Shigeru Katsuyama
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Shigeru Katsuyama has a total of 85 co-authors. Here are the top co-authors by number of shared publications:
Hiroshi Nagai
Department of Materials Science and Processing, Graduate School of Engineering, Osaka University
40 shared publicationsKazuhiko Majima
Department of Materials Science and Processing, Graduate School of Engineering, Osaka University
39 shared publications- Mikio Ito
Osaka University
15 shared publications Mikio Ito
Division of Materials and Manufacturing Science, Graduate School of Engineering, Osaka University, Osaka, Japan
7 shared publications- Hiroshi Nagai
National Astronomical Observatory of Japan
5 shared publications - Tomoya Nagira
National Institute for Materials Science
4 shared publications
Latest Publications
- Open Access
- 15 February 2026
- Published by Japan Society of Powder and Powder Metallurgy in Journal of the Japan Society of Powder and Powder Metallurgy
- Vol. 73 (2) , 15-22
Oxidation Behavior of Skutterudite-Based Thermoelectric Materials in High-Temperature Air Atmosphere
Power generation driven by thermoelectric conversion requires high chemical stability of the module under the practical operating conditions. The stability of the module in a high-temperature atmosphere depends on the constituent elements of the thermoelectric materials. This study systematically examines the oxidation behaviors of four skutterudite compounds (CoSb3, Co0.94Ni0.06Sb3, CeFe3CoSb12, and In0.25Co3FeSb12) under high-temperature atmospheric conditions using thermogravimetric-differential thermal analysis (TG-DTA), X-ray diffraction, scanning electron microscopy (SEM), and energy dispersive x-ray spectroscopy (EDX). All four samples increase in weight at a certain temperature according to the TG curves, and several exothermic peaks are observed in the DTA curves, corresponding to the oxidation or decomposition of the thermoelectric materials. Various phases (e.g., CoSb2O4, Sb2O3, Sb2O4, and CoSb2O6 (or FeSbO4)) are formed after TG-DTA measurement up to 1073 K. The stable temperature ranges of the phases were similar in CoSb3 and Co0.94Ni0.06Sb3, and in CeFe3CoSb12 and In0.25Co3FeSb12. Notably, the temperature range in which the CoSb3-type phase is stable is significantly lower in CeFe3CoSb12 and In0.25Co3FeSb12 than in CoSb3 and Co0.94Ni0.06Sb3. SEM analysis after leaving the sintered materials in air at different temperatures for specified periods of time revealed the formation of several oxide layers on the surface.
- 15 February 2026
- Published by Japan Society of Powder and Powder Metallurgy in Journal of the Japan Society of Powder and Powder Metallurgy
- Vol. 73 (2) , 15-22
Open AccessOxidation Behavior of Skutterudite-Based Thermoelectric Materials in High-Temperature Air Atmosphere
Power generation driven by thermoelectric conversion requires high chemical stability of the module under the practical operating conditions. The stability of the module in a high-temperature atmosphere depends on the constituent elements of the thermoelectric materials. This study systematically examines the oxidation behaviors of four skutterudite compounds (CoSb3, Co0.94Ni0.06Sb3, CeFe3CoSb12, and In0.25Co3FeSb12) under high-temperature atmospheric conditions using thermogravimetric-differential thermal analysis (TG-DTA), X-ray diffraction, scanning electron microscopy (SEM), and energy dispersive x-ray spectroscopy (EDX). All four samples increase in weight at a certain temperature according to the TG curves, and several exothermic peaks are observed in the DTA curves, corresponding to the oxidation or decomposition of the thermoelectric materials. Various phases (e.g., CoSb2O4, Sb2O3, Sb2O4, and CoSb2O6 (or FeSbO4)) are formed after TG-DTA measurement up to 1073 K. The stable temperature ranges of the phases were similar in CoSb3 and Co0.94Ni0.06Sb3, and in CeFe3CoSb12 and In0.25Co3FeSb12. Notably, the temperature range in which the CoSb3-type phase is stable is significantly lower in CeFe3CoSb12 and In0.25Co3FeSb12 than in CoSb3 and Co0.94Ni0.06Sb3. SEM analysis after leaving the sintered materials in air at different temperatures for specified periods of time revealed the formation of several oxide layers on the surface.
- 15 September 2025
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 54 (11) , 10048-10058
In-filled Skutterudite-Based Thermoelectric Power Generation Module with High Durability in Air for Evaluation of Power Generation Performance
- 15 September 2025
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 54 (11) , 10048-10058
In-filled Skutterudite-Based Thermoelectric Power Generation Module with High Durability in Air for Evaluation of Power Generation Performance
- 15 April 2025
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 54 (6) , 4471-4477
Bi1−2xPbxCaxCuSO Synthesized Using Polymerized Complex and Solid-State Reaction Methods for Thermoelectric Evaluation
- 15 April 2025
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 54 (6) , 4471-4477
Bi1−2xPbxCaxCuSO Synthesized Using Polymerized Complex and Solid-State Reaction Methods for Thermoelectric Evaluation
- Open Access
Simple Methods for Evaluating Acid Permeation and Biofilm Formation Behaviors on Polysiloxane Films
The sulfuric acid permeation and biofilm formation behaviors of polysiloxane films have been investigated, and simple methods for evaluating the sulfuric acid permeation and biofilm formation behaviors have been proposed in this paper. The polysiloxane films used in these experiments were practically impermeable to the aqueous sulfuric acid solution, and the amount of biofilm formation varied depending on the composition of the films. Further, the amount of sulfuric acid permeation can be estimated by measuring the polarization curves of polysiloxane films with different thicknesses formed on iron electrodes. By measuring the adhesion work of pure water and simulated biofilm droplets on polysiloxane films of different compositions, we can estimate the resistance of biofilm formation on the polysiloxane films.
Open AccessSimple Methods for Evaluating Acid Permeation and Biofilm Formation Behaviors on Polysiloxane Films
The sulfuric acid permeation and biofilm formation behaviors of polysiloxane films have been investigated, and simple methods for evaluating the sulfuric acid permeation and biofilm formation behaviors have been proposed in this paper. The polysiloxane films used in these experiments were practically impermeable to the aqueous sulfuric acid solution, and the amount of biofilm formation varied depending on the composition of the films. Further, the amount of sulfuric acid permeation can be estimated by measuring the polarization curves of polysiloxane films with different thicknesses formed on iron electrodes. By measuring the adhesion work of pure water and simulated biofilm droplets on polysiloxane films of different compositions, we can estimate the resistance of biofilm formation on the polysiloxane films.
- 1 April 2021
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 860
Possible enhancement of thermoelectric performance for Si–SiO2 sintered composite by percolation effect
- 1 April 2021
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 860
Possible enhancement of thermoelectric performance for Si–SiO2 sintered composite by percolation effect
- 11 June 2019
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 48 (8) , 5257-5263
Fabrication of Thermoelectric Module Consisting of Rare-Earth-Filled Skutterudite Compounds and Evaluation of Its Power Generation Performance in Air
- 11 June 2019
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 48 (8) , 5257-5263
Fabrication of Thermoelectric Module Consisting of Rare-Earth-Filled Skutterudite Compounds and Evaluation of Its Power Generation Performance in Air
- 7 August 2012
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 379 (1) , 012004
Synthesis and thermoelectric properties of sintered skutterudite CoSb3with a bimodal distribution of crystal grains
We have synthesized sintered skutterudite CoSb3 composed of large and small crystal grains. The sintered materials with larger crystal grains tend to show lower electrical resistivity, while those with smaller grains possess lower thermal conductivity. The possibility of enhancing thermoelectric performance by producing sintered materials with a bimodal distribution of crystal grain sizes so that they possess both low electrical resistivity and thermal conductivity is discussed. The electrical resistivity and Seebeck coefficient generally increase as the ratio of small particles increases. The sample with a mass ratio of small particles of 30% possesses the largest power factor of the sample. The thermal conductivity decreases as the ratio of small particles increases. As a result, the samples containing a higher ratio of smaller particles show higher ZT.
- 7 August 2012
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 379 (1) , 012004
Synthesis and thermoelectric properties of sintered skutterudite CoSb3with a bimodal distribution of crystal grains
We have synthesized sintered skutterudite CoSb3 composed of large and small crystal grains. The sintered materials with larger crystal grains tend to show lower electrical resistivity, while those with smaller grains possess lower thermal conductivity. The possibility of enhancing thermoelectric performance by producing sintered materials with a bimodal distribution of crystal grain sizes so that they possess both low electrical resistivity and thermal conductivity is discussed. The electrical resistivity and Seebeck coefficient generally increase as the ratio of small particles increases. The sample with a mass ratio of small particles of 30% possesses the largest power factor of the sample. The thermal conductivity decreases as the ratio of small particles increases. As a result, the samples containing a higher ratio of smaller particles show higher ZT.
- Open Access
- 1 January 2010
- Published by Japan Society of Powder and Powder Metallurgy in Journal of the Japan Society of Powder and Powder Metallurgy
- Vol. 57 (4) , 224-231
Microstructural Control and Development of Synthesis Route for Enhancing Performance of Sintered Thermoelectric Oxide Polycrystals via Chemical Solution Process
- 1 January 2010
- Published by Japan Society of Powder and Powder Metallurgy in Journal of the Japan Society of Powder and Powder Metallurgy
- Vol. 57 (4) , 224-231
Open AccessMicrostructural Control and Development of Synthesis Route for Enhancing Performance of Sintered Thermoelectric Oxide Polycrystals via Chemical Solution Process
- Open Access
- 1 January 2009
- Published by Iron and Steel Institute of Japan in Tetsu-to-Hagane
- Vol. 95 (1) , 1-6
Fabrication of Porous Solidified Materials from Blast Furnace Slag Using Hydrothermal Hot-pressing Method and Measurement of Thermal Conductivity of Solidified Materials
- 1 January 2009
- Published by Iron and Steel Institute of Japan in Tetsu-to-Hagane
- Vol. 95 (1) , 1-6
Open AccessFabrication of Porous Solidified Materials from Blast Furnace Slag Using Hydrothermal Hot-pressing Method and Measurement of Thermal Conductivity of Solidified Materials
- 1 May 2008
- Published by Springer Nature in Journal of Materials Science
- Vol. 43 (10) , 3553-3559
Synthesis of Ca3Co4O9 ceramics by polymerized complex and hydrothermal hot-pressing processes and the investigation of its thermoelectric properties
- 1 May 2008
- Published by Springer Nature in Journal of Materials Science
- Vol. 43 (10) , 3553-3559
Synthesis of Ca3Co4O9 ceramics by polymerized complex and hydrothermal hot-pressing processes and the investigation of its thermoelectric properties