Henry Leung
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Henry Leung has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Zhiwen Zhu
Communications Research Centre Canada, Ottawa, Canada
3 shared publications - Xinping Huang
Communications Research Centre Canada, Ottawa, Canada
2 shared publications - Mario Caron
Communications Research Centre Canada, Ottawa, Canada
1 shared publication - Xinping Huang
Communications Research Centre Canada, Ottawa, Canada
1 shared publication Zhiwen Zhu
1 shared publication
Latest Publications
- 10 September 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 61 (12) , 927-931
Compensation of Delay Mismatch in a Direct Conversion Transmitter
This brief analyzes the effects of the delay mismatch (DM) between in-phase (I) and quadrature (Q) branches of a direct conversion transmitter (DCT) on its image rejection capability. An iterative technique is proposed to compensate for the DM, based on the instantaneous power measurement of the DCT output signal. It is shown that the proposed compensation technique can obtain the true DM value even when the I/Q impairment exists in the DCT. Simulation results show that the proposed technique can effectively compensate for the DM, thereby improving the DCT performance.
- 10 September 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 61 (12) , 927-931
Compensation of Delay Mismatch in a Direct Conversion Transmitter
This brief analyzes the effects of the delay mismatch (DM) between in-phase (I) and quadrature (Q) branches of a direct conversion transmitter (DCT) on its image rejection capability. An iterative technique is proposed to compensate for the DM, based on the instantaneous power measurement of the DCT output signal. It is shown that the proposed compensation technique can obtain the true DM value even when the I/Q impairment exists in the DCT. Simulation results show that the proposed technique can effectively compensate for the DM, thereby improving the DCT performance.
- 9 September 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Signal Processing Letters
- Vol. 20 (11) , 1042-1045
A Blind AM/PM Estimation Method for Power Amplifier Linearization
A higher order statistics (HOS)-based method is proposed in this letter to estimate the nonlinear amplitude-to-phase (AM/PM) conversion function of power amplifiers (PAs) in communications systems. By utilizing the symmetry property of the modulated signal, the proposed method estimates the AM/PM conversion function using only the PA output signal, from which the phase predistorter (PD) function can be derived. Simulation results show that the HOS-based method can accurately determine the phase PD function required to compensate for the AM/PM distortion in the PA, yielding a linearization performance close to that of non-blind methods in terms of adjacent channel power ratio and error vector magnitude.
- 9 September 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Signal Processing Letters
- Vol. 20 (11) , 1042-1045
A Blind AM/PM Estimation Method for Power Amplifier Linearization
A higher order statistics (HOS)-based method is proposed in this letter to estimate the nonlinear amplitude-to-phase (AM/PM) conversion function of power amplifiers (PAs) in communications systems. By utilizing the symmetry property of the modulated signal, the proposed method estimates the AM/PM conversion function using only the PA output signal, from which the phase predistorter (PD) function can be derived. Simulation results show that the HOS-based method can accurately determine the phase PD function required to compensate for the AM/PM distortion in the PA, yielding a linearization performance close to that of non-blind methods in terms of adjacent channel power ratio and error vector magnitude.
- 14 May 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Wireless Communications
- Vol. 12 (6) , 2941-2951
Joint I/Q Mismatch and Distortion Compensation in Direct Conversion Transmitters
Analog and radio frequency (RF) front-end circuit impairments such as mismatches between in-phase (I) and quadrature (Q) branches can severely degrade performance of wireless communications systems. In this paper, we propose a technique to compensate for both frequency-independent and frequency-dependent impairments in direct conversion transmitters (DCTs). The technique employs a recursive algorithm to estimate the impairments from instantaneous power of the transmitted RF signal, and it jointly mitigates the mismatches/imbalances between the I and Q branches and the distortions in each of the I and Q branches. It is applicable to wireless communications systems that employ different modulation techniques. Theoretical analyses are presented for identifiability and convergence properties of the technique. Effects of imperfect measurement are discussed. Both computer simulation and prototype experimentation are carried out to demonstrate that the proposed technique accurately determines and compensates for the DCT impairment, and improves the transmitted signal quality.
- 14 May 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Wireless Communications
- Vol. 12 (6) , 2941-2951
Joint I/Q Mismatch and Distortion Compensation in Direct Conversion Transmitters
Analog and radio frequency (RF) front-end circuit impairments such as mismatches between in-phase (I) and quadrature (Q) branches can severely degrade performance of wireless communications systems. In this paper, we propose a technique to compensate for both frequency-independent and frequency-dependent impairments in direct conversion transmitters (DCTs). The technique employs a recursive algorithm to estimate the impairments from instantaneous power of the transmitted RF signal, and it jointly mitigates the mismatches/imbalances between the I and Q branches and the distortions in each of the I and Q branches. It is applicable to wireless communications systems that employ different modulation techniques. Theoretical analyses are presented for identifiability and convergence properties of the technique. Effects of imperfect measurement are discussed. Both computer simulation and prototype experimentation are carried out to demonstrate that the proposed technique accurately determines and compensates for the DCT impairment, and improves the transmitted signal quality.
- 17 February 2004
- Published by American Physical Society (APS) in Physical Review E
- Vol. 69 (2) , 026201
Time-varying synchronization of chaotic systems in the presence of system mismatch
The problem of synchronization of two identical chaotic systems in the presence of system mismatch is investigated in this article. The instantaneous mean square error (E) of the unidirectionally coupled synchronization scheme is analyzed based on the Jacobian equation of the response system. It is shown that synchronization based on a constant coupling parameter does not produce satisfactory performance. A synchronization scheme is proposed here, and the time-varying coupling parameter sequence used in this new scheme is obtained by minimizing the instantaneous E. Numerical simulations show that the proposed time-varying synchronization method has smaller mean square synchronization error than the conventional approach based on using a constant coupling parameter.
- 17 February 2004
- Published by American Physical Society (APS) in Physical Review E
- Vol. 69 (2) , 026201
Time-varying synchronization of chaotic systems in the presence of system mismatch
The problem of synchronization of two identical chaotic systems in the presence of system mismatch is investigated in this article. The instantaneous mean square error (E) of the unidirectionally coupled synchronization scheme is analyzed based on the Jacobian equation of the response system. It is shown that synchronization based on a constant coupling parameter does not produce satisfactory performance. A synchronization scheme is proposed here, and the time-varying coupling parameter sequence used in this new scheme is obtained by minimizing the instantaneous E. Numerical simulations show that the proposed time-varying synchronization method has smaller mean square synchronization error than the conventional approach based on using a constant coupling parameter.