Alain Soum
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Alain Soum has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
Chantal Semaan
Laboratoire de Chimie des Polymères Organiques, IPB-ENSCBP, Université de Bordeaux, Pessac Cedex, France
3 shared publicationsMichèle Schappacher
Centre National de la Recherche Scientifique, Laboratoire de Chimie des Polymères Organiques, 33607 Pessac Cedex, France
2 shared publications- Clément Sanchez
University of Strasbourg
1 shared publication Gilles Pecastaings
Laboratoire de Chimie des Polymères Organiques, IPB-ENSCBP, Université de Bordeaux, Pessac Cedex, France
1 shared publication- Gilles Pécastaings
Université de Bordeaux, Laboratoire de Chimie des Polymères Organiques UMR 5629 CNRS, ENSCBP 16 avenue Pey Berland, BP 108,Pessac,France
1 shared publication - Marc Birot
Université de Bordeaux Institut des Sciences Moléculaires (ISM) UMR 5255 CNRS, 351 Cours de la Libération 33405 Talence France
1 shared publication
Latest Publications
- 11 December 2012
- Published by Springer Nature in Polymer Bulletin
- Vol. 70 (6) , 1919-1936
Influence of wrapping on some properties of MWCNT–PMMA and MWCNT–PE composites
- 11 December 2012
- Published by Springer Nature in Polymer Bulletin
- Vol. 70 (6) , 1919-1936
Influence of wrapping on some properties of MWCNT–PMMA and MWCNT–PE composites
- 28 November 2011
- Published by Wiley in Polymer Composites
- Vol. 33 (1) , 1-9
Dispersion of carbon nanotubes through amphiphilic block copolymers: Rheological and dielectrical characterizations of poly(ethylene oxide) composites
In this article, we report on some properties of polymer nanocomposites prepared from dispersions of multiwall carbon nanotubes (CNT) in aqueous solution prepared using amphiphilic block copolymers. These nanocomposites are made of polyethylene oxide as matrix and CNT wrapped with copolymers as fillers. We investigated the rheological and electrical behavior of such composites with the objectives of underlined the effect of wrapping. Two rheological and only one electrical percolation thresholds have been observed and related to polymer–CNT and CNT–CNT networks. The low values of these percolation thresholds agree with a homogeneous dispersion of CNT in the matrix. We also demonstrated that specific wrapping may induce an increase of electrical conductivity without affecting too much the viscosity of the melt. POLYM. COMPOS., 2012. © 2011 Society of Plastics Engineers
- 28 November 2011
- Published by Wiley in Polymer Composites
- Vol. 33 (1) , 1-9
Dispersion of carbon nanotubes through amphiphilic block copolymers: Rheological and dielectrical characterizations of poly(ethylene oxide) composites
In this article, we report on some properties of polymer nanocomposites prepared from dispersions of multiwall carbon nanotubes (CNT) in aqueous solution prepared using amphiphilic block copolymers. These nanocomposites are made of polyethylene oxide as matrix and CNT wrapped with copolymers as fillers. We investigated the rheological and electrical behavior of such composites with the objectives of underlined the effect of wrapping. Two rheological and only one electrical percolation thresholds have been observed and related to polymer–CNT and CNT–CNT networks. The low values of these percolation thresholds agree with a homogeneous dispersion of CNT in the matrix. We also demonstrated that specific wrapping may induce an increase of electrical conductivity without affecting too much the viscosity of the melt. POLYM. COMPOS., 2012. © 2011 Society of Plastics Engineers
- 7 July 2011
- Published by Springer Nature in Polymer Bulletin
- Vol. 68 (2) , 465-481
The preparation of carbon nanotube/poly(ethylene oxide) composites using amphiphilic block copolymers
- 7 July 2011
- Published by Springer Nature in Polymer Bulletin
- Vol. 68 (2) , 465-481
The preparation of carbon nanotube/poly(ethylene oxide) composites using amphiphilic block copolymers