JSJorge A. Souza-Corrêa

Jorge A. Souza-Corrêa

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Jorge A. Souza-Corrêa has a total of 19 co-authors. Here are the top co-authors by number of shared publications:

  • Jayr Amorim

    Departamento de Física, Instituto Tecnológico de Aeronáutica, 12228-900, São José dos Campos, Brazil; Departamento de Física, Instituto de Ciências Exatas - ICEx, Universidade Federal Fluminense, Campus do Aterrado, Volta Redonda, RJ 27213-415, Brazil

    11 shared publications
  • C. Oliveira

    Laboratório Nacional de Ciência e Tecnologia do Bioetanol—CTBE/CNPEM

    5 shared publications
  • Marco Antonio Ridenti

    Space Sciences Laboratory Aeronautics Institute of Technology (ITA) São José Dos Campos Brazil

    4 shared publications
  • C Oliveira

    Instituto Tecnológico de Aeronáutica

    2 shared publications
  • Carlos Oliveira

    Laboratório Nacional de Ciência e Tecnologia do Bioetanol - CTBE/CNPEM, Caixa Postal 6170, 13083-970 Campinas, São Paulo, Brazil

    2 shared publications
  • G. J. M. Rocha

    Laboratório Nacional de Ciência e Tecnologia do Bioetanol—CTBE/CNPEM

    2 shared publications

Latest Publications

  • Space Weathering: Processing Velocities in Organic Materials as a Function of Electron Beam Energies—Solar Electron Erosion Rate Application

    by J.A. Souza-Corrêa, E.F. da Silveira

    Samples of α-glycine (α-GLY; 230–350 nm) were irradiated in laboratory as a function of electron beam energies (0.25, 0.50, and 1.00 keV) at room temperature (293–295 K). The evolution of α-glycine irradiation process was monitored in real time by infrared spectroscopy (Fourier transform infrared - FTIR), through specific spectral bands: 2610, 2124, 1410, and 1333 cm −1 . A phenomenological model is proposed to describe the column density decay when thick organic samples are processed by ionizing beams. The α-glycine radiolysis has exhibited transient and stationary modes in such thickness films. The first stage is mainly described by one exponential decay, whereas the latter foremost decays linearly; compaction processes have been neglected; glycine dissociation and sputtering processes are assumed to be responsible for the damage caused by the electron beam impact through the solid film. The second (stationary) stage is due to equilibrium between a partially shielded bulk radiolysis and sputtering of protective layers. The decay rates are measured for the transient and stationary modes and allow determining the processing velocity of the samples as a function of the electron beam energy. Finally, the model is applied to space weathering to find out the typical sputtering rate of organic compounds on the surface of astrophysical analogs with no protection layers attacked by solar wind (SW) electrons at ≈1 AU. Although the velocity of processing materials in SW has natural competing effects, such as regolith overturn by impacts of micro- and macrometeorites and downslope motion of material that is unstable due to changes in the geopotential of the airless bodies ( e.g ., asteroid 101955 Bennu), these competing processes are not included in the simulations presented here.

  • Open Access

    Mass Spectrometry of Atmospheric Pressure Surface Wave Discharges

    by M A Ridenti, J A Souza-Corrêa, J Amorim

    By applying mass spectrometry techniques, we carried out measurements of ionic mass spectrum and their energy distribution in order to investigate an atmospheric argon discharge by using a surfatron surface-wave device. The mass and energy distribution measurements were performed with fixed flow rate (2.5 SLM) of pure argon gas (99.999%) and different Ar-O2 gas mixture compositions (99-1, 98-2 and 97-3). The mass spectra and energy distributions were recorded for Ar+, O+, O+ 2, N+ and N2 +. The axial distribution profiles of ionic mass and their energy were obtained for different experimental conditions as a function of the plasma length. The results showed that the peak of the positive ion energy distributions shifted to higher energies and also that the distribution width increased as the distance between the sampling orifice and the launcher gap was increased. It was also found that under certain experimental conditions the ion flux of atomic species were higher than the ion flux of their diatomic counterpart. The motivation of this study was to obtain a better understanding of a surface wave discharge in atmospheric pressure that may play a key role on new second generation biofuel technologies.


  • Experimental study of unconfined surface wave discharges at atmospheric pressure by optical emission spectroscopy

    by M A Ridenti, J A Souza-Corrêa, J Amorim

    A surface wave discharge (SWD) in argon at atmospheric pressure generated by a surfatron device was studied by optical emission spectroscopy (OES). Two distinct situations were investigated; (i) a discharge plasma in open air and (ii) a discharge plasma totally confined in a quartz tube. The electron density ne, electron temperature Te and gas temperature Tg were investigated as a function of applied power and gas flow rate. The self-absorbing method was used to estimate the population of the metastable state Ar(1s5). These physical quantities were determined through optical measurements along the plasma axis of symmetry. The profile of the electron density presented a maximum value under certain conditions, in contrast with typical electron density profiles of SWDs which are usually monotonically decreasing. A correlation between the electron density and the metastable state Ar(1s5) was found in one of these cases, suggesting that stepwise ionization from metastable states and non-local kinetics play an important role on the unexpected increase in ionization degree along the discharge.


  • Atmospheric Pressure Plasma Pretreatment of Sugarcane Bagasse: the Influence of Biomass Particle Size in the Ozonation Process

    by J. A. Souza-Corrêa, C. Oliveira, V. M. Nascimento, L. D. Wolf, E. O. Gómez, G. J. M. Rocha, J. Amorim

    Atmospheric pressure O2 plasma was used to produce ozone in order to treat sugarcane bagasse as a function of particle sizes. The fixed bagasse moisture content was 50 %. The delignification efficiency had small improvement due to ozonation process as a function of particle size, varying from 75 up to 80 %. Few amounts of hemicellulose were removed, but the ozonation has not been affected significantly with particle size variance as well (from 30 up to 35 %). The cellulose presented some losses below 1.0 mm size (8–15 %) which was an unexpected result. The conversion of cellulose content into free sugar has shown a significant increase as the particle size has diminished as well. The best condition of the bagasse particle size was for 0.08 mm. For this case, a great quantity of cellulose (78.8 %) was converted into glucose. Optical absorption spectroscopy was applied to determine ozone concentrations in real time where the samples with typical bagasse particle sizes equal or below to 0.5 mm had shown a better absorption of ozone in comparison with greater particle size samples.


  • Ozone decay on stainless steel and sugarcane bagasse surfaces

    by Jorge A. Souza-Corrêa, Carlos Oliveira, Jayr Amorim

    Ozone was generated using dielectric barrier discharges at atmospheric pressure to treat sugarcane bagasse for bioethanol production. It was shown that interaction of ozone molecules with the pretreatment reactor wall (stainless steel) needs to be considered during bagasse oxidation in order to evaluate the pretreatment efficiency. The decomposition coefficients for ozone on both materials were determined to be (3.3 ± 0.2) × 10−8 for stainless steel and (2.0 ± 0.3) × 10−7 for bagasse. The results have indicated that ozone decomposition has occurred more efficiently on the biomass material.


  • Atmospheric Pressure Plasma Pretreatment of Sugarcane Bagasse: The Influence of Moisture in the Ozonation Process

    by J. A. Souza-Corrêa, C. Oliveira, L. D. Wolf, V. M. Nascimento, G. J. M. Rocha, J. Amorim

    Sugarcane bagasse samples were pretreated with ozone via atmospheric O2 pressure plasma. A delignification efficiency of approximately 80 % was observed within 6 h of treatment. Some hemicelluloses were removed, and the cellulose was not affected by ozonolysis. The quantity of moisture in the bagasse had a large influence on delignification and saccharification after ozonation pretreatment of the bagasse, where 50 % moisture content was found to be best for delignification (65 % of the cellulose was converted into glucose). Optical absorption spectroscopy was applied to determine ozone concentrations in real time. The ozone consumption as a function of the delignification process revealed two main reaction phases, as the ozone molecules cleave the strong carbon–carbon bonds of aromatic rings more slowly than the weak carbon–carbon bonds of aliphatic chains.


  • Treatment of Sugarcane Bagasse Lignin Employing Atmospheric Pressure Microplasma Jet in Argon

    by Jayr Amorim, Carlos Oliveira, Jorge A. Souza‐Corrêa, Marco A. Ridenti

    An atmospheric argon rf microplasma jet was employed to treat lignin samples. The treatment time was carried out from 30 min to 4 h resulting in a strong degradation of the lignin structure. The most important degradation was observed in functional groups having asymmetric in‐phase ring stretching as well as in CC and CO stretching vibrations. Simple calculations may help us explain the OH bond breakings by electron collisions inside the microplasma. In the afterglow condition, it was not observed any change on the lignin spectra.


  • Decomposition of Lignin from Sugar Cane Bagasse during Ozonation Process Monitored by Optical and Mass Spectrometries

    by J. A. Souza-Corrêa, M. A. Ridenti, C. Oliveira, S. R. Araújo, J. Amorim

    Mass spectrometry was used to monitor neutral chemical species from sugar cane bagasse that could volatilize during the bagasse ozonation process. Lignin fragments and some radicals liberated by direct ozone reaction with the biomass structure were detected. Ozone density was monitored during the ozonation by optical absorption spectroscopy. The optical results indicated that the ozone interaction with the bagasse material was better for bagasse particle sizes less than or equal to 0.5 mm. Both techniques have shown that the best condition for the ozone diffusion in the bagasse was at 50% of its moisture content. In addition, Fourier transform infrared spectroscopy (FTIR) and scanning electron microscopy (SEM) were employed to analyze the lignin bond disruptions and morphology changes of the bagasse surface that occurred due to the ozonolysis reactions as well. Appropriate chemical characterization of the lignin content in bagasse before and after its ozonation was also carried out.


  • Electric and spectroscopic properties of argon-hydrogen RF microplasma jets at atmospheric pressure

    by J A Souza-Corrêa, C Oliveira, M P Gomes, J Amorim

    Microplasma jets of argon–hydrogen (Ar–H2) gas mixture were generated by 144.0 MHz radio-frequency (RF) waves at powers of 5 W, 10 W, 20 W and 50 W. The experimental setup employed creates stable microplasmas at atmospheric pressure from 5.0 mm up to 20.0 mm visual glow lengths. We have determined the rms voltages, the rms electric currents and the power absorptions of these microplasma jets. By making use of optical spectroscopy, the emission spectra of Ar–H2 microplasma jets were recorded in the range 3060–8200 Å, in order to estimate the axial distribution profiles of electron density, rotational temperature, excitation temperature and hydrogen atomic temperature.