RGRobert Chad Gilliam

Robert Chad Gilliam

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Robert Chad Gilliam has a total of 71 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Trends and Variability in Concentrations and Source Contributions of 2002–2019 Ozone and Particulate Matter Over the Northern Hemisphere

    by Christian Hogrefe, Rohit Mathur, Sergey Napelenok, Barron Henderson, Golam Sarwar, George Pouliot, Jeff Willison, Robert Gilliam, Wyat Appel, Bill Hutzell, et al.


  • Open Access

    Investigating processes influencing simulation of local Arctic wintertime anthropogenic pollution in Fairbanks, Alaska, during ALPACA-2022

    by Natalie Brett, Kathy S. Law, Steve R. Arnold, Javier G. Fochesatto, Jean-Christophe Raut, Tatsuo Onishi, Robert Gilliam, Kathleen Fahey, Deanna Huff, George Pouliot, et al.

    Lagrangian tracer simulations are deployed to investigate processes influencing vertical and horizontal dispersion of anthropogenic pollution in Fairbanks, Alaska, during the Alaskan Layered Pollution and Chemical Analysis (ALPACA) 2022 field campaign. Simulated concentrations of carbon monoxide (CO), sulfur dioxide (SO2), and nitrogen oxides (NOx), including surface and elevated sources, are the highest at the surface under very cold stable conditions. Pollution enhancements above the surface (50–300 m) are mainly attributed to elevated power plant emissions. Both surface and elevated sources contribute to Fairbanks' regional pollution that is transported downwind, primarily to the south-west, and may contribute to wintertime Arctic haze. Inclusion of a novel power plant plume rise treatment that considers the presence of surface and elevated temperature inversion layers leads to improved agreement with observed CO and NOx plumes, with discrepancies attributed to, for example, displacement of plumes by modelled winds. At the surface, model results show that observed CO variability is largely driven by meteorology and, to a lesser extent, by emissions, although simulated tracers are sensitive to modelled vertical dispersion. Modelled underestimation of surface NOx during very cold polluted conditions is considerably improved following the inclusion of substantial increases in diesel vehicle NOx emissions at cold temperatures (e.g. a factor of 6 at −30 °C). In contrast, overestimation of surface SO2 is attributed mainly to model deficiencies in vertical dispersion of elevated (5–18 m) space heating emissions. This study highlights the need for improvements to local wintertime Arctic anthropogenic surface and elevated emissions and improved simulation of Arctic stable boundary layers.


  • Open Access

    Performance Evaluation of the Meteorology and Air Quality Conditions From Multiscale WRF‐CMAQ Simulations for the Long Island Sound Tropospheric Ozone Study (LISTOS)

    by Ana Torres‐Vazquez, Jonathan Pleim, Robert Gilliam, George Pouliot

    The Long Island Sound (LIS) Tropospheric Ozone Study was a multi‐agency collaborative field campaign conducted during the summer of 2018 to improve the understanding of ozone chemistry and transport from New York City to areas downstream, especially the LIS and adjacent Connecticut coastline. Measurements made during this campaign were leveraged to test and evaluate the coupled WRF‐CMAQ model at 12 km, 4 and 1.33 km horizontal grid spacing. Special attention was placed on the model's representation of sea breeze circulations, low level jets, and boundary layer evolution. The evaluation suggests using higher resolutions resulted in improved surface meteorology statistics throughout the whole summer, with temperature biases seeing the biggest statistical improvements when using 1.33‐km grid spacing, going from −0.12 to 0.08 K. Additionally, 4‐km grid spacing provided the biggest advantage when simulating ozone over the region of interest, with biases being reduced from 2.40 to 0.57 to 0.37 ppbV with increased resolution. Case studies of two high ozone concentration events (July 10 and August 6) revealed that sound breezes and low‐level jets had a critical role in transporting pollutant‐rich, shallow marine air masses from the LIS inland over the Connecticut coast. Modifications were made to the representation of sea surface temperatures, which subsequently improved the simulation of surface ozone predictions.


  • Diagnostic Analysis of CMAQ Dry Deposition Fields in the Context of AQMEII4

    by Christian Hogrefe, Jesse Bash, Jonathan Pleim, Donna Schwede, Robert Gilliam, Kristen Foley, K. Wyat Appel, Rohit Mathur

  • Open Access

    Establishing the Suitability of the Model for Prediction Across Scales for Global Retrospective Air Quality Modeling

    by Robert C. Gilliam, Jerold A. Herwehe, O. Russell Bullock, Jonathan E. Pleim, Limei Ran, Patrick C. Campbell, Hosein Foroutan

    The U.S. EPA (United States Environmental Protection Agency) is leveraging recent advances in meteorological modeling to construct an air quality modeling system to allow consistency from global to local scales. The Model for Prediction Across Scales‐Atmosphere (MPAS‐A or MPAS) has been developed by the National Center for Atmospheric Research (NCAR) as a global complement to the Weather Research and Forecasting model (WRF). Patterned after a regional coupled system with WRF, the Community Multiscale Air Quality (CMAQ) modeling system has been coupled within MPAS to explore global‐to‐local chemical transport modeling. Several options were implemented into MPAS for retrospective applications. Nudging‐based data assimilation was added to support continuous simulations of past weather to minimize error growth that exists with a weather forecast configuration. The Pleim‐Xiu land‐surface model, the Asymmetric Convective Model 2 boundary layer scheme, and the Pleim surface layer scheme were added as the preferred options for retrospective air quality applications with WRF. Annual simulations were conducted using this EPA‐enhanced MPAS configuration on two different mesh structures and compared against WRF. MPAS generally compares well with WRF over the conterminous United States. Errors in MPAS surface meteorology are comparable to WRF throughout the year. Precipitation statistics indicate MPAS performs slightly better than WRF. Solar radiation in MPAS is higher than WRF and measurements, suggesting fewer clouds in MPAS than WRF. Upper‐air meteorology is well‐simulated by MPAS, but errors are slightly higher than WRF. These comparisons lend confidence to use MPAS for retrospective air quality modeling and suggest ways it can be further improved in the future.


  • Open Access

    Impacts of Tiled Land Cover Characterization on Global Meteorological Predictions Using the MPAS‐A

    by Patrick C. Campbell, Jesse O. Bash, Jerold A. Herwehe, Robert C. Gilliam, Dan Li

    Parameterization of subgrid‐scale variability of land cover characterization (LCC) is an active area of research and can improve model performance compared to the dominant (i.e., most abundant tile) approach. The “Noah” land surface model implementation in the global Model for Prediction Across Scales‐Atmosphere (MPAS‐A), however, only uses the dominant LCC approach that leads to oversimplification in regions of highly heterogeneous LCC (e.g., urban/suburban settings). Thus, in this work we implement a subgrid tiled approach as an option in MPAS‐A, version 6.0, and assess the impacts of tiled LCC on meteorological predictions for two gradually refining meshes (92–25 and 46–12 km) focused on the conterminous United States for January and July 2016. Compared to the dominant approach, results show that using the tiled LCC leads to pronounced global changes in 2‐m temperature (July global average change approximately −0.4 K), 2‐m moisture, and 10‐m wind speed for the 92–25 km mesh. The tiled LCC reduces mean biases in 2‐m temperature (July U.S. average bias reduction approximately factor of 4) and specific humidity in the central and western United States for the 92–25 km mesh and improves the agreement of vertical profiles (e.g., temperature, humidity, and wind speed) with observed radiosondes; however, there is increased bias and error for incoming solar radiation at the surface. The inclusion of subgrid LCC has implications for reducing systematic temperature biases found in numerical weather prediction models, particularly those that employ a dominant LCC approach.


  • Open Access

    Significant ground-level ozone attributed to lightning-induced nitrogen oxides during summertime over the Mountain West States

    by Daiwen Kang, Rohit Mathur, George A. Pouliot, Robert C. Gilliam, David C. Wong

    Using lightning flash data from the National Lightning Detection Network with an updated lightning nitrogen oxides (NOx) emission estimation algorithm in the Community Multiscale Air Quality (CMAQ) model, we estimate the hourly variations in lightning NOxemissions for the summer of 2011 and simulate its impact on distributions of tropospheric ozone (O3) across the continental United States. We find that typical summer-time lightning activity across the U.S. Mountain West States (MWS) injects NOxemissions comparable to those from anthropogenic sources into the troposphere over the region. Comparison of two model simulation cases with and without lightning NOxemissions show that significant amount of ground-level O3in the MWS during the summer can be attributed to the lightning NOXemissions. The simulated surface-level O3from a model configuration incorporating lightning NOxemissions showed better agreement with the observed values than the model configuration without lightning NOxemissions. The time periods of significant reduction in bias in simulated O3between these two cases strongly correlate with the time periods when lightning activity occurred in the region. The inclusion of lightning NOxincreased daily maximum 8 h O3by up to 17 ppb and improved model performance relative to measured surface O3mixing ratios in the MWS region. Analysis of model results in conjunction with lidar measurements at Boulder, Colorado during July 2014 corroborated similar impacts of lightning NOxemissions on O3air quality. The magnitude of lightning NOxemissions estimated for other summers is comparable to the 2011 estimates suggesting that summertime surface-level O3levels in the MWS region could be significantly influenced by lightning NOx.


  • Open Access

    Impacts of tiled land cover characterization in the Model for Prediction Across Scales-Atmosphere (MPAS-A)

    by Patrick Campbell, Jesse Owen Bash, Jerold A. Herwehe, Robert Chad Gilliam, Dan Li

    Parameterization of subgrid-scale variability of land cover characterization (LCC) is an active area of research, and can improve model performance compared to the dominant (i.e., most abundant tile) approach. The “Noah” land surface model implementation in the global Model for Predictions Across Scales-Atmosphere (MPAS-A), however, only uses the dominant LCC approach that leads to oversimplification in regions of highly heterogeneous LCC (e.g., urban/suburban settings). Thus, in this work we implement a subgrid tiled approach as an option in MPAS-A, version 6.0, and assess the impacts of tiled LCC on meteorological predictions for two gradually refining meshes (92-25 and 46-12 km) focused on the conterminous U.S for January and July 2016. Compared to the dominant approach, results show that using the tiled LCC leads to pronounced global changes in 2-m temperature (July global average change ~ -0.4 K), 2-m moisture, and 10-m wind speed for the 92-25 km mesh. The tiled LCC reduces mean biases in 2-m temperature (July U.S. average bias reduction ~ factor of 4) and specific humidity in the central and western U.S. for the 92-25 km mesh, improves the agreement of vertical profiles (e.g., temperature, humidity, and wind speed) with observed radiosondes, and there is a general decrease in error for precipitation in the U.S.; however, there is increased bias and error for incoming solar radiation at the surface. The inclusion of subgrid LCC has implications for reducing systematic warm biases found in numerical weather prediction models.

  • Open Access

    Impact of cumulus parameterization options on clouds, ozone, and PM2.5 in regional- to urban-scale WRF-CMAQ simulations

    by Wyat Appel, Christian Hogrefe, Kristen Foley, Robert Gilliam, Shawn Roselle

    The Community Multiscale Air Quality (CMAQ) model is a state-of-the-science chemical transport model (CTM) capable of simulating the emission, transport and fate of numerous air pollutants. Similarly, the Weather Research and Forecasting (WRF) model is a state-of-the-science meteorological model capable of simulating meteorology at many scales (e.g. global to urban). The coupled WRF-CMAQ system integrates these two models in a “two-way” configuration which allows feedback effects between the chemical (e.g. aerosols) and physical (e.g. solar radiation) states of the atmosphere and more frequent communication between the CTM and meteorological model than is typically done in uncoupled WRF-CMAQ simulations. In this study we apply the various cumulus parameterization (CP) options available in WRF at horizontal grid spacings ranging from regional scale (i.e. 12-km) to urban scale (i.e. 4 and 1 km), focused on the July 2011 DISCOVER-AQ campaign that took place over the Baltimore-Washington D.C region. Of particular interest is the evaluation of the WRF simulated clouds, as analysis of previous WRF-CMAQ simulations using a “standard” 12-km configuration for the model suggest that WRF has difficulty predicting clouds (particularly fair-weather clouds), with decreasing skill at finer horizontal grid spacings. Here we will examine the impact that the WRF CP options have on cloud predictions, using available satellite data to evaluate model the performance. We then examine how changes in the WRF simulated clouds affect CMAQ predictions of ozone and PM2.5 at the various scales.

  • Open Access

    Impact of inherent meteorology uncertainty on air quality model predictions

    by Robert C. Gilliam, Christian Hogrefe, James M. Godowitch, Sergey Napelenok, Rohit Mathur, S. Trivikrama Rao

    It is well established that there are a number of different classifications and sources of uncertainties in environmental modeling systems. Air quality models rely on two key inputs, namely, meteorology and emissions. When using air quality models for decision making, it is important to understand how uncertainties in these inputs affect the simulated concentrations. Ensembles are one method to explore how uncertainty in meteorology affects air pollution concentrations. Most studies explore this uncertainty by running different meteorological models or the same model with different physics options and in some cases combinations of different meteorological and air quality models. While these have been shown to be useful techniques in some cases, we present a technique that leverages the initial condition perturbations of a weather forecast ensemble, namely, the Short‐Range Ensemble Forecast system to drive the four‐dimensional data assimilation in the Weather Research and Forecasting (WRF)‐Community Multiscale Air Quality (CMAQ) model with a key focus being the response of ozone chemistry and transport. Results confirm that a sizable spread in WRF solutions, including common weather variables of temperature, wind, boundary layer depth, clouds, and radiation, can cause a relatively large range of ozone‐mixing ratios. Pollutant transport can be altered by hundreds of kilometers over several days. Ozone‐mixing ratios of the ensemble can vary as much as 10–20 ppb or 20–30% in areas that typically have higher pollution levels.