W. Thomas
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
W. Thomas has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
A. Werner
Deutscher Wetterdienst, Meteorologisches Observatorium Hohenpeissenberg, Albin-Schwaiger-Weg 10, 82383 Hohenpeissenberg, Germany
2 shared publicationsC. Plass-Dülmer
Deutscher Wetterdienst, Meteorologisches Observatorium Hohenpeissenberg, Albin-Schwaiger-Weg 10, 82383 Hohenpeissenberg, Germany
2 shared publicationsH. Claude
Deutscher Wetterdienst, Meteorologisches Observatorium Hohenpeissenberg, Albin-Schwaiger-Weg 10, 82383 Hohenpeissenberg, Germany
2 shared publicationsH. Flentje
Deutscher Wetterdienst, Meteorologisches Observatorium Hohenpeissenberg, Albin-Schwaiger-Weg 10, 82383 Hohenpeissenberg, Germany
2 shared publicationsS. Gilge
Deutscher Wetterdienst, Meteorologisches Observatorium Hohenpeissenberg, Albin-Schwaiger-Weg 10, 82383 Hohenpeissenberg, Germany
2 shared publicationsT. Elste
Deutscher Wetterdienst, Meteorologisches Observatorium Hohenpeissenberg, Albin-Schwaiger-Weg 10, 82383 Hohenpeissenberg, Germany
2 shared publications
Latest Publications
- Open Access
- 26 October 2010
- Published by Copernicus GmbH in Atmospheric Chemistry and Physics
- Vol. 10 (20) , 10085-10092
The Eyjafjallajökull eruption in April 2010 – detection of volcanic plume using in-situ measurements, ozone sondes and lidar-ceilometer profiles
Volcanic emissions from the Eyjafjallajökull volcano eruption on the Southern fringe of Iceland in April 2010 were detected at the Global Atmosphere Watch (GAW) station Zugspitze/Hohenpeissenberg (Germany) by means of in-situ measurements, ozone sondes and ceilometers. Information from the German Meteorological Service (DWD) ceilometer network (Flentje et al., 2010) aided identifying the air mass origin. We discuss ground level in-situ measurements of sulphur dioxide (SO2), sulphuric acid (H2SO4) and particulate matter as well as ozone sonde profiles and column measurements of SO2 by a Brewer spectrometer. At Hohenpeissenberg, a number of reactive gases, e.g. carbon monoxide and nitrogen oxides, and particle properties, e.g. size distribution and ionic composition, were additionally measured during this period. Our results describe the arrival of the volcanic plume at Zugspitze and Hohenpeissenberg during 16 and 17 April 2010 and its residence in the planetary boundary layer (PBL) for several days thereafter. The ash plume was first seen in the ceilometer backscatter profiles at Hohenpeissenberg in about 6–7 km altitude. After entrainment into the PBL at noon of 17 April, largely enhanced values of sulphur dioxide, sulphuric acid and super-micron-particle number concentration were recorded at Zugspitze/Hohenpeissenberg till 21 April.
- 26 October 2010
- Published by Copernicus GmbH in Atmospheric Chemistry and Physics
- Vol. 10 (20) , 10085-10092
Open AccessThe Eyjafjallajökull eruption in April 2010 – detection of volcanic plume using in-situ measurements, ozone sondes and lidar-ceilometer profiles
Volcanic emissions from the Eyjafjallajökull volcano eruption on the Southern fringe of Iceland in April 2010 were detected at the Global Atmosphere Watch (GAW) station Zugspitze/Hohenpeissenberg (Germany) by means of in-situ measurements, ozone sondes and ceilometers. Information from the German Meteorological Service (DWD) ceilometer network (Flentje et al., 2010) aided identifying the air mass origin. We discuss ground level in-situ measurements of sulphur dioxide (SO2), sulphuric acid (H2SO4) and particulate matter as well as ozone sonde profiles and column measurements of SO2 by a Brewer spectrometer. At Hohenpeissenberg, a number of reactive gases, e.g. carbon monoxide and nitrogen oxides, and particle properties, e.g. size distribution and ionic composition, were additionally measured during this period. Our results describe the arrival of the volcanic plume at Zugspitze and Hohenpeissenberg during 16 and 17 April 2010 and its residence in the planetary boundary layer (PBL) for several days thereafter. The ash plume was first seen in the ceilometer backscatter profiles at Hohenpeissenberg in about 6–7 km altitude. After entrainment into the PBL at noon of 17 April, largely enhanced values of sulphur dioxide, sulphuric acid and super-micron-particle number concentration were recorded at Zugspitze/Hohenpeissenberg till 21 April.
- Open Access
- 18 June 2010
- Published by Copernicus GmbH in EGUsphere
- Vol. 10 (20) , 10085-10092
The Eyjafjallajökull eruption in April 2010 – detection of volcanic plume using in-situ measurements, ozone sondes and a new generation ceilometer network
Volcanic emissions from the Eyjafjallajökull volcano eruption on the Southern fringe of Iceland in April 2010 were detected at the Global Atmosphere Watch (GAW) station Zugspitze/Hohenpeissenberg (Germany) by means of in-situ measurements, ozone sondes and ceilometers. Information from the German Meteorological Service (DWD) ceilometer network (Flentje et al., 2010) aided identifying the air mass origin. We discuss ground level in-situ measurements of sulphur dioxide (SO2), sulphuric acid (H2SO4) and particulate matter as well as ozone sonde profiles and column measurements of SO2 by a Brewer spectrometer. At Hohenpeissenberg, a number of reactive gases, e.g. carbon monoxide and nitrogen oxides, and particle properties, e.g. size distribution and ionic composition, were additionally measured during this period. Our results describe the arrival of the volcanic plume at Zugspitze and Hohenpeissenberg during 16 and 17 April 2010 and its residence in the planetary boundary layer (PBL) for several days thereafter. The ash plume was first seen in the ceilometer backscatter profiles at Hohenpeissenberg in about 6–7 km altitude. After entrainment into the PBL at noon of 17 April, largely enhanced values of sulphur dioxide, sulphuric acid and super-micron-particle number concentration were recorded at Zugspitze/Hohenpeissenberg till 21 April.
- 18 June 2010
- Published by Copernicus GmbH in EGUsphere
- Vol. 10 (20) , 10085-10092
Open AccessThe Eyjafjallajökull eruption in April 2010 – detection of volcanic plume using in-situ measurements, ozone sondes and a new generation ceilometer network
Volcanic emissions from the Eyjafjallajökull volcano eruption on the Southern fringe of Iceland in April 2010 were detected at the Global Atmosphere Watch (GAW) station Zugspitze/Hohenpeissenberg (Germany) by means of in-situ measurements, ozone sondes and ceilometers. Information from the German Meteorological Service (DWD) ceilometer network (Flentje et al., 2010) aided identifying the air mass origin. We discuss ground level in-situ measurements of sulphur dioxide (SO2), sulphuric acid (H2SO4) and particulate matter as well as ozone sonde profiles and column measurements of SO2 by a Brewer spectrometer. At Hohenpeissenberg, a number of reactive gases, e.g. carbon monoxide and nitrogen oxides, and particle properties, e.g. size distribution and ionic composition, were additionally measured during this period. Our results describe the arrival of the volcanic plume at Zugspitze and Hohenpeissenberg during 16 and 17 April 2010 and its residence in the planetary boundary layer (PBL) for several days thereafter. The ash plume was first seen in the ceilometer backscatter profiles at Hohenpeissenberg in about 6–7 km altitude. After entrainment into the PBL at noon of 17 April, largely enhanced values of sulphur dioxide, sulphuric acid and super-micron-particle number concentration were recorded at Zugspitze/Hohenpeissenberg till 21 April.
- Open Access
- 1 February 2009
- Published by American Meteorological Society in Journal of Applied Meteorology and Climatology
- Vol. 48 (2) , 301-316
The CM-SAF and FUB Cloud Detection Schemes for SEVIRI: Validation with Synoptic Data and Initial Comparison with MODIS and CALIPSO
The Satellite Application Facility on Climate Monitoring (CM-SAF) is aiming to retrieve satellite-derived geophysical parameters suitable for climate monitoring. CM-SAF started routine operations in early 2007 and provides a climatology of parameters describing the global energy and water cycle on a regional scale and partially on a global scale. Here, the authors focus on the performance of cloud detection methods applied to measurements of the Spinning Enhanced Visible and Infrared Imager (SEVIRI) on the first Meteosat Second Generation geostationary spacecraft. The retrieved cloud mask is the basis for calculating the cloud fractional coverage (CFC) but is also mandatory for retrieving other geophysical parameters. Therefore, the quality of the cloud detection directly influences climate monitoring of many other parameters derived from spaceborne sensors. CM-SAF products and results of an alternative cloud coverage retrieval provided by the Institut für Weltraumwissenschaften of the Freie Universität in Berlin, Germany (FUB), were validated against synoptic measurements. Furthermore, and on the basis of case studies, an initial comparison was performed of CM-SAF results with results derived from the Moderate Resolution Imaging Spectrometer (MODIS) and from the Cloud–Aerosol Lidar with Orthogonal Polarization (CALIOP). Results show that the CFC from CM-SAF and FUB agrees well with synoptic data and MODIS data over midlatitudes but is underestimated over the tropics and overestimated toward the edges of the visible Earth disk.
- 1 February 2009
- Published by American Meteorological Society in Journal of Applied Meteorology and Climatology
- Vol. 48 (2) , 301-316
Open AccessThe CM-SAF and FUB Cloud Detection Schemes for SEVIRI: Validation with Synoptic Data and Initial Comparison with MODIS and CALIPSO
The Satellite Application Facility on Climate Monitoring (CM-SAF) is aiming to retrieve satellite-derived geophysical parameters suitable for climate monitoring. CM-SAF started routine operations in early 2007 and provides a climatology of parameters describing the global energy and water cycle on a regional scale and partially on a global scale. Here, the authors focus on the performance of cloud detection methods applied to measurements of the Spinning Enhanced Visible and Infrared Imager (SEVIRI) on the first Meteosat Second Generation geostationary spacecraft. The retrieved cloud mask is the basis for calculating the cloud fractional coverage (CFC) but is also mandatory for retrieving other geophysical parameters. Therefore, the quality of the cloud detection directly influences climate monitoring of many other parameters derived from spaceborne sensors. CM-SAF products and results of an alternative cloud coverage retrieval provided by the Institut für Weltraumwissenschaften of the Freie Universität in Berlin, Germany (FUB), were validated against synoptic measurements. Furthermore, and on the basis of case studies, an initial comparison was performed of CM-SAF results with results derived from the Moderate Resolution Imaging Spectrometer (MODIS) and from the Cloud–Aerosol Lidar with Orthogonal Polarization (CALIOP). Results show that the CFC from CM-SAF and FUB agrees well with synoptic data and MODIS data over midlatitudes but is underestimated over the tropics and overestimated toward the edges of the visible Earth disk.
- 1 March 2005
- Published by Springer Nature in Journal of Atmospheric Chemistry
- Vol. 50 (3) , 295-320
On the Retrieval of Volcanic Sulfur Dioxide Emissions from GOME Backscatter Measurements
- 1 March 2005
- Published by Springer Nature in Journal of Atmospheric Chemistry
- Vol. 50 (3) , 295-320
On the Retrieval of Volcanic Sulfur Dioxide Emissions from GOME Backscatter Measurements