Patrice Berçot
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Patrice Berçot has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
M. Rezrazi
Institut UTINAM, NCRS UMR 6213, Université de Franche-Comté, 16 route de Gray, 25030 Besançon Cedex, France
6 shared publicationsA. Benyaich
Laboratory of Physical Chemistry of Materials and Environment, Department of Chemistry, University Cadi Ayyad, Faculty of Science Semlalia, BP 2390 Marrakech, Morocco
3 shared publicationsY. Mountassir
Laboratory of Physical Chemistry of Materials and Environment, Department of Chemistry, University Cadi Ayyad, Faculty of Science Semlalia, BP 2390 Marrakech, Morocco
3 shared publicationsH. Addach
FEMTO-ST, Département MN2S, ENSMM, 26 Chemin de l’Epitaphe 25030 Besançon Cedex, France
2 shared publicationsL. Gebrati
Ecotoxicology Laboratory, Department of Biology, University Cadi Ayyad, Faculty of Science Semlalia, BP 2390, Marrakesh, Morocco
2 shared publicationsEl Mustafa Rezrazi
Institut UTINAM CNRS UMR 6213 Université de Franche‐Comté 16 route de Gray Besançon Cedex 25030 France
1 shared publication
Latest Publications
- 1 December 2015
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 3 (4) , 2900-2908
Potential use of clay in electrocoagulation process of textile wastewater: Treatment performance and flocs characterization
- 1 December 2015
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 3 (4) , 2900-2908
Potential use of clay in electrocoagulation process of textile wastewater: Treatment performance and flocs characterization
- 1 June 2013
- Published by IWA Publishing in Water Science & Technology
- Vol. 67 (12) , 2791-2799
Wastewater effluent characteristics from Moroccan textile industry
The objectives of this work were to carry out a complete characterization of textile wastewater, resulting from a textile unit located in the Marrakesh region. A physico-chemical characterization has been performed, focused on organic and toxicological aspects. The cladoceran Daphnia magna was used as the sensor organism and lethal concentration as a criterion to measure the toxicity of textile wastewater. The physico-chemical and toxicological status of a local textile effluent showed considerable values limitation, when compared to the European Union standard limit and Moroccan guide level and other studies. In view of those characteristics, the wastewater effluent from the textile industry should be considered to be treated before discharge to the environment.
- 1 June 2013
- Published by IWA Publishing in Water Science & Technology
- Vol. 67 (12) , 2791-2799
Wastewater effluent characteristics from Moroccan textile industry
The objectives of this work were to carry out a complete characterization of textile wastewater, resulting from a textile unit located in the Marrakesh region. A physico-chemical characterization has been performed, focused on organic and toxicological aspects. The cladoceran Daphnia magna was used as the sensor organism and lethal concentration as a criterion to measure the toxicity of textile wastewater. The physico-chemical and toxicological status of a local textile effluent showed considerable values limitation, when compared to the European Union standard limit and Moroccan guide level and other studies. In view of those characteristics, the wastewater effluent from the textile industry should be considered to be treated before discharge to the environment.
- 1 December 2012
- Published by IWA Publishing in Water Science & Technology
- Vol. 66 (12) , 2586-2596
Decontamination of synthetic textile wastewater by electrochemical processes: energetic and toxicological evaluation
The treatment of a synthetic textile wastewater, prepared with several compounds used in the finishing of textile materials, was comparatively studied by electrochemical methods such as electrooxidation (EO) (titanium electrode) and electrocoagulation (EC) (with aluminum and iron electrodes). The influence of pH, current density and operating time on the treatment was assessed by the parameters used to measure the level of organic contaminants in the wastewater; i.e. color, toxicity and chemical oxygen demand (COD). The experimental results showed that an effective electrochemical oxidation was achieved in which the wastewater was decolorized and 92% of COD was completely eliminated. In particular, the mineralization took place by indirect oxidation, mediated by active chlorine, and the treatment efficiency was enhanced by the addition of NaCl to the wastewater and by increasing the applied current density. The toxicity, still higher than the toxicity of the raw effluent, indicated a presence of toxic products after EO. Good results were obtained with the Al and Fe electrodes, mainly with respect to the removal of color and toxicity. EC is more economical than EO and the toxicity evaluation with the Daphnia magna test shows a significant reduction after EC.
- 1 December 2012
- Published by IWA Publishing in Water Science & Technology
- Vol. 66 (12) , 2586-2596
Decontamination of synthetic textile wastewater by electrochemical processes: energetic and toxicological evaluation
The treatment of a synthetic textile wastewater, prepared with several compounds used in the finishing of textile materials, was comparatively studied by electrochemical methods such as electrooxidation (EO) (titanium electrode) and electrocoagulation (EC) (with aluminum and iron electrodes). The influence of pH, current density and operating time on the treatment was assessed by the parameters used to measure the level of organic contaminants in the wastewater; i.e. color, toxicity and chemical oxygen demand (COD). The experimental results showed that an effective electrochemical oxidation was achieved in which the wastewater was decolorized and 92% of COD was completely eliminated. In particular, the mineralization took place by indirect oxidation, mediated by active chlorine, and the treatment efficiency was enhanced by the addition of NaCl to the wastewater and by increasing the applied current density. The toxicity, still higher than the toxicity of the raw effluent, indicated a presence of toxic products after EO. Good results were obtained with the Al and Fe electrodes, mainly with respect to the removal of color and toxicity. EC is more economical than EO and the toxicity evaluation with the Daphnia magna test shows a significant reduction after EC.
- 31 December 2009
- Published by Elsevier in Corrosion Science
- Vol. 51 (12) , 3069
Responses to the comments by J. Chêne on the paper entitled: “Study of the electrochemical permeation of hydrogen in iron”, Ref.
- 31 December 2009
- Published by Elsevier in Corrosion Science
- Vol. 51 (12) , 3069
Responses to the comments by J. Chêne on the paper entitled: “Study of the electrochemical permeation of hydrogen in iron”, Ref.
- 24 May 2009
- Published by Wiley in Rare Metals
- Vol. 28 (3) , 277-283
Improvement in corrosion resistance of magnesium coating with cerium treatment
Corrosion protection afforded by a magnesium coating treated in cerium salt solution on steel substrate was investigated using open circuit potential, polarization curves, and electrochemical impedance spectroscopy (EIS) in 0.005 M sodium chloride solution (NaCl). The morphology of the surface was characterized by scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS), and X‐ray diffraction (XRD). The cerium treated coating was obtained by immersion in CeCl 3 solution. The results showed that the corrosion resistance of the treated magnesium coating was improved. The corrosion potential of the treated coating was found to be nobler than that of the untreated magnesium coating and the corrosion current decreased significantly. Impedance results showed that the cerium treatment increased corrosion protection. The improvement of anti‐corrosion properties was attributed to the formation of cerium oxides and hydroxides that gave rise to a physical barrier effect.
- 24 May 2009
- Published by Wiley in Rare Metals
- Vol. 28 (3) , 277-283
Improvement in corrosion resistance of magnesium coating with cerium treatment
Corrosion protection afforded by a magnesium coating treated in cerium salt solution on steel substrate was investigated using open circuit potential, polarization curves, and electrochemical impedance spectroscopy (EIS) in 0.005 M sodium chloride solution (NaCl). The morphology of the surface was characterized by scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS), and X‐ray diffraction (XRD). The cerium treated coating was obtained by immersion in CeCl 3 solution. The results showed that the corrosion resistance of the treated magnesium coating was improved. The corrosion potential of the treated coating was found to be nobler than that of the untreated magnesium coating and the corrosion current decreased significantly. Impedance results showed that the cerium treatment increased corrosion protection. The improvement of anti‐corrosion properties was attributed to the formation of cerium oxides and hydroxides that gave rise to a physical barrier effect.
- 29 November 2006
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 37 (2) , 283-289
Effects of some additives on the corrosion behaviour and preferred orientations of zinc obtained by continuous current deposition
- 29 November 2006
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 37 (2) , 283-289
Effects of some additives on the corrosion behaviour and preferred orientations of zinc obtained by continuous current deposition
- 7 October 2006
- Published by EDP Sciences in Matériaux & Techniques
- Vol. 94 (1) , 47-52
Élaboration et caractérisations mécanique et morphologique de revêtements électrolytiques de chrome
- 7 October 2006
- Published by EDP Sciences in Matériaux & Techniques
- Vol. 94 (1) , 47-52
Élaboration et caractérisations mécanique et morphologique de revêtements électrolytiques de chrome
- 1 March 2005
- Published by EDP Sciences in Journal de Physique IV
- Vol. 123, 387-391
Ultrasonically elaborated Au/PTFE composite coatings
- 1 March 2005
- Published by EDP Sciences in Journal de Physique IV
- Vol. 123, 387-391
Ultrasonically elaborated Au/PTFE composite coatings