ports up to BER of 10−12 and the maximum power penalty recorded is about 1.7 dB at a BER of 10−9 which shows good performance of the proposed short pulse controlled optical switch using SMFP-LDs.
- 17 June 2014
- Published by Optica Publishing Group in Optics Express
- Vol. 22 (13) , 15424-15436
Open AccessShort-pulse controlled optical switch using external cavity based single mode Fabry-Pérot laser diode.
We propose and demonstrate a novel scheme for short pulse controlled all-optical switch using external cavity based single mode Fabry- Pérot laser diode (SMFP-LD). The proposed scheme consists of control unit and switching unit as two essential blocks. The basic principle of the proposed scheme is the optical bistability property of SMFP-LD for the control unit and the suppression of the dominant beam of SMFP-LD with injection locking for the switching unit. We also present the analysis of hysteresis width and rising/falling time with change in wavelength detuning which helps to find the optimum wavelength detuning value and power of light beams at different stages of the proposed scheme that gives wide input dynamic power range, high ON/OFF contrast ratio, and low rising/falling time. Input data of 10 Gb/s Non Return to Zero (NRZ) signal is switched at output ports depending upon the control signal generated by the control unit, which comprises of optical SR latch. Output waveforms, clear eye diagrams with extinction ratio of about 11 dB, rising/falling time of about 30 ps and 40 ps, and bit error rate (BER) are measured to validate proposed scheme. No noise floor is observed at output ports up to BER of 10−12 and the maximum power penalty recorded is about 1.7 dB at a BER of 10−9 which shows good performance of the proposed short pulse controlled optical switch using SMFP-LDs.
- 1 August 2013
- Published by IOP Publishing in Chinese Physics B
- Vol. 22 (8)
A power and wavelength detuning-dependent hysteresis loop in a single mode Fabry—Pérot laser diode
- 1 August 2013
- Published by IOP Publishing in Chinese Physics B
- Vol. 22 (8)
A power and wavelength detuning-dependent hysteresis loop in a single mode Fabry—Pérot laser diode
- Open Access
- 23 April 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 5 (2) , 7900811
All-Optical Address Decoder Using Injection-Locking Property of External-Cavity-Based Single-Mode FP-LD
A novel all-optical address decoder (AOAD) using an external-cavity-based single-mode Fabry–Pérot laser diode (SMFP-LD) is proposed and demonstrated. The proposed AOAD is the combination of logic gates that are cascaded together to give specific functions of the decoder. The working principles of all logic gates are based on the single- and multi-input injection-locking properties of SMFP-LD. The outputs of the proposed AOAD have contrast ratios of above 27 dB in the spectrum domain, clear waveforms, and clear eyes diagrams with good BER at the data rate of 10 Gb/s. The proposed AOAD has several advantages such as a simple and cascadable structure, low cost, and low bias current (below 19 mA) compared with other optical technologies.
- 23 April 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 5 (2) , 7900811
Open AccessAll-Optical Address Decoder Using Injection-Locking Property of External-Cavity-Based Single-Mode FP-LD
A novel all-optical address decoder (AOAD) using an external-cavity-based single-mode Fabry–Pérot laser diode (SMFP-LD) is proposed and demonstrated. The proposed AOAD is the combination of logic gates that are cascaded together to give specific functions of the decoder. The working principles of all logic gates are based on the single- and multi-input injection-locking properties of SMFP-LD. The outputs of the proposed AOAD have contrast ratios of above 27 dB in the spectrum domain, clear waveforms, and clear eyes diagrams with good BER at the data rate of 10 Gb/s. The proposed AOAD has several advantages such as a simple and cascadable structure, low cost, and low bias current (below 19 mA) compared with other optical technologies.
- 1 January 2013
- Published by IOP Publishing in Chinese Physics Letters
- Vol. 30 (1)
Spectral Characteristic Based on Fabry—Pérot Laser Diode with Two-Stage Optical Feedback
- 1 January 2013
- Published by IOP Publishing in Chinese Physics Letters
- Vol. 30 (1)
Spectral Characteristic Based on Fabry—Pérot Laser Diode with Two-Stage Optical Feedback
- 19 December 2011
- Published by SPIE-Intl Soc Optical Eng in SPIE Newsroom
Multi-input injection locking in a single-mode Fabry-Pérot laser for all-optical gates
- 19 December 2011
- Published by SPIE-Intl Soc Optical Eng in SPIE Newsroom
Multi-input injection locking in a single-mode Fabry-Pérot laser for all-optical gates
- 8 July 2011
- Published by Optica Publishing Group in Optics Express
- Vol. 19 (15) , 14121-14129
Realization of all-optical multi-logic functions and a digital adder with input beam power management for multi-input injection locking in a single-mode Fabry-Pérot laser diode
We propose a novel idea for the suppression of the dominant mode of the single-mode Fabry-Pérot laser diode (SMFP-LD) to realize all-optical multi-logic functions and a digital adder. The basic principle of the proposed scheme is the power management of input beams to suppress the dominant mode of the SMFP-LD for multi-input injection locking. The proposed principle is explained and implemented to realize all-optical multi-logic functions and a digital adder at an input data rate of 10 Gbps. A clear eye opening with an extinction ratio of about 12 dB and a rising-falling time of less than 40 ps are observed at the outputs. The bit error rate (BER) performance is measured for all logic gates and half adder operation. We found there is no BER floor up to BER of 10−12 and the maximum power penalty of about 1.2 dB at a BER of 10−9.
- 8 July 2011
- Published by Optica Publishing Group in Optics Express
- Vol. 19 (15) , 14121-14129
Realization of all-optical multi-logic functions and a digital adder with input beam power management for multi-input injection locking in a single-mode Fabry-Pérot laser diode
We propose a novel idea for the suppression of the dominant mode of the single-mode Fabry-Pérot laser diode (SMFP-LD) to realize all-optical multi-logic functions and a digital adder. The basic principle of the proposed scheme is the power management of input beams to suppress the dominant mode of the SMFP-LD for multi-input injection locking. The proposed principle is explained and implemented to realize all-optical multi-logic functions and a digital adder at an input data rate of 10 Gbps. A clear eye opening with an extinction ratio of about 12 dB and a rising-falling time of less than 40 ps are observed at the outputs. The bit error rate (BER) performance is measured for all logic gates and half adder operation. We found there is no BER floor up to BER of 10−12 and the maximum power penalty of about 1.2 dB at a BER of 10−9.
- 26 December 2010
- Published by SPIE-Intl Soc Optical Eng
- Vol. 7988, 79881O-79881
All-optical ON-OFF switch using a single-mode Fabry-Perot laser diode
An all-optical ON-OFF switch is demonstrated using a single-mode Fabry-Perot laser diode. The operation principle of the proposed switch is the gain modulation of injection locked single mode Fabry-Perot laser diode (SM FP-LD) by an external control beam. In this paper, the operation principle is explained and a 10 Gb/s data signal is switched ON and OFF with a control signal of 200 MHz. We measured the switched output with an extinction ratio of 15.4 dB. The rising and falling times of the switch were measured as 90 ps and 80 ps, respectively.
- 26 December 2010
- Published by SPIE-Intl Soc Optical Eng
- Vol. 7988, 79881O-79881
All-optical ON-OFF switch using a single-mode Fabry-Perot laser diode
An all-optical ON-OFF switch is demonstrated using a single-mode Fabry-Perot laser diode. The operation principle of the proposed switch is the gain modulation of injection locked single mode Fabry-Perot laser diode (SM FP-LD) by an external control beam. In this paper, the operation principle is explained and a 10 Gb/s data signal is switched ON and OFF with a control signal of 200 MHz. We measured the switched output with an extinction ratio of 15.4 dB. The rising and falling times of the switch were measured as 90 ps and 80 ps, respectively.