Mathias Uhl

Blue–green infrastructures (BGI) play an important role in addressing contemporary challenges posed by urbanization, climate change, and demographic shifts. This study focuses on the parameterization of BGI within hydrological models, specifically emphasizing the Low Impact Development (LID) module of the Storm Water Management Model (SWMM), supplemented by the SWMM-UrbanEVA evapotranspiration model. Employing a systematic approach, a transferable framework is developed to categorize BGI types, leading to a comprehensive parameterization toolset. This toolset includes parameter estimates for predefined BGI types, encompassing both natural and technical systems with a specific emphasis on plant-specific parameterization. The justification of these parameter estimates is supported by an extensive literature review. Sensitivity analyses reveal the influence of plant-specific parameters, such as the crop factor (K_C), and soil storage capacity, on water balance and peak runoff. Additionally, this study presents practical guidelines to enhance the comprehension of model behavior and ensure the highest possible quality in model parameterization. While further research on validity and transferability of the toolset is required, the findings of this study provide useful support for the differentiated representation and analysis of hydrological processes in urban environments. As a result, this study serves as a valuable resource for researchers, practitioners, and decision makers, facilitating the implementation of sustainable water management practices in urban settings.

In Germany, the current sectoral urban planning often leads to inefficient use of resources, partly because municipalities lack integrated planning instruments and argumentation strength toward politics, investors, or citizens. The paper develops the ResourcePlan as (i) legal and (ii) a planning instrument to support the efficient use of resources in urban neighborhoods. The integrative, multi-methodological approach addresses the use of natural resources in the building and infrastructural sectors of (i) water (storm- and wastewater) management, (ii) construction and maintenance of buildings and infrastructure, (iii) urban energy system planning, and (iv) land-use planning. First, the development as legal instrument is carried out, providing (i) premises for integrating resource protection at all legal levels and (ii) options for implementing the ResourcePlan within German municipal structures. Second, the evaluation framework for resource efficiency of the urban neighborhoods is set up for usage as a planning instrument. The framework provides a two-stage process that runs through the phases of setting up and implementing the ResourcePlan. (Eco)system services are evaluated as well as life cycle assessment and economic aspects. As a legal instrument, the ResourcePlan integrates resource protection into municipal planning and decision-making processes. The multi-methodological evaluation framework helps to assess inter-disciplinary resource efficiency, supports the spatial identification of synergies and conflicting goals, and contributes to transparent, resource-optimized planning decisions.

Decentralized treatment of stormwater runoff from heavily polluted surface can be a good solution for effective source control. Decentralized stormwater treatment systems (DS) and test procedures to monitor their performance, have been developed in recent years. At present in Germany, only lab-based tests are officially established to determine the removal efficiency of Total Suspended Solids (TSS), and in situ monitoring is still lacking. Furthermore, the fine fraction of TSS with particle sizes less than 63 µm (TSS63) have been established as a new design parameter in Germany, because of their substitute characteristics of adsorbing pollutant substances. For research and evaluation purposes continuous data of urban stormwater runoff quantity and quality at the in- and outflow of two different DS at two different sites were collected. Turbidity is used as a surrogate for TSS. Continuous turbidity data and time proportional sampling served to obtain (i) regression coefficients and (ii) to determine the TSS removal efficiency of DS. For a wide range of events the total removal efficiency of DS1 was 29% for TSS and 19% for TSS63 and for DS2 19% for TSS and 16% for TSS63. An event-based data analysis revealed a high variability of the efficiencies and its uncertainties. Moreover, outwash of still suspended or remobilization of already deposited material was observed at individual events. At both sites TSS63 dominates urban stormwater runoff as indicated by the mean ratios of TSS63 to TSS of 0.78 at the inflows and 0.89 at the outflows of both DS. A significant shift of TSS63 ratio from inflow to outflow demonstrates that TSS63 particles were removed less efficiently than coarser particles by DS1, for DS2 data was too heterogeny. It clarifies that common sedimentation methods can only contribute to a small extent to the reduction of solid emissions if the stormwater runoff contains mainly fine-particle solids. The findings suggest that treatment of urban stormwater runoff with high TSS63 pollution requires additional techniques such as a proper filtering to retain fine particles more effective.

Urban hydrology has so far lacked a suitable model for a precise long-term determination of evapotranspiration (ET) addressing shading and vegetation-specific dynamics. The proposed model “SWMM-UrbanEVA” is fully integrated into US EPA’s Stormwater Management Model (SWMM) and consists of two submodules. Submodule 1, “Shading”, considers the reduction in potential ET due to shading effects. Local variabilities of shading impacts can be addressed for both pervious and impervious catchments. Submodule 2, “Evapotranspiration”, allows the spatio-temporal differentiated ET simulation of vegetation and maps dependencies on vegetation, soil, and moisture conditions which are necessary for realistically modeling vegetation’s water balance. The model is tested for parameter sensitivities, validity, and plausibility of model behaviour and shows good model performance for both submodules. Depending on location and vegetation, remarkable improvements in total volume errors Vol (from Vol = 0.59 to −0.04% for coniferous) and modeling long-term dynamics, measured by the Nash–Sutcliffe model efficiency (NSE) (from NSE = 0.47 to 0.87 for coniferous) can be observed. The most sensitive model inputs to total ET are the shading factor K_S and the crop factor K_C. Both must be derived very carefully to minimize volume errors. Another focus must be set on the soil parameters since they define the soil volume available for ET. Process-oriented differentiation between ET fluxes interception evaporation, transpiration, and soil evaporation, using the leaf area index, behaves realistically but shows a lack in volume errors. Further investigations on process dynamics, validation, and parametrization are recommended.

Stormwater quality models are usually calibrated using observed pollutographs. As current models still rely on simplified model concepts for pollutant accumulation and wash-off, calibration results for continuous pollutant concentrations are highly uncertain. In this paper, we introduce an innovative calibration approach based on total suspended solids (TSS) event load distribution. The approach is applied on stormwater quality models for a flat roof and a parking lot for which reliable distributions are available. Exponential functions are employed for both TSS buildup and wash-off. Model parameters are calibrated by means of an evolutionary algorithm to minimize the distance between a parameterized lognormal distribution function and the cumulated distribution of simulated TSS event loads. Since TSS event load characteristics are probabilistically considered, the approach especially respects the stochasticity of TSS buildup and wash-off and, therefore, improves conventional stormwater quality calibration concepts. The results show that both experimental models were calibrated with high goodness-of-fit (Kolmogorov–Smirnov test statistic: 0.05). However, it is shown that events with high TSS event loads (>0.8 percentile) are generally underestimated. While this leads to a relative deviation of −28% of total TSS loads for the parking lot, the error is compensated for the flat roof (+5%). Calibrated model parameters generally tend to generate wash-off proportional to runoff, which is indicated by mass-volume curves. The approach itself is, in general, applicable and creates a new opportunity to calibrate stormwater quality models especially when calibration data is limited.

Results from a long-term stormwater quality monitoring program were used to derive total suspended solids (TSS) event load distributions at four small urban environments (flat roof, parking lot, residential catchment, high traffic street). Theoretical distribution functions were fitted to the empirical distribution functions obtained. Parameters of the theoretical distribution functions were optimized with respect to a likelihood function to get both optimized parameters and standard errors. Kolmogorov-Smirnov and Anderson-Darling test statistics were applied to assess the goodness-of-fit between empirical and theoretical distribution. The lognormal distribution function was found to be most expressive to approximate empirical TSS event load distributions at all sites. However, the goodness-of-fit of the statistical model strongly depends on the number of events available. Based on the results of a Monte-Carlo-based resampling strategy, around 40 events should be considered.

Stormwater runoff quality was measured with online turbidity sensors at four common types of small urban subcatchments: (i) a flat roof; (ii) a parking lot; (iii) a residential catchment; and (iv) a high-traffic street. Samples were taken to estimate site-specific correlations between total suspended solids (TSS) and turbidity. Continuous TSS time series were derived from online turbidity measurements and were used to estimate event loads and event mean concentrations. Rainfall runoff event characteristics were subjected to correlation analysis to TSS loads. Significant correlations were found for rainfall intensities at sites with high imperviousness and decrease with increasing catchment size. Antecedent dry weather periods are only correlated at the parking lot site. Intra-event TSS load distributions were studied with M (V)-curves. M (V)-curves are grouped at runoff quantiles and statistically described with boxplots. All sites show, in general, a more pronounced first-flush effect. While wash-off of the flat roof tends to be source-limited, the parking lot and high-traffic street sites show a more transport-limited behavior. Wash-off process of the residential catchment appears to be influenced by a composition of different subcatchments.

Die Auswirkungen des Klimawandels und der demografische Wandel zählen derzeit zu den zentralen Herausforderungen der Kommunalpolitik. In Deut

Vertical flow treatment wetlands have been developed as very useful tools for treatment of combined sewage overflow. Several systems have been in operation for over 15 years. Based on recent research work, new technical guidelines now recommend systems with a drained filter of sand 0/2 mm and a throttled outflow. COD, NH₄-N and SS removal rates of 85–99% can be expected from this type of filter. SS loadings that are too high and very long or frequent inundation affect the performance adversely. Information for successful long-term operation were derived from various existing plants.