Angela M. Orozco
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Angela M. Orozco has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Ala’a H. Al-Muhtaseb
Department of Petroleum and Chemical Engineering, College of Engineering, Sultan Qaboos University, Muscat 123, Oman
3 shared publications David Rooney
Centre for the Theory and Application of Catalysis, School of Chemistry and Chemical Engineering, Queen's University Belfast, Belfast BT9 5AG, Northern Ireland, UK
3 shared publications- Gavin M. Walker
Department of Chemical Sciences, University of Limerick, Limerick, Ireland
3 shared publications - Mohammad Nadeem Ahmad
Universiti Teknologi Malaysia, Malaysia
3 shared publications - Ahmad B. Albadarin
Pharmaceutical & Chemical Engineering, German Jordanian University, Amman, Jordan
2 shared publications Farid Aiouache
Engineering Department, Lancaster University, Lancaster, Lancashire, UK
1 shared publication
Latest Publications
- 14 May 2013
- Published by Taylor & Francis in Environmental Technology
- Vol. 34 (22) , 3005-3016
Fermentable sugars recovery from lignocellulosic waste-newspaper by catalytic hydrolysis
The urgent need for alternative renewable energies to supplement petroleum-based fuels and the reduction of landfill sites for disposal of solid wastes makes it increasingly attractive to produce inexpensive biofuels from the organic fraction of the municipal solid waste. Therefore, municipal waste in the form of newspaper was investigated as a potential feedstock for fermentable sugars production. Hydrolysis of newspaper by dilute phosphoric acid was carried out in autoclave Parr reactor, where reactor temperature and acid concentration were examined. Xylose concentration reached a maximum value of 14 g/100 g dry mass corresponding to a yield of 94% at the best identified conditions of 2.5 wt% H3PO4, 135°C, 120 min reaction time, and at 2.5 wt% H3PO4, 150°C, and 60 min reaction time. For glucose, an average yield of 26% was obtained at 2.5 wt% H3PO4, 200°C, and 30 min. Furfural and 5-hydroxymethylfurfural (HMF) formation was clearly affected by reaction temperature, where the higher the temperature the higher the formation rate. The maximum furfural formed was an average of 3 g/100 g dry mass, corresponding to a yield of 28%. The kinetic study of the acid hydrolysis was also carried out using the Saeman and the two-fraction models. It was found for both models that the kinetic constants (K) depend on the acid concentration and temperature. The degradation of HMF to levulinic acid is faster than the degradation of furfural to formic acid. Also, the degradation rate is higher than the formation rate for both inhibitors when degradation is observed.
- 14 May 2013
- Published by Taylor & Francis in Environmental Technology
- Vol. 34 (22) , 3005-3016
Fermentable sugars recovery from lignocellulosic waste-newspaper by catalytic hydrolysis
The urgent need for alternative renewable energies to supplement petroleum-based fuels and the reduction of landfill sites for disposal of solid wastes makes it increasingly attractive to produce inexpensive biofuels from the organic fraction of the municipal solid waste. Therefore, municipal waste in the form of newspaper was investigated as a potential feedstock for fermentable sugars production. Hydrolysis of newspaper by dilute phosphoric acid was carried out in autoclave Parr reactor, where reactor temperature and acid concentration were examined. Xylose concentration reached a maximum value of 14 g/100 g dry mass corresponding to a yield of 94% at the best identified conditions of 2.5 wt% H3PO4, 135°C, 120 min reaction time, and at 2.5 wt% H3PO4, 150°C, and 60 min reaction time. For glucose, an average yield of 26% was obtained at 2.5 wt% H3PO4, 200°C, and 30 min. Furfural and 5-hydroxymethylfurfural (HMF) formation was clearly affected by reaction temperature, where the higher the temperature the higher the formation rate. The maximum furfural formed was an average of 3 g/100 g dry mass, corresponding to a yield of 28%. The kinetic study of the acid hydrolysis was also carried out using the Saeman and the two-fraction models. It was found for both models that the kinetic constants (K) depend on the acid concentration and temperature. The degradation of HMF to levulinic acid is faster than the degradation of furfural to formic acid. Also, the degradation rate is higher than the formation rate for both inhibitors when degradation is observed.
- 1 October 2011
- Published by Elsevier in Bioresource Technology
- Vol. 102 (19) , 9076-9082
Dilute phosphoric acid-catalysed hydrolysis of municipal bio-waste wood shavings using autoclave parr reactor system
- 1 October 2011
- Published by Elsevier in Bioresource Technology
- Vol. 102 (19) , 9076-9082
Dilute phosphoric acid-catalysed hydrolysis of municipal bio-waste wood shavings using autoclave parr reactor system
- 1 September 2011
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 1 (5) , 839-846
Acid-catalyzed hydrolysis of cellulose and cellulosic waste using a microwave reactor system
A microwave reactor system was investigated as a potential technique to maximize sugar yield for the hydrolysis of municipal solid waste for ethanol production. Specifically, dilute acid hydrolysis of α-cellulose and waste cellulosic biomass (grass clippings) with phosphoric acid was undertaken within the microwave reactor system. The experimental data and reaction kinetic analysis indicate that the use of a microwave reactor system can successfully facilitate dilute acid hydrolysis of cellulose and waste cellulosic biomass, producing high yields of total sugars in short reaction times. The maximum yield of reducing sugars was obtained at 7.5% (w/v) phosphoric acid and 160 °C, corresponding to 60% of the theoretical total sugars, with a reaction time of 5 min. When using a very low acid concentration (0.4% w/v) for the hydrolysis in the microwave reactor, it was found that 10 g of total sugars/100 g dry mass was produced, which is significant considering the low acid concentration. When hydrolyzing grass clippings using the microwave reactor, the optimum conditions were an acid concentration of 2.5% (w/v), 175 °C with a 15 min reaction time, giving 18 g/100 g dry mass of total sugars, with xylose being the sugar with the highest yield. It was observed that pentose sugars were more easily formed but also more easily degraded, these being significantly affected by increases in acid concentration and temperature. Kinetic modeling of the data indicated that the use of microwave heating may account for an increase in reaction rate constant, k1, found in this study in comparison with conventional systems described in the literature.
- 1 September 2011
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 1 (5) , 839-846
Acid-catalyzed hydrolysis of cellulose and cellulosic waste using a microwave reactor system
A microwave reactor system was investigated as a potential technique to maximize sugar yield for the hydrolysis of municipal solid waste for ethanol production. Specifically, dilute acid hydrolysis of α-cellulose and waste cellulosic biomass (grass clippings) with phosphoric acid was undertaken within the microwave reactor system. The experimental data and reaction kinetic analysis indicate that the use of a microwave reactor system can successfully facilitate dilute acid hydrolysis of cellulose and waste cellulosic biomass, producing high yields of total sugars in short reaction times. The maximum yield of reducing sugars was obtained at 7.5% (w/v) phosphoric acid and 160 °C, corresponding to 60% of the theoretical total sugars, with a reaction time of 5 min. When using a very low acid concentration (0.4% w/v) for the hydrolysis in the microwave reactor, it was found that 10 g of total sugars/100 g dry mass was produced, which is significant considering the low acid concentration. When hydrolyzing grass clippings using the microwave reactor, the optimum conditions were an acid concentration of 2.5% (w/v), 175 °C with a 15 min reaction time, giving 18 g/100 g dry mass of total sugars, with xylose being the sugar with the highest yield. It was observed that pentose sugars were more easily formed but also more easily degraded, these being significantly affected by increases in acid concentration and temperature. Kinetic modeling of the data indicated that the use of microwave heating may account for an increase in reaction rate constant, k1, found in this study in comparison with conventional systems described in the literature.