Miglena Kirilova
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Miglena Kirilova has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Dessislava Pashkouleva
Institute of Mechanics, Bulgarian Academy of Sciences, 1113 Sofia, Bulgaria
2 shared publications Stoyan Stoytchev
2 shared publicationsRadka Hristoskova
Department of Clinical Pathology, Tsaritsa Joanna University Hospital, 1527 Sofia, Bulgaria
1 shared publicationVasil Kavardzhikov
1 shared publicationVesselina Tsenova
Department of Clinical Pathology, Tsaritsa Joanna University Hospital, 1527 Sofia, Bulgaria
1 shared publication
Latest Publications
- 18 August 2011
- Published by Taylor & Francis in Connective Tissue Research
- Vol. 53 (1) , 21-28
Time-Dependent Properties of Human Umbilical Fascia
This investigation is devoted to the study of the viscoelastic behavior of human abdominal fascia from the umbilical region. Seventeen samples 10 mm wide and up to 70 mm long were cut along the primary fiber direction (group FL) or perpendicular to it (group FT) and subjected to relaxation tests. The viscoelastic response of the tissue at three different strain levels (4%, 5%, and 6%) was investigated. The relaxation curves were fitted using a two-stage decaying exponential form. The following parameters were determined: initial stress σ0, relaxation times τ1 and τ2, stress reduction Δσ, initial relaxation modulus E and equilibrium relaxation modulus Eeq, as well as the ratio E/Eeq. Fiber orientation and strain levels were varied to determine their influence on the viscoelastic properties of fascia. The results highlight the inherent viscoelastic mechanical properties of umbilical fascia. The values of the viscoelastic parameters determined for the longitudinal and transverse directions varied markedly. Significant differences were found between the two groups FL and FT for the initial stress at 5% and 6% strain (p < 0.038) and for the initial and equilibrium moduli at the 6% strain level (p < 0.046). The stress reduction in samples from the FL group (45–55%) was less than that in samples from the FT group (37–54%), but this difference was not significant (p > 0.388). The influence of strain level on the parameter values was not statistically significant (p > 0.121). The nonlinear response of the tissue was demonstrated over the chosen strain range.
- 18 August 2011
- Published by Taylor & Francis in Connective Tissue Research
- Vol. 53 (1) , 21-28
Time-Dependent Properties of Human Umbilical Fascia
This investigation is devoted to the study of the viscoelastic behavior of human abdominal fascia from the umbilical region. Seventeen samples 10 mm wide and up to 70 mm long were cut along the primary fiber direction (group FL) or perpendicular to it (group FT) and subjected to relaxation tests. The viscoelastic response of the tissue at three different strain levels (4%, 5%, and 6%) was investigated. The relaxation curves were fitted using a two-stage decaying exponential form. The following parameters were determined: initial stress σ0, relaxation times τ1 and τ2, stress reduction Δσ, initial relaxation modulus E and equilibrium relaxation modulus Eeq, as well as the ratio E/Eeq. Fiber orientation and strain levels were varied to determine their influence on the viscoelastic properties of fascia. The results highlight the inherent viscoelastic mechanical properties of umbilical fascia. The values of the viscoelastic parameters determined for the longitudinal and transverse directions varied markedly. Significant differences were found between the two groups FL and FT for the initial stress at 5% and 6% strain (p < 0.038) and for the initial and equilibrium moduli at the 6% strain level (p < 0.046). The stress reduction in samples from the FL group (45–55%) was less than that in samples from the FT group (37–54%), but this difference was not significant (p > 0.388). The influence of strain level on the parameter values was not statistically significant (p > 0.121). The nonlinear response of the tissue was demonstrated over the chosen strain range.
- 20 November 2010
- Published by IOP Publishing in Medical Engineering & Physics
- Vol. 33 (1) , 1-6
Experimental study of the mechanical properties of human abdominal fascia
The aim of the study is to characterise mechanical properties of human abdominal fascia according to its direction of loading and localization. The one-dimensional tensile behaviour of human abdominal fascia and its orthotropy has been studied experimentally using human umbilical (UF) and transversalis fascia (FT). The specimens have been cut and stretched parallel and orthogonal to the main fibre bundles. 90 specimens 10 mm wide and up to 70 mm long have been tested. The following mechanical parameters, characterising tensile properties of human abdominal fascia, have been calculated from the obtained stress-stretch ratio curves: maximal stress T(L)(max), stretch ratio at maximal stress λ(T(max)), maximal stretch ratio at failure λ(max), and a secant modulus E(i). The tissue strips obtained from defined areas reveal break stress between 0.63 and 1.99 MPa for FT and 0.93-1.61 MPa for UF. The parameter estimation has shown that in the physiological strain range specimens from both type of fascia can be considered orthotropic material according to their secant module, maximum stress T(L)(max) and stretch at maximum stress. Anisotropy factor AF (ratio of the stress in longitudinal and transverse directions) has been used to establish the level of the orthotropy of material and its variations with the stretch ratio. The maximum AF is 4.3 for FT at 20% deformation and 3.3 for UF at 5% deformation. The differences between the mechanical properties of FT and UF according to localization are not statistically significant thus the mechanical properties of human abdominal fascia are not affected by the localization.
- 20 November 2010
- Published by IOP Publishing in Medical Engineering & Physics
- Vol. 33 (1) , 1-6
Experimental study of the mechanical properties of human abdominal fascia
The aim of the study is to characterise mechanical properties of human abdominal fascia according to its direction of loading and localization. The one-dimensional tensile behaviour of human abdominal fascia and its orthotropy has been studied experimentally using human umbilical (UF) and transversalis fascia (FT). The specimens have been cut and stretched parallel and orthogonal to the main fibre bundles. 90 specimens 10 mm wide and up to 70 mm long have been tested. The following mechanical parameters, characterising tensile properties of human abdominal fascia, have been calculated from the obtained stress-stretch ratio curves: maximal stress T(L)(max), stretch ratio at maximal stress λ(T(max)), maximal stretch ratio at failure λ(max), and a secant modulus E(i). The tissue strips obtained from defined areas reveal break stress between 0.63 and 1.99 MPa for FT and 0.93-1.61 MPa for UF. The parameter estimation has shown that in the physiological strain range specimens from both type of fascia can be considered orthotropic material according to their secant module, maximum stress T(L)(max) and stretch at maximum stress. Anisotropy factor AF (ratio of the stress in longitudinal and transverse directions) has been used to establish the level of the orthotropy of material and its variations with the stretch ratio. The maximum AF is 4.3 for FT at 20% deformation and 3.3 for UF at 5% deformation. The differences between the mechanical properties of FT and UF according to localization are not statistically significant thus the mechanical properties of human abdominal fascia are not affected by the localization.
- 31 October 2009
- Published by Elsevier in Journal of Bodywork and Movement Therapies
- Vol. 13 (4) , 336-337
Visco-elastic mechanical properties of human abdominal fascia
- 31 October 2009
- Published by Elsevier in Journal of Bodywork and Movement Therapies
- Vol. 13 (4) , 336-337
Visco-elastic mechanical properties of human abdominal fascia