Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Fabian M. Dayrit has a total of 20 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Analysis of 26 Studies of the Impact of Coconut Oil on Lipid Parameters: Beyond Total and LDL Cholesterol

    by Mary T. Newport, Fabian M. Dayrit

    Coconut oil (CNO) is often characterized as an “artery-clogging fat” because it is a predominantly saturated fat that ostensibly raises total cholesterol (TChol) and LDL cholesterol (LDL-C). Whereas previous analyses assessed CNO based on the relative effects on lipid parameters against other fats and oils, this analysis focuses on the effects of CNO itself. Here, we review the literature on CNO and analyze 984 lipid profile data sets from 26 CNO studies conducted over the past 40 years. This analysis shows considerable heterogeneity among CNO studies regarding participant selection, the amount consumed, and the study duration. The analysis reveals that, overall, CNO consumption gives variable TChol and LDL-C values, but that the HDL-cholesterol (HDL-C) values increase and triglycerides (TG) decrease. This holistic lipid assessment, together with the consideration of lipid ratios, shows that CNO does not pose a health risk for heart disease. Because the predominantly medium-chain fatty acid profile of CNO is significantly different from that of lard and palm oil, studies using these as reference materials do not apply to CNO. This paper concludes that the recommendation to avoid consuming coconut oil due to the risk of heart disease is not justified.


  • Open Access

    Analysis of 26 Studies of the Impact of Coconut Oil on Lipid Parameters: Beyond Total- and LDL-Cholesterol

    by Mary T. Newport, Fabian M. Dayrit

    Coconut oil (CNO) is often characterized as an “artery clogging fat” because it is a predominantly saturated fat that ostensibly raises total cholesterol (TChol) and LDL-cholesterol (LDL-C). Whereas previous analyses assessed CNO based on relative effects on lipid parameters against other fats and oils, this analysis focuses on the effects of CNO itself. Here, we review the literature on CNO and analyze 984 lipid profile data sets from 26 CNO studies conducted over the past 40 years. This analysis found considerable heterogeneity among CNO studies regarding participant selection, amount consumed, and study duration. The analysis reveals that, overall, CNO consumption gives variable TChol and LDL-C values, but that HDL-cholesterol (HDL-C) values increase and triglycerides (TG) decrease. This holistic lipid assessment, together with consideration of lipid ratios, shows that CNO does not pose a health risk for heart disease. Because the predominantly medium-chain fatty acid profile of CNO is significantly different from lard and palm oil, studies using these as reference materials do not apply to CNO. This paper concludes that the recommendation to avoid consuming coconut oil due to the risk of heart disease is not justified.

  • Open Access

    The Lipid–Heart Hypothesis and the Keys Equation Defined the Dietary Guidelines but Ignored the Impact of Trans-Fat and High Linoleic Acid Consumption

    by Mary T. Newport, Fabian M. Dayrit

    In response to a perceived epidemic of coronary heart disease, Ancel Keys introduced the lipid–heart hypothesis in 1953 which asserted that high intakes of total fat, saturated fat, and cholesterol lead to atherosclerosis and that consuming less fat and cholesterol, and replacing saturated fat with polyunsaturated fat, would reduce serum cholesterol and consequently the risk of heart disease. Keys proposed an equation that would predict the concentration of serum cholesterol (ΔChol.) from the consumption of saturated fat (ΔS), polyunsaturated fat (ΔP), and cholesterol (ΔZ): ΔChol. = 1.2(2ΔS − ΔP) + 1.5ΔZ. However, the Keys equation conflated natural saturated fat and industrial trans-fat into a single parameter and considered only linoleic acid as the polyunsaturated fat. This ignored the widespread consumption of trans-fat and its effects on serum cholesterol and promoted an imbalance of omega-6 to omega-3 fatty acids in the diet. Numerous observational, epidemiological, interventional, and autopsy studies have failed to validate the Keys equation and the lipid–heart hypothesis. Nevertheless, these have been the cornerstone of national and international dietary guidelines which have focused disproportionately on heart disease and much less so on cancer and metabolic disorders, which have steadily increased since the adoption of this hypothesis.


  • Open Access

    The Lipid-Heart Hypothesis and the Keys Equation Defined the Dietary Guidelines but Ignored the Impact of Trans-fat and High Linoleic Acid Consumption

    by Mary T Newport, Fabian M Dayrit

    In response to a perceived epidemic of coronary heart disease, Ancel Keys introduced the lipid-heart hypothesis in 1953 which asserted that high intakes of total fat, saturated fat, and cholesterol lead to atherosclerosis and that consuming less fat and cholesterol, and replacing saturated fat with polyunsaturated fat, would reduce serum cholesterol and consequently the risk of heart disease. Keys proposed an equation that would predict the concentration of serum cholesterol (DChol.) from consumption of saturated fat (DS), polyunsaturated fat (DP), and cholesterol (DZ): ΔChol. = 1.2(2ΔS − ΔP) + 1.5ΔZ. However, the Keys equation conflated natural saturated fat and industrial trans-fat into a single parameter and considered only linoleic acid as the polyunsaturated fat. This ignored the widespread consumption of trans-fat and its effects on serum cholesterol and promoted an imbalance of omega-6 to omega-3 fatty acids in the diet. Numerous observational, epidemiological, interventional, and autopsy studies have failed to validate the Keys equation and the lipid-heart hypothesis. Nevertheless, these have been the cornerstone of national and international dietary guidelines which have focused disproportionately on heart disease and much less so on cancer and metabolic disorders, which have steadily increased since the adoption of this hypothesis.


  • Open Access

    Editorial: Saturated fat: metabolism, nutrition, and health impact

    by Fabian M. Dayrit

    Editorial: Saturated fat: metabolism, nutrition, and health impact


  • Open Access

    Rethinking Saturated Fat

    by Fabian Dayrit

    One of the most common warnings in dietary guidelines worldwide is to avoid saturated fat. However, there is no clear definition of what a saturated fat is. There are four definitions that have been used to describe saturated fat: amount of saturated fatty acids in grams per 100 grams, % fatty acid profile, iodine value, and solid fat. The current description of “saturated fat” does not distinguish between fats and oils, which are mainly triglycerides of fatty acids, and whole food items, which contain proteins and minerals and much lower amounts of triglycerides. Secondly, the current classification of saturated fat ignores the difference in the cholesterol content of vegetable oils and animal fats. The first definition of saturated fat was based on iodine values which does not give fatty acid composition. This classification is still used today by various dietary guidelines. The use of solid fat as a defining property of saturated fat is based on the melting of a fat at room temperature. This is not scientifically precise. This paper discusses the confusion due to the multiple definitions of saturated fat. The following are proposed to overcome this situation: first, fats and oils and animal-derived whole food items should be considered in separate categories based on their lipid content; second, the saturated fatty acid composition measured in grams per 100 grams (g/100 g) should be used as the basis for classifying fats and oils as saturated fat; and third, a new category of meso-fat is proposed.

  • Circular Plastics Economy: Redesigning Technology and Reimagining Society

    by Fabian Dayrit, Ateneo de Manila University, National Academy of Science and Technology Philippines

    The UN Environment Programme has identified plastic waste as one of the urgent challenges of the 21st century and has set 2024 as the target date for the drafting of an international legally binding agreement on plastic pollution. While the concern for plastic pollution is justified, a workable solution that considers both the role that plastics play in society and the economy, and the scientific and technological challenges involved, will take a major global effort. The six thermoplastics that are most widely used today were not designed to be recycled. Likewise, over 10,000 chemical additives in plastics were not tested for their health and environmental safety. The complexity of plastic waste makes their effective management very difficult and uneconomic. A new system with two types of plastics is proposed: circular plastics that can be chemically reprocessed, and bio-based plastics that are designed for single-use and are biodegradable. This will require R&D into new plastics, as well as new standards and regulations. At the same time, R&D into the conversion of our current plastic waste into environmentally safe products must be undertaken. These will require a multi-sectoral approach which assigns responsibility to all sectors. Industry should institute extended producer responsibility and develop circular plastics. Society should adopt extended consumer responsibility. Government should replace its single-minded focus on GDP as the sole measure of development with the more holistic UN Sustainable Development Goals. This transition will not happen if it is seen only as a technological challenge. This transition will require a multi-sectoral approach which assigns responsibility to all sectors of society. We will not be able to reimagine plastics if we do not reimagine society.


  • Overview on Plastic Waste: The Philippine Perspective

    by Fabian Dayrit, National Academy of Science and Technology Philippines

    Plastics are the most ubiquitous materials that modern society depends on and plastic waste has become one of the most serious challenges of modern society. The challenge of plastic waste encompasses industry, commerce, culture, and society. This paper is divided into four sections: I. What are plastics? II. How are plastics used in society? III. How can we manage plastic wastes? IV. How can the Philippines manage plastic waste under RA 9003? Plastics are the designer materials of the modern age. The properties of plastics can be controlled by the choice of polymer and chemical additives. Although there are numerous types of polymers, only six are clearly recyclable polymers. Because of its volume of use and visibility, particular attention has been focused on single-use plastics, in particular thin plastic bags and sachets. However, the COVID-19 pandemic has significantly increased the consumption of single-use plastic, in particular for medical applications. The other large group of polymers, called thermosets, are not recyclable. The major campaign to address plastic waste — the 3Rs, reduce, reuse, recycle – has been unsuccessful in addressing this problem because this campaign has been focused mainly on the consumer and plastics were not designed to be recyclable. Recently, several approaches have been proposed, such as extended producer responsibility (EPR), the circular economy, and the addition of recover and redesign to give the 5Rs. These approaches can be used to strengthen the Ecological Solid Waste Management Act (RA 9003) and prepare the Philippines for a circular economy.


  • Open Access

    Profile of Volatile Organic Compounds (VOCs) from Cold-Processed and Heat-Treated Virgin Coconut Oil (VCO) Samples

    by Ian Ken D. Dimzon, Grace B. Tantengco, Noel A. Oquendo, Fabian M. Dayrit

    Virgin coconut oil (VCO) can be prepared with or without heat. Fermentation and centrifuge processes can be done without the use of heat (cold process), while expelling involves heat due to friction. Volatile organic compounds (VOCs) from VCO samples prepared using these three methods were collected using solid phase microextraction (SPME) and analyzed using gas chromatography–mass spectrometry (GC-MS). Twenty-seven VCO samples from nine VCO producers were analyzed. The VOCs from refined, bleached, and deodorized coconut oil (RBDCO) were also obtained for comparison. Fourteen compounds were found to be common in more than 80% of the VCO samples analyzed. These included: Acetic acid; C6, C8, C10, C12, and C14 fatty acids, and their corresponding delta-lactones; and C8, C10 and C12 ethyl carboxylates. Fourteen minor VOCs were likewise detected which can be grouped into five types: Carboxylic acids (formic acid, butanoic acid, benzoic acid, and pentadecanoic acid), ketones (acetoin, 2-heptanone), an alcohol (ethanol), aldehydes (acetaldehyde, hexanal, benzaldehyde), esters (ethyl acetate, methyl tetradecanoate), and hydrocarbons (n-hexane and toluene). Five pyrazines were detected in expeller VCO. Various hydrocarbons from C5 to C14 were noted to be higher in old RBDCO and VCO samples. There were variations in the VOCs within each VCO process as each producer used different processing times, temperatures, and drying procedures. Principal components analysis (PCA) was able to group the samples according to the process used, but there were overlaps which may be due to variations in the specific procedures used by the manufacturers. These results may help VCO manufacturers control their production processes.


  • Open Access

    The Application of 13C NMR and Untargeted Multivariate Analysis for Classifying Virgin Coconut Oil

    by Lolita G. Lagurin, Mark Joseph M. Garrovillas, Fabian M. Dayrit

    Virgin coconut oil (VCO) is produced from fresh mature coconut meat without the use of chemicals or high heat. VCO can be made using three processes: fermentation, centrifuge, and expeller. To determine quality, it is important to be able to differentiate control VCO (fresh) from old VCO, refined bleached and deodorized coconut oil (RBDCO), and VCO which has been adulterated with RBDCO. Differentiating these types of samples has remained a challenge because of their chemical similarity. This study investigated the ability of 13C NMR and multivariate analysis to differentiate these different coconut oil samples. The methodology used the standard 13C NMR pulse sequence with broadband 1H decoupling with dioxane as the internal standard (IS). After pre-processing of the spectra (alignment, bucketing/binning, normalization with respect to dioxane IS peak), untargeted multivariate analyses, both unsupervised and supervised, were done on the bins of the 13C peaks. Principal components analysis (PCA), a linear unsupervised method, was able to differentiate control VCO (n = 57) from RBDCO (n = 21), adulterated VCO (n = 9), and old VCO (n = 11). Partial least squares–discriminant analysis (PLS–DA) was used as the supervised linear binary classifier. Using overall accuracy and AUC-ROC curves (by 100 cross validation and single validation using manual holdout), the supervised dataset with an optimized model gave performances that were 99%, 95%, and 80% improved in differentiating control VCO vs. RBDCO, old VCO, and adulterated VCO (one vs. one), respectively. Predictive ability (Q2 < 0.20) and overall accuracy (<0.80) were poor compared to the previous models for binary classifier models (one vs. rest) to differentiate among the three VCO processes. This may be due to the variations in production conditions and methods that different VCO producers use. We conclude that 13C NMR combined with linear techniques can be used to accurately differentiate fresh VCO from RBDCO, old VCO, and adulterated VCO.