Katsuhiro Uesugi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Katsuhiro Uesugi has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
Ikuo Suemune
Research Institute for Electronic Science, Hokkaido University, Kita-12, Nishi-6, Sapporo 060-0812, Japan
6 shared publications- Hidekazu Kumano
Research Institute for Electronic Science, Hokkaido University, Sapporo 001-0021, Japan
2 shared publications Adrian Avramescu
Research Institute for Electronic Science, Hokkaido University, Sapporo 060, Japan
1 shared publicationAkio Ueta
Research Institute for Electronic Science, Hokkaido University, Sapporo 060, Japan
1 shared publicationHideaki Machida
Trichemical Laboratory, 8154-217 Uenohara, Kitatsurugun, Yamanashi 409-0112, Japan
1 shared publicationJun’ichiro Nakahara
Faculty of Science, Hokkaido University, Sapporo 060, Japan
1 shared publication
Latest Publications
- 9 July 2002
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 17 (8) , 755-761
Growth and structural characterization of III N V semiconductor alloys
The growth of GaNAs and related alloys has been studied using metal–organic molecular beam epitaxy. The lattice mismatch of GaNAs layers grown on GaAs induces lattice relaxation, the details of which are investigated with a mapping measurement of x-ray diffraction. The experimental results are compared to the calculated value of the critical thickness for the generation of misfit dislocations. It is shown that the surface morphology changes with the nitrogen (N) incorporation and, especially, wire-like surfaces associated with lateral compositional modulation are observed in a certain range of N compositions and with a thickness of more than 1 μm. The effects of indium and selenium doping on the N incorporation in GaNAs alloys are also discussed.
- 9 July 2002
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 17 (8) , 755-761
Growth and structural characterization of III N V semiconductor alloys
The growth of GaNAs and related alloys has been studied using metal–organic molecular beam epitaxy. The lattice mismatch of GaNAs layers grown on GaAs induces lattice relaxation, the details of which are investigated with a mapping measurement of x-ray diffraction. The experimental results are compared to the calculated value of the critical thickness for the generation of misfit dislocations. It is shown that the surface morphology changes with the nitrogen (N) incorporation and, especially, wire-like surfaces associated with lateral compositional modulation are observed in a certain range of N compositions and with a thickness of more than 1 μm. The effects of indium and selenium doping on the N incorporation in GaNAs alloys are also discussed.
- 28 February 2002
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 41 (Part 1, No) , 1030-1033
Metalorganic Molecular-Beam Epitaxial Growth and Optical Properties of Er-Doped GaNP
Erbium (Er) doping in GaNP during growth by metalorganic molecular-beam epitaxy was studied. Nitrogen (N) doping in GaP was possible up to ~ 2% and exhibited large band-gap bowing consistent with previous reports. Er was doped in GaNP to study the codoping effect of Er and N. Er concentration was estimated to be about 0.2–0.8 at.% depending on the Er Knudsen cell temperature. Er doping in GaNP resulted in photoluminescence (PL) spectra similar to that of GaP in the visible-wavelength region, but the PL subpeaks at energies near the longitudinal-optical-phonon replica observed in GaP exhibited variations with Er doping. Although no sharp Er emissions originating from the 4f-4f inner-shell transitions were observed with the codoping, intense wide-band infrared (IR) luminescence covering the wavelength range from 1.1 to 1.6 µm was observed with the codoping of Er and N. The IR luminescence was linearly increased for the higher excitations, while the corresponding IR-PL intensity in undoped GaNP was weak and easily saturated.
- 28 February 2002
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 41 (Part 1, No) , 1030-1033
Metalorganic Molecular-Beam Epitaxial Growth and Optical Properties of Er-Doped GaNP
Erbium (Er) doping in GaNP during growth by metalorganic molecular-beam epitaxy was studied. Nitrogen (N) doping in GaP was possible up to ~ 2% and exhibited large band-gap bowing consistent with previous reports. Er was doped in GaNP to study the codoping effect of Er and N. Er concentration was estimated to be about 0.2–0.8 at.% depending on the Er Knudsen cell temperature. Er doping in GaNP resulted in photoluminescence (PL) spectra similar to that of GaP in the visible-wavelength region, but the PL subpeaks at energies near the longitudinal-optical-phonon replica observed in GaP exhibited variations with Er doping. Although no sharp Er emissions originating from the 4f-4f inner-shell transitions were observed with the codoping, intense wide-band infrared (IR) luminescence covering the wavelength range from 1.1 to 1.6 µm was observed with the codoping of Er and N. The IR luminescence was linearly increased for the higher excitations, while the corresponding IR-PL intensity in undoped GaNP was weak and easily saturated.
- 8 November 2001
- Published by AIP Publishing in Applied Physics Letters
- Vol. 79 (20) , 3284-3286
Highly conductive GaAsNSe alloys grown on GaAs and their nonalloyed ohmic properties
Doping properties of Se in GaAsN alloys grown on GaAs (001) substrates by metalorganic-molecular-beam epitaxy were studied. Ditertiarybutylselenide (DtBSe) precursor was used as a Se source. It was found that Se was incorporated into GaAs and GaAsN layers up to a considerable concentration of ∼15%. It was also suggested that the N concentrations in GaAsNSe layers were increased by the DtBSe supply. The GaAsNSe layers were heavily doped type, and the maximum electron concentration was as high as With the increase of the carrier concentrations, the resistivity of GaAsNSe dramatically decreased to Ω cm. This made it possible to have ohmic contacts without thermal annealing, which indicates that GaAsNSe alloys are an attractive candidate for the formation of nonalloyed ohmic contacts.- 8 November 2001
- Published by AIP Publishing in Applied Physics Letters
- Vol. 79 (20) , 3284-3286
Highly conductive GaAsNSe alloys grown on GaAs and their nonalloyed ohmic properties
Doping properties of Se in GaAsN alloys grown on GaAs (001) substrates by metalorganic-molecular-beam epitaxy were studied. Ditertiarybutylselenide (DtBSe) precursor was used as a Se source. It was found that Se was incorporated into GaAs and GaAsN layers up to a considerable concentration of ∼15%. It was also suggested that the N concentrations in GaAsNSe layers were increased by the DtBSe supply. The GaAsNSe layers were heavily doped type, and the maximum electron concentration was as high as With the increase of the carrier concentrations, the resistivity of GaAsNSe dramatically decreased to Ω cm. This made it possible to have ohmic contacts without thermal annealing, which indicates that GaAsNSe alloys are an attractive candidate for the formation of nonalloyed ohmic contacts.- 23 February 1999
- Published by AIP Publishing in Applied Physics Letters
- Vol. 74 (9) , 1254-1256
Reexamination of N composition dependence of coherently grown GaNAs band gap energy with high-resolution x-ray diffraction mapping measurements
GaNAs films grown on GaAs(001) substrates by metalorganic molecular beam epitaxy were studied by high-resolution x-ray diffraction (XRD) mapping measurements. The lattice constants of epitaxial films are usually estimated from symmetric and asymmetric XRD measurements. In this study, it is pointed out that the consideration of the tilt angle between the GaAs(115) and GaNAs(115) planes caused by elastic deformation of the films is crucial to determine the lattice constants of the GaNAs films coherently grown on GaAs substrates. Mapping measurements of (115) XRD were performed for this purpose. The band gap energy of the films was determined by Fourier transform absorption spectroscopy measurements. The band gap energy bowing measured up to the N composition of 4.5% will be discussed by comparing with other measurements and theoretical calculations.- 23 February 1999
- Published by AIP Publishing in Applied Physics Letters
- Vol. 74 (9) , 1254-1256
Reexamination of N composition dependence of coherently grown GaNAs band gap energy with high-resolution x-ray diffraction mapping measurements
GaNAs films grown on GaAs(001) substrates by metalorganic molecular beam epitaxy were studied by high-resolution x-ray diffraction (XRD) mapping measurements. The lattice constants of epitaxial films are usually estimated from symmetric and asymmetric XRD measurements. In this study, it is pointed out that the consideration of the tilt angle between the GaAs(115) and GaNAs(115) planes caused by elastic deformation of the films is crucial to determine the lattice constants of the GaNAs films coherently grown on GaAs substrates. Mapping measurements of (115) XRD were performed for this purpose. The band gap energy of the films was determined by Fourier transform absorption spectroscopy measurements. The band gap energy bowing measured up to the N composition of 4.5% will be discussed by comparing with other measurements and theoretical calculations.- 9 February 1998
- Published by AIP Publishing in Applied Physics Letters
- Vol. 72 (6) , 716-718
Atomic force microscope lithography on carbonaceous films deposited by electron-beam irradiation
A nanometer-scale mask that can be used for selective growth or selective etching was obtained by two-stage patterning. In the first step, a microscopic patterning was performed using a scanning electron microscope (SEM). In the SEM the mask was deposited by decomposition of residual oil molecules in the vicinity of the semiconductor surface. In the second stage, patterning of the carbonaceous film was made using an atomic force microscope (AFM). Use of the AFM assures not only a precise alignment with the previous marks but also a better resolution. Applying an electric bias between the conductive tip and the substrate surface previously covered with the carbonaceous film gave the local modification of the film composition. Further etching resulted in the pattern formation on the semiconductor surface with a minimum linewidth of nm.- 9 February 1998
- Published by AIP Publishing in Applied Physics Letters
- Vol. 72 (6) , 716-718
Atomic force microscope lithography on carbonaceous films deposited by electron-beam irradiation
A nanometer-scale mask that can be used for selective growth or selective etching was obtained by two-stage patterning. In the first step, a microscopic patterning was performed using a scanning electron microscope (SEM). In the SEM the mask was deposited by decomposition of residual oil molecules in the vicinity of the semiconductor surface. In the second stage, patterning of the carbonaceous film was made using an atomic force microscope (AFM). Use of the AFM assures not only a precise alignment with the previous marks but also a better resolution. Applying an electric bias between the conductive tip and the substrate surface previously covered with the carbonaceous film gave the local modification of the film composition. Further etching resulted in the pattern formation on the semiconductor surface with a minimum linewidth of nm.- 5 February 1996
- Published by AIP Publishing in Applied Physics Letters
- Vol. 68 (6) , 844-846
Epitaxial growth of zinc-blende ZnSe/MgS superlattices on (001) GaAs
We report the growth of zinc-blende ZnSe/MgS superlattices (SLs) on GaAs (001) substrates. The SLs were grown with metalorganic vapor phase epitaxy by selecting appropriate precursors for Mg and S. MgS naturally forms rocksalt structures, but zinc-blende MgS layers were grown. The lattice constant of MgS was estimated to be 5.59 Å. X-ray diffraction measurements show that the ZnSe/MgS SLs are grown coherently to the GaAs substrates up to the total thicknesses of ∼3000 Å.
- 5 February 1996
- Published by AIP Publishing in Applied Physics Letters
- Vol. 68 (6) , 844-846
Epitaxial growth of zinc-blende ZnSe/MgS superlattices on (001) GaAs
We report the growth of zinc-blende ZnSe/MgS superlattices (SLs) on GaAs (001) substrates. The SLs were grown with metalorganic vapor phase epitaxy by selecting appropriate precursors for Mg and S. MgS naturally forms rocksalt structures, but zinc-blende MgS layers were grown. The lattice constant of MgS was estimated to be 5.59 Å. X-ray diffraction measurements show that the ZnSe/MgS SLs are grown coherently to the GaAs substrates up to the total thicknesses of ∼3000 Å.