Sultan Olmez
Research Subjects
Sultan Olmez has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
Servet Dogan
Professor, Department of Orthodontics, School of Dentistry, Ege University, Izmir, Turkey
3 shared publicationsGunvor Semb
Dental Faculty, University of Oslo, and Affiliate, Oslo Celft Team, Department of Plastic Surgery, Oslo, Norway and Senior Lecturer in Craniofacial Anomalies, University of Manchester, Manchester, United Kingdom
1 shared publicationHasan Yildiz
Professor, Department of Mechanical Engineering, Faculty of Engineering, Ege University, Izmir, Turkey
1 shared publication- Isil Aras
School of Orthodontics, Brooks Rehabilitation College of Healthcare Sciences, Jacksonville University, Jacksonville, Fla
1 shared publication Mahmut Pekedis
Research Assistant, Department of Mechanical Engineering, Faculty of Engineering, Ege University, Izmir, Turkey
1 shared publication
Latest Publications
- Open Access
- 31 August 2016
- Published by IntechOpen
Distraction Osteogenesis in the Treatment of Maxillary Hypoplasia
Distraction Osteogenesis in the Treatment of Maxillary Hypoplasia | InTechOpen, Published on: 2016-08-31. Authors: Sultan Olmez-Gurlen
- 31 August 2016
- Published by IntechOpen
Open AccessDistraction Osteogenesis in the Treatment of Maxillary Hypoplasia
Distraction Osteogenesis in the Treatment of Maxillary Hypoplasia | InTechOpen, Published on: 2016-08-31. Authors: Sultan Olmez-Gurlen
- 1 September 2014
- Published by The Angle Orthodontist (EH Angle Education & Research Foundation) in The Angle Orthodontist
- Vol. 84 (5) , 815-824
Biomechanical evaluation of sagittal maxillary internal distraction osteogenesis in unilateral cleft lip and palate patient and noncleft patients: A three-dimensional finite element analysis
Objective: To compare the pattern and amount of stress and displacement during maxillary sagittal distraction osteogenesis (DO) between a patient with unilateral cleft lip and palate (UCLP) and a noncleft patient. Materials and Methods: Three-dimensional finite element models for both skulls were constructed. Displacements of the surface landmarks and stress distributions in the circummaxillary sutures were analyzed after an anterior displacement of 6 mm was loaded to the elements where the inferior plates of the distractor were assumed to be fixed and were below the Le Fort I osteotomy line. Results: In sagittal plane, more forward movement was found on the noncleft side in the UCLP model (−6.401 mm on cleft side and −6.651 mm on noncleft side for the central incisor region). However, similar amounts of forward movement were seen in the control model. In the vertical plane, a clockwise rotation occurred in the UCLP model, whereas a counterclockwise rotation was seen in the control model. The mathematical UCLP model also showed higher stress values on the sutura nasomaxillaris, frontonasalis, and zygomatiomaxillaris on the cleft side than on the normal side. Conclusions: Not only did the sagittal distraction forces produce advancement forces at the intermaxillary sutures, but more stress was also present on the sutura nasomaxillaris, sutura frontonasalis, and sutura zygomaticomaxillaris on the cleft side than on the noncleft side.
- 1 September 2014
- Published by The Angle Orthodontist (EH Angle Education & Research Foundation) in The Angle Orthodontist
- Vol. 84 (5) , 815-824
Biomechanical evaluation of sagittal maxillary internal distraction osteogenesis in unilateral cleft lip and palate patient and noncleft patients: A three-dimensional finite element analysis
Objective: To compare the pattern and amount of stress and displacement during maxillary sagittal distraction osteogenesis (DO) between a patient with unilateral cleft lip and palate (UCLP) and a noncleft patient. Materials and Methods: Three-dimensional finite element models for both skulls were constructed. Displacements of the surface landmarks and stress distributions in the circummaxillary sutures were analyzed after an anterior displacement of 6 mm was loaded to the elements where the inferior plates of the distractor were assumed to be fixed and were below the Le Fort I osteotomy line. Results: In sagittal plane, more forward movement was found on the noncleft side in the UCLP model (−6.401 mm on cleft side and −6.651 mm on noncleft side for the central incisor region). However, similar amounts of forward movement were seen in the control model. In the vertical plane, a clockwise rotation occurred in the UCLP model, whereas a counterclockwise rotation was seen in the control model. The mathematical UCLP model also showed higher stress values on the sutura nasomaxillaris, frontonasalis, and zygomatiomaxillaris on the cleft side than on the normal side. Conclusions: Not only did the sagittal distraction forces produce advancement forces at the intermaxillary sutures, but more stress was also present on the sutura nasomaxillaris, sutura frontonasalis, and sutura zygomaticomaxillaris on the cleft side than on the noncleft side.
- 1 November 2012
- Published by SAGE Publications in The Cleft Palate Craniofacial Journal
- Vol. 49 (6) , 75-81
Comparative Evaluation of Nasopharyngeal Airways of Unilateral Cleft Lip and Palate Patients Using Three-Dimensional and Two-Dimensional Methods
Aim: Comparison of nasopharyngeal airway dimensions among UCLP patients and the control group. Materials and Methods: Computed tomography imaging data and cephalometric films of 20 patients with UCLP and 20 controls were acquired prior to treatment. Three-dimensional (3D) reconstructions of nasal, superior, middle, and inferior pharyngeal airways were carried out from dicom data, and volumes of these compartments were calculated. Nasal width and superior, middle, and inferior nasopharyngeal areas were calculated from cephalometric films. Results: The only statistically significant difference among the cleft and noncleft patients was detected in nasal volume ( p < .01). Upper and middle pharyngeal airway areas were found to display significant larger areas in the noncleft group on cephalometric appraisal. Nonsignificantly larger nasal widths were measured in the cleft group. Discussion and Conclusion: Evaluation of the nasopharyngeal airways of cleft and noncleft patients was done, resulting in only the nasal region showing statistically significant difference. Our results showed significantly lower nasal volume measurements of cleft patients when compared with the healthy individuals (p < .01). This inadequacy can be interpreted as an outcome of the deficiency. The controversy among results of cephalometric appraisal and 3D imaging can be associated with superimpositions, density, and contrast inadequacies and obscured landmarks. When 2D data are compared with 3D data, the former can be insufficient and therefore deceiving. Consequently, although the radiation dose of 3D imaging systems is greater, they have the advantage of superior diagnostic outputs.
- 1 November 2012
- Published by SAGE Publications in The Cleft Palate Craniofacial Journal
- Vol. 49 (6) , 75-81
Comparative Evaluation of Nasopharyngeal Airways of Unilateral Cleft Lip and Palate Patients Using Three-Dimensional and Two-Dimensional Methods
Aim: Comparison of nasopharyngeal airway dimensions among UCLP patients and the control group. Materials and Methods: Computed tomography imaging data and cephalometric films of 20 patients with UCLP and 20 controls were acquired prior to treatment. Three-dimensional (3D) reconstructions of nasal, superior, middle, and inferior pharyngeal airways were carried out from dicom data, and volumes of these compartments were calculated. Nasal width and superior, middle, and inferior nasopharyngeal areas were calculated from cephalometric films. Results: The only statistically significant difference among the cleft and noncleft patients was detected in nasal volume ( p < .01). Upper and middle pharyngeal airway areas were found to display significant larger areas in the noncleft group on cephalometric appraisal. Nonsignificantly larger nasal widths were measured in the cleft group. Discussion and Conclusion: Evaluation of the nasopharyngeal airways of cleft and noncleft patients was done, resulting in only the nasal region showing statistically significant difference. Our results showed significantly lower nasal volume measurements of cleft patients when compared with the healthy individuals (p < .01). This inadequacy can be interpreted as an outcome of the deficiency. The controversy among results of cephalometric appraisal and 3D imaging can be associated with superimpositions, density, and contrast inadequacies and obscured landmarks. When 2D data are compared with 3D data, the former can be insufficient and therefore deceiving. Consequently, although the radiation dose of 3D imaging systems is greater, they have the advantage of superior diagnostic outputs.
- 1 May 2012
- Published by SAGE Publications in The Cleft Palate Craniofacial Journal
- Vol. 49 (3) , 347-351
Comparative Assessment of Dental Arch Relationships Using Goslon Yardstick in Patients with Unilateral Complete Cleft Lip and Palate Using Dental Casts, Two-Dimensional Photos, and Three-Dimensional Images
Objective: Comparison of the use of two-dimensional (2D) and three-dimensional (3D) images for rating dental arch relationships. Materials and Methods: The sample consists of pretreatment dental casts, 2D photographs, and 3D images of 70 patients with unilateral complete cleft lip and palate. Two experienced examiners used the Goslon Yardstick to rate dental arch relationships. The ratings were done three times for all groups. Weighted kappa statistics were used to evaluate intra- and interrater agreement and the agreement between the groups. Results: Intra- and interexaminer agreement were high for all groups (between 0.86 and 0.96), indicating very good reproducibility. The mean Goslon scores ranged between 2.84 and 2.90. Conclusion: 2D and 3D imaging of dental casts provides a valid alternative for actual study models for rating dental arch relationships.
- 1 May 2012
- Published by SAGE Publications in The Cleft Palate Craniofacial Journal
- Vol. 49 (3) , 347-351
Comparative Assessment of Dental Arch Relationships Using Goslon Yardstick in Patients with Unilateral Complete Cleft Lip and Palate Using Dental Casts, Two-Dimensional Photos, and Three-Dimensional Images
Objective: Comparison of the use of two-dimensional (2D) and three-dimensional (3D) images for rating dental arch relationships. Materials and Methods: The sample consists of pretreatment dental casts, 2D photographs, and 3D images of 70 patients with unilateral complete cleft lip and palate. Two experienced examiners used the Goslon Yardstick to rate dental arch relationships. The ratings were done three times for all groups. Weighted kappa statistics were used to evaluate intra- and interrater agreement and the agreement between the groups. Results: Intra- and interexaminer agreement were high for all groups (between 0.86 and 0.96), indicating very good reproducibility. The mean Goslon scores ranged between 2.84 and 2.90. Conclusion: 2D and 3D imaging of dental casts provides a valid alternative for actual study models for rating dental arch relationships.