Taesik Kim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Interests
Taesik Kim has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
Richard J. Finno
Professor, Dept. of Civil and Environmental Engineering, Northwestern Univ., Evanston, IL 60208
2 shared publications- Dennis R. Hiltunen
Graduate Research Assistant, Department of Civil and Coastal Engineering, University of Florida, 365 Weil Hall, P.O. Box 116580, Gainesville, FL 32611
1 shared publication - Richard J. Finno
Professor, Dept. of Civil and Environmental Engineering, Northwestern Univ., Evanston, IL 60208
1 shared publication
Latest Publications
- 1 April 2012
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 138 (4) , 526-534
Effects of Stress Path Rotation Angle on Small Strain Responses
The results of experimental studies on the stress-strain behavior of Chicago glacial clays are presented and discussed. This paper describes small strain responses as a function of stress path rotation angle. Undrained compression and extension tests with three different preshear stress paths were conducted on high quality, hand-cut block samples obtained at two different depths from the excavation for the Block 37 project in Chicago. One preshear stress path was applied to investigate the stress-strain response representative of the in situ conditions via a recompression technique. The other two preshear stress paths were selected to isolate the effects of recent stress history such that the only difference between the two sets of paths was the direction of loading to a common effective stress condition. A period of drained creep at constant effective stress was imposed on all specimens prior to shearing to negate the possible effects of creep on the small strain responses. The results are discus...
- 1 April 2012
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 138 (4) , 526-534
Effects of Stress Path Rotation Angle on Small Strain Responses
The results of experimental studies on the stress-strain behavior of Chicago glacial clays are presented and discussed. This paper describes small strain responses as a function of stress path rotation angle. Undrained compression and extension tests with three different preshear stress paths were conducted on high quality, hand-cut block samples obtained at two different depths from the excavation for the Block 37 project in Chicago. One preshear stress path was applied to investigate the stress-strain response representative of the in situ conditions via a recompression technique. The other two preshear stress paths were selected to isolate the effects of recent stress history such that the only difference between the two sets of paths was the direction of loading to a common effective stress condition. A period of drained creep at constant effective stress was imposed on all specimens prior to shearing to negate the possible effects of creep on the small strain responses. The results are discus...
- 29 March 2012
- Published by American Society of Civil Engineers (ASCE)
- p. 2609-2618
Elastic Cross-Anisotropy of Chicago Glacial Clays from Field and Laboratory Data
The initial anisotropy of natural clays can be characterized by the elastic shear moduli measured by wave propagation techniques both in situ and in the laboratory. This paper summarizes results of studies of the initial anisotropy of fresh water glacial clays from two sites in the Chicago area. Advanced cross-hole seismic tests which measure both horizontally propagating and vertically- and horizontallypolarized shear wave velocities and seismic cone penetration tests (sCPT) were performed in situ. Bender elements were used to measure propagation velocities on laboratory specimens cut from high quality block samples of soft to medium clays obtained from the excavation for the Ford Design Center project. These clays are lightly overconsolidated, supraglacial tills. Laboratory specimens of hard clay from the One Museum Park West site were obtained with a Pitcher barrel sampler; these clays are overconsolidated, basal tills. Both in situ and laboratory results for the soft to medium clays indicate that the magnitude of the shear moduli are the same in each polarized direction. These clays are slightly cross anisotropic. For the harder clays, the in situ shear moduli are larger than those measured in the laboratory, presumably as a result of the sample disturbance arising from Pitcher barrel sampling.
- 29 March 2012
- Published by American Society of Civil Engineers (ASCE)
- p. 2609-2618
Elastic Cross-Anisotropy of Chicago Glacial Clays from Field and Laboratory Data
The initial anisotropy of natural clays can be characterized by the elastic shear moduli measured by wave propagation techniques both in situ and in the laboratory. This paper summarizes results of studies of the initial anisotropy of fresh water glacial clays from two sites in the Chicago area. Advanced cross-hole seismic tests which measure both horizontally propagating and vertically- and horizontallypolarized shear wave velocities and seismic cone penetration tests (sCPT) were performed in situ. Bender elements were used to measure propagation velocities on laboratory specimens cut from high quality block samples of soft to medium clays obtained from the excavation for the Ford Design Center project. These clays are lightly overconsolidated, supraglacial tills. Laboratory specimens of hard clay from the One Museum Park West site were obtained with a Pitcher barrel sampler; these clays are overconsolidated, basal tills. Both in situ and laboratory results for the soft to medium clays indicate that the magnitude of the shear moduli are the same in each polarized direction. These clays are slightly cross anisotropic. For the harder clays, the in situ shear moduli are larger than those measured in the laboratory, presumably as a result of the sample disturbance arising from Pitcher barrel sampling.
- 1 February 2012
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 138 (2) , 155-165
Anisotropy Evolution and Irrecoverable Deformation in Triaxial Stress Probes
This paper presents the results and analysis of experimental investigations of compressible Chicago clays with regard to the evolution of stiffness anisotropy. The experimental program was conducted on high-quality block samples obtained from the excavation for the Block 37 project in Chicago. The specimens were consolidated to in situ stresses via a recompression technique and then were subjected to directional stress probes. On-specimen LVDTs and an internal load cell with high accuracy were used for stress-strain response of the specimen. The stiffness and stiffness anisotropy ratio at very small strains were obtained synchronously from bender element tests during the consolidation and stress probes. The structural change as anisotropy evolves within a specimen is discussed. The results of the experimental program showed that compressible Chicago clay is an initially cross-anisotropic material under the in situ stresses. This anisotropy changes at the onset of irrecoverable deformation at stresses defi...
- 1 February 2012
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 138 (2) , 155-165
Anisotropy Evolution and Irrecoverable Deformation in Triaxial Stress Probes
This paper presents the results and analysis of experimental investigations of compressible Chicago clays with regard to the evolution of stiffness anisotropy. The experimental program was conducted on high-quality block samples obtained from the excavation for the Block 37 project in Chicago. The specimens were consolidated to in situ stresses via a recompression technique and then were subjected to directional stress probes. On-specimen LVDTs and an internal load cell with high accuracy were used for stress-strain response of the specimen. The stiffness and stiffness anisotropy ratio at very small strains were obtained synchronously from bender element tests during the consolidation and stress probes. The structural change as anisotropy evolves within a specimen is discussed. The results of the experimental program showed that compressible Chicago clay is an initially cross-anisotropic material under the in situ stresses. This anisotropy changes at the onset of irrecoverable deformation at stresses defi...