Abraham C. F. Chiu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Abraham C. F. Chiu has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Wei Zhu
College of Environment, Hohai University, Nanjing 210098, China
3 shared publications - C. L. Zhang
Professor, State Key Laboratory of Hydrology, Water Resources and Hydraulic Engineering, Hohai Univ., Nanjing 210098, China
1 shared publication - J. P. Yuan
Associate Professor, Key Laboratory of Ministry of Education for Geomechanics and Embankment Engineering, Hohai Univ., 1 Xikang Rd., Nanjing 210098, China
1 shared publication X. Zhao
Associate Professor, Key Laboratory of Ministry of Education for Geomechanics and Embankment Engineering, Hohai Univ., 1 Xikang Rd., Nanjing 210098, China
1 shared publicationXuedong Chen
Associate Professor, Key Laboratory of Ministry of Education for Geomechanics and Embankment Engineering, Hohai Univ., Nanjing 210098, China
1 shared publication
Latest Publications
- 1 September 2010
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 136 (9) , 1251-1262
State Boundary Surfaces for an Aged Compacted Clay
The yielding and the peak strength of an aged compacted clay were studied by conducting a series of suction-controlled triaxial tests. The test results were interpreted using the framework of intrinsic properties of reconstituted soil. The peak strength envelopes of undisturbed samples lie above those of reconstituted samples. The suction provides additional attractive forces to stabilize the soil structure, which result in the augmentation of the yield stress and peak strength envelope. The shear strength is normalized by the equivalent preconsolidation pressure ( pe′ ) and Hvorslev surfaces are identified from undisturbed samples which expand with suction. A single peak strength envelope and Hvorslev surface will be emerged from the saturated and unsaturated (degree of saturation >80% ) samples if the shear strength data are presented in terms of the average skeleton stress. The influence of the soil structure on the shear strength of the aged compacted clay may be measured by the ratio of normalized st...
- 1 September 2010
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 136 (9) , 1251-1262
State Boundary Surfaces for an Aged Compacted Clay
The yielding and the peak strength of an aged compacted clay were studied by conducting a series of suction-controlled triaxial tests. The test results were interpreted using the framework of intrinsic properties of reconstituted soil. The peak strength envelopes of undisturbed samples lie above those of reconstituted samples. The suction provides additional attractive forces to stabilize the soil structure, which result in the augmentation of the yield stress and peak strength envelope. The shear strength is normalized by the equivalent preconsolidation pressure ( pe′ ) and Hvorslev surfaces are identified from undisturbed samples which expand with suction. A single peak strength envelope and Hvorslev surface will be emerged from the saturated and unsaturated (degree of saturation >80% ) samples if the shear strength data are presented in terms of the average skeleton stress. The influence of the soil structure on the shear strength of the aged compacted clay may be measured by the ratio of normalized st...
- 1 January 2010
- Published by Springer Nature
- p. 395-404
Role of Soil Water in Cement-Based Treatment of Dredged Materials
- 1 January 2010
- Published by Springer Nature
- p. 395-404
Role of Soil Water in Cement-Based Treatment of Dredged Materials
- 1 August 2009
- Published by American Society of Civil Engineers (ASCE) in Journal of Hydrologic Engineering
- Vol. 14 (8) , 882-886
Rainfall Infiltration Pattern in an Unsaturated Silty Sand
One-dimensional infiltration tests were conducted to investigate the effects of rainfall intensity and initial water content on the transient infiltration pattern of unsaturated silty sand. For a constant rainfall intensity greater than the saturated permeability but smaller than the maximum infiltration capacity of soil, the infiltration curve is divided into preponding and postponding stages. The time to ponding reduces with increasing rainfall intensity and initial water content. After ponding, the infiltration rate reduces with time and its reducing rate increases with rainfall intensity but does not vary significantly with initial water content. The infiltration pattern can be simulated qualitatively by solving Richard’s equation numerically with the use of the flux and head type boundary conditions at the soil surface in the preponding and postponding stages, respectively.
- 1 August 2009
- Published by American Society of Civil Engineers (ASCE) in Journal of Hydrologic Engineering
- Vol. 14 (8) , 882-886
Rainfall Infiltration Pattern in an Unsaturated Silty Sand
One-dimensional infiltration tests were conducted to investigate the effects of rainfall intensity and initial water content on the transient infiltration pattern of unsaturated silty sand. For a constant rainfall intensity greater than the saturated permeability but smaller than the maximum infiltration capacity of soil, the infiltration curve is divided into preponding and postponding stages. The time to ponding reduces with increasing rainfall intensity and initial water content. After ponding, the infiltration rate reduces with time and its reducing rate increases with rainfall intensity but does not vary significantly with initial water content. The infiltration pattern can be simulated qualitatively by solving Richard’s equation numerically with the use of the flux and head type boundary conditions at the soil surface in the preponding and postponding stages, respectively.
- 1 May 2007
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 133 (5) , 588-598
Soil–Water Transfer Mechanism for Solidified Dredged Materials
The paper presents a study of the soil–water transfer mechanism for solidified dredged materials. Soil–water consists of free water, bound water, and hydration water. The resulting hydrates change the soil–water composition in a cement-based solidification process. A soil–water transfer model is postulated to explain the relationship between soil–water composition and cement content. The test results of solidified specimens cured after 7 and 28 days showed that the hydration water increases linearly with the cement content, and the bound water increases nonlinearly with the cement content. There exists a threshold cement content beyond which the free water is eliminated from the solidified specimen. Further, the model is used to predict the mechanical behavior of the solidified dredged materials. Below the threshold cement content, the unconfined compressive strength may be related to the bound water content. Above the threshold cement content, the shear strength may be related to the hydration water cont...
- 1 May 2007
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 133 (5) , 588-598
Soil–Water Transfer Mechanism for Solidified Dredged Materials
The paper presents a study of the soil–water transfer mechanism for solidified dredged materials. Soil–water consists of free water, bound water, and hydration water. The resulting hydrates change the soil–water composition in a cement-based solidification process. A soil–water transfer model is postulated to explain the relationship between soil–water composition and cement content. The test results of solidified specimens cured after 7 and 28 days showed that the hydration water increases linearly with the cement content, and the bound water increases nonlinearly with the cement content. There exists a threshold cement content beyond which the free water is eliminated from the solidified specimen. Further, the model is used to predict the mechanical behavior of the solidified dredged materials. Below the threshold cement content, the unconfined compressive strength may be related to the bound water content. Above the threshold cement content, the shear strength may be related to the hydration water cont...