Henri P. Sangam
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Henri P. Sangam has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Rk Rowe
GeoEngineering Centre at Queen's-RMC, Queen's University
2 shared publications - A. M. R. Ewais
Soil Mechanics and Foundation Engineering Unit, Structural Engineering Department, Ain Shams University, Cairo, Egypt
1 shared publication - S. Rimal
Geotechnical Engineer, Golder Associates Ltd., 6925 Century Avenue, Suite #100, Mississauga, ON, Canada L5N 7K2
1 shared publication
Latest Publications
- 1 October 2018
- Published by Emerald Publishing in Geosynthetics International
- Vol. 25 (5) , 525-544
17-year elevated temperature study of HDPE geomembrane longevity in air, water and leachate
A 17-year investigation of a geomembrane (GMB) aged at 55, 70 and 85°C in air, water and leachate is reported. At test termination, the mechanical properties had only reached nominal failure in leachate and water at 70 and 85°C. Consistent with a previous study, there is a significant reduction in stress crack resistance (SCR) before there is clear evidence of oxidative degradation; this is attributed to the morphological changes due to disentanglement of entangled polymer chains. The effect of this apparent morphological change on SCR appeared to be greatest for the GMB when immersed in water and leachate at 70°C, although it is evident for all fluids at all three test temperatures. Using the most conservative estimates, the time to nominal failure (tNF, time to 50% of the initial or specified property value) in leachate, water and air (no UV exposure) ranged from >13, 18 and 170 years at 60°C to 660, 1500, and 1700 years, respectively, at 20°C. Assuming minimal tensile strains in the GMB, the time to nominal failure of this GMB in a composite liner is likely estimated to vary from >50 years at 60°C to >550 years at 35°C and > 1100 years at 20°C.
- 1 October 2018
- Published by Emerald Publishing in Geosynthetics International
- Vol. 25 (5) , 525-544
17-year elevated temperature study of HDPE geomembrane longevity in air, water and leachate
A 17-year investigation of a geomembrane (GMB) aged at 55, 70 and 85°C in air, water and leachate is reported. At test termination, the mechanical properties had only reached nominal failure in leachate and water at 70 and 85°C. Consistent with a previous study, there is a significant reduction in stress crack resistance (SCR) before there is clear evidence of oxidative degradation; this is attributed to the morphological changes due to disentanglement of entangled polymer chains. The effect of this apparent morphological change on SCR appeared to be greatest for the GMB when immersed in water and leachate at 70°C, although it is evident for all fluids at all three test temperatures. Using the most conservative estimates, the time to nominal failure (tNF, time to 50% of the initial or specified property value) in leachate, water and air (no UV exposure) ranged from >13, 18 and 170 years at 60°C to 660, 1500, and 1700 years, respectively, at 20°C. Assuming minimal tensile strains in the GMB, the time to nominal failure of this GMB in a composite liner is likely estimated to vary from >50 years at 60°C to >550 years at 35°C and > 1100 years at 20°C.
- 1 June 2005
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 131 (6) , 694-704
Effect of Surface Fluorination on Diffusion through a High Density Polyethylene Geomembrane
The relative improvement of the diffusive barrier function of high density polyethylene (HDPE) geomembranes to volatile organic compounds (VOCs) when subjected to surface fluorination is experimentally examined. The surface fluorination consisted of applying elemental fluorine, which exchanged with hydrogen along polymer chains at the surface of a polyolefin substrate. Sorption and diffusion tests were performed on both traditional “untreated” and “fluorinated” HDPE geomembranes using dilute aqueous organic contaminants commonly found in municipal solid waste leachate. The partitioning coefficient is shown to remain essential the same after the surface fluorination; however, the surface fluorination resulted in a reduction in both the diffusion and the permeation coefficients by factors ranging between 1.5 and 4.5, depending on the hydrocarbon examined. Modeling of VOC diffusion through a geomembrane/compacted clay composite liner indicated that contaminant impacts were about 1.7–2.9 times lower when a fluorinated geomembrane is used. To achieve the same level of protection as provided by the fluorinated geomembrane underlain by of compacted clay, one would need an additional of compacted clay in conjunction with a conventional (untreated) geomembrane. The importance of the thickness of the treated layer is highlighted.- 1 June 2005
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 131 (6) , 694-704
Effect of Surface Fluorination on Diffusion through a High Density Polyethylene Geomembrane
The relative improvement of the diffusive barrier function of high density polyethylene (HDPE) geomembranes to volatile organic compounds (VOCs) when subjected to surface fluorination is experimentally examined. The surface fluorination consisted of applying elemental fluorine, which exchanged with hydrogen along polymer chains at the surface of a polyolefin substrate. Sorption and diffusion tests were performed on both traditional “untreated” and “fluorinated” HDPE geomembranes using dilute aqueous organic contaminants commonly found in municipal solid waste leachate. The partitioning coefficient is shown to remain essential the same after the surface fluorination; however, the surface fluorination resulted in a reduction in both the diffusion and the permeation coefficients by factors ranging between 1.5 and 4.5, depending on the hydrocarbon examined. Modeling of VOC diffusion through a geomembrane/compacted clay composite liner indicated that contaminant impacts were about 1.7–2.9 times lower when a fluorinated geomembrane is used. To achieve the same level of protection as provided by the fluorinated geomembrane underlain by of compacted clay, one would need an additional of compacted clay in conjunction with a conventional (untreated) geomembrane. The importance of the thickness of the treated layer is highlighted.