Albert Gan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Albert Gan has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Priyanka Alluri
Department of Civil and Environmental Engineering, Florida International University, 10555 West Flagler Street, EC 3628, Miami, FL 33174, United States
10 shared publications - Dibakar Saha
Department of Civil and Environmental Engineering, Florida International University, 10555 West Flagler Street, EC 3680, Miami, FL 33174, United States
4 shared publications - Kirolos Haleem
Institute of Technology Florida International University
4 shared publications - Kirolos Haleem
School of Engineering & Applied Sciences Western Kentucky University 1906 College Heights Blvd, EBS 2122, Bowling Green, KY 42101
3 shared publications - Fabian Cevallos
Institute of Technology Florida International University
2 shared publications - Mohammed Hadi
Department of Civil and Environmental Engineering, Florida International University, 10555 West Flagler Street, EC 3730, Miami, FL 33174, USA
2 shared publications
Latest Publications
- Open Access
- 11 April 2022
- Published by Elsevier in Journal of Public Transportation
- Vol. 24
Methodology for rural and small-city U.S. transit agency peer grouping
- 11 April 2022
- Published by Elsevier in Journal of Public Transportation
- Vol. 24
Open AccessMethodology for rural and small-city U.S. transit agency peer grouping
- 1 March 2020
- Published by Elsevier in Accident Analysis & Prevention
- Vol. 137, 105456
Application of the Poisson-Tweedie distribution in analyzing crash frequency data
- 1 March 2020
- Published by Elsevier in Accident Analysis & Prevention
- Vol. 137, 105456
Application of the Poisson-Tweedie distribution in analyzing crash frequency data
- 1 February 2019
- Published by Elsevier in Accident Analysis & Prevention
- Vol. 123, 303-313
Estimation of bicycle crash modification factors (CMFs) on urban facilities using zero inflated negative binomial models
- 1 February 2019
- Published by Elsevier in Accident Analysis & Prevention
- Vol. 123, 303-313
Estimation of bicycle crash modification factors (CMFs) on urban facilities using zero inflated negative binomial models
- 22 June 2018
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2672 (8) , 41-51
Characteristics of Bus Transit Vehicles in the United States: A 30-Year National Trend Analysis
In 2015, transit agencies in the United States spent over 60% of their bus transit capital funds on their revenue vehicles. Using 30 years of data from the National Transit Database (NTD), this paper examines the national trends of seven major characteristics associated specifically with bus revenue vehicles. These trends can provide important information on where the market might be heading and aid in planning decisions on transit investments. The characteristics examined include the number of vehicles, spare ratio, average age, average capacity, Americans with Disabilities Act (ADA) accessibility, vehicle reliability, and vehicle operations and maintenance expenses. Some findings from the trend data include: (1) a steady increase in the privatization of bus services; (2) the average spare ratios have consistently exceeded the maximum of 20%, as suggested by the Federal Transit Administration (FTA) for systems operating with more than 50 vehicles; (3) vehicles operated by contractors tended to be significantly newer than those operated directly by transit agencies, although the gap has narrowed in recent years; (4) vehicles operated directly by transit agencies tended to have higher seating and standing capacities than those operated by contractors; (5) there was a tendency among transit agencies to trade seats for more standing room; (6) by 2015, nearly all bus vehicles were ADA-compliant, and increasingly vehicles with lifts were converted to vehicles with ramps/low-floor; (7) reliability of vehicles considering the number of mechanical failures per million revenue vehicle miles has significantly improved over the years; and (8) contractors spent significantly less on average than transit agencies in operating and maintaining their vehicles.
- 22 June 2018
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2672 (8) , 41-51
Characteristics of Bus Transit Vehicles in the United States: A 30-Year National Trend Analysis
In 2015, transit agencies in the United States spent over 60% of their bus transit capital funds on their revenue vehicles. Using 30 years of data from the National Transit Database (NTD), this paper examines the national trends of seven major characteristics associated specifically with bus revenue vehicles. These trends can provide important information on where the market might be heading and aid in planning decisions on transit investments. The characteristics examined include the number of vehicles, spare ratio, average age, average capacity, Americans with Disabilities Act (ADA) accessibility, vehicle reliability, and vehicle operations and maintenance expenses. Some findings from the trend data include: (1) a steady increase in the privatization of bus services; (2) the average spare ratios have consistently exceeded the maximum of 20%, as suggested by the Federal Transit Administration (FTA) for systems operating with more than 50 vehicles; (3) vehicles operated by contractors tended to be significantly newer than those operated directly by transit agencies, although the gap has narrowed in recent years; (4) vehicles operated directly by transit agencies tended to have higher seating and standing capacities than those operated by contractors; (5) there was a tendency among transit agencies to trade seats for more standing room; (6) by 2015, nearly all bus vehicles were ADA-compliant, and increasingly vehicles with lifts were converted to vehicles with ramps/low-floor; (7) reliability of vehicles considering the number of mechanical failures per million revenue vehicle miles has significantly improved over the years; and (8) contractors spent significantly less on average than transit agencies in operating and maintaining their vehicles.
- 1 January 2017
- Published by Elsevier in Accident Analysis & Prevention
- Vol. 98, 74-86
A Bayesian procedure for evaluating the frequency of calibration factor updates in highway safety manual (HSM) applications
- 1 January 2017
- Published by Elsevier in Accident Analysis & Prevention
- Vol. 98, 74-86
A Bayesian procedure for evaluating the frequency of calibration factor updates in highway safety manual (HSM) applications
- 15 April 2016
- Published by Taylor & Francis in Traffic Injury Prevention
- Vol. 17 (5) , 544-551
Safety performance evaluation of cable median barriers on freeways in Florida
Objective: This article aims to evaluate the safety performance of cable median barriers on freeways in Florida. Method: The safety performance evaluation was based on the percentages of barrier and median crossovers by vehicle type, crash severity, and cable median barrier type (Trinity Cable Safety System [CASS] and Gibraltar system). Twenty-three locations with cable median barriers totaling about 101 miles were identified. Police reports of 6,524 crashes from years 2005–2010 at these locations were reviewed to verify and obtain detailed crash information. A total of 549 crashes were determined to be barrier related (i.e., crashes involving vehicles hitting the cable median barrier) and were reviewed in further detail to identify crossover crashes and the manner in which the vehicles crossed the barriers; that is, by either overriding, underriding, or penetrating the barriers. Results: Overall, 2.6% of vehicles that hit the cable median barrier crossed the median and traversed into the opposite travel lane. Overall, 98.1% of cars and 95.5% of light trucks that hit the barrier were prevented from crossing the median. In other words, 1.9% of cars and 4.5% of light trucks that hit the barrier had crossed the median and encroached on the opposite travel lanes. There is no significant difference in the performance of cable median barrier for cars versus light trucks in terms of crossover crashes. In terms of severity, overrides were more severe compared to underrides and penetrations. The statistics showed that the CASS and Gibraltar systems performed similarly in terms of crossover crashes. However, the Gibraltar system experienced a higher proportion of penetrations compared to the CASS system. The CASS system resulted in a slightly higher percentage of moderate and minor injury crashes compared to the Gibraltar system. Conclusions: Cable median barriers are successful in preventing median crossover crashes; 97.4% of the cable median barrier crashes were prevented from crossing over the median. Of all of the vehicles that hit the barrier, 83.6% were either redirected or contained by the cable barrier system. Barrier crossover crashes were found to be more severe compared to barrier noncrossover crashes. In addition, overrides were found to be more severe compared to underrides and penetrations.
- 15 April 2016
- Published by Taylor & Francis in Traffic Injury Prevention
- Vol. 17 (5) , 544-551
Safety performance evaluation of cable median barriers on freeways in Florida
Objective: This article aims to evaluate the safety performance of cable median barriers on freeways in Florida. Method: The safety performance evaluation was based on the percentages of barrier and median crossovers by vehicle type, crash severity, and cable median barrier type (Trinity Cable Safety System [CASS] and Gibraltar system). Twenty-three locations with cable median barriers totaling about 101 miles were identified. Police reports of 6,524 crashes from years 2005–2010 at these locations were reviewed to verify and obtain detailed crash information. A total of 549 crashes were determined to be barrier related (i.e., crashes involving vehicles hitting the cable median barrier) and were reviewed in further detail to identify crossover crashes and the manner in which the vehicles crossed the barriers; that is, by either overriding, underriding, or penetrating the barriers. Results: Overall, 2.6% of vehicles that hit the cable median barrier crossed the median and traversed into the opposite travel lane. Overall, 98.1% of cars and 95.5% of light trucks that hit the barrier were prevented from crossing the median. In other words, 1.9% of cars and 4.5% of light trucks that hit the barrier had crossed the median and encroached on the opposite travel lanes. There is no significant difference in the performance of cable median barrier for cars versus light trucks in terms of crossover crashes. In terms of severity, overrides were more severe compared to underrides and penetrations. The statistics showed that the CASS and Gibraltar systems performed similarly in terms of crossover crashes. However, the Gibraltar system experienced a higher proportion of penetrations compared to the CASS system. The CASS system resulted in a slightly higher percentage of moderate and minor injury crashes compared to the Gibraltar system. Conclusions: Cable median barriers are successful in preventing median crossover crashes; 97.4% of the cable median barrier crashes were prevented from crossing over the median. Of all of the vehicles that hit the barrier, 83.6% were either redirected or contained by the cable barrier system. Barrier crossover crashes were found to be more severe compared to barrier noncrossover crashes. In addition, overrides were found to be more severe compared to underrides and penetrations.
- Top Cited Papers
- 1 August 2015
- Published by Elsevier in Accident Analysis & Prevention
- Vol. 81, 14-23
Analyzing pedestrian crash injury severity at signalized and non-signalized locations
- 1 August 2015
- Published by Elsevier in Accident Analysis & Prevention
- Vol. 81, 14-23
Top Cited PapersAnalyzing pedestrian crash injury severity at signalized and non-signalized locations
- 1 June 2015
- Published by Elsevier in Journal of Safety Research
- Vol. 53, 23-29
Contributing factors of crash injury severity at public highway-railroad grade crossings in the U.S.
- 1 June 2015
- Published by Elsevier in Journal of Safety Research
- Vol. 53, 23-29
Contributing factors of crash injury severity at public highway-railroad grade crossings in the U.S.
- 1 June 2015
- Published by Elsevier in Accident Analysis & Prevention
- Vol. 79, 133-144
Prioritizing Highway Safety Manual’s crash prediction variables using boosted regression trees
- 1 June 2015
- Published by Elsevier in Accident Analysis & Prevention
- Vol. 79, 133-144
Prioritizing Highway Safety Manual’s crash prediction variables using boosted regression trees
- Open Access
- 1 December 2014
- Published by University of South Florida Libraries in Journal of Public Transportation
- Vol. 17 (4) , 157-173
Use of Movable Bus Stop Loading Pads: Feasibility and Design Alternatives
The Americans with Disabilities Act (ADA) of 1990 requires bus stops to be accessible for individuals with disabilities. At a minimum, bus stops must have firm, stable, slip-resistant loading pads with connected sidewalks and curb ramps. Consequently, the typical approach of transit agencies has been to install permanent concrete loading pads at bus stops. This study explored alternatives to conventional concrete pads with movable pads that could be installed quickly, resulting in savings in construction and labor costs and minimizing both disruptions to traffic and impacts to abutting businesses. Potential design alternatives in terms of materials and structural support for these pads were evaluated. The review focused on existing and alternative design materials, especially in applications other than for transit purposes. Six materials were evaluated based on their structural performance, long-term durability, adaptability, life cycle cost, aesthetics, and safety and accessibility of transit riders with mobility devices. Of the six materials, plastic lumber and metal were found to have the highest potential to replace conventional designs. Two design alternatives that rely on the concept of bridge construction were introduced, both of which consist of four major components: foundation, slab, beam, and connections. These new design alternatives are anticipated to minimize maintenance of traffic and the need for heavy machinery to excavate, fill, and/or compact the soil.
- 1 December 2014
- Published by University of South Florida Libraries in Journal of Public Transportation
- Vol. 17 (4) , 157-173
Open AccessUse of Movable Bus Stop Loading Pads: Feasibility and Design Alternatives
The Americans with Disabilities Act (ADA) of 1990 requires bus stops to be accessible for individuals with disabilities. At a minimum, bus stops must have firm, stable, slip-resistant loading pads with connected sidewalks and curb ramps. Consequently, the typical approach of transit agencies has been to install permanent concrete loading pads at bus stops. This study explored alternatives to conventional concrete pads with movable pads that could be installed quickly, resulting in savings in construction and labor costs and minimizing both disruptions to traffic and impacts to abutting businesses. Potential design alternatives in terms of materials and structural support for these pads were evaluated. The review focused on existing and alternative design materials, especially in applications other than for transit purposes. Six materials were evaluated based on their structural performance, long-term durability, adaptability, life cycle cost, aesthetics, and safety and accessibility of transit riders with mobility devices. Of the six materials, plastic lumber and metal were found to have the highest potential to replace conventional designs. Two design alternatives that rely on the concept of bridge construction were introduced, both of which consist of four major components: foundation, slab, beam, and connections. These new design alternatives are anticipated to minimize maintenance of traffic and the need for heavy machinery to excavate, fill, and/or compact the soil.