Takayuki Hirai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Takayuki Hirai has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
Isao Komasawa
21 shared publicationsSusumu Shiojiri
Department of Chemical Science and Engineering, Graduate School of Engineering Science, Osaka University
3 shared publicationsSyouhei Nishihama
Department of Chemical Science and Engineering, Graduate School of Engineering Science, and Research Center for Solar Energy Chemistry, Osaka University, Machikaneyama-cho 1-3, Toyonaka, Osaka 560-8531, Japan
3 shared publicationsAkira Hino
Department of Chemical Science and Engineering, Graduate School of Engineering Science, Osaka University
2 shared publicationsMasanori Miyamoto
Department of Chemical Science and Engineering, Graduate School of Engineering Science, Osaka University
2 shared publicationsMasanori Nanba
2 shared publications
Latest Publications
- Open Access
- 1 December 2020
- Published by MDPI AG in Chemosensors
- Vol. 8 (4) , 123
A Naphthalimide–Sulfonylhydrazine Conjugate as a Fluorescent Chemodosimeter for Hypochlorite
Hypochlorite anion (ClO−) is a widely-used disinfectant and a microbicidal agent in the immune system. Accurate detection of ClO− in environmental and biological samples by simply prepared chemosensors/chemodosimeters is important. Herein, we report that a naphthalimide–sulfonylhydrazine conjugate with an imine (C=N) linker, prepared via simple condensation, acts as an effective fluorescent chemodosimeter for ClO−. The molecule exhibits a weak emission, but ClO−-selective cleavage of its C=N bond creates a strong green emission. Ab initio calculation showed that the emission enhancement by ClO− originates from the suppression of intramolecular electron transfer from the photoexcited naphthalimide through the C=N linker. This response enables selective and sensitive detection of ClO− at physiological pH range (7–9) and allows fluorometric ClO− imaging in the presence of cells.
- 1 December 2020
- Published by MDPI AG in Chemosensors
- Vol. 8 (4) , 123
Open AccessA Naphthalimide–Sulfonylhydrazine Conjugate as a Fluorescent Chemodosimeter for Hypochlorite
Hypochlorite anion (ClO−) is a widely-used disinfectant and a microbicidal agent in the immune system. Accurate detection of ClO− in environmental and biological samples by simply prepared chemosensors/chemodosimeters is important. Herein, we report that a naphthalimide–sulfonylhydrazine conjugate with an imine (C=N) linker, prepared via simple condensation, acts as an effective fluorescent chemodosimeter for ClO−. The molecule exhibits a weak emission, but ClO−-selective cleavage of its C=N bond creates a strong green emission. Ab initio calculation showed that the emission enhancement by ClO− originates from the suppression of intramolecular electron transfer from the photoexcited naphthalimide through the C=N linker. This response enables selective and sensitive detection of ClO− at physiological pH range (7–9) and allows fluorometric ClO− imaging in the presence of cells.
- 6 March 2018
- Published by Wiley in ChemCatChem
- Vol. 10 (9) , 2070-2077
Hydrogen Peroxide Production on a Carbon Nitride–Boron Nitride‐Reduced Graphene Oxide Hybrid Photocatalyst under Visible Light
Photocatalytic production of hydrogen peroxide (H2O2) from earth‐abundant water and O2 is a desirable artificial photosynthesis for solar fuel production. A metal‐free hybrid photocatalyst consisting of pyromellitic diimide‐doped carbon nitride (g‐C3N4/PDI), boron nitride (BN), and reduced graphene oxide (rGO) was prepared. The g‐C3N4/PDI‐BN‐rGO catalyst, when photoirradiated in water with O2 by visible light at room temperature, efficiently produces H2O2. The photoexcited g‐C3N4/PDI moiety transfers the conduction band electrons to rGO, leading to selective production of H2O2 via two‐electron reduction of O2 on the rGO surface. In contrast, the valence‐band holes photoformed on the g‐C3N4/PDI moieties are transferred to BN, leading to efficient oxidation of water. The electron–hole separation enhanced by the incorporation of rGO and BN significantly suppresses the charge recombination and exhibits high photocatalytic activity. The solar‐to‐chemical conversion (SCC) efficiency for H2O2 production on the hybrid catalyst is 0.27 %, which is higher than the highest efficiencies obtained by overall water splitting on powdered catalysts.
- 6 March 2018
- Published by Wiley in ChemCatChem
- Vol. 10 (9) , 2070-2077
Hydrogen Peroxide Production on a Carbon Nitride–Boron Nitride‐Reduced Graphene Oxide Hybrid Photocatalyst under Visible Light
Photocatalytic production of hydrogen peroxide (H2O2) from earth‐abundant water and O2 is a desirable artificial photosynthesis for solar fuel production. A metal‐free hybrid photocatalyst consisting of pyromellitic diimide‐doped carbon nitride (g‐C3N4/PDI), boron nitride (BN), and reduced graphene oxide (rGO) was prepared. The g‐C3N4/PDI‐BN‐rGO catalyst, when photoirradiated in water with O2 by visible light at room temperature, efficiently produces H2O2. The photoexcited g‐C3N4/PDI moiety transfers the conduction band electrons to rGO, leading to selective production of H2O2 via two‐electron reduction of O2 on the rGO surface. In contrast, the valence‐band holes photoformed on the g‐C3N4/PDI moieties are transferred to BN, leading to efficient oxidation of water. The electron–hole separation enhanced by the incorporation of rGO and BN significantly suppresses the charge recombination and exhibits high photocatalytic activity. The solar‐to‐chemical conversion (SCC) efficiency for H2O2 production on the hybrid catalyst is 0.27 %, which is higher than the highest efficiencies obtained by overall water splitting on powdered catalysts.
- 1 April 2005
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 284 (1) , 184-189
Preparation of ZnO nanoparticles in a reverse micellar system and their photoluminescence properties
- 1 April 2005
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 284 (1) , 184-189
Preparation of ZnO nanoparticles in a reverse micellar system and their photoluminescence properties
- 26 February 2005
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 109 (12) , 5569-5573
Preparation of Sr2CeO4:Eu3+,Dy3+ White Luminescence Phosphor Particles and Thin Films by Using an Emulsion Liquid Membrane System
Sr2CeO4 and Sr2CeO4:Eu3+,Dy3+ phosphor particles and thin films were prepared by using an emulsion liquid membrane (ELM, water-in-oil-in-water (W/O/W) emulsion) system, containing VA-10 (2-methyl-2-ethylheptanoic acid) as extractant (cation carrier). A two-step extraction enabled efficient extraction for Sr3+ and rare earth ions, and the resulting precursor metal oxalate particles produced in the internal water phase of the ELM system were about 60 nm in diameter. Calcination of the oxalate particles in air gave submicrometer-sized Sr2CeO4 and Sr2CeO4:Eu3+,Dy3+ particles, which showed blue and white luminescence, respectively, by UV excitation. Blue and white luminescence phosphor thin films were also prepared by soaking alumina substrates into the W/O emulsion containing precursor oxalate particles, followed by calcination in air.
- 26 February 2005
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 109 (12) , 5569-5573
Preparation of Sr2CeO4:Eu3+,Dy3+ White Luminescence Phosphor Particles and Thin Films by Using an Emulsion Liquid Membrane System
Sr2CeO4 and Sr2CeO4:Eu3+,Dy3+ phosphor particles and thin films were prepared by using an emulsion liquid membrane (ELM, water-in-oil-in-water (W/O/W) emulsion) system, containing VA-10 (2-methyl-2-ethylheptanoic acid) as extractant (cation carrier). A two-step extraction enabled efficient extraction for Sr3+ and rare earth ions, and the resulting precursor metal oxalate particles produced in the internal water phase of the ELM system were about 60 nm in diameter. Calcination of the oxalate particles in air gave submicrometer-sized Sr2CeO4 and Sr2CeO4:Eu3+,Dy3+ particles, which showed blue and white luminescence, respectively, by UV excitation. Blue and white luminescence phosphor thin films were also prepared by soaking alumina substrates into the W/O emulsion containing precursor oxalate particles, followed by calcination in air.
- 1 August 2004
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 276 (2) , 339-345
Preparation of Y2O3:Eu3+ nanoparticles in reverse micellar systems and their photoluminescence properties
- 1 August 2004
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 276 (2) , 339-345
Preparation of Y2O3:Eu3+ nanoparticles in reverse micellar systems and their photoluminescence properties
- 1 July 2004
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 275 (2) , 508-513
Preparation of Y2O3 nanoparticulate thin films using an emulsion liquid membrane system
- 1 July 2004
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 275 (2) , 508-513
Preparation of Y2O3 nanoparticulate thin films using an emulsion liquid membrane system
- 1 May 2004
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 273 (2) , 470-477
Preparation of yttrium oxysulfide phosphor nanoparticles with infrared-to-green and -blue upconversion emission using an emulsion liquid membrane system
- 1 May 2004
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 273 (2) , 470-477
Preparation of yttrium oxysulfide phosphor nanoparticles with infrared-to-green and -blue upconversion emission using an emulsion liquid membrane system
- 1 January 2004
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 269 (1) , 103-108
Preparation of Gd2O3:Yb,Er and Gd2O2S:Yb,Er infrared-to-visible conversion phosphor ultrafine particles using an emulsion liquid membrane system
- 1 January 2004
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 269 (1) , 103-108
Preparation of Gd2O3:Yb,Er and Gd2O2S:Yb,Er infrared-to-visible conversion phosphor ultrafine particles using an emulsion liquid membrane system
- 1 January 2004
- Published by Taylor & Francis in JOURNAL OF CHEMICAL ENGINEERING OF JAPAN
- Vol. 37 (5) , 675-679
Preparation of ZnS:Mn Nanoparticles in Reverse Micellar Systems and Their Photoluminescent Properties
- 1 January 2004
- Published by Taylor & Francis in JOURNAL OF CHEMICAL ENGINEERING OF JAPAN
- Vol. 37 (5) , 675-679
Preparation of ZnS:Mn Nanoparticles in Reverse Micellar Systems and Their Photoluminescent Properties
- 1 December 2003
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 268 (2) , 394-399
Dithiol-mediated incorporation of CdS nanoparticles from reverse micellar system into Zn-doped SBA-15 mesoporous silica and their photocatalytic properties
- 1 December 2003
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 268 (2) , 394-399
Dithiol-mediated incorporation of CdS nanoparticles from reverse micellar system into Zn-doped SBA-15 mesoporous silica and their photocatalytic properties