PNParvin Nassiri

Parvin Nassiri

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Parvin Nassiri has a total of 63 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Indoor Radon in Larijan Buildings Affected by Geological Characteristics

    by Somayeh Dadashpoor, Parvin Nassiri, Alireza Mirzahosseini, Nabiollah Mansouri, Zahra Azizi

    Background: The decay of uranium and thorium is the primary source of radon emissions, a radioactive gas. The transfer and accumulation of this gas indoors pose serious health risks. Methods: This study investigated indoor radon concentrations in buildings located in areas with different geological characteristics. Thirty-six buildings were examined across three locations in Larijan, Iran, with samples collected from living rooms and bedrooms over a three-month period. Results: The average radon concentrations in bedrooms and living rooms were 114.40 Bq/m3 and 128.35 Bq/m3 , respectively. Indoor radon levels in buildings near hot springs were 24.66% higher than those in buildings close to, and 45.31% higher than those in buildings far from, hot springs. Seasonal variation was also observed: the average concentration in winter was 112.05 Bq/m3 , compared with 130.89 Bq/m³ in summer. These findings indicate that both climatic and geological conditions significantly influence indoor radon levels. Conclusion: Since radon concentrations in most buildings exceeded the World Health Organization (WHO) guideline of 100 Bq/m3 , implementing exposure control programs in residential buildings is essential.

  • Indoor PM2.5 concentrations of pre-schools; determining the effective factors and model for prediction

    by Yasser Baharfar, Mahmoud Mohammadyan, Faramarz Moattar, Parvin Nassiri, Mohammad Hassan Behzadi

    Purpose: This paper aims to present the most influential factors on classroom indoor PM2.5 (Particulate Matter < 2.5 µ), determining the level of PM2.5 concentration in five pre-schools located in the most densely populated district of the Tehran metropolitan area (district 6) as a case study to consider the children's exposure to air pollutants and introducing a suitable model, for the first time, to predict PM2.5 concentration changes, inside pre-schools.Design/methodology/approach: Indoor and outdoor classes PM2.5 concentrations were measured using two DUSTTRAK direct-reading instruments. Additional class status information was also recorded; concurrently, urban PM2.5 concentrations and meteorological data were obtained from the fixed monitoring stations and Meteorological Organization. Then, the predicted concentrations of the indoor PM2.5, from introduced multiple linear regression model via SPSS, compared with the nearest urban air pollution monitoring stations data.Findings: The average outdoor PM2.5 concentration (43 ± 0.32 µg m−3) was higher than the mean indoor (32 ± 0. 21 µg m−3), and both were significantly (p < 0.001) surpassing the 24-h EPA standard level. The indoor PM2.5 concentrations had the highest level in the autumn (48.7 µg m−3) and significantly correlated with the outdoor PM2.5 (r = 0.94, p < 0.001), the number of pupils, ambient temperature, wind speed, wind direction and open area of the doors and windows (p < 0.001). These parameters, as the main determinants, have led to present a 7-variable regression model, with R2 = 0.705, which can predict PM2.5 concentrations in the pre-school classes with more than 80% accuracy. It can be presumed that the penetration of outdoor PM2.5 was the main source of indoor PM2.5 concentrations.Research limitations/implications: This study faced several limitations, such as accessibility to classrooms, and limitations in technicians' numbers, leading to researchers monitoring indoor and outdoor PM concentrations in schools once a week. Additionally, regarding logistical limitations to using monitoring instruments in pre-schools simultaneously, correction factors by running the instruments were applied to obtain comparable measurements.Originality/value: The author hereby declares that this submission is his own work and to the best of its knowledge it contains no materials previously published or written by another person.


  • Synthesis of a multicomponent silica aerogel-containing nanocomposite for efficient sound absorption properties

    by Mansoureh Hamidi, Parvin Nassiri, Homayoon Ahmad Panahi, Lobat Taghavi, Saeed Bazgir

    In this study, the sound properties of four types of nanocomposites have been investigated. To this end, the prepared samples were measured by the impedance tube model BSWA-SW 422, SW477. It was found that the Sound Absorption Coefficient (SAC) of all samples was increased at high frequencies relatively well. The highest SAC at medium and low frequencies was related to the nanocomposite D. The results of sound Transmission Loss (TL) of nanocomposites showed that the TL value for the nanocomposite D (optimum sample) was higher at all frequencies compared to other nanocomposites. The results confirmed that adding organic and mineral materials to the silica aerogel (SA) simultaneously improves its sound properties. By measuring the Sound Pressure Level (SPL) around the enclosure without optimum sample and with optimum sample in the four sound ranges, we found that using nanocomposite D can significantly reduce the noise. According to this study, SA/polyester nonwoven layer/pan nanofibers/nanoclay nanocomposite (nanocomposites D) have great sound absorption properties, which can be used in different environments.


  • Modeling heat stress changes based on wet-bulb globe temperature in respect to global warming

    by Parvin Nassiri, Mohammad Reza Monazzam, Farideh Golbabaei, Somayeh Farhang Dehghan, Aliakbar Shamsipour, Mohammad Javad Ghanadzadeh, Mehdi Asghari

    Background This ecological study aims to model the trend of changes in exposure of outdoor workers to heat stress in outdoors in the coming decades with the use of the Wet-Bulb Globe Temperature (WBGT), Hadley Coupled Atmosphere- Ocean General Circulation Model, version 3 (HADCM3), and Long Ashton Research Station Weather Generator (LARS-WG) in Tehran, Iran, considering the climate change and the global warming. Methods The hourly values of environmental parameters including minimum and maximum air temperature, relative humidity, precipitation and radiation related to Prakash , Shahriar and Damavand cities were obtained from the Meteorological Organization of Iran. These data were recorded during 1965 to 2015. The climate modeling was done for 2011–2030, 2046–2065, and 2080–2099. Results The minimum and maximum air temperatures in the different months of the year in the three studied cities show an increasing trend. Our finding shows that the WBGT will be increased by 2099. In Pakdasht, this index will be close to the danger zone in the coming years, especially in 2080–2099. Conclusions All the results obtained indicate an increase in risk of heat stress in outdoor workplaces, given the global warming.


  • Predicting the probability of occupational fall incidents: a Bayesian network model for the oil industry

    by Yaser Shokouhi, Parvin Nassiri, Iraj Mohammadfam, Kamal Azam

    Purpose: The probability of being injured or killed from occupational incident is much higher than process mishap in the oil and gas industry. The aim of this study was to establish a model...


  • The effect of battery charge levels of Mobile phone on the amount of Electromagnetic waves emission

    by Javad Sajedifar, Parvin Nassiri, Mohammad Reza Monazzam, Mansour Shamsipour, Ramin Ramezani

    Purpose Over the past decades, mobile phone usage have increased dramatically. Extensive development and use of mobile telecommunication services has increased exposure to radio frequency electromagnetic waves (RF-EMW) in the daily lives of humans, and concerns about the harmful effects of mobile phones have also increased on human health. Therefore, this study aimed to investigate the effect of battery charge levels of the mobile phone on electromagnetic waves emission. Methods The mobile phone used in the current study was HTC One E9+ (0.181 W/kg SAR) with a non-removable battery model Li-Po 2800 mAh. The power density was measured with the mobile phone set to operate at the 2G mode by a SMP2 Portable Electromagnetic Field Monitoring System. Power density was measured in Calling mode (50 sec), Called mode (40 sec) and Talking mode (360 sec) at the battery charge levels of 1, 5, 10, 15, 20, 30, 50, 60, 70, 80 and 100%. Results In Calling mode, the maximum electromagnetic waves were determined when the mobile phone had 1% battery charge and also while it was being charged. Contrary to Calling mode, there is no statistically significant difference between the power density emitted in Called mode and Talking mode at the various battery charge levels. Power density was found to be highest in the Called mode (29.11 μw/cm2), and to be higher in the Talking mode (23.005 μw/cm2) than in the Calling mode (10.27 μw/cm2). Conclusions The data of the present study can be used to monitor the daily exposure of mobile phone users as well as to estimate exposure levels in the laboratory and non-laboratory studies. As long as a mobile phone that is in the standby mode remains within the geographic domain of the operator’s service zone, the power density emitted from that phone will be virtually zero, and any background wave can be attributed to other sources.


  • Presenting a conceptual pattern of HSE performance of oil trucks

    by Sahar Ghaleh, Manouchehr Omidvari, Parvin Nassiri, Mansour Momeni, Seyed Mohammadreza Miri Lavasani

    Accidents are among the main problems in the oil product supply chain. The most important effective factors in these events are the kind of trucks used and their health, safety, and environment (HSE) condition. The aim of this study was to present a conceptual pattern of the HSE performance of oil trucks in oil industries. In this study, 20 truck models (with fixed tanks), in use over different periods of time, were investigated. In this regard, the criteria and sub-criteria were first determined in two parts—carrier and tank—and weighted by fuzzy analytical hierarchy process (FAHP). The results showed that the most important sub-criteria regarding the HSE factors of the carrier were resistance and strength of the front and rear shields, the brake system, and the ventilation system. The most important sub-criteria regarding the HSE factors of the tank were tank shell thickness and a good tank design shape with respect to portable material. It should be noted that the weight of the criteria with each other and sub-criteria with each other are not equal. This issue is important for decision-making. The main reason for the use of trucks with the lowest score in developing countries is the lack of attention by managers to safety issues and international standards and agreements such as the ADR.


  • Open Access

    Provision of an Empirical Model to Estimate the Adaptive Capacity of Workers at Risk of Heat Stress

    by Mehdi Asghari, Parvin Nassiri, Mohammad Reza Monazzam, Farideh Golbabaei, Ali Aliakbar Shamsipour, Hossein Arabalibeik

    Background: Workers exposed to extreme heat in the workplace may be at risk of various heat related-illnesses. There are different ways to control heat stress in the workplace. Adaptation to heat is a process by which the body can cope with the heat stress and remove the excess heat. Some criteria affect the adaptability parameter. The present study aimed at determining some important criteria for adaptability to heat. Methods: The most important criteria were extracted according to experts’ opinions and by Delphi model, their weights were specified by fuzzy analytic hierarchy Process (FAHP), and a model was introduced for adaptability. The weights of criteria determined by FAHP were used for prioritization. Results: The maximum percentage of responses (100%) with the relative weight of 0.063 was allocated to the criterion of administrative control. Engineering controls (86.6%), providing shaded area and special places for rest (70%), and having access to healthy drinking water (60%) were considered as other effective criteria for adaptability. Having a second job, personal protective plans, training programs and suitable working clothes can also affect adaptation to heat. Conclusions: In conclusion, adaptability will enable the workers to work in hotter environments for longer periods. According to obtained percentages and weights, the introduced model can be used to prioritize the suitable measures for improving the adaptability of workers and controlling the heat stress. Developing a heat stress control program and implementing this policy requires the cooperation of all members, especially employees. Keywords: Heat Stress; Adaptive Capacity; Heat Stress Disorders/Mortality; Fuzzy AHP; Workers


  • Open Access

    Weighting Criteria and Prioritizing of Heat stress indices in surface mining using a Delphi Technique and Fuzzy AHP-TOPSIS Method

    by Mehdi Asghari, Parvin Nassiri, Mohammad Reza Monazzam, Farideh Golbabaei, Hossein Arabalibeik, Aliakbar Shamsipour, Armin Allahverdy

    Heat stress as a physical harmful agent can increase the risk of health and safety problems in different workplaces such as mining. Although there are diff


  • Open Access

    Evaluation of the effects of occupational noise exposure on serum aldosterone and potassium among industrial workers

    by Sajad Zare, Parvin Nassiri, Mohammad Reza Monazzam, Akram Pourbakht, Kamal Azam, Taghi Golmohammadi

    The existing literature indicates that occupational exposure to noise may have adverse effects on workers’ health. The aim of this study was to evaluate the possible effects of exposure to different sound pressure levels (SPLs) on serum aldosterone and potassium concentration among Iranian blue collar workers in Golgohar Mining and Industrial Company in Sirjan, Kerman Province, Iran. This case-control study was performed on 45 workers of Golgohar Mining and Industrial Company. The subjects consisted of 30 workers from manufacturing departments and 15 office employees of the mining company. The controls, mainly with administrative jobs were exposed to 72 dBA SPL. Cases, in two separate groups, were exposed to noise levels of 88 dBA and 103 dBA, respectively. Noise intensity was measured at the desired locations. Noise measurements were performed according to the International Organization for Standardization (ISO) 9612. To measure the serum aldosterone and potassium concentrations, a 5 mL blood sample was taken from each worker at the specified time intervals and aldosterone concentration was determined using enzyme-linked immunosorbent assay (ELISA) test in the laboratory. Repeated measurement and Spearman’s correlation coefficient analysis were used with α = 0.05. Exposure to the different levels of sound pressure resulted in different aldosterone concentrations and meanwhile an increase in the SPL did not affect the concentration of potassium. From 10:00 AM to 10:30 AM, as SPL increased, aldosterone concentrations did not increase significantly but from 13:30 PM to 14:00 PM, raised SPL led to a significant increase in aldosterone concentration. However, there was no correlation between the concentration of potassium and different factors. This study indicated that increases in SPLs affect aldosterone concentration but at the same time do not have significant effects on serum potassium level.